Zinc phosphate granules in tissue surrounding the midgut of the barnacle Balanus balanoides

The chemical composition of inorganic granules found in parenchyma cells surrounding the midgut of adult Balanus balanoides (L.) was determined. X-ray microanalysis indicated the presence of magnesium, phosphorus, potassium, calcium, iron and zinc in the granules. A quantitative analysis of granule-rich pellets isolated from the midguts of adult barnacles showed that the granules were composed mainly of zinc phosphate, the remaining elements being minor constituents only.     

Carbon monoxide levels at a toll plaza near Durban, South Africa

Reliable measurements of pollutant levels in the vicinity of a toll plaza appear to be rare. In order to assess the exposure of toll booth operators to carbon monoxide, a continuous carbon monoxide monitor was installed at head height in the booth of a medium density traffic lane at the Mariannhill toll plaza, situated on a busy highway near Durban, South Africa. Measurements in excess of 500 ppmv were recorded and the high daily mean carbon monoxide concentrations may account for some of the symptoms such as headaches and general malaise that have been reported by workers in the booths. Generally, carbon monoxide levels recorded far exceed the recommended limit set by the South African authorities. These results have led to recommendations regarding the structure of new and existing toll booths to minimize the exposure of toll booth workers to adverse effects of vehicle-emitted pollutants.     

An empirical relationship between PM(2.5) and aerosol optical depth in Delhi Metropolitan

Atmospheric remote sensing offers a unique opportunity to compute indirect estimates of air quality, which are critically important for the management and surveillance of air quality in megacities of developing countries, particularly in India and China, which have experienced elevated concentration of air pollution but lack adequate spatial-temporal coverage of air pollution monitoring. This article examines the relationship between aerosol optical depth (AOD) estimated from satellite data at 5 km spatial resolution and the mass of fine particles ≤2.5 μm in aerodynamic diameter (PM(2.5)) monitored on the ground in Delhi Metropolitan where a series of environmental laws have been instituted in recent years.PM(2.5) monitored at 113 sites were collocated by time and space with the AOD computed using the data from Moderate Resolution Imaging Spectroradiometer (MODIS onboard the Terra satellite). MODIS data were acquired from NASA's Goddard Space Flight Center Earth Sciences Distributed Active Archive Center (DAAC). Our analysis shows a significant positive association between AOD and PM(2.5). After controlling for weather conditions, a 1% change in AOD explains 0.52±0.202% and 0.39±0.15% change in PM(2.5) monitored within ±45 and 150 min intervals of AOD data. This relationship will be used to estimate air quality surface for previous years, which will allow us to examine the time-space dynamics of air pollution in Delhi following recent air quality regulations, and to assess exposure to air pollution before and after the regulations and its impact on health.     

Methods for sampling and analysis of tropospheric ethanol in gaseous and aqueous phases

In this paper, we report on techniques for sampling and measuring ethanol in both the gas and aqueous phases of the lower troposphere. In the gas phase, the best sampling conditions were ensured by adsorption on Hayesep Q with a Chromosorb W AW coated with LiCl dryer (method 1) or by cryogenic trapping (method 2). An intercomparison campaign showed good agreement between both methods under various conditions. Method 1 (adsorption on Hayesep Q with dryer) is easier to set up and to carry away from the laboratory. Method 2 (cryogenic trapping) requires longer sampling time (up to 60 min while method 1 requires only 10-15 min). Method 1 is adapted to high concentrations of ethanol (>20 ppb) and low relative humidity (<30%). Method 2 gives more accurate results than method 1 for low ethanol concentrations (1-20 ppb). Comparing these results to previous studies, it is clear that sampling with appropriate solid adsorbents or with stainless steel canisters (with appropriate humidified air and short storage time) is adapted to urban or industrial environments where ethanol concentrations are high. Cryogenic sampling must be preferred for remote places where ethanol concentrations are low. Three techniques were tested for sampling ethanol in the liquid phase, namely solid phase microextraction, purge and trap injection, and direct injection. Among those, the latter was chosen for field measurements of ethanol in rain samples at an urban location. These first ever results at an urban location show concentrations ranging from <1 to 5 microM in rains, which agree with the expected range of concentrations. However, the purge and trap method showed detection limits that were 50 times lower and should be preferred for liquid phase ethanol measurements in rural and remote locations. Combining cryogenic trapping for the gas phase (method 2) and direct injection for the liquid phase is convenient and well adapted for a multiphase study of ethanol in the atmosphere, where simultaneous measurements in both phases are needed.     

Investigation of unrecognized former secondary lead smelting sites: confirmation by historical sources and elemental ratios in soil

Twelve suspected former secondary lead smelting sites were investigated. Ten of the sites were confirmed to be former secondary lead smelters or lead works by historical fire insurance maps and contemporaneous metal industry trade directories. At eight sites sampled, the ratio Sb:Pb was closer to ratios from 10 known lead smelting sites than were the As:Pb and Cd:Pb ratios. Data from the 10 known lead smelting sites showed that the Sb:Pb ratio is most characteristic of secondary lead smelting sites. This is because the primary alloy smelted at such sites is antimonial lead. Lead contamination at the eight sites investigated here can be attributed At least in part to the former smelters because of the association between Sb and Pb.     

Yield and Water Productivity of Winter Wheat under Various Irrigation Capacities

The Agricultural Production Systems sIMulator model validated in a prior study for winter wheat was used to simulate yield, aboveground crop biomass (BM), transpiration (T), and evapotranspiration under four irrigation capacities (ICs) (0, 1.7, 2.5, and 5 mm/day) with two nitrogen (N) application rates (N1, 94 kg N/ha; N2, 160 kg N/ha) to (1) understand the performance of winter wheat under different ICs and (2) develop crop water production function under various ICs and N rates. Evaluation was based on yield, aboveground crop BM, transpiration productivity (TP), crop water productivity (WP), and irrigation WP (IWP). Simulation results showed winter wheat yield increased with increase in N application rate and IC. However, the rate of yield increase gradually reduced with additional irrigation beyond 2.5 mm/day. A 5 mm/day IC required a total of 190 mm irrigation and produced a 5%–16% yield advantage over 2.5 mm/day. This indicates it is possible to reduce groundwater use for wheat by 50% incurring only 5%–16% yield loss relative to 5 mm/day. The TP and IWP for grain were slightly higher under IC of 1.7 mm/day (15.2–16.1 kg/ha/mm and 0.98–1.6 kg/m³) when compared to 5 mm/day (14.7–15.5 kg/ha/mm and 0.6–1.06 kg/m³), respectively. Since TP and IWPs are relatively higher under lower ICs, winter wheat could be a suitable crop under lower ICs in the region. Relationship between yield–T and yield–ET was linear with a slope of 15–16 and 9.5–10 kg/ha/mm, respectively. Editor's note : This paper is part of the featured series on Optimizing Ogallala Aquifer Water Use to Sustain Food Systems. See the February 2019 issue for the introduction and background to the series.     

Low paternity in the hornet Vespa crabro indicates that multiple mating by queens is derived in vespine wasps

Queen mating frequency was studied in the European hornet, Vespa crabro, by analyzing four DNA microsatellite loci in 20 workers from each of 14 nests. Queens were found to be predominantly singly mated (9/14), although double (4/14) and triple mating (1/14) also occurred. For most multiply mated queens, paternity was significantly biased with the majority male fathering on average 80% of the female offspring. The population-wide effective mating frequency was therefore low (1.11), and sister-sister relatedness high (0.701 ± 0.023 SE). Low effective mating frequency in Vespa, in combination with data from other vespines, suggests that high paternity frequency is derived in the group. Some problems with the non-detection of fathers, where the queen was not sampled or shared alleles with males, are analyzed. Received: 16 November 1998 / Received in revised form: 29 March 1999 / Accepted: 12 April 1999     

The influence of successional processes and disturbance on the structure of Tsuga canadensis forests

Old-growth forests are valuable sources of ecological, conservation, and management information, yet these ecosystems have received little study in New England, due in large part to their regional scarcity. To increase our understanding of the structures and processes common in these rare forests, we studied the abundance of downed coarse woody debris (CWD) and snags and live-tree size-class distributions in 16 old-growth hemlock forests in western Massachusetts. Old-growth stands were compared with eight adjacent second-growth hemlock forests to gain a better understanding of the structural differences between these two classes of forests resulting from contrasting histories. In addition, we used stand-level dendroecological reconstructions to investigate the linkages between disturbance history and old-growth forest structure using an information-theoretic model selection framework. Old-growth stands exhibit a much higher degree of structural complexity than second-growth forests. In particular, old-growth stands had larger overstory trees and greater volumes of downed coarse woody debris (135.2 vs. 33.2 m3/ha) and snags (21.2 vs. 10.7 m3/ha). Second-growth stands were characterized by either skewed unimodal or reverse-J shaped diameter distributions, while old-growth forests contained bell-shaped, skewed unimodal, rotated sigmoid, and reverse J-shaped distributions. The variation in structural attributes among old-growth stands, particularly the abundance of downed CWD, was closely related to disturbance history. In particular, old-growth stands experiencing moderate levels of canopy disturbance during the last century (1930s and 1980s) had greater accumulations of CWD, highlighting the importance of gap-scale disturbances in shaping the long-term development and structural characteristics of old-growth forests. These findings are important for the development of natural disturbance-based silvicultural systems that may be used to restore important forest characteristics lacking in New England second-growth stands by integrating structural legacies of disturbance (e.g., downed CWD) and resultant tree-size distribution patterns. This silvicultural approach would emulate the often episodic nature of CWD recruitment within old-growth forests.     

How regulations impact innovative environmental technologies: A recent case study

The White House Conference on Environmental Technology, held December 12–14, 1994, is the most recent of many events building toward a national environmental technology strategy, which President Clinton will announce on April 22, 1995, the 25th anniversary of Earth Day. Promoting innovation and eliminating barriers to new environmental technologies are important issues in developing this strategy. Anticipating these developments, EPA launched its own Technology Innovation Strategy in early 1994. EPA's strategy explicitly calls for strengthening incentives for technology innovation within regulatory, policy, and enforcement programs. In this light, it is worthwhile to look at a recent case study showing how regulations impact innovative environmental technologies, particularly because there appears to be a gathering political sentiment for deeper regulatory reform.     

Getting to Grips with Groundwater Pollution Protection in Developing Countries*

Although groundwater is widely and increasingly exploited for potable water-supply in developing countries the threat of groundwater pollution has, as yet, received little attention. Activities currently producing the principal risks are described in some detail. A basis for rapid assessment of the degree of groundwater pollution risk is proposed, based on the evaluation of, and the interaction between, pollutant loading and aquifer vulnerability. Protection zones around individual groundwater supply sources can generally play, at most, only a minor role in overall policy. The strategy proposed is aquifer-oriented and activity-related. The evaluation of aquifer pollution vulnerability, made in the rapid risk assessment and based on three semi-independent criteria, could be used to select the required protection measures in relation to specific land-use activities.