Determination of carbamazepine and 12 degradation products in various compartments of an outdoor aquatic mesocosm by reliable analytical methods based on liquid chromatography-tandem mass spectrometry

Environmental Science and Pollution Research - The aims of this work are to develop suitable analytical methods to determine the widely used anticonvulsant carbamazepine and 12 of its...     

Impact of vegetated filter strips on sorbed herbicide concentrations and sorption equilibrium in agricultural plots

The objective was to investigate the impact of vegetated filter strips on exported atrazine and deethylatrazine concentrations [dissolved and sorbed to eroded sediments (>1.5 μm)], the deethylatrazine to atrazine ratio in water and sediments, the ratio of sorbed to dissolved herbicides in runoff and subsurface infiltration as well as field equilibrium state under natural climate during two seasons. We hypothesize that sorption equilibrium was not achieved in 2004 because of the short delay (<24 h) between herbicide application and the first rain event. In 2005, observations suggest that possible changing sorption equilibrium conditions were reached (20 days after atrazine application), especially for eroded sediments submitted to changing environmental conditions in subsurface. If confirmed by other experiments, this will raise the question of the representativeness of laboratory-determined soil sorption coefficients to predict the fate of pesticides.     

Pedogenesis and nickel biogeochemistry in a typical Albanian ultramafic toposequence

This study aimed at relating the variability of Ni biogeochemistry along the ultramafic toposequence to pedogenesis and soil mineralogy. Hypereutric Cambisols dominate upslope; Cambic Vertisols and Fluvic Cambisols occur downslope. The soil mineralogy showed abundance of primary serpentine all over the sequence. It is predominant upslope but secondary smectites dominate in the Vertisols. Free Fe-oxides are abundant in all soils but slightly more abundant in the upslope soils. Whereas serpentines hold Ni in a similar and restricted range in every soil (approx. 0.3 %), Ni contents in smectites may vary a lot and Mg-rich and Al-poor smectites in the Vertisol could hold up to 4.9 % Ni. Ni was probably adsorbed onto amorphous Fe-oxides and was also exchangeable in secondary smectites. High availability of Ni in soils was confirmed by DTPA extractions. However, it varied significantly along the toposequence, being higher in upslope soils, where Ni-bearing amorphous Fe-oxides were abundant and total organic carbon higher and sensibly lower downslope on the Vertisols: Ni_DTPA varied from 285 mg kg^?1 in the surface of soil I (upslope) to 95.9 mg kg^?1 in the surface of Fluvic Cambisols. Concentration of Ni in Alyssum murale shoots varied from 0.7 % (Hypereutric Cambisols) to 1.4 % (Hypereutric Vertisol). Amazingly, Ni uptake by A. murale was not correlated to Ni_DTPA, suggesting the existence of specific edaphic conditions that affect the ecophysiology of A. murale upslope.     

Differential global profiling as a new analytical strategy for revealing micropollutant treatment by-products: application to ethinylestradiol and chlorination water treatment

The detection and structural elucidation of micropollutants treatment by-products are major issues to estimate efficiencies of the processes employed for drinking water production versus endocrine disruptive compounds contamination. This issue was mainly investigated at the laboratory scale and in high concentration conditions. However, potential by-products generated after chlorination can be influenced by the dilution factor employed in real conditions. The present study proposes a new methodology borrowed to the metabolomic science, using liquid chromatography coupled to high-resolution mass spectrometry, in order to reveal potential chlorination by-products of ethinylestradiol in spiked real water samples at the part-per-billion level (5 μg L⁻¹). Conventional targeted measurements first demonstrated that chlorination with sodium hypochlorite (0.8 mg L⁻¹) led to removals of ethinylestradiol over 97%. Then, the developed differential global profiling approach permitted to reveal eight chlorination by-products of EE2, six of them being described for the first time. Among these eight halogenated compounds, five have been structurally identified, demonstrating the potential capabilities of this new methodology applied to environmental samples.     

A national reconnaissance for selected organic micropollutants in sediments on French territory

To collect a large data set regarding the occurrence of organic substances in sediment, this study presents the examination of 20 micropollutants, as a national survey. The list of target compounds contains two alkylphenols, three polycyclic aromatic hydrocarbons (PAHs) not commonly included in monitoring programmes, six pesticides or metabolites, five pharmaceutical compounds, two hormones, one UV filter and bisphenol A. The selective and sensitive analytical methods, based on quick, easy, cheap, effective, rugged, and safe (QuEChERS) sample preparation followed by liquid chromatography-tandem mass spectrometry (LC-MS/MS) or gas chromatography-time-of-flight mass spectrometry (GC-ToF-MS), allow the quantification at limits comprised between 0.5 and 23 ng/g, depending on the compound. The paper summarizes the analytical results from 154 sampling points. Of the 20 target compounds, 9 were determined at least once, and the sediments contained a maximum of 7 substances. The most frequently detected were PAHs (frequency, 77 %; max., 1,400 ng/g). The pharmaceutical compounds, hormones and pesticides were rarely detected in the samples; the most frequently detected was carbamazepine (frequency, 6 %; max., 31 ng/g). In some cases, the levels of PAHs and bisphenol A exceed the predicted no-effect concentration (PNEC) values.     

A study on identification of bacteria in environmental samples using single-cell Raman spectroscopy: feasibility and reference libraries

We report on our recent efforts towards identifying bacteria in environmental samples by means of Raman spectroscopy. We established a database of Raman spectra from bacteria submitted to various environmental conditions. This dataset was used to verify that Raman typing is possible from measurements performed in non-ideal conditions. Starting from the same dataset, we then varied the phenotype and matrix diversity content included in the reference library used to train the statistical model. The results show that it is possible to obtain models with an extended coverage of spectral variabilities, compared to environment-specific models trained on spectra from a restricted set of conditions. Broad coverage models are desirable for environmental samples since the exact conditions of the bacteria cannot be controlled.     

Impact of vegetated filter strips on sorbed herbicide concentrations and sorption equilibrium in agricultural plots

The objective was to investigate the impact of vegetated filter strips on exported atrazine and deethylatrazine concentrations [dissolved and sorbed to eroded sediments (>1.5?μm)], the deethylatrazine to atrazine ratio in water and sediments, the ratio of sorbed to dissolved herbicides in runoff and subsurface infiltration as well as field equilibrium state under natural climate during two seasons. We hypothesize that sorption equilibrium was not achieved in 2004 because of the short delay (<24?h) between herbicide application and the first rain event. In 2005, observations suggest that possible changing sorption equilibrium conditions were reached (20?days after atrazine application), especially for eroded sediments submitted to changing environmental conditions in subsurface. If confirmed by other experiments, this will raise the question of the representativeness of laboratory-determined soil sorption coefficients to predict the fate of pesticides.     

BRC4Env,a network of Biological Resource Centres for research in environmental and agricultural sciences

The Biological Resource Centre for the Environment BRC4Env is a network of Biological Resource Centres (BRCs) and collections whose leading objectives are to improve the visibility of genetic and biological resources maintained by its BRCs and collections and to facilitate their use by a large research community, from agriculture research to life sciences and environmental sciences. Its added value relies on sharing skills, harmonizing practices, triggering projects in comparative biology, and ultimately proposing a single-entry portal to facilitate access to documented samples, taking into account the partnership policies of research institutions as well as the legal frame which varies with the biological nature of resources. BRC4Env currently includes three BRCs: the Centre for Soil Genetic Resources of the platform GenoSol, in partnership with the European Conservatory of Soil Samples; the Egg Parasitoids Collection (EP-Coll); and the collection of ichthyological samples, Colisa. BRC4Env is also associated to several biological collections: microbial consortia (entomopathogenic bacteria, freshwater microalgae…), terrestrial arthropods, nematodes (plant parasitic, entomopathogenic, animal parasitic...), and small mammals. The BRCs and collections of BRC4Env are involved in partnership with academic scientists, as well as private companies, in the fields of medicinal mining, biocontrol, sustainable agriculture, and additional sectors. Moreover, the staff of the BRCs is involved in many training courses for students from French licence degree to Ph.D, engineers, as well as ongoing training.     

Influence of hydropower dams on the composition of the suspended and riverbank sediments in the Danube

Large hydropower dams have major impacts on flow regime, sediment transport and the characteristics of water and sediment in downstream rivers. The Gabcikovo and Iron Gate dams divide the studied Danube transect (rkm 1895-795) into three parts. In the Gabcikovo Reservoir (length of 40km) only a part of the incoming suspended sediments were deposited. Contrary to this, in the much larger Iron Gate backwater zone and reservoir (length of 310km) all riverine suspended sediments were deposited within the reservoir. Subsequently, suspended sediments were transported by tributaries into the Iron Gate backwater zone. Here they were modified by fractional sedimentation before they transgressed downstream via the dams. Compared with undammed Danube sections, Iron Gate reservoir sediment and suspended matter showed higher clay contents and different K/Ga and Metal/Ga ratios. These findings emphasize the importance of reservoir-river sediment-fractionation.