Determination of the utility of groundwater with respect to the geochemical parameters: a case study from Tuticorin District of Tamil Nadu (India)

In modern living, rapid development has created an increase in demand for groundwater. An endeavor has been made to understand the hydrogeochemical parameters to determine the utility of groundwater. This situation is severe in coastal hard rock aquifers due to the influence of salinity ingression and other anthropogenic influence. A total of 135 groundwater samples were collected from the coastal aquifer of the Tuticorin district and analyzed for major cations and anions during premonsoon (PRM) and postmonsoon (POM). The ions analyzed were used to determine the drinking, agricultural and domestic utility of groundwater. The electrical conductivity (EC) contour shows that the groundwater quality is poor along the coast. The parameters were compared with WHO (Guidelines for drinking water quality recommendations, WHO, Geneva, 2004) standard for drinking purpose. A groundwater classification method has been developed for groundwater in the area using a dynamic water quality index (WQI). On the basis of the WQI so computed, groundwater in the area has been spatially classified into “excellent,” “good,” “poor” and “very poor” to “Unsuitable” water types variation lithologywise. Corrosivity ratio and hardness were noted to be higher and found to be unsuitable in majority of the regions for domestic purpose. Higher fluoride concentration was noted in the central part of the study area represented by complex geology comprising of the hornblende biotite gneiss and charnockite. Sodium percentage (Na%), sodium absorption ratio, residual sodium carbonate, Wilcox (Classification and use of irrigation waters, US Department of Agriculture, Washington, 1955), permeability index, residual sodium bicarbonate, magnesium hazard, Kelly’s ratio and potential salinity also indicate that most of the groundwater samples are not suitable for irrigation purposes.     

The structure of bumblebee communities (Hymenoptera,Apidae, Bombus spp.) in some ecosystems of Kunashir Island and Southern Sakhalin (Russian Far East)

The structure of bumblebee communities has been studied in some ecosystems of Kunashir Island and Southern Sakhalin. The island taxocenes include five to eight bumblebee species. Bombus hypnorum is dominant in the majority of habitats. In geothermal areas near hot springs on Kunashir, the families of this species develop more rapidly than in areas without geothermal heating.     

The holocene dynamics of vegetation and environmental conditions on the eastern slope of the Northern Urals

Consideration is given to changes in the vegetation and climatic conditions on the eastern slope of the Northern Urals in the second half of the Holocene as reconstructed on the basis of integrated palynological, botanical, paleocarpological, and radiocarbon analysis of material from a peat bog section in the floodplain of the Loz’va River. The results show that the northern taiga zone of the study region in the period between approximately 5000 and 700 years BP was occupied by forests of southern taiga facies, as the climate was significantly warmer than it is today.     

On monitoring anthropogenic airborne uranium concentrations and (235)U/(238)U isotopic ratio by Lichen - bio-indicator technique

Lichens are widely used to assess the atmospheric pollution by heavy metals and radionuclides. However, few studies are available in publications on using lichens to qualitatively assess the atmospheric pollution levels. The paper presents research results applying epiphytic lichens as bio-monitors of quantitative atmospheric contamination with uranium. The observations were conducted during 2.5 years in the natural environment. Two experimental sites were used: one in the vicinity of a uranium contamination source, the other one - at a sufficient distance away to represent the background conditions. Air and lichens were sampled at both sites monthly. Epiphytic lichens Hypogimnia physodes were used as bio-indicators. Lichen samples were taken from various trees at about 1.5m from the ground. Air was sampled with filters at sampling stations. The uranium content in lichen and air samples as well as isotopic mass ratios (235)U/(238)U were measured by mass-spectrometer technique after uranium pre-extraction. Measured content of uranium were 1.45 mgkg(-1) in lichen at 2.09 E-04 microgm(-3) in air and 0.106 mgkg(-1) in lichen at 1.13 E-05 microgm(-3) in air. The relationship of the uranium content in atmosphere and that in lichens was determined, C(AIR)=exp(1.1 x C(LICHEN)-12). The possibility of separate identification of natural and man-made uranium in lichens was demonstrated in principle.     

Fibre crops as alternative land use for radioactively contaminated arable land

The transfer of radiocaesium, one of the most important and widespread contaminants following a nuclear accident, to the fibre crops hemp (Cannabis sativa L.) and flax (Linum usitatissimum L.) as well as the distribution of radiocaesium during crop conversion were studied for sandy soil under greenhouse and lysimeters conditions. Soil parameters did not unequivoqually explain the transfer factors (TF) observed. TFs to flax stems ranged from 1.34 to 2.80x10(-3) m2 kg(-1). TFs to seeds are about a factor of 4 lower. During the retting process for separating the fibres from the straw, more than 95% of the activity was removed with the retting water. For hemp, the TF to the stem was about 0.6x10(-3) m2 kg(-1). For hemp, straw and fibres were mechanically separated and TF to straw was about 0.5x10(-3) m2 kg(-1) and to fibres 1.0x10(-3) m2 kg(-1). Generally, the TFs to the useable plant parts both for hemp and flax, are low enough to allow for the production of clean end-products (fibre, seed oil, biofuel) even on heavily contaminated land. Given the considerable decontamination during retting, contamination levels in flax fibres would only exceed the exemption limits for fibre use after production in extreme contamination scenarios (>12,300kBq m(-2)). Since hemp fibres are mechanically separated, use of hemp fibres is more restricted (contamination <740kBq m(-2)). Use of stems as biofuel is restricted to areas with contamination levels of <250 and 1050kBq m(-2) for flax and hemp, respectively. Use of seeds for edible oil production and flour is possible almost without restriction for flax but due to the high TFs to seed observed for hemp (up to 3x10(-3) m2 kg(-1)) consumption of hemp seed products should be considered with care.     

Yield and arsenate uptake of arbuscular mycorrhizal tomato colonized by Glomus mosseae BEG167 in As spiked soil under glasshouse conditions

A glasshouse pot experiment was conducted to study the effect of arbuscular mycorrhizal (AM) colonization by Glomus mosseae BEG167 on the yield and arsenate uptake of tomato plants in soil experimentally contaminated with five As levels (0, 25, 50, 75 and 150 mg kg(-1)). Mycorrhizal colonization (50-70% of root length) was little affected by As application and declined only in soil amended with 150 mg As kg(-1). Mycorrhizal colonization increased plant biomass at As application rates of 25, 50 and 75 mg kg(-1). Shoot As concentration increased with increasing As addition up to 50 mg kg(-1) but decreased with mycorrhizal colonization at As addition rates of 75 and 150 mg kg(-1). Shoot As uptake increased with mycorrhizal colonization at most As addition levels studied, but tended to decrease with addition of 150 mg As kg(-1). Total P uptake by mycorrhizal plants was elevated at As rates of 25, 50 and 75 mg kg(-1), and more P was allocated to the roots of mycorrhizal plants. Mycorrhizal plants had higher shoot and root P/As ratios at higher As application rates than did non-mycorrhizal controls. The soil of inoculated treatments had higher available As than uninoculated controls, and higher pH values at As addition levels of 25, 50 and 75 mg kg(-1). Mycorrhizal colonization may have increased plant resistance to potential As toxicity at the highest level of As contamination studied. Mycorrhizal tomato plants may have potential for phytoextraction of As from moderately contaminated soils or phytostabilization of more highly polluted sites.     

Use of contaminated well water, example reference biospheres 1 and 2A

The BIOMASS programme's Theme 1 evaluated a number of scenarios, which assisted in the development of practical guidance. A total of four Example Reference Biospheres were fully developed, with the assumptions, data, and models thoroughly documented. These Examples display both the practicality and the transparency available through the use of the Reference Biosphere Methodology. While the methodology is designed to promote transparency and traceability, proper documentation and justification is still the responsibility of the user. The Examples can also be used as generic analyses in some situations. Although it is anticipated that each of the Reference Biospheres explored within BIOMASS Theme 1 should be a useful practical example, the quantitative results of the model calculations are not intended to be understood as prescribed biosphere 'conversion factors'. In choosing to implement an Example, careful consideration would need to be given to their relevance (including associated data) to the particular assessment context at hand. In general, the more complex the model is, the more limited applicability it has for generic purposes. For example, ERB1A (direct use of well water for drinking) can be used straightforwardly, with minor or no adjustments, at a number of generic sites. Example 2A, however, for which climatic conditions and agricultural practices need to be specified, would need to be implemented for each specific situation.     

Deposition rates of unattached and attached radon progeny in room with turbulent airflow and ventilation

In this paper deposition rate coefficients for unattached and attached radon progeny were estimated according to a particle deposition model for turbulent indoor airflow described by Zhao and Wu [2006. Modeling particle deposition from fully developed turbulent flow in ventilation duct. Atmos. Environ. 40, 457–466]. The parameter which characterizes turbulent indoor airflow in this model is friction velocity, u*. Indoor ventilation changes indoor airflow and friction velocity and influences deposition rate coefficients. Correlation between deposition and ventilation rate coefficients in the room was determined. It was shown that deposition rate coefficient increases with ventilation rate coefficient and that these parameters of the Jacobi room model cannot be assumed to be independent. The values of deposition rate coefficients were presented as functions of friction velocity and ventilation rate coefficient. If ventilation rate coefficient varies from 0.1 up to 1 h⁻¹, deposition rate coefficients for unattached and attached fractions were estimated to be in the range 3–110 h⁻¹ and 0.015–0.35 h⁻¹, respectively.