Controlled Enrichment System for Experimental Fumigation of Plants in the Field with Sulfur Dioxide

A prototype Free-Air Controlled Enrichment (FACE) system was developed at Brookhaven National "Laboratory (BNL) for the experimental control of gas concentrations in an open field, without any form of enclosure. This FACE system consists of a toroidal plenum chamber, 15 m in diameter, with a series of 32 vertical vent pipes from which the release of a test gas can be controlled. Data on gas concentration at the center of the array and wind velocity are fed to a microprocessor where a proportional, integrative, differential (PID) algorithm is used to regulate a mass-flow controller. Data on wind direction are used to control the opening and closing of the vertical vent pipes to maintain an upwind release. In 72 hours of continuous operation during which wind velocity varied between 0.3 to 8 m sec^-1, the FACE prototype maintained 1 -min averaged concentrations within twenty percent of the 40 ppb set point 94 percent of the time.     

Ambient Air Benzene Concentrations in Canada (1989-1993): Seasonal and Day of Week Variations,Trends, and Source Influences

Abstract

Since 1987, the Pollution Measurement Division of the Environmental Protection Service, Environment Canada, has operated a field program for measuring benzene in ambient air. With the cooperation of provincial and municipal environmental agencies, samples have been collected at over 30 urban and rural monitoring sites across the country. Samples are collected in evacuated canisters and analyzed by gas chromatography with a mass-selective detector. Using data from all sites, the composite average benzene concentration for Canada over the years 1989 to 1993 was 3.6 μg/m³ and the composite median was found to be 2.6 μ/m³. Benzene concentrations are highest at urban sites near major streets and at sites influenced by industrial sources. For eighteen urban and suburban trend sites (those with no nearby industrial sources), composite annual median benzene concentrations decreased by 20% between 1989 and 1993. For the same period, median benzene concentrations decreased by 33% at four trend sites with nearby industries. At most monitoring sites the parameters for benzene and CO are highly correlated; supporting the inventory estimate that most emissions of benzene are due to vehicle exhaust. For sites with nearby industrial sources of benzene, the industries are estimated to account for 35 to 70% of the benzene dose experienced at the sites. These site specific contributions are much more significant than the estimated national emissions assigned to industrial sources.     

Flow Injection Analysis of MWC Fly Ash Leaching Characteristics

Abstract

A completely mixed batch reactor leaching method utilizing flow injection analysis (the CMBR-FIA method) was developed to study the lead leaching characteristics of municipal waste combustor fly ash. Flow injection analysis (FIA) coupled with atomic absorption spectrophotometry enabled the determination of lead concentrations at one minute intervals. The pH and oxidation-reduction potential of the solution were continuously monitored to characterize the leaching conditions. Automatic titration was used to alter the solution pH to defined endpoints. The CMBR-FIA method offers the ability to immediately observe alterations to the leaching solution, and grants the freedom to study a number of parameters concurrently. The CMBR-FIA method is a rapid and reliable means to investigate leaching characteristics. This paper describes the method and demonstrates its use to monitor the leaching of lead from municipal solid waste combustor fly ash as a function of pH. Soluble lead concentrations are shown to increase quickly with decreasing pH.

A maximum of 50% of the total lead concentration was available in solution at pH 2. This value gradually decreased with time to over 35% of the total.     

Measurement of Volatile Organics at Part per Billion Concentrations Using a Cold Trap Inlet and High Speed Gas Chromatography

Direct inlet gas chromatography (GC) is becoming one of the most frequently used techniques for measurement of volatile organics in air. Although GC is an effective tool, its usefulness as a field method can be limited by retention times of several minutes or more, and by the limits of detection. In order to address these issues, a high speed GC system featuring a capillary cold trap inlet and variable speed electrometeramplifier was developed and tested.

The gas cooled inlet was used to collect and focus organic vapors from injection volumes of up to 1 ml. Resistance heating of the metal cold trap produced a narrow injection band that allowed simple separations to be completed in 5 to 20 seconds. Use of a variable speed electrometer-amplifier allowed the response time and noise suppression characteristics to be adjusted to the needs of the specific analysis.

Simple mixtures of organics including aromatics, alkanes and chlorinated hydrocarbons were separated in 20 seconds or less. The limits of detection for 13 test compounds ranged from less than 1 part per billion by volume (ppbv) to about 50 ppbv. Data presented here indicate that high speed GC using a cold trap inlet may be a feasible approach for near real-time measurement of volatile organics in ambient air.     

Characterization of Municipal Solid Waste Incineration Residues From Facilities with Different Air Pollution Control Systems

Abstract

Municipal Solid Waste incinerator residues produced in two types of facilities were exhaustively characterized: granulometry, mineralogy, chemical composition, leaching behavior, and elemental distribution as a function of particle size. Air Pollution Control (APC) residues coming from a semi-dry scrubber have shown higher solubility than fly ashes originating in an Electrostatic Precipitator (ESP), as well as higher contents in volatile metals (Cd, Hg). Different metal speciation and distribution as a function of particle size have been found in fly ashes (ESP residues) and APC residues. In APC residues, heavy metals (with the exception of Hg) show a parabolic distribution with maxima in the smallest and largest particles, following the same profile as soluble salts. Metal distribution for APC residues exhibits that metals generally are not associated with silicate aluminate matrix. Results show the effect of adding lime to APC residues in metal speciation and distribution.     

Contribution of Nitrate and Carbonaceous Species to PM2.5 Observed in Canadian Cities

ABSTRACT

At a variety of Canadian monitoring sites, carbonaceous compounds were estimated to account for an average of 50% of fine particle mass. These estimates were determined by subtracting the total fine particle mass associated with inorganic compounds from the total fine mass determined gravimetrically. This approach, which yields an upper limit estimate of the total amount of carbon-related mass was necessary since particulate carbon was not measured in the Canadian National Air Pollution Surveillance (NAPS) network. In this paper, total carbon estimates are evaluated against organic and elemental carbon measurements at locations in the Greater Vancouver area and Toronto. In addition, particle nitrate measurements at seven Canadian locations are used to determine the importance of nitrate relative to total mass and to examine the sampling artifacts due to the loss of particle nitrate from Teflon filters used in the NAPS di-chotomous samplers.

Measurements of organic and elemental carbon indicated that the total carbon estimation approach provides representative estimates of the average contribution by carbonaceous material to the total fine and coarse mass. The average total carbon among all Vancouver area measurements (N = 225) was 4.28 μg m^-3, while the estimated value was 4.34 μg m^-3. There was a larger discrepancy between Toronto total carbon measurements (12.1 μg m^-3) and estimates (8.8 μg m^-3), which is attributed in part to sampling of particles above 10 mm in diameter. However, the R² relating the measurements and estimates was about 0.71 for both areas. Linear regression slopes of 0.98 for Vancouver and 0.78 for Toronto (nonsignificant intercepts) indicate little bias in the Vancouver estimates, but a tendency for underestimation as the observed total carbon concentration increased in Toronto.

Annually, nitrate was responsible for 17% and 12% of the fine mass in the Vancouver area and Ontario, respectively. In contrast, at two rural locations in southern Quebec and Nova Scotia, only 6% of fine mass was associated with nitrate. Due to filter losses, nitrate concentrations determined through the NAPS dichot sampling were much lower than actual concentrations (0.44 μg m^-3 vs. 2.63 μg m^-3). As a result of these losses (attributed mostly to loss during laboratory storage), previous total carbon estimates for the Canadian NAPS sites were likely to have been overestimated on average by about 10%.     

Biological Removal of Gaseous Ammonia in Biofilters: Space Travel and Earth-Based Applications

ABSTRACT

Gaseous NH₃ removal was studied in laboratory-scale biofilters (14-L reactor volume) containing perlite inoculated with a nitrifying enrichment culture. These biofilters received 6 L/min of airflow with inlet NH₃ concentrations of 20 or 50 ppm, and removed more than 99.99% of the NH₃ for the period of operation (101, 102 days). Comparison between an active reactor and an autoclaved control indicated that NH₃ removal resulted from nitrification directly, as well as from enhanced absorption resulting from acidity produced by nitrification. Spatial distribution studies (20 ppm only) after 8 days of operation showed that nearly 95% of the NH₃ could be accounted for in the lower 25% of the biofilter matrix, proximate to the port of entry. Periodic analysis of the biofilter material (20 and 50 ppm) showed accumulation of the nitrification product NO₃ ^- early in the operation, but later both NO₂ ^- and NO₃ ^- accumulated. Additionally, the N-mass balance accountability dropped from near 100% early in the experiments to ~95 and 75% for the 20- and 50-ppm biofilters, respectively. A partial contributing factor to this drop in mass balance accountability was the production of NO and N₂O, which were detected in the biofilter exhaust.     

Comparison of Computer Simulations of Total Lung Deposition to Human Subject Data in Healthy Test Subjects

ABSTRACT

A mathematical model was used to predict the deposition fractions (DF) of PM within human lungs. Simulations using this computer model were previously validated with human subject data and were used as a control case. Human intersubject variation was accounted for by scaling the base lung morphology dimensions based on measured functional residual capacity (FRC) values. Simulations were performed for both controlled breathing (tidal volumes [V_T] of 500 and 1000 mL, respiratory times [T] from 2 to 8 sec) and spontaneous breathing conditions. Particle sizes ranged from 1 to 5 um. The deposition predicted from the computer model compared favorably with the experimental data. For example, when V_T = 1000 mL and T = 2 sec, the error was 1.5%. The errors were slightly higher for smaller tidal volumes. Because the computer model is deterministic (i.e., derived from first principles of physics), the model can be used to predict deposition fractions for a range of situations (i.e., for different ventilatory parameters and particle sizes) for which data are not available. Now that the model has been validated, it may be applied to risk assessment efforts to estimate the inhalation hazards of airborne pollutants.     

Exposure of Chronic Obstructive Pulmonary Disease Patients to Particulate Matter: Relationships between Personal and Ambient Air Concentrations

ABSTRACT

Most time-series studies of particulate air pollution and acute health outcomes assess exposure of the study population using fixed-site outdoor measurements. To address the issue of exposure misclassification, we evaluate the relationship between ambient particle concentrations and personal exposures of a population expected to be at risk of particle health effects.

Sampling was conducted within the Vancouver metropolitan area during April-September 1998. Sixteen subjects (non-smoking, ages 54-86) with physician-diagnosed chronic obstructive pulmonary disease (COPD) wore personal PM_{2 5} monitors for seven 24-hr periods, randomly spaced approximately 1.5 weeks apart. Time-activity logs and dwelling characteristics data were also obtained for each subject. Daily 24-hr ambient PM₁₀ and PM_2.5 concentrations were measured at five fixed sites spaced throughout the study region. SO₄ ^2-, which is found almost exclusively in the fine particle fraction and which does not have major indoor sources, was measured in all PM_{2 5} samples as an indicator of accumulation mode particu-late matter of ambient origin.     

The 1999 Fresno Particulate Matter Exposure Studies: Comparison of Community,Outdoor, and Residential PM Mass Measurements

ABSTRACT

Two collaborative studies have been conducted by the U.S. Environmental Protection Agency (EPA) National Exposure Research Laboratory (NERL) and National Health and Environmental Effects Research Laboratory to determine personal exposures and physiological responses to par-ticulate matter (PM) of elderly persons living in a retirement facility in Fresno, CA. Measurements of PM and other criteria air pollutants were made inside selected individual residences within the retirement facility and at a central outdoor site on the premises. In addition, personal PM exposure monitoring was conducted for a subset of the participants, and ambient PM monitoring data were available for comparison from the NERL PM research monitoring platform in central Fresno. Both a winter (February 1-28, 1999) and a spring (April 19-May 16, 1999) study were completed so that seasonal effects could be