Emission characteristics of air pollutants from incense and candle burning in indoor atmospheres

Volatile organic compounds (VOCs) and particles emitted by incense sticks and candles combustion in an experimental room have been monitored on-line and continuously with a high time resolution using a state-of-the-art high sensitivity-proton transfer reaction-mass spectrometer (HS-PTR-MS) and a condensation particle counter (CPC), respectively. The VOC concentration–time profiles, i.e., an increase up to a maximum concentration immediately after the burning period followed by a decrease which returns to the initial concentration levels, were strongly influenced by the ventilation and surface interactions. The obtained kinetic data set allows establishing a qualitative correlation between the elimination rate constants of VOCs and their physicochemical properties such as vapor pressure and molecular weight. The emission of particles increased dramatically during the combustion, up to 9.1(±0.2)?×?10⁴ and 22.0(±0.2)?×?10⁴ part cm^?3 for incenses and candles, respectively. The performed kinetic measurements highlight the temporal evolution of the exposure level and reveal the importance of ventilation and deposition to remove the particles in a few hours in indoor environments.     

Emerging technologies for removing nonpoint phosphorus from surface water and groundwater: introduction

Coastal and freshwater eutrophication continues to accelerate at sites around the world despite intense efforts to control agricultural P loss using traditional conservation and nutrient management strategies. To achieve required reductions in nonpoint P over the next decade, new tools will be needed to address P transfers from soils and applied P sources. Innovative remediation practices are being developed to remove nonpoint P sources from surface water and groundwater using P sorbing materials (PSMs) derived from natural, synthetic, and industrial sources. A wide array of technologies has been conceived, ranging from amendments that immobilize P in soils and manures to filters that remove P from agricultural drainage waters. This collection of papers summarizes theoretical modeling, laboratory, field, and economic assessments of P removal technologies. Modeling and laboratory studies demonstrate the importance of evaluating P removal technologies under controlled conditions before field deployment, and field studies highlight several challenges to P removal that may be unanticipated in the laboratory, including limited P retention by filters during storms, as well as clogging of filters due to sedimentation. Despite the potential of P removal technologies to improve water quality, gaps in our knowledge remain, and additional studies are needed to characterize the long-term performance of these technologies, as well as to more fully understand their costs and benefits in the context of whole-farm- and watershed-scale P management.     

Living with nuclear power: Sense of place,proximity, and risk perceptions in local host communities

Previous research notes that sense of place may intensify, and that levels of public risk perception may decrease with proximity to an established hazardous or stigmatised site. In addition, the literature suggests that sense of place may act either to mediate or moderate community perceptions of risk in such localities. This study comprised a major household survey (n = 1326) and an interview study (n = 39) and was conducted close to the nuclear power stations at Oldbury and Hinkley Point, both in the UK. It investigated the roles of perceptions of place and hazard proximity in considering (a) perceptions of risk and (b) public attitudes towards the building of a new nuclear power station in the nearby area. In addition, a novel scale was developed to measure the perceived contribution of the nearby nuclear power station to sense of place. The results suggest first, that sense of place mediates (but does not moderate) perceptions of risk in very proximate communities, and second, that public attitudes to new build in communities situated very close to established nuclear sites may be largely dependent on the extent to which the existing facility is perceived to contribute towards sense of place. The implications of these results for existing theory are discussed.     

A Framework for Responding to Coral Disease Outbreaks that Facilitates Adaptive Management

Predicted increases in coral disease outbreaks associated with climate change have implications for coral reef ecosystems and the people and industries that depend on them. It is critical that coral reef managers understand these implications and have the ability to assess and reduce risk, detect and contain outbreaks, and monitor and minimise impacts. Here, we present a coral disease response framework that has four core components: (1) an early warning system, (2) a tiered impact assessment program, (3) scaled management actions and (4) a communication plan. The early warning system combines predictive tools that monitor the risk of outbreaks of temperature-dependent coral diseases with in situ observations provided by a network of observers who regularly report on coral health and reef state. Verified reports of an increase in disease prevalence trigger a tiered response of more detailed impact assessment, targeted research and/or management actions. The response is scaled to the risk posed by the outbreak, which is a function of the severity and spatial extent of the impacts. We review potential management actions to mitigate coral disease impacts and facilitate recovery, considering emerging strategies unique to coral disease and more established strategies to support reef resilience. We also describe approaches to communicating about coral disease outbreaks that will address common misperceptions and raise awareness of the coral disease threat. By adopting this framework, managers and researchers can establish a community of practice and can develop response plans for the management of coral disease outbreaks based on local needs. The collaborations between managers and researchers we suggest will enable adaptive management of disease impacts following evaluating the cost-effectiveness of emerging response actions and incrementally improving our understanding of outbreak causation.     

Determination of anti-anxiety and anti-epileptic drugs in hospital effluent and a preliminary risk assessment

In this study, an analytical methodology was developed for the determination of psycho-active drugs in the treated effluent of the University Hospital at the Federal University of Santa Maria, RS – Brazil. Samples were collected from point A (Emergency) and point B (General effluent). The adopted methodology included a pre-concentration procedure involving the use of solid phase extraction and determination by liquid chromatography coupled to mass spectrometry. The limit of detection for bromazepam and lorazepam was 4.9 ± 1.0 ng L⁻¹ and, for carbamazepine, clonazepam and diazepam was 6.1 ± 1.5 ng L⁻¹. The limit of quantification was 30.0 ± 1.1 ng L⁻¹, for bromazepam, clonazepam and lorazepam; for carbamazepine was 50.0 ± 1.8 ng L⁻¹ and was 40.0 ± 1.0 ng L⁻¹ for diazepam. The mean concentrations in the Emergency and General effluent treated currents were as follows: for bromazepam, 195 ± 6 ng L⁻¹ and 137 ± 7 ng L⁻¹; for carbamazepine, 590 ± 6 ng L⁻¹ and 461 ± 10 ng L⁻¹; for diazepam, 645 ± 1 ng L⁻¹ and 571 ± 10 ng L⁻¹; for lorazepam, 96 ± 7 ng L⁻¹ and 42 ± 4 ng L⁻¹; and for clonazepam, 134 ± 10 ng L⁻¹ and 57 ± 10 ng L⁻¹. A preliminary risk assessment was conducted: carbamazepine and diazepam require considerable attention owing to their environmental toxicity. The occurrence of these psychoactive-drugs and the environmental risks that they pose demonstrated the need for a more efficient treatment system. As far we are aware, there have been no comparable studies to this on the hazards of hospital effluents in Brazil, and very few that have carried out a risk assessment of psycho-active drugs in hospital effluent in general.     

A Multipurpose Flare Stack for Control of Chemical Process Wastes

Abstract

To test the effectiveness of California’s vehicle inspection/ maintenance (I/M) program, exclusive of vehicle-owner intervention, a fleet of more than 1,100 vehicles that previously had failed California’s Smog Check test were sent to randomly selected Smog Check stations in the Los Angeles area for covert inspections and repairs. The two-speed idle test was used for repairs. For those vehicles that were repaired at the first inspection, their FTP emission reductions were 25%, 14%, and 11% for hydrocarbons (HC), carbon monoxide (CO), and nitrogen oxides (NO_x), respectively, although emissions testing for NO_x was not performed at the Smog Check stations. Idle HC and CO emissions increased for 35% and 43% of the vehicles, respectively, after repairs. This data set shows that most vehicles that fail the Smog Check inspection are only marginal emitters, with 61% and 44% of the total potential for HC and CO emission reductions, respectively, coming from only 10% of the vehicles that currently fail the inspection. When the vehicles were rank-ordered by idle emissions from dirtiest to cleanest, emission reduction costs for the highest-emitting 10% of the fleet averaged $l,100/ton and $250/ton for HC and CO, respectively, attributing all the costs to each pollutant exclusively. For the remaining vehicles, costs increased dramatically.     

Measurement of Automobile Exhaust GAS Hydrocarbons

While snowflakes fell and Christmas carols heralded the imminent holiday, over 3000 delegates to the Third National Conference on Air Pollution were told to “Control Now for Clean Air.”

They were told this in many ways by many people—by the Vice President of the United States; by the Secretary of the Department of Health, Education, and Welfare who summoned the Conference; and by senators, congressmen, governors, and mayors.

Then eight panel sessions convened to discuss and to determine how to control now for clean air. Speakers from every section of American life addressed themselves to this subject; when they were finished, the eight session chairmen summarized what had been said, what had been, learned. These summaries appear on the following pages.     

Acrylamide monomer leaching from polyacrylamide-treated irrigation furrows

Water-soluble anionic polyacrylamide (WSPAM), which is used to reduce erosion in furrow irrigated fields and other agriculture applications, contains less than 0.05% acrylamide monomer (AMD). Acrylamide monomer, a potent neurotoxicant and suspected carcinogen, is readily dissolved and transported in flowing water. The study quantified AMD leaching losses from a WSPAM-treated corn (Zea mays L.) field using continuous extraction-walled percolation samplers buried at 1.2 m depth. The samplers were placed 30 and 150 m from the inflow source along a 180-m-long corn field. The field was furrow irrigated using WSPAM at the rate of 10 mg L(-1) during furrow advance. Percolation water and furrow inflows were monitored for AMD during and after three furrow irrigations. The samples were analyzed for AMD using a gas chromatograph equipped with an electron-capture detector. Furrow inflows contained an average AMD concentration of 5.5 microg L(-1). The AMD in percolation water samples never exceeded the minimum detection limit and the de facto potable water standard of 0.5 microg L(-1). The risk that ground water beneath these WSPAM-treated furrow irrigated soils will be contaminated with AMD appears minimal.     

Physical and chemical changes during composting of wood chip-bedded and straw-bedded beef cattle feedlot manure

In the 1990s, restrictions on incineration encouraged the forest industry in western Canada to develop new uses for their wood residuals by product. One such use was as a replacement for cereal straw bedding in southern Alberta's beef cattle (Bos taurus) feedlot industry. However, use of carbon (C)-rich bedding, such as wood chips, had implications for subsequent composting of the feedlot manure, a practice that was being increasingly adopted. In a 3-yr study, we compared composting of wood chip-bedded manure (WBM) and barley (Hordeum vulgare L.) straw-bedded manure (SBM). There were no significant differences in temperature regimes of SBM and WBM, indicating similar rates of successful composting. Of 17 physical and chemical parameters, five showed significant (P < 0.10) differences due to bedding at the outset of composting (Day 0), and 11 showed significant differences at final sampling (Day 124). During composting (10 sampling times), seven parameters showed significant bedding effects, 16 showed significant time effects, and four showed a Bedding x Time interaction. Significantly lower (P < 0.10) losses of nitrogen (N) occurred with WBM (19%) compared with SBM (34%), which has positive implications for air quality and use as a soil amendment. Other advantages of WBM compost included significantly higher total C (333 vs. 210 kg Mg(-1) for SBM) and inorganic N (1.3 vs. 1.0 kg Mg(-1) for SBM) and significantly lower total phosphorus (4.5 vs. 5.3 kg Mg(-1) for SBM). Our results showed that wood chip bedding should not be a problem for subsequent composting of the manure after pen cleaning. In combination with other benefits, our findings should encourage the adoption of wood chips over straw as a bedding choice for southern Alberta feedlots.     

In situ transmissiometer measurements for real-time monitoring of dust discharge during orchard nut harvesting

Rapid assessments of operating conditions and field preparation on dust discharge from nut harvesters are needed to guide improved equipment design and grower practices for dust reduction. An industrial opacity sensor, typically used for industrial stack monitoring, was adapted for use on a nut harvester to measure relative dust intensity during nut pick-up operations in almond orchards. Due to the high volume of discharge air and the presence of large debris such as leaves, additional components were coupled with the sensor to enable subsampling of the air. Pre-harvest windrow preparation conditions were evaluated. Results indicated that relative dust intensity decreased by 32% during harvest activities after windrow preparation with proper nut sweeper adjustment. Conventional harvesting results indicated that under typical operating conditions, reducing the separation fan speed could reduce relative dust intensity by 54%. Ground speed also had a strong effect; reducing speed from 4.8 to 2.4 km h(-1) reduced opacity of discharged air by 50%. The measurement system was also mounted on a separate vehicle and used as a tool for comparing modifications in harvest machine designs where direct measurement of discharge may not be feasible due to mechanical constraints. A comparison between a conventional harvester and one modification in the harvester design found that the machine modification decreased relative dust intensity by 73%. The measurement tools described in this work can be used to provide rapid feedback on harvester operating conditions, orchard cultural practices, and machine design modifications.