System dynamic analysis of construction waste recycling industry chain in China

Environmental Science and Pollution Research - With the acceleration of China’s urbanization process, construction activities have led to a substantial increase in construction waste....     

Effects of intercropping with floricultural accumulator plants on cadmium accumulation in grapevine

Environmental Science and Pollution Research - Grapevine (Vitis vinifera L.) intercropping with floricultural cadmium (Cd) accumulator plants (Helianthus annuus L., Cosmos sulphureus Cav., Cosmos...     

SBR法降解有机物规律的研究

本研究是以处理啤酒废水的试验为基础展开的。试验结果进一步验证了SBR法具有简易,快速、低耗等优点。除此之外,还得出以下结论:增加间歇反应时起始污泥浓度可以提高处理效率或减少反应时间;非限制曝气方式耐冲击负荷,需氧均匀,能缩短反应周期;间歇反应中微生物细胞的合成代谢占主导地位,对氮与磷的需要量大于传统的理论值。本文还指出SBR法是很适合我国国情的一种废水处理工艺,应当加强对它的研究和推广应用。     

UniTank工艺流程氨氮浓度的动态特征

利用基于ASM2D的数学模型对上海石洞口污水厂UniTank工艺内氨氮浓度的动态特性进行了仿真研究,发现该流程反应器氨氮浓度具有非稳态特征.反应器内氨氮浓度的变化规律与曝气时间设定及进水时间设定有关.增加曝气强度,能降低边池及中池的氨氮浓度,相应增大边池及中池的硝态氮浓度.     

SBR法处理豆制品废水工艺条件的研究

用SBR法处理豆制品废水的试验表明,该系统具有较好的抗负荷冲击能力,进水COD在300～2000 mg/L之间变化,对系统不造成任何影响;考察了曝气时间、曝气量和污泥浓度等对去除效果的影响,试验结果表明,曝气时间和曝气量对处理效果影响很大,确定该反应系统最佳曝气时间是8 h,适宜的曝气量是800 L/h,而污泥浓度控制在4000 mg/L左右时,处理效率最高,采用进水顶出水的排水方式是可行的,确定系统的最佳排水比是3/5.厌氧段的插入可以减少剩余污泥的产量.     

臭氧-曝气生物滤池处理酸性玫瑰红染料废水

在实验室配制含酸性玫瑰红染料的印染废水，采用臭氧氧化-曝气生物滤池工艺开展处理试验。试验运行结果表明，臭氧氧化处理能提高模拟废水的可生化性，BOD／COD值由原水的0．18上升到0．36。经组合工艺处理后出水COD〈40mg／L，色度40倍以下，SS约50mg／L，处理效果良好。     

接种厌氧消化污泥EGSB反应器的快速启动

对接种市政消化污泥的EGSB反应器的启动进行实验研究以寻求快速启动EGSB反应器的有效方法。接种厌氧消化污泥EGSB反应器的成功启动仅需要46d。在整个启动期保持适当的液体上升流速是非常重要的。启动初期，高液体上升流速能够将悬浮污泥冲出反应器，使适合聚集的微生物留在反应器内。接下来需要降低进水流量和液体上升流速以利于构建稳定的微生态系统，使高活性颗粒污泥尽快形成。然后适当提高液体上升流速能保持污水与微生物的良好接触，促进颗粒污泥内外高效传质，形成更加稳定高效的微生物群落结构。为尽快形成高活性颗粒污泥，保证产甲烷菌的最佳营养需求是关键，可通过考虑进水基质、微量营养元素和硫化物来提高其活性。     

超高交联吸附树脂对有机物质甲苯的吸附热力学研究

比较了2种超高交联聚苯乙烯吸附树脂NDa99与ZH-04对甲苯的静态吸附行为.结果表明,在288～293 K和研究的浓度范围内,ZH-04、NDa99对甲苯的吸附平衡数据符合Freundlich和Langmuir吸附等温方程.吸附为放热过程,适当降低温度有利于吸附,并计算了甲苯在ZH-04和NDa99树脂上的吸附焓变、自由能变和熵变,对吸附行为进行了合理的解释,为废水处理提供一定的理论依据.     

Wet air oxidation of a reactive dye solution using CoAlPO(4)-5 and CeO(2) catalysts

Wet air oxidation of a prepared reactive dye solution was performed to assess the efficacy of CoAlPO(4)-5 and CeO(2) as catalysts in the reaction. Via adsorption and oxidation of dye, CoAlPO(4)-5 effectively decreased American Dye Manufacturers Institute and chemical oxygen demand (COD) values in the dye solution. At a reaction temperature of 135 degrees C and an applied pressure of 1.0 MPa, color and COD removal were as high as 95% and 90%, respectively, after 2 h. Active sites on the outer surface of CoAlPO(4)-5 are responsible for adsorption and decomposition of dye while active sites in the pores dominate further destruction and oxidation of intermediate products. Since the outer surface only represents a minor part of the total surface, the color removal does not increase appreciably with loading of CoAlPO(4)-5. The CeO(2) catalyst, calcined from cerium chloride under high thermal impact (type A CeO(2)) was very effective in removing color and COD from the solution. This catalyst demonstrated near 100% color removal at temperatures above 135 degrees C and the COD removal could be above 95% at 165 degrees C. With both CoAlPO(4)-5 and CeO(2) catalysts, COD rose and then fell back during the reaction, a feature typical of a consecutive reaction. In contrast to prepared CeO(2), a commercial CeO(2) did not exhibit any catalytic ability for the removal of color and COD. The durability of both CoAlPO(4)-5 and prepared CeO(2) is considered to be fair.     

Comparison of different sequential extraction procedures for mercury fractionation in polluted soils

Environmental Science and Pollution Research - Three sequential extraction procedures (SEPs), modified Tessier, modified BCR, and CIEMAT, were compared for mercury fractionation in polluted soils....