汶川地震极震区泥石流动力特征及参数研究——以安县高川乡为例

2008年汶川8.0级地震发生以来,极震区泥石流爆发频率有增无减且规模越来越大,破坏性越来越强,严重威胁灾区人民生命财产安全。对比采取现场勘查、遥感图像分析、历史资料对比分析等方法,分析了极震区泥石流动力特征受地形、地层、物源等因素的影响,特别是泥石流爆发过程中深侵蚀和溃决对泥石流动力特征的影响。针对四川安县高川乡流域泥石流沟的调查和分析,建立泥石流流量-冲刷模型,分析了常规地区泥石流峰值流量与极震区泥石流峰值流量差别,推导出极震区峰值流量及冲刷深度定量计算公式。通过实例分析,理论与实际具有较好的一致性,对极震区泥石流动力参数计算具有较好适用性和有效性。     

有效磷含量对硝酸铵溶液热安全性的影响

为了了解硝酸磷肥生产过程中,硝酸铵溶液中加入磷酸一铵的安全性,通过自制实验装置,研究了有效磷含量对质量分数为85%的硝酸铵溶液热分解的影响。结果表明,质量分数为85%的硝酸铵和磷酸一铵混合溶液的临界爆炸温度高于纯质量分数为85%的硝酸铵溶液,稳定性更好;磷酸一铵抑制硝酸铵的热分解,随着有效磷含量的增加,硝酸铵混合溶液临界爆炸温度升高;升温速率对硝酸铵混合溶液的临界爆炸温度影响很大,随着升温速率由2℃/min升高到3℃/min,质量分数为85%的硝酸铵混合溶液的临界爆炸温度升高,不易发生爆炸,安全性更好。研究结果对硝酸磷肥的生产安全有一定的指导意义。     

未熟-低熟烃源岩的有机岩石学特征

采用全岩光片镜鉴和显微荧光分析方法 ,对我国不同地区 5 0 0余块未熟 低熟烃源岩样品进行了系统的有机岩石学研究。未熟 低熟烃源岩显微组分组成具有显著的非均质性 ,不同地区显示出陆源组分与水生生源组分不同的“配比”关系 ,反映出其有机质组成的复杂性 ,并确认藻类体、孢子体、树脂体、木栓质体、壳屑体和矿物沥青基质等组分是其最常见的生烃组分。基于对镜质组反射率Ro和孢子体荧光变化等演化指标特征的分析 ,认为未熟 低熟烃源岩有机质早期热演化具有明显的阶段性 ,一般都表现为“二段式”变化 ,其变化界限大致以Ro等于 0 .5 0 %～ 0 .5 5 %为界。     

稀土酞菁锰对表面活性剂(LAS)的催化氧化性能研究

研究了一种新型含稀土酞菁锰(KCeO2MnPcX)催化剂对水中表面活性剂直链烷基苯磺酸钠(LAS)氧化降解的催化性能,讨论了影响催化氧化反应的各种因素,并确定了最佳反应条件。同时初步探讨了这种催化剂对表面活性剂的催化氧化机理,为处理表面活性剂废水提供了新的途径。     

降水变化、氮添加对鼎湖山主要森林土壤有机碳矿化和土壤微生物碳的影响

全球变化对土壤有机碳(SOC)存贮与分解的影响在全球碳(C)循环中具有重要地位.分别通过室内土壤培养法和氯仿熏蒸法,研究了降水变化和氮(N)添加处理对鼎湖山3种不同演替阶段的季风常绿阔叶林、针阔混交林和马尾松针叶林SOC矿化和土壤微生物量碳(SMBC)的影响.结果表明:1)降水量增加能够提高森林演替晚期SOC累积矿化量和矿化速率,而对森林演替早期SOC累积矿化量和矿化速率没有显著影响(P>0.05).2)干旱条件(降水量减少)降低森林SMBC含量,且在鼎湖山季风林表层土壤(0～10 cm)中SMBC的减少达到显著水平(P<0.05).3)N添加处理对鼎湖山3种森林类型SOC累积矿化量、矿化速率以及SMBC都没有显著影响(P>0.05).未来关于SOC矿化对全球变化响应的研究,要综合考虑土壤有机质质量、C/N比例、外源性氮输入等因素的作用.图4表2参37     

2种电除尘优化改造方案模拟及经济性分析

中国环境保护部和国家质量监督检验检疫总局联合发布了GB 13223-2014,要求火电厂烟尘排放限值应小于30 mg·m-3,老式单一的电除尘器已经很难达到环保要求。以某电厂为例,对电除尘器入口处接低低温省煤器和将原静电除尘器改造为电袋复合除尘器的2种优化改造方案进行了模拟,并对2种方案的经济性进行了分析,所得结论可供类似机组在电除尘器改造和设计时参考。     

杂质对硝酸铵水溶液临界爆炸温度的影响

利用自制装置对含杂质的硝酸铵水溶液临界爆炸温度进行测试研究.结果表明,Cl-单独作用在一定程度上抑制硝酸铵溶液的热分解,提高了其临界爆炸温度;pH值一定时,随着Cl-浓度的增大,硝酸铵水溶液的临界爆炸温度呈指数形式降低;Cl-浓度一定时,pH值越小,硝酸铵水溶液的临界爆炸温度越低;油脂会降低硝酸铵溶液的热稳定性.该结果...     

人工湿地除磷存在的问题及其对策探讨

人工湿地是20世纪七八十年代发展起来的一种污水生态处理技术,能高效去除有机污染物,氮、磷等营养物,近年来得到了广泛的应用。对磷的去除不同于常规化学除磷或生化处理工艺,而是集物理化学法和生物法于一体,即通过基质、水生植物及微生物的协同作用完成。基质容易达到饱和是人工湿地除磷面临的主要问题,进水水质、水力条件、温度变化等条件也不同程度影响人工湿地的除磷效果。针对以上问题,提出了相应对策,以实现人工湿地除磷系统的稳定运行。     

A pyrazine based metal-organic framework for selective removal of copper from strongly acidic solutions

● pz-UiO-66 was synthesized facilely by a solvothermal method. ● Efficient capture of copper from highly acidic solution was achieved by pz-UiO-66. ● pz-UiO-66 exhibited excellent selectivity and capacity for copper capture. ● Pyrazine-N in pz-UiO-66 was shown to be the dominant adsorption site. The selective capture of copper from strongly acidic solutions is of vital importance from the perspective of sustainable development and environmental protection. Metal organic frameworks (MOFs) have attracted the interest of many scholars for adsorption due to their fascinating physicochemical characteristics, including adjustable structure, strong stability and porosity. Herein, pz-UiO-66 containing a pyrazine structure is successfully synthesized for the efficient separation of copper from strongly acidic conditions. Selective copper removal at low pH values is accomplished by using this material that is not available in previously reported metal–organic frameworks. Furthermore, the material exhibits excellent adsorption capacity, with a theoretical maximum copper uptake of 247 mg/g. As proven by XPS and FT-IR analysis, the coordination of pyrazine nitrogen atoms with copper ions is the dominant adsorption mechanism of copper by pz-UiO-66. This work provides an opportunity for efficient and selective copper removal under strongly acidic conditions, and promises extensive application prospects for the removal of copper in the treatment for acid metallurgical wastewater.     

Feedforward control for nitrogen removal in a pilot-scale anaerobic-anoxic-oxic plant for municipal wastewater treatment

To improve the efficiency of nitrogen removal with lower energy consumption, the study of feedforward control was carried out on a pilot-scale anaerobic-anoxicoxic (AAO) plant for the treatment of municipal wastewater. The effluent qualities of the pilot plant under different control strategies were investigated. The results indicated that the change of external recycle was not a suitable approach to regulate the sludge concentration of plug-flow reactors; adjusting the aeration valve and dissolved oxygen set-point according to ammonia load could overcome the impact of influent fluctuation; and the denitrification potential could be estimated based on the transit time of anoxic zone and the relative content of carbon resource entering the anoxic zone. Simple feedforward control strategies for aeration and internal recycle were subsequently proposed and validated. The nitrogen removal was successfully improved in the pilot plant. The effluent total nitrogen had decreased by 29.9% and was steadily controlled below 15 mg·L⁻¹. Furthermore, approximately 38% of the energy for aeration had been saved.