Compatibility analysis of material and energy recovery in a regional solid waste management system

The rising prices of raw materials and concerns about energy conservation have resulted in an increasing interest in the simultaneous recovery of materials and energy from waste streams. Compatibility exists for several economic, environmental, and managerial reasons. Installing an on-site or off-site presorting facility before an incinerator could be a feasible alternative to achieve both goals if household recycling programs cannot succeed in local communities. However, the regional impacts of presorting solid waste on a waste-to-energy facility remain unclear because of the inherent complexity of solid waste compositions and properties over different areas. This paper applies a system-based approach to assess the impact of installing a refuse-derived fuel (RDF) process before an incinerator. Such an RDF process, consisting of standard unit operations of shredding, magnetic separation, trommel screening, and air classification, might be useful for integrating the recycling and presorting efforts for a large-scale municipal incinerator from a regional sense. An optimization modeling analysis is performed to characterize such integration potential so that the optimal size of the RDF process and associated shipping patterns for flow control can be foreseen. It aims at exploring how the waste inflows with different rates of generation, physical and chemical compositions, and heating values collected from differing administrative districts can be processed by either a centralized presorting facility or an incinerator to meet both the energy recovery and throughput requirements. A case study conducted in Taipei County, which is one of the most densely populated metropolitan areas in Taiwan, further confirms the application potential of such a cost-benefit analysis.     

Pore structure effects on Ca-based sorbent sulfation capacity at medium temperatures: activated carbon as sorbent/catalyst support

The reaction between three different Ca-based sorbents and SO2 were studied in a medium temperature range (473-773 K). The largest SO2 capture was found with Ca(OH)2 at 773 K, 126.31 mg SO2 x g Ca(OH)2(-1), and the influence of SO2 concentration on the sorbent utilization was observed. Investigations of the internal porous structure of Ca-based sorbents showed that the initial reaction rate was controlled by the surface area, and once the sulfated products were produced, pore structure dominated. To increase the surface area of Ca-based sorbents available to interact with and retain SO2, one kind of CaO/ activated carbon (AC) sorbent/catalyst was prepared to study the effect of AC on the dispersion of Ca-based materials. The results indicated that the Ca-based material dispersed on high-surface-area AC had more capacities for SO2 than unsupported Ca-based sorbents. The initial reaction rates of the reaction between SO2 and Ca-based sorbents and the prepared CaO/AC sorbents/catalysts were measured. Results showed that the reaction rate apparently increased with the presence of AC. It was concluded that CaO/AC was the active material in the desulfurization reaction. AC acting as the support can play a role to supply O2 to increase the affinity to SO2. Moreover, when AC is acting as a support, the surface oxygen functional group formed on the surface of AC can serve as a new site for SO2 adsorption.     

Rapid reductive destruction of hazardous organic compounds by nanoscale Fe0

Fe0-mediated reductive destruction of hazardous organic compounds such as chlorinated organic compounds (COCs) and nitroaromatic compounds (NACs) in the aqueous phase is one of the latest innovative technologies. In this paper, rapid reductive degradation of COCs and NACs by synthesized nanoscale Fe0 in anaerobic batch systems was presented. The nanoscale Fe0, characterized by high specific surface area and high reactivity, rapidly transformed trichloroethylene (TCE), chloroform (CF), nitrobenzene (NB), nitrotoluene (NT), dinitrobenzene (DNB) and dinitrotoluene (DNT) under ambient conditions, which results in complete disappearance of the parent compounds from the aqueous phase within a few minutes. GC analysis reported that the main products of the dechlorination of TCE and CF were ethane and methane as well as that most of the nitro groups in NACs were reductively transformed to amine groups. These results suggest that the rapid reductive destruction by nanoscale Fe0 is potentially a viable in situ or aboveground treatment of groundwater contaminated with hazardous organic compounds including COCs and NACs.     

Investigation of polychlorinated biphenyl removal from contaminated soil using microwave-generated steam

A feasibility study of polychlorinated biphenyl (PCB) removal from contaminated soils using microwave-generated steam (MGS) was performed. Initial experimental results show that MGS effectively removed PCBs from contaminated soil with an overall removal efficiency of greater than 98% at a steam-to-soil mass ratio of 3:1. Removal efficiency was found to be dependent upon the amount of steam employed, expressed as a mass ratio of steam applied to soil mass. Evaporation was identified as a major mechanism in removing PCBs from the soil. Rapid expansion and evaporation of pore water by microwave dielectric heating accelerated evaporation rates of PCB molecules. Increased solubility of PCBs into the heated aqueous phase is also hypothesized. Together these effects increase mass-transfer rates, thus enhancing removal of PCBs from the soil.     

嫩江—齐齐哈尔江段几种蚌类重金属残毒水平

通过对嫩江几种蚌类不同部位重金属残毒分析，得了３种蚌类中背角无齿蚌的富集能力最强，不同部位中，足对总汞的富集能力强，外套膜对镉的富集能力最强，而鳃对铅，铜，锌富集能力最强。     

上流式厌氧污泥床反应器处理饮料废水

通过监测西安可口可乐饮料有限公司污水处理站的上流式厌氧污泥床(UASB)反应器,探讨饮料废水厌氧处理过程中COD去除率、沼气组分、氢分压、出水挥发性脂肪酸、产甲烷活性以及污泥形态。结果表明,UASB反应器对饮料废水中的COD去除率达到84.55%,产生的沼气中甲烷组分含量高达74.5%。反应器内的氢分压仅2.5 Pa,为水解发酵和产氢产乙酸过程创造了良好的条件。UASB反应器中污泥具有较高的产甲烷活性,以乙酸、丙酸和丁酸为基质时,最大比产甲烷活性分别为407.14、331.74和241.27 mL CH4/(g VSS·d)。UASB反应器中的污泥形态主要为絮状,甲烷菌中的优势菌为甲烷丝菌,同时存在少量甲烷杆菌。针对该厂UASB反应器中污泥的现状,提出了影响颗粒化的因素和控制措施,为后期的运行和管理提供了参考依据。     

Removal of nutrients and veterinary antibiotics from swine wastewater by a constructed macrophyte floating bed system

The potential of three varieties of Italian ryegrass (Lolium multiflorum Lam.), Dryan, Tachimasari and Waseyutaka, to improve the water quality of swine wastewater was evaluated using a constructed macrophyte floating bed system. With respect to reductions in levels of nutrients, chemical oxygen demand (COD), and sulfonamide antimicrobials (SAs, including sulfadiazine, sulfamethazine, and sulfamethoxazole), Dryan performed better than Tachimasari and Waseyutaka. For Dryan, total N was reduced by 84.0%, total P by 90.4%, COD by 83.4% and sulfonamide antimicrobials by 91.8–99.5%. Similar results were observed for Tachimasari and Waseyutaka. The results indicated that the treatment of swine wastewater using the constructed macrophyte floating bed system was effective in the removal of nutrients and veterinary antibiotics.     

Vacuum pyrolysis of waste tires with basic additives

Granules of waste tires were pyrolyzed under vacuum (3.5-10kPa) conditions, and the effects of temperature and basic additives (Na(2)CO(3), NaOH) on the properties of pyrolysis were thoroughly investigated. It was obvious that with or without basic additives, pyrolysis oil yield increased gradually to a maximum and subsequently decreased with a temperature increase from 450 degrees C to 600 degrees C, irrespective of the addition of basic additives to the reactor. The addition of NaOH facilitated pyrolysis dramatically, as a maximal pyrolysis oil yield of about 48wt% was achieved at 550 degrees C without the addition of basic additives, while a maximal pyrolysis oil yield of about 50wt% was achieved at 480 degrees C by adding 3wt% (w/w, powder/waste tire granules) of NaOH powder. The composition analysis of pyrolytic naphtha (i.b.p. (initial boiling point) approximately 205 degrees C) distilled from pyrolysis oil showed that more dl-limonene was obtained with basic additives and the maximal content of dl-limonene in pyrolysis oil was 12.39wt%, which is a valuable and widely-used fine chemical. However, no improvement in pyrolysis was observed with Na(2)CO(3) addition. Pyrolysis gas was mainly composed of H(2), CO, CH(4), CO(2), C(2)H(4) and C(2)H(6). Pyrolytic char had a surface area comparable to commercial carbon black, but its proportion of ash (above 11.5wt%) was much higher.     

5种化学品对丽斑麻蜥和日本鹌鹑的毒性研究

目前,在化学品生态风险评价体系中对爬行动物的毒性效应研究较少。本研究参考鸟类急性经口毒性试验建立了我国本土爬行动物——丽斑麻蜥(Eremias argus)的急性毒性测试方法,来评价化学品对爬行动物和鸟类的毒性效应之间的差异。选择异氰酸酯、1,2-苯并异噻唑-3-酮、2,4-二氯苯酚、苯并噻唑和二苯甲酮5种化学品分别对丽斑麻蜥进行暴露实验,并与鸟类模式物种——日本鹌鹑(Coturnix japonica)的急性毒性结果进行比较。结果发现异氰酸酯和苯并噻唑对丽斑麻蜥7 d的半数致死剂量(7 d-LD50)分别为125 mg·kg~(-1)和500 mg·kg~(-1),而对日本鹌鹑的7 d-LD50值分别为27 mg·kg~(-1)和37 mg·kg~(-1);1,2-苯并异噻唑-3-酮、2,4-二氯苯酚和二苯甲酮对丽斑麻蜥的7 d-LD50值分别为909 mg·kg~(-1)、787 mg·kg~(-1)和528 mg·kg~(-1),而对日本鹌鹑7 d-LD50值均大于剂量上限1 000 mg·kg~(-1)。结果表明,丽斑麻蜥和日本鹌鹑对相同化学品的毒性敏感性是存在差异的,用鸟类来评价化学品对爬行动物的潜在风险可能不够准确,应该重视化学品对爬行动物的毒性效应研究。同时,以本土爬行动物的代表物种丽斑麻蜥作为化学品环境风险评价的模式生物,对保护我国本土物种及其多样性、维持生态平衡具有重要意义。     

环境中重金属和有机污染物的物种敏感性分布研究进展

物种敏感性分布法(SSD,Species Sensitivity Distribution)是一种相对于传统评价因子法具有更高置信度的统计学外推方法,在环境质量基准制定及生态风险评价中得到广泛应用。本文对近年来国内外重金属和有机污染物的物种敏感性分布研究成果进行了综述,阐述了在水体、土壤和沉积物等环境介质中应用SSD方法开展生态风险评价的研究现状,从SSD模型选择、毒性数据点筛选等方面对影响SSD模型不确定性的因素进行探讨,并对SSD方法在生态风险评价领域的应用进行了展望。