镉对鲫鱼鳃和肝脏超氧化物歧化酶活性的影响

使用浸浴法以 0 mg/ L、0 .73 mg/ L、1 .46 mg/ L、2 .95 mg/ L 4个镉 (Cd Cl2 · 2 .5H2 O)浓度为丰产鲫 (Carassiusauratus of Penze(♀ )× Cyprinusacutidorsalis(♂ ) )幼鱼染毒 ,测定了 1 4 4 h内鳃及肝组织中超氧化物歧化酶 (SOD)活性的变化。结果表明 ,低浓度组Cd曝露时 ,鲫鱼鳃和肝组织中 SOD活性的变化短时间内不明显 ,但随着处理时间的延长 ,Cd提高了鳃和肝组织中 SOD的活性 ,导致“毒物兴奋效应”。高浓度组 Cd曝露时均抑制了肝和鳃中的 SOD活性 ,其作用随着曝露时间的延长和浓度的升高而增强 ,SOD酶活性降低所造成的活性氧伤害是引起鲫幼鱼死亡的重要原因。肝组织中的 SOD酶活性和敏感性高于鳃 ,这与其执行的生理功能有关     

高速公路下伏富水多层采空区注浆处理技术研究

采空区的治理是矿区工程建设关键问题之一。以京福高速公路徐州东绕城某多层富水采空区注浆充填法治理工程为依托,研究了注浆法处理多层富水采空区的设计方法、施工技术,重点包括治理范围确定、浆材配合比设计、布孔原则、成孔工艺、注浆工艺及控制技术等,确定了浆液扩散半径、单孔注浆量和终孔标准等注浆参数,为该种特殊条件下的采空区处治提供了科学的设计及施工技术方法、技术参数等。     

曲靖电厂灰渣性质及其用作水泥混合材的试验研究

在对粉煤灰及炉渣的主要物理、化学性质进行分析测试的基础上，对它们用作水泥混合材所表现出的性能及存在的问题进行了分析研究。     

Degradation of phenol in an upflow anaerobic sludge blanket(UASB) reactor at ambient temperatureKE

A synthetic wastewater containing phenol as sole substrate was treated in a 2.8 L upflow anaerobic sludge blanket(UASB) reactor at ambient temperature. The operation conditions and phenol removal efficiency were discussed, microbial population in the UASB sludge was identified based on DNA cloning, and pathway of anaerobic phenol degradation was proposed. Phenol in wastewater was degraded in an UASB reactor at loading rate up to 18 gCOD/(L·d), With a 1:1 recycle ratio, at 26(1℃, pH 7.0-7.5. An UASB reactor was able to remove 99% of phenol up to 1226 mg/L in wastewater with 24 h of hydraulic retention time(HRT). For HRT below 24 h, phenol degradation efficiency decreased with HRT, from 95.4% at 16 h to 93.8% at 12 h. It further deteriorated to 88.5% when HRT reached 8 h. When the concentration of influent phenol of the reactor was 1260 mg/L(corresponding COD 3000 mg/L), with the HRT decreasing(from 40 h to 4 h, corresponding COD loading increasing), the biomass yields tended to increase from 0.265 to 3.08 g/(L·d). While at 12 h of HRT, the biomass yield was lower. When HRT was 12 h, the methane yield was 0.308 L/(gCOD removed), which was the highest. Throughout the study, phenol was the sole organic substrate. The effluent contained only residual phenol without any detectable intermediates, such as benzoate, 4-hydrobenzoate or volatile fatty acids(VFAs). Based on DNA cloning analysis, the sludge was composed of five groups of microorganisms. Desulfotomaculum and Clostridium were likely responsible for the conversion of phenol to benzoate, which was further degraded by Syntrophus to acetate and H2/CO2. Methanogens lastly converted acetate and H2/CO2 to methane. The role of epsilon-Proteobacteria was, however, unsure.     

模拟海洋全浸区环境下A517海工钢的腐蚀机理研究

目的 探究 A517 海工钢在海洋全浸区环境下的腐蚀机理。方法 通过模拟海洋全浸区腐蚀环境,利用失重法、SEM、EDS、XRD、电化学等测试技术,分析A517钢的腐蚀行为历程,并探讨其在全浸区的腐蚀机理。结果A517钢在厚度方向上的最大电位差为 13 mV,小于发生电偶腐蚀的最小电位差50mV,说明材料在厚度方向上的腐蚀敏感性一致。随浸泡时间的延长,腐蚀质量损失量逐渐增加,平均腐蚀速率先降低、后升高、最后趋于稳定,腐蚀速率约为 0.127 mm/a。结论 腐蚀动力初期主要是由溶解氧的极限扩散控制,后期则是腐蚀产物的氧化还原电荷转移控制。腐蚀首先在 Al₂O₃、MgO 等夹杂物处萌生扩展,腐蚀产物出现明显的分层现象,外锈层主要是疏松易脱落的γ-FeOOH,内锈层主要是致密均匀的 Fe₃O₄,同时锈层中还检测到了β-FeOOH和α-FeOOH的存在。锈层中存在大量微裂纹,削弱了产物膜的保护作用,促进了腐蚀的进行。     

加速量热仪在物质热稳定性研究中的应用

加速量热仪（ARC）是一种基于绝热原理设计的热分析仪器,与其它热分析仪器相比,加速量热仪可以测量克量级的固体或高闪点液体样品,具有测试样品最大,敏感度高等特点,并能够实时记录样品放热反应过程中的温度和压力变化,以过氧化氢叔丁基为例说明加速量热仪测试结果在研究物质质变热稳定性方面的应用,得到了过氧化氢叔丁基放热分解反应的温度－时间和压力－时间关系曲线以及升温速度和压力随温度变化的曲线,通过计算和分析得到了反应系统升压速率随压力的变化曲线,计算出了过氧化氢叔丁基分解反应的动力学参数表观活化能Ea和指前因子A。     

炼油企业挥发性有机物无组织排放通量监测现状与发展

炼油企业是重要的挥发性有机物(VOCs)人为排放源,排放的VOCs主要来自无组织源,监控及排放核算困难。笔者总结了国内外炼油企业VOCs排放通量监控及核算技术体系,综述了各类VOCs无组织排放通量监测技术的原理及适用范围,着重评述了工业场地VOCs无组织排放通量监测最佳实用技术——红外掩日通量监测(SOF)和差分吸收激光雷达(DIAL)及其在炼油企业的应用进展。总体上,SOF仪器及监测费用适中,但易受阳光等天气条件限制; DIAL几乎可全天候监测,但仪器及监测费用较高。SOF和DIAL监测的欧美炼油企业VOCs排放系数一般为0. 02%～0. 10%,约为排放清单值的3～10倍。国内炼油厂VOCs排放核算采用的排放系数约为美国排放清单值(0. 01%～0. 02%)的10倍,尚待实测校验和修订。VOCs无组织排放通量监测技术也可用于检查或评估炼油企业泄漏检测与修复(LDAR)等VOCs无组织排放控制效果。     

水相中羟基自由基诱导二甲基硫氧化的研究

用激光闪光光解技术研究了水相中二甲基硫(DMS)与羟基自由基(·OH)的反应机理,并讨论了溶液pH值和O2对该反应的影响,进而比较了气液相DMS与·OH反应的不同,初步评估了由·OH氧化引起的海洋和大气液相中DMS的寿命.结果表明:在pH 6-9时, ·OH会与DMS反应生成·DMSOH, ·DMSOH在水相中继续与DMS反应生成(DMS) 2, (DMS) 2与氧气的反应速度很慢,其衰减受pH影响较大.     

纤维素热裂解的二次反应研究

在热重红外联用分析仪上开展了纤维素的热裂解失重研究,通过对纤维素热裂解的TG和DTG曲线以及热解产物的红外析出图谱的分析研究,探讨了纤维素热裂解的二次反应过程及机理,并在经典Broido—Shafizdeh模型的基础上．提出了改进的纤维素热裂解模型。     

Competitive adsorption and mobility sequence of heavy metals in urban soils of southeastern China

Heavy metals can be introduced into urban soils at the same time. Therefore, their selective retention and competitive adsorption by the soils become of major importance in determining their availability and movement throughout the soil. In this study, the availability and mobility of six heavy metals in eight urban soils collected from different cities of Zhejiang Province, southeastern China were assessed using distribution coefficients（Kd） and retardation factor（Rf）. The results showed that there were great differences in the Kd and Rfamong the tested soils. The adsorption sequences were Cr〉Pb〉Cu〉Cd〉Zn〉Ni, and the Kd decreased with increasing levels of metal addition. Ni generally has the lowest Rf values followed closely by Cd, and Zn whereas Cr and Pb reached the highest values. The results suggest that Ni and Zn have the highest mobility associated to the lowest adsorption, Cr and Pb present the opposite behavior. Correlation analysis indicates that soil pH, CaCO3 content, and cation exchange capacity （CEC） are key factors controlling the solubility and mobility of the metals in the urban soils.