Stochastic model to forecast ground-level ozone concentration at urban and rural areas

Stochastic models that estimate the ground-level ozone concentrations in air at an urban and rural sampling points in South-eastern Spain have been developed. Studies of temporal series of data, spectral analyses of temporal series and ARIMA models have been used. The ARIMA model (1,0,0) x (1,0,1)24 satisfactorily predicts hourly ozone concentrations in the urban area. The ARIMA (2,1,1) x (0,1,1)24 has been developed for the rural area. In both sampling points, predictions of hourly ozone concentrations agree reasonably well with measured values. However, the prediction of hourly ozone concentrations in the rural point appears to be better than that of the urban point. The performance of ARIMA models suggests that this kind of modelling can be suitable for ozone concentrations forecasting.     

Compensation processes of Aleppo pine (Pinus halepensis Mill.) to ozone exposure and drought stress

A long-term experiment was performed to study the effects of O3 and drought-stress (DS) on Aleppo pine seedlings (Pinus halepensis Mill.) exposed in open-top chambers. Ozone reduced gas exchange rates, ribulose-1,5-biphosphate carboxylase/oxygenase activity (Rubisco), aboveground C and needle N concentrations and C/N ratio and Ca concentrations of the twigs under 3 mm (twigs<3) and the aerial biomass. Also it increased phosphoenolpyruvate carboxylase (PEPc) and N and K concentrations of the twigs<3. Water stress decreased gas exchange rates, predawn needle water potential (PsiPd), C/N ratio, twigs<3 Ca, plant growth, aerial biomass and increased N, twigs with a diameter above 3 mm P and Mg concentrations. The combined exposure to both stresses increased N concentrations of twigs<3 and roots and aboveground biomass K content and decreased root C, maximum daily assimilation rate and instantaneous water use efficiency. The sensitivity of Aleppo pine to both stresses is determined by plant internal resource allocation and compensation mechanisms to cope with stress.     

Water management for a megacity: Mexico City Metropolitan Area

The paper presents an overview of the present situation of the Mexico City Metropolitan Area (MCMA). The analysis indicates an urgent need to radically improve the current water supply and wastewater management practices, to become sustainable. The MCMA is one of the most rapidly growing urban centers of the world, with a population of about 21 million people, a very high rate of immigration and numerous illegal settlements. In order to meet the increasing water demand, successive governments have focused almost exclusively on supply management and engineering solutions, which have resulted in investments of hundreds of millions of USD and the construction of major infrastructure projects for interbasin water transfer. Environmental, economic and social policies associated with water management are mostly inadequate and insufficient, which is resulting in increasing deterioration in the environment, health and socioeconomic conditions of a population living in one of the largest urban agglomerations of the world. Surprisingly, however, no long-term strategies on demand-management, reuse, conservation, and improved water-management practices have been developed so far.     

Biodegradation of technical mixtures of oxyethylenated aliphatic alcohols in an aqueous environment

A study of the biodegradability of nonionogenic surfactants of oxyethylenated n-butyl, isobutyl, n-pentyl and isopentyl alcohols was conducted by modified static test according to International Standard Organization method 9888. Degradation was evaluated by changes in concentrations of individual oligomers, ethylene glycols, carboxylic and dicarboxylic acids. Good biological degradability was found, with a "primary" degradability of 75-98% in 10 days. Obtained results, in agreement with our previous work, proved the dominant proportion of degradative scission in the hydrophile part of surfactant molecule. During biological degradation no significant cumulation of mono- to polyethylene glycols appeared neither that of mono- or dicarboxylic acids, and degradation of these components was not a rate-determining degradation factor.     

Simulation of atmospheric PAH emissions from diesel engines

Simulation of atmospheric PAH emissions in a typical European passenger car diesel engine at steady conditions or under a certification cycle is made using in-house software. It is based on neural fitting of experimental data from eight different fuels tested under five operating steady conditions (reproducing modes of the European transient urban/extraurban certification cycle). The software allows the determination of PAH emissions as a function of the fuel composition parameters (aromatic content, cetane index, gross heat power, nitrogen and sulphur content) and operation conditions (torque and engine speed). The mathematical model reproduces experimental data with a maximum error of 20%. This tool is very useful, since changes in parameters can be made without experimental cost and the trend in modifications in PAH emissions is immediately obvious.     

Isolation and identification of intermediates from biodegradation of low chlorinated biphenyls (Delor-103)

Microorganism Pseudomonas species P2 metabolizes polychlorinated biphenyls (PCBs) and biphenyl, producing the whole spectrum of intermediates, among them coloured intermediates, which are suitable for the monitoring of PCBs degradation by optical sensors. Knowledge of chemical structures and conditions of development of colour metabolites is necessary for application of optical analytical methods. The main goal of this work was the isolation and identification of intermediates from the biodegradation of the mixture of low chlorinated biphenyls (Delor-103), which is based on the solid phase extraction (SPE) of the whole mixture using LiChrolut EN cartridges, then silylation of the extract as one way to the identification of one part of intermediates by GC-MS, and acetylation of the extract as a way for the further concentration and analysis of more polar chlorobiphenylols and chlorobiphenyldiols. The combination of SPE and following acetylation allows to obtain chlorobiphenylols and chlorobiphenyldiols as an almost pure fraction. The acetylation method could be also used instead SPE procedure with the same final concentration effect. Using the simulation mass spectrometry program, two new compounds, dihydrodihydroxytrichloro- and tetrahydrodihydroxytrichlorobiphenyl, as silylderivatives, were identified.     

Adsorption of atrazine from aqueous solution on heat treated kerolites

The adsorption of 6-chloro-N(2)-ethyl-N(4)-isopropyl-1,3,5-triazine-2,4-diamine (atrazine) on heat treated kerolite samples at 110 degrees C (K-110), 200 degrees C (K-200), 400 degrees C (K-400) and 600 degrees C (K-600) from aqueous solution at 25 degrees C has been studied. The evolution of surface properties of kerolite samples such as specific surface area and porosity after heat treatment was analysed. The clays were characterised by using usual techniques: FTIR spectroscopy, XRD diffraction, TG and DTG analysis, surface analysis and Hg porosimetry. The adsorption experimental data points have been fitted to the Freundlich equation in order to calculate the adsorption capacities (K(f)) of the samples; K(f) values range from 468 mgkg(-1) for the K-110 sample up to 2291 mgkg(-1) for the K-600 sample. The values obtained for the removal efficiency (R), (percentage of pesticide removed), ranged from 48% for K-110 up to 78% for K-600. The adsorption experiments showed that the stronger heat treatment, the most effective adsorption of atrazine, so, as this type of clay is relatively plentiful, these activated samples might be used in order to remove this pesticide from water.     

The three-year monitoring of 18 elements in five edible mushroom species collected from an old orchard

Abstract

The content of Al, As, Be, Cd, Ca, Cr, Co, Cu, Fe, Pb, Li, Mg, Mn, Ni, Rb, Se, Sr, and Zn in fruiting bodies of edible mushrooms Calocybe gambosa, Entoloma clypeatum, Entoloma saepium, Xerocomellus chrysenteron, and Amanita rubescens growing in an orchard planted with fruit trees and situated close to a high-grown forest was studied during years 2016–2018. A. rubescens showed the highest potential of the element accumulation with bioconcentration factors of 48.5, 16.2, 7.80, 6.53, 1.75, and 1.68 obtained for Rb, Cd, Cu, Zn, Sr, and Mg, respectively. Both Entoloma species accumulated the elements similarly with bioconcentration factors >1.0 obtained for Rb, Cu, Cd, and Mg. Bioconcentration factors <0.05 were obtained for Al, Cr, Fe, and Pb in all studied species. The contents of beryllium (<0.1?mg/kg dry matter) were always the lowest among the studied elements. The contents of some elements of studied mushroom species significantly fluctuated over the years. Despite the fact that some studied elements (As, Be, Cd, Pb, Ni) are considerably toxic for humans, the pronounced effect on health is not expected if the studied mushroom species are consumed occasionally and do not represent the main component of the diet.     

Photocatalytic degradation of formaldehyde containing wastewater from veterinarian laboratories

The photocatalytic destruction of methanol, formaline (mixture of formaldehyde, methanol and water) and formaline wastes from the preservation of vertinarian physiologic samples has been attempted by two different processes, at high concentrations of reagents and by dossification of reagents, varying pH in both. Experiment evolution has been monitored by measuring the organic matter such as TOC and formaldehyde concentrations [H2CO]. Also, methanol and methanol-formaldehyde interactions with the TiO2 surface have been analysed by FTIR spectroscopy. Results indicate that at high concentrations the catalyst surfacial alterations given by methoxy, formates or carbonates, according to the pH of the sample can profoundly affect catalyst behaviour. It has been established that reagent dossification is advantageous for enhancing photonic efficiency as it minimizes the adsorbate presence that hampers the photocatalytic process.     

Vegetation of the selected forest stands and land use in the Carpathian Mountains

Within the framework of the project "Effects of forest health on biodiversity with emphasis on air pollution in the Carpathian Mountains" 26 permanent study sites were established in the vicinity of the ozone monitoring sites. The study sites were located on the NW-SE transect through the Western (12 sites), Eastern (11 sites) and Southern (3 sites) Carpathians in forest ecosystems typical of each area. Some of the forest monitoring sites were located in national parks, biosphere reserves and areas of protected landscape. Each permanent site of 0.7 ha area consisted of 5 small 500m(2) circular plots, arranged in the form of a cross, i.e. four placed on the cardinal points (N, E, S, W) and one in the center. Phytosociological records were done twice during the 1998 growing season using the Braun-Blanquet's method. The study sites represented various types of forest: Picea abies stands (8), beech (Fagus sylvatica) stands (10), fir (Abies alba) stands (2) and mixed beech-fir, spruce-fir and beech-spruce stands (6). Age of most stands was 80-100 years. Degree of crown damage varied greatly between sites, a percentage of damaged trees decrease in Carpathians from West to East. It corresponds well with the O(3) level in these areas. Typical damage by O(3) in herb layer species in several Carpathian sites were found. Land-use map for the entire Carpathian Mountains and two detailed land use maps for Tatras (Western Carpathians) and Retezat (Southern Carpathians) are presented. A little more than half of the Carpathian territory is forested. The most densely forested are Eastern Carpathians, while the most sparsely Western Carpathians. Arable lands occupy 22.6% of the Carpathians, pastures and meadows 6.2%, water bodies 1.9%, and build up areas several percent. In the highest elevation of the Carpathians alpine meadows (11.3%) and rocks (3.5%) are distributed.