Management of agricultural biomass wastes: Preliminary study on characterization and valorisation in clay matrix bricks

In this work the feasibility of using woody agricultural biomass wastes as grapes and cherries seeds, sawdust, as pore forming agent, and sugar cane ash, as silica precursor, in bricks, were reported.Sawdust and grapes and cherries seeds, thanks to their organic substances content, during their combustion, bring an energetic support in the bricks firing phase and act as pore forming agent. Usually the addition of this kind of waste is limited to 10 wt.% in order to reach an equilibrium between positive (weight and shrinkage decrease and porosity increase) and negative (increase of water absorption and mechanical resistance decrease) effects. The results show that grapes and cherries seeds, added in a percentage of 5 wt.% to a brick formulation, have better influence with respect to the sawdust, maintaining the mechanical properties of the fired brick (950 °C), showing modulus of rupture around 21–23 MPa with a weight reduction of 3–10% (respect to the standard one). Regarding the sugar cane ash, the addition of 5 wt.% improves the mechanical properties (modulus of rupture around 27 MPa) and no weight decrease is observed. These results confirmed the role played by this kind of agricultural waste, which thanks to its high silica content (61 wt.%) is capable to demonstrate a filler and plasticity reducing effect on the brick bodies. Tests carried out highlighted that the addition of these by-products (5 wt.%) do not change negatively the main technological properties measured (water absorption, linear shrinkage, flexural resistance, etc.) and permit to hypothesize their use to obtain bricks with both insulating and higher mechanical properties using a pore agent forming or silica carrier alternative raw materials, respectively.     

Oxidative damage to Pseudomonas aeruginosa ATCC 27833 and Staphylococcus aureus ATCC 24213 induced by CuO-NPs

Environmental Science and Pollution Research - The cytotoxicity of nanoparticles (NPs) and their properties are important issues in nanotechnology research. Particularly, NPs affect the metabolism...     

Biodegradable Polyester-Based Blend Reinforced with Curauá Fiber: Thermal,Mechanical and Biodegradation Behaviour

Biodegradable composites can be produced by the combination of biodegradable polymers (BP) as matrix and vegetal fibers as reinforcement. Composites of a commercial biodegradable polymer blend and curauá fibers (loaded at 5, 15 and 20 wt%) were prepared by melt mixing in a twin-screw extruder. Chemical treatments such as alkali treatment of the fiber and addition of maleic anhydride grafted polypropylene (MA-g-PP) as coupling agent were performed to promote polymer/fiber interfacial adhesion so that mechanical performance can be improved. The resulting composites were evaluated through hardness, melt flow index and tensile, flexural and impact strengths as well as water absorption. Thermal analysis and Fourier transform infrared spectroscopy were also employed to characterize the composites. The polymer/fiber interface was investigated through scanning electron microscopy analysis. The biodegradability of composites was evaluated by compost-soil burial test. The addition of curauá fiber promoted an increase in the mechanical strengths and composites treated with 2 wt% MA-g-PP with 20 wt% curauá fiber showed an increase of nearly 75% in tensile and 56% in flexural strengths besides an improvement in impact strength with respect to neat polymer blend. Nevertheless, treated composites showed an increase in water absorption and biodegradation tests showed that the addition of fiber retards degradation time. The retained mass of BP/20 wt% fiber composite with MA-g-PP and neat BP was 68 and 26%, respectively, after 210 days of degradation test.     

Assessment of groundwater quality in a region of endemic fluorosis in the northeast of Brazil

The aim of this study was to estimate the risk for caries and fluorosis in a desertification area, applying the calcium/fluoride concentration ratio of underground water and the quality of water in a selected geographical region. This study was performed in the municipality of São João do Rio do Peixe, located in the tropical semiarid lands of Brazil. A total of 111 groundwater samples were collected. Fluoride concentration varied from 0.11 to 9.33 mg/L. Thirty percent of all samples analyzed showed values above 1.5 mg/L, while 64 % were above the ideal limit of 0.7 mg/L. Mean calcium concentration was 47.6 mg/L, and 14.4 % of all samples presented values above the WHO acceptable limits. The proportional value of calcium/fluoride in water showed that only 12 % of the samples were suitable for dental caries prevention with minimal risk for dental fluorosis. Mapping of the fluoride distribution indicated that approximately 2,465 people could be affected by dental fluorosis and 1,057 people might be affected by skeletal fluorosis. It can be concluded that, in addition to fluoride, many water parameters were not suitable for the drinking water. Mapping out calcium/fluoride ratio may indicate areas of water suitability for caries control, whereas the fluoride concentration solely can indicate the areas with the risk for fluorosis. This approach can be relevant for health authorities for identifying communities where dental caries or dental fluorosis is prevalent.     

Dissolved and particulate metals in water from Sonora Coast: a pristine zone of Gulf of California

The purpose of this study was to investigate the distribution of metals (Cd, Pb, Hg, Cu, Fe, Mn, and Zn) in dissolved and particulate fractions in seawater from Bacochibampo Bay, Northern part of Mexico. Water samples were collected from November 2004 to October 2005. Metal analysis was done by graphite furnace atomic absorption spectroscopy. Results indicated highest concentrations of dissolved Cd and Zn in the sites localized at the mouth and center of the bay. During summer and spring, the highest levels of Cd, Mn, and Fe were detected, Zn in fall, and Pb and Cu in winter and spring. Mercury was the only metal that was not found in this fraction. In particulate fraction, Fe, Hg, and Mn were the most abundant elements in all the sampling sites, followed by Zn, Cu, Pb, and Cd. The highest levels of the majority of the metals were observed in the coastline, suggesting a continental and/or urban source for these chemicals. The highest level of Cd was detected during the summer and the rest of the metals in the fall. Statistically significant correlations were observed between dissolved and particulate forms of Pb:Mn, Cu:Fe, and Cu:Mn. The mean partition coefficient values were as follows: Fe>Mn>Cu>Pb>Cd>Zn. All dissolved metal concentrations found, except Pb, were lower than EPA-recommended water quality values. The levels of dissolved metals in this study reveal low bioavailability and toxic potential. However, further toxicological and sediment chemistry studies in this area are needed for a full risk assessment.     

Organochlorine contaminants in albatrosses and petrels during migration in South Atlantic Ocean

Albatrosses and petrels (Procellariiformes) are migratory oceanic birds of considerable conservational interest. Polychlorinated biphenyls (PCBs) and organochlorine pesticides (OCPs) were assessed in the subcutaneous fat, liver and muscle of 100 birds belonging to eight species of Procellariiformes collected during their migration period in southern Brazil, one of the most important feeding areas for these species. Although the profiles of PCBs and OCPs were similar among the individuals, with predominance of penta, hexa and heptachlorobiphenyls and p′p-DDE, organochlorine concentrations exhibited a high degree of intra-species variability. The influence of body condition during the migration period in the distribution of organochlorine contaminants was also evaluated, showing that it is a significant factor in the variation and redistribution of these compounds in the tissues of these birds. The intense use of lipid reserves associated to the contamination from organochlorine compounds could be a troubling factor for seabirds with extended breeding periods and that spend most of their lives at sea migrating long distances, such as most of Procellariiformes. Studies on contamination are necessary to improve the knowledge of the threats to these birds and their populations as well as to contribute with information about persistent organic pollutants in the South Atlantic marine environment.     

Diversity of a chlorine-resistant Bacillus population isolated from a wastewater treatment station

This paper describes the phenotypic and genotypic diversity of a Gram-positive, aerobic bacterial population isolated from the chlorine tank of a wastewater treatment plant. A total of 12 sporeforming, rod-shaped isolates were identified using 16S rRNA gene sequencing and biochemical tests. Pairwise genetic comparisons revealed the identity among sequences obtained from isolates varied from 92.6 to 100%. Similarity searches on GenBank showed that five strains were closely related (99 to 100% identity) to Bacillus subtilis and two were almost identical (99%) to B. megaterium and B. licheniformis. Because the five remaining strains were either closely related (97 to 99% identity) or identical to B. cereus, B. thuringiensis, and B. anthracis, they were classified as belonging to the B. cereus group. Apart from one strain, all clades in the phylogenetic tree were identical to clusters formed in the dendrogram based on biochemical tests results. According to the biochemical profiles, all isolates were characterized as different strains. In addition to chlorine resistance, all isolates were found to be resistant to at least one of five antibiotics tested. These results identify the potential risk of spreading antibiotic resistance genes in the environment by chlorine-resistant strains of Bacillus.     

Anthocyanins and tannins in ozone-fumigated guava trees

Psidium guajava “Paluma”, a tropical tree species, is known to be an efficient ozone indicator in tropical countries. When exposed to ozone, this species displays a characteristic leaf injury identified by inter-veinal red stippling on adaxial leaf surfaces. Following 30 days of three ozone treatments consisting of carbon filtered air (CF – AOT40 = 17 ppb h), ambient non-filtered air (NF – AOT40 = 542 ppb h) and ambient non-filtered air + 40 ppb ozone (NF + O₃ – AOT40 = 7802 ppb h), the amounts of residual anthocyanins and tannins present in 10 P. guajava (“Paluma”) saplings were quantified. Higher amounts of anthocyanins were found in the NF + O₃ treatment (1.6%) when compared to the CF (0.97%) and NF (1.30%) (p < 0.05), and of total tannins in the NF + O₃ treatment (0.16%) compared to the CF (0.14%). Condensed tannins showed the same tendency as enhanced amounts. Regression analyses using amounts of tannins and anthocyanins, AOT40 and the leaf injury index (LII), showed a correlation between the leaf injury index and quantities of anthocyanins and total tannins. These results are in accordance with the association between the incidence of red-stippled leaves and ozone polluted environments.