超重力技术治理火炸药行业氮氧化物的初步研究

火炸药行业排放氮氧化物(NOX)具有浓度高、排放点不集中和间歇排放的特点,采用超重力技术对尾气中高浓度的NOX进行湿法吸收.以清水为吸收剂,研究了进气量、液气比和超重力因子等因素对NOX吸收率的影响.结果表明,单级NOX吸收率可达64.69%(β＝90).超重力旋转填料床具有占地面积小、投资低和操作方便等优点,适宜于火炸药行业吸收NOX.     

铁屑去除酸法地浸采铀地下水中硝酸盐的试验研究

在酸法地浸采铀过程中,硝酸及硝酸盐的广泛使用使硝酸盐在地下不断累积并扩散到地下水中,这给矿区地下水造成了一定程度的污染.本试验以铁屑为还原剂,对该地下水中NO3--N的去除进行了批试验和动态试验研究.试验结果表明,铁屑可有效去除地下水中的NO3--N,其去除率随pH值的降低而逐渐升高;溶液中共存的Ca2 、Mg2 对NO3--N的去除影响不大,而SO42-、HCO3-的存在可明显降低NO3--N去除率;铁屑最佳投加量为120 g/L,铁炭最佳体积比为1∶1;二级柱可以明显提高柱子的稳定运行时间,在55 h内NO3--N去除率可保持在93%以上,去除效果较好.     

活性炭纤维对氯仿气体动态吸附的研究

为了探讨活性炭纤维(ACF)对氯仿有机废气的动态吸附,考察氯仿气体流速、浓度、温度、ACF再生次数对吸附效率的影响以及滤速和压降的关系。结果表明:低浓度、低流速、低温度均有利于吸附。ACF对氯仿的吸附以物理吸附为主。提高氯仿气体滤速,气体压降增大。     

N2O profiles in the enhanced CANON process via long-term N2H4 addition: minimized N2O production and the influence of exogenous N2H4 on N2O sources

Environmental Science and Pollution Research - Production of the greenhouse gas nitrous oxide (N2O) from the completely autotrophic nitrogen removal over nitrite (CANON) process is of growing...     

Development of an extraction method for perchlorate in soils

Perchlorate originates as a contaminant in the environment from its use in solid rocket fuels and munitions. The current US EPA methods for perchlorate determination via ion chromatography using conductivity detection do not include recommendations for the extraction of perchlorate from soil. This study evaluated and identified appropriate conditions for the extraction of perchlorate from clay loam, loamy sand, and sandy soils. Based on the results of this evaluation, soils should be extracted in a dry, ground (mortar and pestle) state with Milli-Q water in a 1 ratio 1 soil ratio water ratio and diluted no more than 5-fold before analysis. When sandy soils were extracted in this manner, the calculated method detection limit was 3.5 microg kg(-1). The findings of this study have aided in the establishment of a standardized extraction method for perchlorate in soil.     

The Metallic Composition of Aerosols at Three Monitoring Sites in Korea During Winter 2002

In the present study, the distribution patterns of various metals were analyzed and compared using PM samples collected concurrently from three monitoring sites located in Korea (Seoul, Busan, and Jeju island) in December 2002. As these sites can represent metal pollution with different degrees of anthropogenic activities, their concentration levels were distinguished in a systematic manner in the order of Jeju, Busan, and Seoul. By comparing the present data sets with those measured previously from other locations in Korea and around the world, we attempted to diagnose the general status of elemental pollution on the Korean peninsula. Through an application of different statistical approaches, the major processes controlling elemental levels were assessed for each of the three study sites. The results indicated the importance of both crustal and anthropogenic sources in all sites with their relative roles varying significantly from each other. The results of the metal analysis data, when examined in relation to back trajectory analysis, confirmed that their concentration changes are affected quite sensitively with air mass movement patterns. The overall results of this study consistently indicated the contribution of a strong anthropogenic source area (e.g., China) to the observed metal concentration levels in the study area, but the strengths of such signals vary considerably across the Korean peninsula.     

城市自来水中挥发性有机氯污染物检测及健康风险评价初步研究

水质安全是饮用水安全的重中之重,直接关系到人体健康。采用健康风险评价模式,对某市饮用水进行了分析和评价。研究结果表明,该市通过饮水途径引起的非致癌健康风险中四氯化碳最大,三氯甲烷次之,两者风险水平在10-5～10-6,远低于美国环境保护署推荐的最大可接受风险水平。通过饮水途径所致健康风险中,四氯乙烯所引起的致癌风险最大(1.2×10-8),但远远低于美国环境保护署推荐的通过饮水途径最大可接受风险水平(5×10-5)。根据美国环境保护署的推荐值,初步认为目前该市饮用水中挥发性有机污染物不会对人体产生明显的健康危害。     

Modeling of a combined ultraviolet-biofilter system to treat gaseous chlorobenzene I: model development and parametric sensitivity

A new type of a combined ultraviolet (UV)-biofilter system for air pollution control is developed. In this paper, two conceptual mathematical submodels of the UV reactor and standalone biofilter are developed. All model parameters have been determined by independent experiments or have been taken from literature. Results from UV and the standalone biofilter submodels are in a good agreement with experimental data. However, the performance of the combined system has significantly deviated from those of the UV or standalone submodels because of the stimulating effects of UV irradiation products on the subsequent biofilter performance. A modified model that considers the stimulating effects has agreed well with experimental data over a wide range of operating conditions. Further analysis of the primary parametric sensitivity of the model has shown that inlet chlorobenzene concentrations, gas empty-bed residence time in the UV reactor, and light intensity are important operating conditions.     

曝气强度对同时硝化反硝化（SND）脱氮过程中N2O排放的影响

为了控制污水脱氮中N2O排放,在不同曝气强度下研究了好氧硝化段同时硝化反硝化（SND）系统的N2O排放特性,并采用PCR—DGGE技术分析微生物群落特征。结果发现,随着曝气强度的增强,系统总氮去除率下降,但脱氮中N2O—N所占比例则上升,实验中从低到高3个曝气强度下,总氮去除率分别为80．01％、65．28％和58．62％,脱氮中N2O—N所占的比例为1．89％、7．84％和9．20％。PCR—DGGE分析显示,和低曝气强度下相比中、高曝气强度下系统微生物群落发生明显变化,但中曝气强度和高曝气强度下系统微生物群落表现出较高相似性。这表明,不同曝气强度下系统N2O排放受到氮素转化和微生物群落变化的影响。适宜曝气强度不仅提高总氮去除率,还可有效控制N2O排放。     

Investigation of titanium liquid/gas diffusion layers in proton exchange membrane electrolyzer cells

In a proton exchange membrane electrolyzer cell (PEMEC), liquid/gas diffusion layer (LGDL) is expected to transport electrons, heat, and reactants/products to and from the catalyst layer with minimum voltage, current, thermal, interfacial, and fluidic losses. In addition, carbon materials, which are typically used in PEM fuel cells (PEMFCs), are unsuitable in PEMECs due to the high ohmic potential and highly oxidative environment of the oxygen electrode. In this study, a set of titanium gas diffusion layers with different thicknesses and porosities are designed and examined coupled with the development of a robust titanium bipolar plate. It has been found that the performance of electrolyzer improves along with a decrease in thickness or porosity of the anode LGDL of titanium woven meshes. The ohmic resistance of anode LGDL and contact resistance between anode LGDL and the anode catalyst play dominant roles in electrolyzer performance, and better performance can be obtained by reducing ohmic resistance. Thin titanium LGDLs with straight-through pores and optimal pore morphologies are recommended for the future developments of low-cost LGDLs with minimum ohmic/transport losses.