Water quality test based on dielectrophoretic measurements of fresh water algae Selenastrum capricornutum

A method is described whereby dielectrophoresis of algal cells is used to perform rapid water quality analysis, specifically detecting the presence of CuSO4. The dielectric collection spectrum of the fresh water alga Selenastrum capricornutum was determined for a range of concentrations of CuSO4 from 25 mg L(-1) to 0.25 mg L(-1) for exposure times of 15 min and 18 h. In all cases increasing the concentration of CuSO4 reduced cell collection, but a step reduction was observed in collection between 2 mg L(-1) and 5 mg L(-1). This method has potential for forming a rapid, low-cost test for water quality with broad specificity and significantly reduced analysis time compared to current methods.     

Human plasma levels of POPs,and diet among native people from Uelen,Chukotka

Some of the people living in the Chukotka Peninsula of Russia depend heavily on marine mammals, but little is known of the exact dietary patterns and plasma levels of POPs among these populations. In this study, POPs levels in plasma from 50 participants from the isolated community of Uelen (Bering Strait) were determined and related to dietary information obtained through a food frequency questionnaire. The intake of marine mammals was high and the combined intake of blubber from walrus, seal and whale was a significant predictor (p < 0.01) of plasma concentrations of sum PCBs and borderline for sum CDs (p = 0.02) and sum DDTs (p = 0.04). There was a significant gender difference in the levels of POPs, and among women there was a significant increase with age. Extensive breastfeeding and lower blubber intake among women could be possible explanations for this gender difference. Despite the high intake of blubber the plasma levels of PCBs and DDTs were lower than some of those reported for the East Coast of Greenland. The geometric mean values for sum PCBs (17 congeners) and sum DDTs were 1316 ng g(-1) lipids and 563 ng g(-1) lipids, respectively. PCB 163, which partly co-eluted with PCB 138, was found in high concentrations (40% of PCB 138). This raises questions regarding the validity of using PCB 138 and PCB 153 to calculate the level of Arochlor 1260. The geometric mean of sum CDs was 518 ng g(-1) lipids. Concentrations of beta-HCH (geometric mean; 410 ng g(-1) lipids) were higher than observed for other native populations depending on marine mammals. Transportation of beta-HCH by ocean currents through the Bering Strait into the Arctic Ocean or regional point sources might explain these elevated levels.     

Integration of modeling,monitoring and laboratory observation to determine reasons for air quality violations

An attempt was made to explain ambient air quality violations in the vicinity of industrial plants. Micrometeorology, diffusion calculaations, ambient readings, and plant engineering data are all taken into consideration to ascertain whether the plant is or is not the principal offender.Scrutiny of hi-vol filters using scanning electron microscopy for particle size analysis and particle chemical make-up as an assessment technique is also described.Case histories using the above analytical techniques are discussed.Presented at the 16th National Conference on Energy and the Environment, May 23, 1979     

Further studies using X-ray fluorescence to sample lead contaminated carpeted surfaces

The sampling of carpeted surfaces to test for lead contamination primarily focuses upon vacuum techniques. Vacuum sampling techniques, however, require time-consuming, expensive laboratory analysis of the dusts obtained and are unable to determine total lead load on the carpet. X-ray fluorescence (XRF) analysis is an on-site, inexpensive, non-destructive, quick technique for predicting metals levels in a variety of media, such as water, soil, filter paper and painted surfaces. A 1992 study of the feasibility of XRF to analyze for lead and soil loadings on carpeted surfaces indicated that XRF can detect lead at a low enough level to warrant further study. This paper expands this earlier study and developes lead and soil loading calibration curves for three different carpet types based upon XRF lead L-beta peak areas and XRF iron and barium K-alpha peak and background areas. Results indicate that variation in the data can be reduced through modifications of the XRF analysis technique, thus reducing the statistically determined detection level, and that carpet type does affect the calibration. Detection levels of approximately 70 mg/m² for lead and 5 g/m² for soil were obtained. Overall, good agreement was found between results of this study and the earlier one. XRF shows excellent potential for quantitative analysis of lead on carpeted surfaces.     

Heavy metals in the SPM of air in the environment surrounding a ferro-alloy industrial plant in India

Prices for ferro-alloys have hardened due to the closure of plants in developed countries on account of increasingly stringent pollution control legislation, resulting in a higher cost of production. A ferro-alloy industry with a capacity of 80000 MT per annum was selected to study the nature of pollution. Because of the objectionable nature of polluting air in and around the plant it was located in a rural area where there was no other industry. The area was agriculturally active and there was no effective control system for this plant.The quality of ambient air around the plant site is discussed in this paper along with the meteorological conditions. The maximum concentration of suspended particulate matter (SPM) was 768 µg/NM³ downwind of the plant, minimum 184 µg/NM³, and the average was more than 446 µg/NM³. The presence of heavy metals, viz. Fe, Mn, Cr and Pb, was also assessed. The concentration of Fe was 50 µg/NM³ downwind and 10 µg/NM³ upwind. The concentration of other metals followed a similar trend.     

Patchy distributions: Optimising sample size

A method for estimating sample size which does not require an a priori definition of desired precision, or the assumption that the population is normally distributed with constant variance, has recently been proposed. This paper discusses this method and presents five modifications which make the method easier to use and reduce the probability of estimating a larger sample size than is actually required. The method is extended and used to estimate the mean abundance of patchily distributed benthic organisms. The technique can be used to guide the design of any environmental sampling programme, be it physical, chemical or biological, where comparisons between times and/or locations are required. Trade-offs between numbers of replicates and numbers of levels/sites are discussed.     

Monitoring of the three organophosphate esters TBP,TCEP and TBEP in river water and ground water (Oder,Germany)

The behaviour of the three organophosphate esters tributyl phosphate (TBP), tris(2-chloroethyl)phosphate (TCEP) and tris(2-butoxyethyl)phosphate (TBEP) during infiltration of river water to ground water has been investigated. The monitoring site is the Oder River and the adjacent Oderbruch aquifer. From March 2000 to July 2001, 76 ground water samples from monitoring wells located close to the Oder River and nine river water samples were collected. Additionally, influent and effluent samples from local waste water treatment plants, one sample of rain water and samples of roof runoff were collected. All samples were analysed by solid-phase-extraction followed by gas chromatography/mass spectrometry. TBP, TCEP and TBEP were detected at mean values of 622 ng l(-1), 352 ng l(-1), and 2955 ng l(-1), respectively in municipal waste water effluents. This points to a major input of these compounds into the Oder River by municipal waste water discharge. The concentrations of TBP and TBEP decreased downstream the Oder River possibly due to aerobic degradation. TBP, TCEP and TBEP were detected in ground water influenced predominantly by bank-filtered water. This demonstrates a transport of organic compounds by river water infiltration to ground water. TBP, TCEP and TBEP were also detected in rain water precipitation, roof runoff and ground water predominantly influenced by rain water infiltration. This hints to an input of these compounds to ground water by dry and wet deposition after atmospheric transport. Organophosphate esters were also detected in parts of the aquifer at 21 m depth. This demonstrates low anaerobic degradation rates of TBP, TCEP and TBEP.     

Distribution of polychlorinated biphenyls (PCBs) and organochlorine pesticides in soils from the East Antarctic coast

Concentrations of hexachlorobenzene (HCB), alpha-, beta- and gamma-hexachlorocyclohexane (HCH) isomers, 6 o,p'-and p,p'-isomers of DDT and 28 PCB congeners have been measured in eleven soil samples and one lichen collected on the Eastern coast of Antarctica from 5 Russian stations. For samples with low concentrations of PCBs (range 0.20-0.41 ng g(-1) dry weight) and pesticides (0.86-4.69 ng g(-1) and 0.11-1.22 ng g(-1) dry weight for HCHs and DDTs, respectively), atmospheric long-range transport from Africa, South America or Australia was suggested as the sole source of contamination. The profile of PCB congeners was dominated by the more volatile tri-, tetra- and penta-PCBs congeners, thus supporting long-range transport hypothesis. Four samples contained moderate levels of PCBs (range 1.98-6.94 ng g(-1) dry weight) and variable concentrations of pesticides (gamma-HCH, p,p'-DDT and o,p'-DDT being the main contaminants). For samples with high concentrations of PCBs (range 90.26-157.45 ng g(-1)) and high concentrations of pesticides, the presence of high molecular weight PCB congeners such as: 153, 180, 187, 170 etc, strongly suggest a local source (biotic) of PCBs rather than atmospheric transport. It is likely that on a local scale, biotic focussing of pollutants, due to bird activities (nesting and excrement) can cause high contamination levels and become more significant than contaminant input via abiotic pathways.     

Application of PCR and probe hybridization techniques in detection of airborne fungal spores in environmental samples

Specific PCR amplification and probe hybridization techniques were applied to examine the compositions of airborne fungi in samples from three different environments. The results from microscopic and CFU counting were compared to those of the molecular-based detections. The detection sensitivity for PCR amplifications was 9 to 73 spores and 1.3 to 19.3 CFUs per PCR reaction. The hybridization detection limit was 2 to 4 spores and 0.2 to 1.2 CFU. The hybridization method was more sensitive than PCR amplification and showed less variation among samples. Using specific PCR primers and probes we identified the presence of several fungal groups and species in the air samples. Specific detections through probe hybridization to PCR products amplified with universal or group-specific fungal primers have promising applications in the examination of air samples for environmental monitoring.     

Partitioning of mercury onto suspended sediments in estuaries

Radiochemical partitioning experiments using 203Hg have been undertaken with mixtures of river, seawater and sediment samples taken from three geochemically contrasting UK estuaries: the Plym, Beaulieu and Mersey. Species of dissolved Hg were determined using reversed-phase C18 chelating columns and particulate species were determined by sequential leaching with 1 M NH4OAc and 1 M HCl. Mercury had a high particle reactivity with partition coefficients, KDs, ranging from 10(4) to 5 x 10(5) ml g(-1), depending on salinity, the chemical composition of the end-member waters, and on the physico-chemical characteristics of the sediment. Dissolved organic matter present in the waters (humic substances and/or anthropogenic compounds) was found to be the main factor governing the forms of dissolved Hg and their reactivity. From the spiked 203Hg, up to 95% of the dissolved metal was retained on the C18 columns for the Mersey waters, whereas this fraction was < 60% in the Plym and Beaulieu waters. Quasi-irreversible adsorption of Hg onto particles from each estuary was observed over a time-scale of a few hours and < 20% of total particulate Hg was released by the sequential leach. In this paper, physico-chemical processes are proposed to explain the estuarine behaviour of Hg and the results are discussed in terms of Hg availability in estuarine systems.