Air Pollution and Heat Exposure Study in the Workplace in a Glass Manufacturing Unit in India

Air pollution in the workplace environment due to industrial operation have been found to cause serious occupational health hazard. Similarly, heat stress is still most neglected occupational hazard in the tropical and subtropical countries like India. The hot climate augments the heat exposure close to sources like furnaces. In this study an attempt is made to assess air pollution and heat exposure levels to workers in the workplace environment in glass manufacturing unit located in the State of Gujarat, India. Samples for workplace air quality were collected for SPM, SO₂, NO₂ and CO₂ at eight locations. Results of workplace air quality showed 8-hourly average concentrations of SPM: 165–9118 μg/m³, SO₂: 6–9 μg/m³ and NO₂: 5–42 μg/m³, which were below the threshold limit values of workplace environment. The level of CO₂ in workplace air of the plant was found to be in the range 827–2886 μg/m³, which was below TLV but much higher than the normal concentration for CO₂ in the air (585 mg/m³). Indoor heat exposure was studied near the furnace and at various locations in an industrial complex for glass manufacturing. The heat exposure parameters including the air temperature, the wet bulb temperature, and the globe parameters were measured. The Wet Bulb Globe Temperature (WBGT), an indicator of heat, exceeded ACGIH TLVs limits most of the time at all the locations in workplace areas. The recommended duration of work and rest have also been estimated.     

Environmental benchmarks vs. ecological benchmarks for assessment and monitoring in Canada: Is there a difference?

Environmental benchmarks are widely used in Canadian environmental assessment as a standard against which to monitor air or water quality in response to human activities in the environment. Recent work in Canada has developed the concept of ecological benchmarks as a complement to environmental benchmarks. However, implementation of ecological benchmarks may be challenging. This paper presents an analogy between ecological benchmarks and the more commonly used environmental benchmarks, as an attempt to increase understanding and use of ecological benchmarks in resource management, assessment, and monitoring. Ecological benchmarks, and their corresponding indicators, will be challenging to identify and use. However, through the use of the principles of adaptive management, effective ecological indicators and benchmarks can be established. Although it is essential that ecological benchmarks are site-specific, the analogy and general principles outlined here are applicable to assessment and monitoring in any part of the world.     

The study of age influence on human bone lead metabolism by using a simplified model and X-ray fluorescence data

Long term lead metabolism in the human body has never been fully understood due to the lack of human data in this area. The technological improvement of bone lead measurement systems has made bone lead data of substantial populations available. In this study, a set of X-ray fluorescence bone lead data was used to test Leggett's lead metabolism model (R. W. Leggett, Environ. Health Perspect., 1993a, 101, 598-616), especially the model of metabolism in bone. The data set includes the bone lead concentration of 539 occupationally exposed workers, of whom 327 were measured twice in five years. The bone lead concentrations of both cortical bone (tibia) and trabecular bone (calcaneus) were obtained by Cd-109 gamma-ray induced XRF measurement. The histories of blood lead concentration for these workers were used to regulate the input file of the model. The results show that the bone lead concentrations predicted by Leggett's model greatly underestimate the measured values, especially for older workers. This data set was then organized into five age groups. A new simplified model was applied to estimate the lead transfer rates between blood and lead compartments for these age groups. The original transfer rates and the new transfer rates are compared, and the differences are discussed. When the transfer rates derived from measured bone lead data were put into the input file of the model to replace the existing parameters, the predicted values were much closer to the measured values for both cortical bone and trabecular bone.     

Examples of the role of analytical chemistry in environmental risk management research

Analytical chemistry is an important tier of environmental protection and has been traditionally linked to compliance and/or exposure monitoring activities for environmental contaminants. The adoption of the risk management paradigm has led to special challenges for analytical chemistry applied to environmental risk analysis. Namely, methods developed for regulated contaminants may not be appropriate and/or applicable to risk management scenarios. This paper contains examples of analytical chemistry applied to risk management challenges broken down by the analytical approach and analyte for some selected work in our laboratory. Specific techniques discussed include stable association complex electrospray mass spectrometry (cESI-MS), gas chromatography-mass spectrometry (GC-MS), split-flow thin cell (SPLITT) fractionation and matrix-assisted laser desorption time of flight mass spectrometry (MALDI-ToF-MS). Specific analytes include haloacetic acids (HAA9), perchlorate, bromate, triazine degradation products, metal-contaminated colloids and Cryptosporidium parvum oocysts.     

Luminescence spectroscopy as a screening tool for the potential carcinogenicity of asphalt fumes

A subset of polycyclic aromatic compounds (PACs), which contain 4-6 annulated rings, has been documented as the source of carcinogenicity in animal skin painting studies of petroleum products and asphalt fumes (M. L. Machado, P. W. Beatty, J. C. Fetzer, A. H. Glickman and E. L. McGinnis, Fundam. Appl. Toxicol., 1993, 21, 492; T. A. Roy, S. W. Johnson, G. R. Blackburn and C. R. Mackerer, Fundam. Appl. Toxicol., 1988, 10, 466). Because of the chemical complexity of these materials, it has been difficult to identify the specific compounds within this broad range of PACs responsible for their carcinogenicity. An alternative approach using luminescence spectroscopy was taken in this study to quantify, without identification, a subset of these compounds that appears to cause cancer. The fluorescence response at a specific wavelength pair was obtained for 39 laboratory asphalt fume condensates from animal skin painting studies, yielding a linear correlation coefficient of R2 = 0.96 between the fluorescence response in these materials and the carcinogenicity found in animal studies. In the absence of other asphalt fume condensates from animal studies, 17 petroleum oils were also evaluated using this method and compared with the available animal skin painting data. The details of the method include a clean-up step that removes the highly polar compounds and spectral subtraction of two- and three-ring PAC interference, both of which add to the fluorescence response, yet were not found to contribute to a carcinogenic response from skin painting studies. Full scan fluorescence plots also produce a fingerprint which can be used to assess contamination, such as coal tar products or mixtures of materials, that are not defined as asphalt, yet may be present in the working environment.     

Assessing the Effects of Atmospheric Ethylene on Epinasty and Tuber Yield of Potato (Solanum Tuberosum L.) Near Polyethylene Manufacturing Plants

A multi-year programme was performed to assess the effects of atmospheric ethylene on potato (Solanum tuberosum L.) in the vicinity of polyethylene manufacturing plants. There was a strong temporal variation of the hourly ethylene concentrations measured close to the sources from 1982 through 1991. Growing seasonal means exceeded 12 g m^–3 ethylene, the threshold for phytotoxic effects under laboratory conditions. Young test plants of potato showed an epinastic response to enhanced levels of ethylene. This response was reversible and did not occur when atmospheric ethylene was not detected. Based on hourly observations for the growing seasons of 1984 through 1991, epinasty occurred on average during circa 5% of the growing season and varied from circa 1% in 1985 to circa 18% in 1991. At night, ethylene concentrations were higher and epinasty was more frequent than during daylight hours. The intermittent exposures to ethylene did not affect tuber yield for the growing seasons of 1982 through 1990. The occurrence of epinasty indicated that ethylene exposure levels in the vicinity of the industrial sources might be sufficiently high to affect sensitive plants.     

Lead in Soil and Sediment in Iqaluit, Nunavut, Canada, and Links with Human Health

This study determined the spatial distribution of soiland of sediment-associated lead in Iqaluit, Nunavut.Samples were collected from the following areas:outside the built-up area of the town to reflectbackground concentrations; known or potential pointsources of lead, such as the Upper Base, the SylviaGrinnell Dump and the Metal Dump (North 40); andresidential and commercial areas of Iqaluit and Apex,a satellite community. In the laboratory, the <63 m sample fraction was analyzed for total lead andbioavailable lead, estimated by non-residual acidextractable lead content. The research findings revealthat elevated levels of bioavailable lead are presentin the study area. Total lead concentrations generallydo not exceed environmental guidelines. However, leadconcentrations in the Sylvia Grinnell Dump, and Apexand Iqaluit grid areas exceed health-based guidelines.The research concludes that there is not a serioushealth hazard posed by lead levels in the soil andsediment in the study area. However, severalenvironmental (elevated lead levels, bioavailableforms of lead and bare soil surfaces) and behaviouralfactors (vigorous and unsupervised play outside) maycreate a risk of lead exposure.     

Macroinvertebrate Regionalisation for use in the Management of Aquatic Ecosystems in Victoria, Australia

The development of a broader, more holistic approach to aquaticecosystem management has been called for in recent years. Physical and chemical objectives alone are no longer consideredsufficient for the protection of aquatic ecosystems and shouldbe supplemented with biological objectives. The ubiquitousand sedentary nature of macroinvertebrates, combined with theirmeasurable response to environmental conditions, favour their use as important indicators in environmental policies. To establish biological objectives, there is a need for a regionalframework to limit the variability between ecosystems. Past studies have demonstrated that an a posteriori regionalisationapproach may be more useful than an a priori approach in explaining single component (e.g. macroinvertebrates) patternsacross ecosystems. This is particularly important as aquaticresource management agencies often focus on one or twocomponents of the ecosystem to assess environmental health. This study uses an a posteriori method to delineate and describebiological regions based on edge and riffle macroinvertebrate data. The regionalisation will provide a framework for settingbiological objectives, based on the range of reference conditionsmeasured within each separate region. The objectives will includeregional checklists for taxa and biotic indices. Predictive modelling in the style of RIVPACS or AUSRIVAS will also be usedwithin each region to develop objectives, incorporating local, regional and systematic features as predictor variables.