Production costs and operative margins in electric energy generation from biogas. Full-scale case studies in Italy

The purpose of this study was to observe the economic sustainability of three different biogas full scale plants, fed with different organic matrices: energy crops (EC), manure, agro-industrial (Plants B and C) and organic fraction of municipal solid waste (OFMSW) (Plant A). The plants were observed for one year and total annual biomass feeding, biomass composition and biomass cost (€ Mg^?1), initial investment cost and plant electric power production were registered. The unit costs of biogas and electric energy (€ Sm^?3_biogas, € kW h^?1_EE) were differently distributed, depending on the type of feed and plant. Plant A showed high management/maintenance cost for OFMSW treatment (0.155 € Sm^?3_biogas, 45% of total cost), Plant B suffered high cost for EC supply (0.130 € Sm^?3_biogas, 49% of total cost) and Plant C showed higher impact on the total costs because of the depreciation charge (0.146 € Sm^?3_biogas, 41% of total costs). The breakeven point for the tariff of electric energy, calculated for the different cases, resulted in the range 120–170 € MW h^?1_EE, depending on fed materials and plant scale. EC had great impact on biomass supply costs and should be reduced, in favor of organic waste and residues; plant scale still heavily influences the production costs. The EU States should drive incentives in dependence of these factors, to further develop this still promising sector.     

Urban waterfowl population: Ecological evaluation of management and planning

An urban population of ducks in Puyallup, Washington, USA was studied for 14 consecutive months beginning in November 1978. Observations were made weekly from four study sites where ducks would congregate at early morning hours. Factors contributing to the presence of waterfowl in Puyallyup included abundant food supplies and a creek corridor that connected fragmented habitats in the urban area to the larger rural populations of waterfowl. Mallards (Anas platyrhynchos) were the most abundant of the 13 species observed and were the only ducks remaining during the nesting season. Habitat size and complexity were important factors influencing the species diversity of a particular site. Nesting success of mallards was poor due to limited distribution of nesting habitat, intraspecific aggression, and human disturbance. Both site-specific and more broad-based strategies are suggested for managing and planning for duck populations in urban areas.     

Evaluation of synthetic adsorbents for cleanup of herbicide-laden wastewater

Small-and large-scale farm operators and applicators urgently need user-friendly and cost-effective on-site methods to treat dilute-formulated herbicide-laden wastewater (i.e., rinsate). In this study, we investigated solvent-regenerable synthetic adsorbents, Ambersorb® 563 adsorbent, Ambersorb 572 adsorbent, and Ambersorb 575 adsorbent, as alternatives to activated carbon (Filtrasorb ® 400) for cleanup of water containing Dual 8E (a.i., metolachlor [2-chloro-N-(2-ethyl-6-methylphenyl)-N-(2-methoxy-1-methylethyl)acetamide]) or Banvel 4L (a.i., dicamba [3,6-dichloro-2-methoxybenzoic acid]). Batch-type adsorption experiments were conducted to compare adsorptive capacities of the various adsorbents. Adsorption maxima, obtained from adsorption isotherms, indicated that of the Ambersorb adsorbents tested, Ambersorb 572 adsorbent generally exhibited the highest adsorptive capacities for the herbicides tested and was comparable to Filtrasorb 400. Solvent (methanol) regenerability studies demonstrated that herbicide was readily recovered from Ambersorb 572 adsorbent and Filtrasorb 400. In general, metolachlor was more readily recoverable than dicamba. In fixed-bed column studies, Ambersorb 572 adsorbent exhibited twice the adsorptive capacity of Filtrasorb 400. Fixed-bed columns were more effective in removing metolachlor from herbicide containing water regardless of the adsorbent used. Multicycling of Ambersorb 572 adsorbent resulted in 30% loss of adsorptive capacity for dicamba as Banvel 4L and no loss of adsorptive capacity for metolachlor as Dual 8E. Working capacity was reached after three adsorption-regeneration cycles. Fixed-bed columns packed with solvent-regenerable adsorbents may prove useful as part of an on-site wastewater disposal system.     

Element Removal in Harvested Tree Biomass: Scenarios for Critical Loads in Wallonia,South Belgium

The critical load concept is nowwidely used as a tool for developing emissioncontrol policies in Europe. As a signatorycountry of the Convention of Long-RangeTransboundary Air Pollution, critical loads foracidity, nutrient nitrogen, nitrogen and sulphurhave been calculated for the Flemish and Walloonregions in Belgium. This paper describes themethodology used for estimating critical loadsfor forest soils in the Walloon region accordingto the Steady-State Mass Balance equations. As anexample the methodology was applied to thecatchment `Waroneu', situated in a sensitive areaof the Haute Ardenne. Main input parameters tothe equations were derived from precipitation andrunoff data of the catchment study. Improvedestimates of nitrogen uptake (Nu) and base cationuptake (BCu) were obtained by intensive samplingof Picea abies and Quercus roburtrees. Nutrient contents (Ca, Mg, K, N) andnutrient to nitrogen ratios of Picea abiesreflected the poor soil quality at a site withhigh N deposition. Quercus robur nutrientcontents increased from stem to higher orderbranches with a high proportion of nutrientslocated in the bark. However the simulation ofstem only harvesting had a minor effect oncritical loads. Measured wood densities werelower than reported literature values with a maineffect on Nu and BCu estimates. The use ofrecommended default values and/or data derivedfrom the experimental site resulted in a widerange of critical loads, some of which werelargely overestimated. Results demonstrated theimportance of site specific data for criticalload calculations.     

Leaching of inorganic contaminants from cement-based waste materials as a result of carbonation during intermittent wetting

Characterization of the leaching behavior of wastes is a crucial step in the environmental assessment for reuse or disposal scenarios. The release of inorganic contaminants from waste materials is typically evaluated by tank leaching of continuously water-saturated material. However, materials, in many field or management scenarios, experience cyclic wetting and drying under varied environmental conditions (i.e. variable relative humidity, atmospheric CO2 or CO2 from biologic activities). During periods of storage in an unsaturated environment, many processes may occur that can influence the release potential and release rate of inorganic constituents. The research presented here was carried out to examine how the phenomena of carbonation during drying influence the release of inorganic contaminants from Portland cement-based materials during cyclic wetting and storage. Batch equilibrium leaching tests were used to determine constituent solubility as a function of pH. Dynamic leaching tests on monolithic material were carried out to determine the rate of constituent release as a function of leaching time and intermittent storage conditions. This paper presents the results observed for three typical waste constituents, arsenic, cadmium and lead.     

Application of tracer ratio and inverse dispersion methods with boat-based plume measurements to estimate ammonia emissions from seabird colonies

Ammonia emissions from two contrasting seabird colonies in Scotland were measured, based on the determination of atmospheric concentrations downwind of the colonies. Atmospheric concentrations of ammonia (NH₃) across the downwind plume were compared with the inverse application of a Gaussian dispersion model (ID) to calculate the modelled NH₃ emission that would generate the measured cross-wind-integrated plume concentration. In parallel, a tracer gas (sulphur hexafluoride, SF₆) was released from the colonies with air samples taken to allow determination of SF₆ concentrations. On the basis of the known emission rate of SF₆, the magnitude of ammonia emissions was estimated by the cross-wind-integrated tracer ratio (TR) of NH₃/SF₆ concentrations. Coupled with data on annual bird attendance, the measurements indicate annual emissions from the Isle of May and the Bass Rock of 18 and 132 tonnes NH₃-N year^–1, respectively. The measured NH₃ emissions were compared with estimates of seabird nitrogen excretion to estimate the proportion of excreted N that is volatilised as NH₃ (F_Nr). The emission estimates of the two methods compared favourably, giving 4 and 6 kg NH₃-N h^–1 (F_Nr = 15%) for the Isle of May for the ID and TR methods, respectively, and 21 and 25 kg NH₃-N h^–1 (F_Nr = 50%) for the Bass Rock for the ID and TR methods, respectively. The results provide the first measurement-based estimates to allow regional up scaling of ammonia emissions from seabirds.     

An ecotoxicological approach for hazard identification of energy ash

Within the EU, ash should be classified by its inherent hazardous effects under criterion H-14 (ecotoxic) in the Directive on waste (2008/98/EC). Today, however, there are no harmonized quantitative criterions for such a classification, but it is stated that biological test systems can be used. In this study seven ash materials were leached and characterized, both biologically and chemically. The objectives were to evaluate if (a) clear concentration-response relationships could be achieved for the selected toxicity tests (bacteria, algae, crustacean and fish), (b) some test(s) are generally more sensitive and (c) the toxic responses were consistent with the chemical analyzes. Interestingly, our results indicate that high concentrations of non-hazardous components (Ca, K) influenced the toxicity of almost all ash eluates, whereas hazardous components (e.g. Zn, Pb) only influenced the toxicity of the eluates ranked as most hazardous. If considering both hazardous and non-hazardous substances, the observed toxic responses were relatively consistent with the chemical analyzes. Our results further showed that the (sub)chronic tests were much more sensitive than the acute tests. However, the use of extrapolation factors to compensate for using the less sensitive acute tests will likely lead to either over- or underestimations of toxicity. Our recommendation is therefore that classification of waste according to H-14 should be based on (sub)chronic test data. Finally, given that treatment of the eluates prior to toxicity testing has a major significance on the concentration and speciation of released substances, further studies are needed in order to propose a relevant testing scheme.