FIA-coupled spectrophotometric method for determination of Cr (VI) traces in natural waters: application of in-line dissolution of 1,5-diphenylcarbazide after heat treatment and activated alumina as adsorbent for preconcentration

This work proposes the quantification of Cr (VI) ions in natural waters in trace level, using activated alumina (Al₂O₃) as preconcentration support, controlled in-line dissolution of the solidified chromophore diphenylcarbazide after heat treatment and spectrophotometric detection. The manifold ensures high sensitivity of analytical response, good repeatability, and stability. In this work, optimization of experimental conditions of a flow injection system was chosen as the parameters for greater sensitivity and better selectivity. The selected optimized conditions were 0.30 mol L^?1 for H₂SO₄ concentration, system flow rate as 0.40 mL min^?1, sample injection volume of 192.50 μL, 2 min for preconcentration time, and 0.10 mol L^?1 for eluent concentration. The analytical curves obtained for real sample analysis show linear range from 0.192 to 0.961 μM, linear correlation coefficient R?=?0.9997 and LOD?=?0.024 μM. The preconcentration factor of about four times was obtained through the passage of 800 μL of a standard solution containing 0.961 μM of Cr (VI) through mini-column of preconcentration followed by elution at 192.5 μL of NH₄OH 0.1 mol L^?1 solution. The solid chromogenic reagent presented high durability (weeks in daily use with mass of 0.0993 g) and good reproducibility in analytical signal. The reactivation of the mini-column of alumina should be executed after ten injections of eluent, using 800 μL of HCl 0.02 mol L^?1 solution in flow through the same. Each cycle of injection and elution of the sample takes about 5 min on the proposed terms. Despite the length of each cycle still be high, low concentrations can be detected using a technique of relatively low cost. This is due in part, the association dissolution of the chromogenic reagent directly in the line and the preconcentration step. Another important factor is the economy of reagent chromogenic, low generation of reject contributing to better quality of the environment, and the high potential for applications to work in field.     

Urban tracer dispersion experiments during the second DAPPLE field campaign in London 2004

As part of the DAPPLE programme two large scale urban tracer experiments using multiple simultaneous releases of cyclic perfluoroalkanes from fixed location point sources was performed. The receptor concentrations along with relevant meteorological parameters measured are compared with a three screening dispersion models in order to best predict the decay of pollution sources with respect to distance. It is shown here that the simple dispersion models tested here can provide a reasonable upper bound estimate of the maximum concentrations measured with an empirical model derived from field observations and wind tunnel studies providing the best estimate. An indoor receptor was also used to assess indoor concentrations and their pertinence to commonly used evacuation procedures.     

Characterisation of PM10 emissions from woodstove combustion of common woods grown in Portugal

A series of source tests was performed to evaluate the chemical composition of particle emissions from the woodstove combustion of four prevalent Portuguese species of woods: Pinus pinaster (maritime pine), Eucalyptus globulus (eucalyptus), Quercus suber (cork oak) and Acacia longifolia (golden wattle). Analyses included water-soluble ions, metals, radionuclides, organic and elemental carbon (OC and EC), humic-like substances (HULIS), cellulose and approximately l80 organic compounds. Particle (PM₁₀) emission factors from eucalyptus and oak were higher than those from pine and acacia. The carbonaceous matter represented 44–63% of the particulate mass emitted during the combustion process, regardless of species burned. The major organic components of smoke particles, for all the wood species studied, with the exception of the golden wattle (0.07–1.9% w/w), were anhydrosugars (0.2–17% w/w). Conflicting with what was expected, only small amounts of cellulose were found in wood smoke. As for HULIS, average particle mass concentrations ranged from 1.5% to 3.0%. The golden wattle wood smoke presented much higher concentrations of ions and metal species than the emissions from the other wood types. The results of the analysis of radionuclides revealed that the ²²⁶Ra was the naturally occurring radionuclide more enriched in PM₁₀. The chromatographically resolved organics included n-alkanes, n-alkenes, PAH, oxygenated PAH, n-alkanals, ketones, n-alkanols, terpenoids, triterpenoids, phenolic compounds, phytosterols, alcohols, n-alkanoic acids, n-di-acids, unsaturated acids and alkyl ester acids.     

Variable emissions of microbial volatile organic compounds (MVOCs) from root-associated fungi isolated from Scots pine

Soils emit a large variety of volatile organic compounds. In natural ecosystems, measurements of microbial volatile organic compound (MVOC) exchange rates between soil and atmosphere are difficult due to e.g. the spatial heterogeneity of the belowground organisms, and due to the many potential sources for the same compounds. We measured in laboratory conditions the MVOC emission rates and spectra of eight typical fungi occurring in boreal forest soils. The studied species are decomposers (Gymnopilus penetrans, Ophiostoma abietinum), ectomycorrhizal (Cenococcum geophilum, Piloderma olivaceum, Suillus variegatus, Tomentellopsis submollis) and endophytic fungi (Meliniomyces variabilis, Phialocephala fortinii). The MVOC emissions contained altogether 21 known and 6 unidentified compounds whose emission rates were >0.1 μg g(DW)^?1 h^?1. The most abundant compounds were the short-chain carbonyl compounds (acetone and acetaldehyde). The greatest carbonyl emissions were measured from P. olivaceum (1.9 mg acetone g(DW)^?1 h^?1) and P. fortinii (0.114 mg acetaldehyde g(DW)^?1 h^?1). Terpenoid emissions (isoprene, mono- and sesquiterpenes) were detected from some fungal cultures, but in relatively small amounts. We conclude that soil micro-organisms can potentially be responsible for significant emissions of volatiles, especially short-chain oxygenated compounds, to the below-canopy atmosphere.     

Climate Policy to Defeat the Green Paradox

Carbon dioxide emissions have accelerated since the signing of the Kyoto Protocol. This discouraging development may partly be blamed on accelerating world growth and on lags in policy instruments. However, it also raises serious question concerning whether policies to reduce CO₂ emissions are as effective as generally assumed. In recent years, a considerable number of studies have identified various feedback mechanisms of climate policies that often erode, and occasionally reinforce, their effectiveness. These studies generally focus on a few feedback mechanisms at a time, without capturing the entire effect. Partial accounting of policy feedbacks is common in many climate scenarios. The IPCC, for example, only accounts for direct leakage and rebound effects. This article attempts to map the aggregate effects of different types of climate policy feedback mechanisms in a cohesive framework. Controlling feedback effects is essential if the policy measures are to make any difference on a global level. A general conclusion is that aggregate policy feedback mechanisms tend to make current climate policies much less effective than is generally assumed. In fact, various policy measures involve a definite risk of ‘backfiring’ and actually increasing CO₂ emissions. This risk is particularly pronounced once effects of climate policies on the pace of innovation in climate technology are considered. To stand any chance of controlling carbon emissions, it is imperative that feedback mechanisms are integrated into emission scenarios, targets for emission reduction and implementation of climate policy. In many cases, this will reduce the scope for subsidies to renewable energy sources, but increase the scope for other measures such as schemes to return carbon dioxide to the ground and to mitigate emissions of greenhouse gases from wetlands and oceans. A framework that incorporates policy feedback effects necessitates rethinking the design of the national and regional emission targets. This leads us to a new way of formulating emission targets that include feedback effects, the global impact target. Once the full climate policy feedback mechanisms are accounted for, there are probably only three main routes in climate policy that stand a chance of mitigating global warming: (a) returning carbon to the ground, (b) technological leaps in zero-emission energy technology that make it profitable to leave much carbon in the ground even in Annex II countries and (c) international agreements that make it more profitable to leave carbon in the ground or in forests.     

Will photosynthetic capacity of aspen trees acclimate after long-term exposure to elevated CO2 and O3?

Photosynthetic acclimation under elevated carbon dioxide (CO₂) and/or ozone (O₃) has been the topic of discussion in many papers recently. We examined whether or not aspen plants grown under elevated CO₂ and/or O₃ will acclimate after 11 years of exposure at the Aspen Face site in Rhinelander, WI, USA. We studied diurnal patterns of instantaneous photosynthetic measurements as well as A/C_i measurements monthly during the 2004-2008 growing seasons. Our results suggest that the responses of two aspen clones differing in O₃ sensitivity showed no evidence of photosynthetic and stomatal acclimation under either elevated CO₂, O₃ or CO₂ + O₃. Both clones 42E and 271 did not show photosynthetic nor stomatal acclimation under elevated CO₂ and O₃ after a decade of exposure. We found that the degree of increase or decrease in the photosynthesis and stomatal conductance varied significantly from day to day and from one season to another.     

Identification of microcystins from three collection strains of Microcystis aeruginosa

Microcystins (MCs) are toxic cyclic heptapeptides produced by various cyanobacteria genera, especially Microcystis. We identified 10 out of 12 MCs produced by three Microcystis aeruginosa strains from cyanobacteria collections, UTEX 2666, UTEX 2670 and UAM 1303, by using two analytical methods: Matrix-assisted Laser Desorption Ionization Time of Flight Mass Spectrometry (MALDI-TOF/MS) and HPLC Photodiode Array Detector coupled to a hybrid Quadrupole Time of Flight Mass Spectrometry (HPLC-PDA-QTOF/MS). MALDI-TOF/MS failed to detect non-polar MCs, such as MC-LY and MC-LW. HPLC-QTOF/MS permitted the accurate identification of most MCs present in methanolic extracts. Besides, three new MCs, namely: [D-Glu(OCH₃)⁶, D-Asp³] MC-LAba, MC-YL and MC-YM were detected by HPLC-QTOF/MS.     

Biomonitoring perfluorinated compounds in Catalonia,Spain: concentrations and trends in human liver and milk samples

Background, aim and scope  

Perfluorinated compounds (PFCs) are global environmental pollutants that bioaccumulate in wildlife and humans. Laboratory experiments have revealed toxic effects such as delayed development, humoral suppression, and hepatotoxicity. Although numerous human blood levels have been reported, little is known about distribution in the human body. Knowledge about PFC distribution and accumulation in the human body is crucial to understanding uptake and subsequent effects as well as to conduct risk assessments. The present study reports PFC levels in human liver and breast milk from a general population living in Catalonia, Spain. Liver and milk levels are compared to previously reported levels in blood from the same geographic area as well as to other existing reports on human liver and milk levels in other countries.     

Pollution in coastal fog at Alto Patache,Northern Chile

Background  

The Atacama Desert in Northern Chile is one of the most arid places on earth. However, fog occurs regularly at the coastal mountain range and can be collected at different sites in Chile to supply settlements at the coast with freshwater. This is also planned in the fog oasis Alto Patache (20°49′S, 70°09′W). For this pilot study, we collected fog water samples in July and August 2008 for chemical analysis to find indications for its suitability for domestic use.     

Block Copolymers Containing (R)-3-Hydroxybutyrate and Isosorbide Succinate or (S)-Lactic Acid Mers

A new aliphatic block copolyester was synthesized in bulk from transesterification techniques between poly((R)-3-hydroxybutyrate) (PHB) and poly(isosorbide succinate) (PIS). Additionally, other two block copolyesters were synthesized in bulk either from transesterification reactions involving PHB and poly(l-lactide) (PLLA) or from ring-opening copolymerization of l-lactide and hydroxyl-terminated PHB, as result of a previous transesterification reactions with isosorbide. Two-component blends of PHB and PIS or PLLA were also prepared as comparative systems. SEC, MALDI-TOF mass spectrometry (MALDI-TOFMS), ¹H and ¹³C NMR spectroscopy, WAXD, solubility tests, and TG thermal analysis were used for characterization. The block copolymer structures of the products were evidenced by MALDI-TOFMS, ¹³C NMR, and WAXD data. The block copolymers and the corresponding binary blends presented different solubility properties, as revealed by solubility tests. Although the incorporation of PIS sequences into PHB main backbone did not enhance the thermal stability of the product, it reduced its crystallinity, which could be advantageous for faster biodegradation rate. These products, composed of PHB and PIS or PLLA sequences, are an interesting alternative in biomedical applications.