Plant availability of bound anilazine residues in a degraded loess soil

Abstract

The relative biological availability of [benzene ring‐U‐¹⁴C] and Ctriazine‐U‐¹⁴C] anilazine for maize plants was studied in a degraded loess soil in a standardized microecosystem. The total uptake of radiocarbon in the course of the 4‐week experiment was 3.1 and 4 % respectively of the radioactivity applied if anilazine was uniformly mixed into the soil immediately before beginning the experiment. However, if anilazine was subjected to a degradation at 65 % of the maximum water holding capacity of the soil and temperatures varying daily between 16 and 27°C for 100 days before the plant experiment then the uptake was reduced to 0.4 or 0.7 % respectively. The uptake from soil with non‐extractable (bound) anilazine residues was similarly low. The mineralization rate of aged and bound anilazine residues was below 0.1 % of the radioactivity applied. Up to 2/3 of the radioactivity present in the soil after the plant experiment remained in the humic fraction.     

Diflubenzuron residue and persistence on an oak forest after aerial application

Abstract

A twenty hectare forest block in central Pennsylvania was aerially sprayed with diflubenzuron (Dimilin 25W®) at the dose of 33.23g A.I./ha in 9.4 litres/ha. Leaf samples were collected from the upper and lower canopies of 27 oaks and understory within this block on the day of spray, May 29, 1991. Canopy leaves were also collected on May 31, June 10, July 29 and September 26, 1991.

Recovery of diflubenzuron residues on fortified canopy‐leaf and litter‐leaf samples using analytical techniques employed in this study averaged 87.4% (SE = 7.5%) and 66.2% (SE = 8.2%), respectively.

On the day of spray, diflubenzuron residues on the upper canopy, lower canopy and understory averaged 81.18, 39.65 and 8.35 ng/cm², respectively. Diflubenzuron residues on canopy‐leaf samples collected 2, 12, 61 and 120 days post‐spray averaged 14.83 (SE = 10.19), 16.75 (SE = 9.95), 12.84 (SE = 8.25) and 11.20 (SE = 7.52) ng/cm², respectively. Diflubenzuron residues on litter‐leaf samples collected after leaf senescence ‐ 169 and 323 days post spray contained measurable amounts of diflubenzuron in 51 and 59% of the samples, respectively. Of the samples with measurable amounts of diflubenzuron, residues averaged 1.36 (SE = 2.44) and 0.65 ng/cm² (SE = 0.73) respectively.     

Minimizing drift and exposure from knapsack sprayers

Abstract

An improved drift shield for attaching to the lance of conventional knapsack sprayer to reduce wind induced drift and operator exposure was designed and tested. The drift shield consists of a conical wire frame covered with polythene and has an annular opening at the point of attachment to the lance which allows air to be drawn into the shield while spraying. Tests conducted with winds in the range of 1.25–5.75 m/s show that wind can increase the width of spray swath from an unshielded lance, up to 4.3 times the normal swath in no‐wind condition. Use of a conventional shield contained the swath width within 3.5 times and the improved shield restricted the swath width to 3.1 times the normal swath. Spray deposit from an unshielded lance, within the normal swath decreased to as low as 45%, due to wind effects. However, use of the conventional, and the improved shields enhanced the spray deposit to 54.2% and 68%, respectively. The improved drift shield improved the spray pattern displacement (SPD) significantly (P<0.05) compared with the conventional shield and the unshielded lance when the wind speed exceeded 1.25 m/s. The improved shield decreased the off target drift by as much as 63% compared with the unshielded spray. It also decreased the quantity of pesticide deposit on the operator's body by 41–84% and thereby reduced exposure and improved safety.     

Toxicity of hydroquinone to different freshwater phototrophs is influenced by time of exposure and pH

The interaction of natural organic matter with phytoplankton communities in freshwater ecosystems is an intensively studied subject matter. Previous studies showed that apparently plant-derived phenols were able to inhibit algal and cyanobacterial growth. Furthermore, it was also assumed that humic substances (HS), which comprise the major part of dissolved organic carbon in freshwater ecosystems, directly interact with freshwater phototrophs. For example, quinoid building blocks of HS were thought to be algicidal. To identify key environmental variable for the toxic action of potential quinone algicides, we tested the toxicity of hydroquinone (HQ) to different eukaryotic and prokaryotic freshwater phototrophs in terms of growth performance and investigated also the effect of HQ oxidation at different pH values on its algicidal potential. It was shown that cyanobacterial species were much more susceptible to hydroquinone than coccal green algal species were, with Microcystis aeruginosa being the most sensitive species by far. In addition, it was obvious that the aging of hydroquinone-stock solution at pH 11 led to polymerization and, by this process, to a total loss of toxicity; whereas the algicidal potential sustained if the polyphenol was kept at pH 7. Since most lakes with heavy blooms of phototrophs possess pH values clearly above 7.0, it is questionable, if polyphenols in general and quinones in particular are the effective chemicals and if litter and straw leachates are applied as means to combat algal and cyanobacterial blooms.     

Numerical modeling on air quality in an urban environment with changes of the aspect ratio and wind direction

Due to heavy traffic emissions within an urban environment, air quality during the last decade becomes worse year by year and hazard to public health. In the present work, numerical modeling of flow and dispersion of gaseous emissions from vehicle exhaust in a street canyon were investigated under changes of the aspect ratio and wind direction. The three-dimensional flow and dispersion of gaseous pollutants were modeled using a computational fluid dynamics (CFD) model which was numerically solved using Reynolds-averaged Navier–Stokes (RANS) equations. The diffusion flow field in the atmospheric boundary layer within the street canyon was studied for different aspect ratios (W/H?=?1/2, 3/4, and 1) and wind directions (θ?=?90°, 112.5°, 135°, and 157.5°). The numerical models were validated against wind tunnel results to optimize the turbulence model. The numerical results agreed well with the wind tunnel results. The simulation demonstrated that the minimum concentration at the human respiration height within the street canyon was on the windward side for aspect ratios W/H?=?1/2 and 1 and wind directions θ?=?112.5°, 135°, and 157.5°. The pollutant concentration level decreases as the wind direction and aspect ratio increase. The wind velocity and turbulence intensity increase as the aspect ratio and wind direction increase.     

Emission characteristics of air pollutants from incense and candle burning in indoor atmospheres

Volatile organic compounds (VOCs) and particles emitted by incense sticks and candles combustion in an experimental room have been monitored on-line and continuously with a high time resolution using a state-of-the-art high sensitivity-proton transfer reaction-mass spectrometer (HS-PTR-MS) and a condensation particle counter (CPC), respectively. The VOC concentration–time profiles, i.e., an increase up to a maximum concentration immediately after the burning period followed by a decrease which returns to the initial concentration levels, were strongly influenced by the ventilation and surface interactions. The obtained kinetic data set allows establishing a qualitative correlation between the elimination rate constants of VOCs and their physicochemical properties such as vapor pressure and molecular weight. The emission of particles increased dramatically during the combustion, up to 9.1(±0.2)?×?10⁴ and 22.0(±0.2)?×?10⁴ part cm^?3 for incenses and candles, respectively. The performed kinetic measurements highlight the temporal evolution of the exposure level and reveal the importance of ventilation and deposition to remove the particles in a few hours in indoor environments.     

Approximation and spatial regionalization of rainfall erosivity based on sparse data in a mountainous catchment of the Yangtze River in Central China

In densely populated countries like China, clean water is one of the most challenging issues of prospective politics and environmental planning. Water pollution and eutrophication by excessive input of nitrogen and phosphorous from nonpoint sources is mostly linked to soil erosion from agricultural land. In order to prevent such water pollution by diffuse matter fluxes, knowledge about the extent of soil loss and the spatial distribution of hot spots of soil erosion is essential. In remote areas such as the mountainous regions of the upper and middle reaches of the Yangtze River, rainfall data are scarce. Since rainfall erosivity is one of the key factors in soil erosion modeling, e.g., expressed as R factor in the Revised Universal Soil Loss Equation model, a methodology is needed to spatially determine rainfall erosivity. Our study aims at the approximation and spatial regionalization of rainfall erosivity from sparse data in the large (3,200 km²) and strongly mountainous catchment of the Xiangxi River, a first order tributary to the Yangtze River close to the Three Gorges Dam. As data on rainfall were only obtainable in daily records for one climate station in the central part of the catchment and five stations in its surrounding area, we approximated rainfall erosivity as R factors using regression analysis combined with elevation bands derived from a digital elevation model. The mean annual R factor (R _a) amounts for approximately 5,222 MJ?mm?ha^?1?h^?1?a^?1. With increasing altitudes, R _a rises up to maximum 7,547 MJ?mm ha^?1?h^?1 a^?1 at an altitude of 3,078 m a.s.l. At the outlet of the Xiangxi catchment erosivity is at minimum with approximate R _a?=?1,986 MJ?mm?ha^?1?h^?1?a^?1. The comparison of our results with R factors from high-resolution measurements at comparable study sites close to the Xiangxi catchment shows good consistance and allows us to calculate grid-based R _a as input for a spatially high-resolution and area-specific assessment of soil erosion risk.     

An integrated approach to model the biomagnification of organic pollutants in aquatic food webs of the Yangtze Three Gorges Reservoir ecosystem using adapted pollution scenarios

The impounding of the Three Gorges Reservoir (TGR) at the Yangtze River caused large flooding of urban, industrial, and agricultural areas, and profound land use changes took place. Consequently, substantial amounts of organic and inorganic pollutants were released into the reservoir. Additionally, contaminants and nutrients are entering the reservoir by drift, drainage, and runoff from adjacent agricultural areas as well as from sewage of industry, aquacultures, and households. The main aim of the presented research project is a deeper understanding of the processes that determines the bioaccumulation and biomagnification of organic pollutants, i.e., mainly pesticides, in aquatic food webs under the newly developing conditions of the TGR. The project is part of the Yangtze-Hydro environmental program, financed by the German Ministry of Education and Science. In order to test combinations of environmental factors like nutrients and pollution, we use an integrated modeling approach to study the potential accumulation and biomagnification. We describe the integrative modeling approach and the consecutive adaption of the AQUATOX model, used as modeling framework for ecological risk assessment. As a starting point, pre-calibrated simulations were adapted to Yangtze-specific conditions (regionalization). Two exemplary food webs were developed by a thorough review of the pertinent literature. The first typical for the flowing conditions of the original Yangtze River and the Daning River near the city of Wushan, and the second for the stagnant reservoir characteristics of the aforementioned region that is marked by an intermediate between lake and large river communities of aquatic organisms. In close cooperation with German and Chinese partners of the Yangtze-Hydro Research Association, other site-specific parameters were estimated. The MINIBAT project contributed to the calibration of physicochemical and bathymetric parameters, and the TRANSMIC project delivered hydrodynamic models for water volume and flow velocity conditions. The research questions were firstly focused on the definition of scenarios that could depict representative situations regarding food webs, pollution, and flow conditions in the TGR. The food webs and the abiotic site conditions in the main study area near the city of Wushan that determine the environmental preconditions for the organisms were defined. In our conceptual approach, we used the pesticide propanil as a model substance.     

Solution by dilution?—A review on the pollution status of the Yangtze River

The Yangtze River has been a source of life and prosperity for the Chinese people for centuries and is a habitat for a remarkable variety of aquatic species. But the river suffers from huge amounts of urban sewage, agricultural effluents, and industrial wastewater as well as ship navigation wastes along its course. With respect to the vast amounts of water and sediments discharged by the Yangtze River, it is reasonable to ask whether the pollution problem may be solved by simple dilution. This article reviews the past two decades of published research on organic pollutants in the Yangtze River and several adjacent water bodies connected to the main stream, according to a holistic approach. Organic pollutant levels and potential effects of water and sediments on wildlife and humans, measured in vitro, in vivo, and in situ, were critically reviewed. The contamination with organic pollutants, including polycyclic aromatic hydrocarbons, polychlorinated biphenyls (PCBs), organochlorine pesticides (OCPs), polychlorinated dibenzo-p-dioxins/polychlorinated dibenzofurans, polybrominated diphenyl ethers (PBDEs), perfluorinated compounds (PFCs), and others, of water and sediment along the river was described. Especially Wuhan section and the Yangtze Estuary exhibited stronger pollution than other sections. Bioassays, displaying predominantly the endpoints mutagenicity and endocrine disruption, applied at sediments, drinking water, and surface water indicated a potential health risk in several areas. Aquatic organisms exhibited detectable concentrations of toxic compounds like PCBs, OCPs, PBDEs, and PFCs. Genotoxic effects could also be assessed in situ in fish. To summarize, it can be stated that dilution reduces the ecotoxicological risk in the Yangtze River, but does not eliminate it. Keeping in mind an approximately 14 times greater water discharge compared to the major European river Rhine, the absolute pollution mass transfer of the Yangtze River is of severe concern for the environmental quality of its estuary and the East China Sea. Based on the review, further research needs have been identified.     

Learning About the History of Landscape Use for the Future: Consequences for Ecological and Social Systems in Swedish Bergslagen

Barriers and bridges to implement policies about sustainable development and sustainability commonly depend on the past development of social–ecological systems. Production of metals required integration of use of ore, streams for energy, and wood for bioenergy and construction, as well as of multiple societal actors. Focusing on the Swedish Bergslagen region as a case study we (1) describe the phases of natural resource use triggered by metallurgy, (2) the location and spatial extent of 22 definitions of Bergslagen divided into four zones as a proxy of cumulative pressure on landscapes, and (3) analyze the consequences for natural capital and society. We found clear gradients in industrial activity, stream alteration, and amount of natural forest from the core to the periphery of Bergslagen. Additionally, the legacy of top-down governance is linked to today’s poorly diversified business sector and thus municipal vulnerability. Comparing the Bergslagen case study with other similar regions in Russia and Germany, we discuss the usefulness of multiple case studies.