Vertical distribution of Cd, Pb and Zn in soils near smelters in the North of France

The analysis of the horizons of 12 soil profiles confirm occasionally significant levels of Cd, Pb and Zn contamination in the areas surrounding two lead and zinc smelters in the North of France. A pedological approach enabled the original Cd, Pb and Zn content of the horizons to be estimated, based on physico-chemical characteristics of soil unaffected by contamination. The main contamination was found in the upper 20-30 cm. Traces of Cd and Zn contamination were found at a depth of around 2 m. The mobility of the metals may be classified in the following order: Cd>Pb> or =Zn. The concentration profile of a metal seems insufficient to evaluate its movement as the metal could have been leached beyond the contaminated horizons. The depth reached by the metals increases with their concentration in the surface horizon; a decrease in pH and an increase in sand content seem to facilitate their movement. The depth reached by Zn increases with the organic carbon content in the surface horizon. Earthworm galleries act as paths via which metals migrate downwards     

In situ sequential treatment of a mixed contaminant plume

Groundwater plumes often contain a mixture of contaminants that cannot easily be remediated in situ using a single technology. The purpose of this research was to evaluate an in situ treatment sequence for the control of a mixed organic plume (chlorinated ethenes and petroleum hydrocarbons) within a Funnel-and-Gate. A shallow plume located in the unconfined aquifer at Alameda Point, CA, was found to contain up to 218,000 μg/l of cis-1,2 dichloroethene (cDCE), 16,000 μg/l of vinyl chloride (VC) and <1000 μg/l of 1,1 dichloroethene (1,1 DCE), trans-1,2 dichloroethene (trans-1,2 DCE) and trichloroethene (TCE). Total benzene, toluene, ethylbenzene and xylenes (BTEX) concentrations were <10,000 μg/l. Contaminated groundwater was funneled into a gate, 3.0 m wide, 4.5 m long and 6.0 m deep (keyed into the underlying aquitard) where treatment occurred. The initial gate segment consisted of granular iron, for the reductive dechlorination of the higher chlorinated ethenes. The second segment, the biosparge zone, promoted aerobic biodegradation of petroleum hydrocarbons and any remaining lesser-chlorinated compounds, stimulated by dissolved oxygen (DO) and carbon dioxide (CO₂) additions via an in situ sparge system (CO₂ was used to neutralize the high pH produced from reactions in the iron wall). Groundwater was drawn through the gate by pumping two wells located at the sealed, downgradient, end. Over a 4-month period an estimated 1350 g of cDCE flowed into the treatment gate and the iron wall removed 1230 g, or 91% of the mass. The influent mass of VC was 572 g and the iron wall removed 535 g, corresponding to 94% mass removal. The other chlorinated ethenes had significantly lower influent masses (3 to 108 g) and the iron wall removed the majority of the mass resulting in >96% mass removal for any of the compounds. In spite of these high removal percentages, laboratory column tests indicated that at these levels of chlorinated contaminants, surface saturation of the iron grains likely contributed to lower than expected reaction rates. In the biosparge zone, mass removal of cDCE appeared to occur predominantly by biodegradation (65%) with volatilization (35%) being an important secondary process. The dominant removal process for VC was volatilization (70%) although significant biodegradation was also indicated (30%). Laboratory microcosm results confirmed the potential for aerobic biodegradation of cDCE and VC. When average influent field concentrations for cDCE and VC were 220,000 and 46,000 μg/l, respectively, the sequential treatment unit removed 99.6% of the total mass and when the influent concentrations decreased to 26,000 and 19,000 μg/l for cDCE and VC, respectively, >99.9% removal within the treatment gate was attained. BTEX compounds were found to be significantly retarded in the iron treatment zone. Although they did eventually break through the granular iron, and into the gravel transition zone, none of these compounds was detected in the biosparge zone. No noticeable interferences between the anaerobic (reductive) and aerobic parts of the system occurred during testing. The results of this experiment show that in situ treatment sequences are viable, although further work is needed to optimize performance.     

Biospheric influence on carbon dioxide measurements in Italy

The study concerning carbon dioxide measurements taken during the 1997, 1998 and 1999 summer campaigns at two different altitude stations and biospheric conditions are presented. The higher station (Mt. Cimone, 2165 m a.s.l.) is characterised by 360° free horizon and is located on a rocky mountain while the lower (Ninfa lake, 1550 m a.s.l.) is located inside the red spruce and beech forest. The different behaviour of CO₂ at the two mountain stations has been registered. It shows the strong effect of nighttime soil emission and vegetation respiration on CO₂ mixing ratio increases and of diurnal vegetative activity on CO₂ concentration decreases at the lower measurement site. The baseline character of the higher measurement site has been confirmed by comparison of CO₂ diurnal amplitudes recorded at the two stations.     

Evidence for the contribution of methane in the formation of aromatics and soot in fuel-rich pre-mixed combustion

Experimental results from an isothermal laminar flow reactor at atmospheric pressure are presented on the chemical composition in the post-oxidative region of two sooting fuel-rich pre-mixed mixtures diluted in nitrogen. A base case composed of n-heptane and O2 in N2 at 1425 K with a C/O of 2.85 was perturbed by substituting 10% of the carbon in n-heptane with carbon as CH4. While these changes would intuitively reduce aromatics and soot formation by increasing H2 and decreasing C2H2 concentrations, we observe the opposite. The concentrations of individual aromatic species are observed to actually increase by up to 50% and the soot yield increases by 80%.     

Semiconductor-assisted photocatalytic degradation of reactive dyes in aqueous solution

This work reports the semiconductor-assisted photochemical degradation of reactive dyes. In an oxygenated-UV-ZnO system almost total decolorization of Remazol Brilliant Blue R, Remazol Black B, Reactive Blue 221 and Reactive Blue 222 was observed in reaction times of about 60 min. Extending the photochemical treatment up to 120 min, mineralization higher than 80% for all the dyes was observed. During the same period, the residual acute toxicity was significantly reduced only for Remazol Black B. A systematic optimization study carried out by factorial design showed that for the reactive dyes tested, the ZnO semiconductor exhibits a better efficiency than that observed with anatase TiO2. A synergistic effect in the coupled TiO2-ZnO system was not observed.     

Atrazine induction of cytochrome P450 in Chironomus tentans larvae

Cytochrome P450-dependent aldrin epoxidation was characterized in third instar larvae of the aquatic midge, Chironomus tentans. Optimal in vitro assay conditions for the epoxidase were pH 7.6 and 31 degrees C. Activity was linear up to 40 min of incubation time and 0.5 mg microsomal protein per incubation. The activity was concentrated in the microsomal fraction of whole body homogenates and was NADPH-dependent. The effect of atrazine exposure on aldrin epoxidase was measured to determine if this herbicide induces cytochrome P450-dependent activity. Comparisons of control and atrazine-exposed midges indicated increased epoxidase activity as a result of atrazine exposure, and a 45 kDa protein of increased intensity was observed after SDS-PAGE of microsomal protein. The molecular weight of this protein was similar in size to cytochrome P450 enzymes reported for other insects. Heme staining of SDS-PAGE gels and immunochemical studies using a Drosophila melanogaster anti-P450 polyclonal antiserum, further support the cytochrome P450 nature of this inducible 45 kDa protein.     

Steel mill waste application in soil: dynamics of potentially toxic elements in rice and health risk perspectives

Environmental Science and Pollution Research - Potentially toxic elements (PTEs) are of great concern in steel mill wastes. Therefore, in order to use them as potential fertilizers in soil, risk...     

Appraisal of kinetin spraying strategy to alleviate the harmful effects of UVC stress on tomato plants

Environmental Science and Pollution Research - Increasing ultraviolet (UV) radiation is causing oxidative stress that accounts for growth and yield losses in the present era of climate change....