Co3O4/介孔分子筛催化剂对苯催化完全氧化的研究

分别以介孔分子筛MCM-41、MCM-48、SBA-15为载体,采用等体积浸渍法制备了氧化钴/介孔分子筛催化剂,利用N₂吸附、X射线衍射、程序升温还原等技术对催化剂进行了表征,考察了Co₃O₄的负载量及载体的孔结构对催化剂完全催化氧化苯的性能的影响。结果表明,Co₃O₄的负载量为20%时,催化剂的催化活性最好;载体的孔径和催化剂的可还原性能是影响催化活性的主要因素,催化剂活性顺序为Co₃O₄ /SBA-15> Co₃O₄ /MCM41> Co₃O₄ /MCM-48。     

耐热乳杆菌的分离及在食物垃圾乳酸发酵中的应用

食物垃圾在我国城市生活垃圾中占有较大比重.发酵食物垃圾生产乳酸是实现其资源化的有效方法.从厌氧发酵的食物垃圾中分离到一株耐热乳酸菌TY50,根据形态、生理生化特征和16S rDNA序列,确定该菌株属于乳杆菌属的干酪乳杆菌组群(Lactobacillus casei group),其最高生长温度为52℃.TY50发酵食物垃圾生产乳酸的最佳同液比为1:12,最适温度为45 ℃.在pH 5.5～6.0条件下,发酵食物垃圾产生36.29 g/L的乳酸,乳酸体积产牢和转化率(乳峻/垃圾干重)分别达到1.01 g/(L·h)和0.44.     

由粉煤灰合成单一的沸石及其对Cr(Ⅵ)的吸附研究

以粉煤厌为原料采用两步法合成了2种单一沸石矿物种的NaA和NaX型沸石,并对产物的结构和性能进行了详细表征.2种沸石产物的吸附性能比较结果表明,NaA型沸石优于NaX型沸石.在静态吸附条件下,研究了NaA型沸石吸附水溶液中Cr(Ⅵ)的相关参数(溶液pH值、吸附温度和吸附时间),并用Langmuir和Freundlich等温吸附线对吸附结果进行拟和.结果表明:Cr(Ⅵ)的吸附行为符合Langmuir方程;饱和吸附量为47.78 mg/g.NaA型沸石对Cr(Ⅵ)的吸附是物理和化学吸附两种行为共同作用的结果.     

Assessment of population exposure to particulate matter pollution in Chongqing, China

To determine the population exposure to PM(10) in Chongqing, China, we developed an indirect model by combining information on the time activity patterns of various demographic subgroups with estimates of the PM(10) concentrations in different microenvironments (MEs). The spatial and temporal variations of the exposure to PM(10) were illustrated in a geographical information system (GIS). The population weighted exposure (PWE) for the entire population was 229, 155 and 211 microg/m(3), respectively, in winter, summer and as the annual average. Indoor PM(10) level at home was the largest contributor to the PWE, especially for the rural areas where high pollution levels were found due to solid fuels burning. Elder people had higher PM(10) exposure than adults and youth, due to more time spent in indoor MEs. The highest health risk due to particulate was found in the city zone and northeast regions, suggesting that pollution abatement should be prioritized in these areas.     

A strategy for aromatic hydrocarbon bioremediation under anaerobic conditions and the impacts of ethanol: a microcosm study

Increased use of ethanol-blended gasoline (gasohol) and its potential release into the subsurface have spurred interest in studying the biodegradation of and interactions between ethanol and gasoline components such as benzene, toluene, ethylbenzene and xylene isomers (BTEX) in groundwater plumes. The preferred substrate status and the high biological oxygen demand (BOD) posed by ethanol and its biodegradation products suggests that anaerobic electron acceptors (EAs) will be required to support in situ bioremediation of BTEX. To develop a strategy for aromatic hydrocarbon bioremediation and to understand the impacts of ethanol on BTEX biodegradation under strictly anaerobic conditions, a microcosm experiment was conducted using pristine aquifer sand and groundwater obtained from Canadian Forces Base Borden, Canada. The initial electron accepter pool included nitrate, sulfate and/or ferric iron. The microcosms typically contained 400 g of sediment, 600 approximately 800 ml of groundwater, and with differing EAs added, and were run under anaerobic conditions. Ethanol was added to some at concentrations of 500 and 5000 mg/L. Trends for biodegradation of aromatic hydrocarbons for the Borden aquifer material were first developed in the absence of ethanol, The results showed that indigenous microorganisms could degrade all aromatic hydrocarbons (BTEX and trimethylbenzene isomers-TMB) under nitrate- and ferric iron-combined conditions, but not under sulfate-reducing conditions. Toluene, ethylbenzene and m/p-xylene were biodegraded under denitrifying conditions. However, the persistence of benzene indicated that enhancing denitrification alone was insufficient. Both benzene and o-xylene biodegraded significantly under iron-reducing conditions, but only after denitrification had removed other aromatics. For the trimethylbenzene isomers, 1,3,5-TMB biodegradation was found under denitrifying and then iron-reducing conditions. Biodegradation of 1,2,3-TMB or 1,2,4-TMB was slower under iron-reducing conditions. This study suggests that addition of excess ferric iron combined with limited nitrate has promise for in situ bioremediation of BTEX and TMB in the Borden aquifer and possibly for other sites contaminated by hydrocarbons. This study is the first to report 1,2,3-TMB biodegradation under strictly anaerobic condition. With the addition of 500 mg/L ethanol but without EA addition, ethanol and its main intermediate, acetate, were quickly biodegraded within 41 d with methane as a major product. Ethanol initially present at 5000 mg/L without EA addition declined slowly with the persistence of unidentified volatile fatty acids, likely propionate and butyrate, but less methane. In contrast, all ethanol disappeared with repeated additions of either nitrate or ferric iron, but acetate and unidentified intermediates persisted under iron-enhanced conditions. With the addition of 500 mg/L ethanol and nitrate, only minor toluene biodegradation was observed under denitrifying conditions and only after ethanol and acetate were utilized. The higher ethanol concentration (5000 mg/L) essentially shut down BTEX biodegradation likely due to high EA demand provided by ethanol and its intermediates. The negative findings for anaerobic BTEX biodegradation in the presence of ethanol and/or its biodegradation products are in contrast to recent research reported by Da Silva et al. [Da Silva, M.L.B., Ruiz-Aguilar, G.M.L., Alvarez, P.J.J., 2005. Enhanced anaerobic biodegradation of BTEX-ethanol mixtures in aquifer columns amended with sulfate, chelated ferric iron or nitrate. Biodegradation. 16, 105-114]. Our results suggest that the apparent conservation of high residual labile carbon as biodegradation products such as acetate makes natural attenuation of aromatics less effective, and makes subsequent addition of EAs to promote in situ BTEX biodegradation problematic.     

Design of a novel non-equilibrium plasma-based water treatment reactor

A novel non-equilibrium plasma-based water treatment reactor consisting of high voltage multi-needle electrode submerged in aqueous phase and reticulated ground electrode suspended in gas phase above water was developed and applied to treat low concentrations of methyl orange (MO). The electrode configuration was optimized. Higher number and more uniform distribution of streamers were produced in gas phase when parallel five-needle configuration with needle spacing of 10mm for high voltage electrode, macroporous ground electrode with mesh size of 0.42mm, and electrode gap of 17mm were adopted. This case corresponds to the largest amount of hydrogen peroxide and ozone produced in aqueous phase and gas phase, respectively, and air flow rate presents an economical value. The injection of wastewater above ground electrode for pretreatment and the design of fixed mesh barriers further increase the amount of ozone dissolved in aqueous solution. The conversion of MO presents a positive correlation with input voltage and the increase of pulse repetition rate is conducive for the conversion. In addition, the effect of initial solution concentration and treating volume on the conversion, energy yield and COD removal was evaluated.     

Changes of organic acid exudation and rhizosphere pH in rice plants under chromium stress.

The effect of chromium (Cr) stress on the changes of rhizosphere pH, organic acid exudation, and Cr accumulation in plants was studied using two rice genotypes differing in grain Cr accumulation. The results showed that rhizosphere pH increased with increasing level of Cr in the culture solution and with an extended time of Cr exposure. Among the six organic acids examined in this experiment, oxalic and malic acid contents were relatively higher, and had a significant positive correlation with the rhizosphere pH, indicating that they play an important role in changing rhizosphere pH. The Cr content in roots was significantly higher than that in stems and leaves. Cr accumulation in plants was significantly and positively correlated with rhizosphere pH, and the exudation of oxalic, malic and citric acids, suggesting that an increase in rhizosphere pH, and exudation of oxalic, malic and citric acid enhances Cr accumulation in rice plants.     

Surface functional characteristics (C, O, S) of waste tire-derived carbon black before and after steam activation

The effects of steam activation on the surface functional characteristics of waste tire-derived carbon black were investigated. Two carbon-based materials, powdered carbon black (PCB) and PCB-derived powdered activated carbon (PCB-PAC), were selected for this study. A stainless steel tubular oven was used to activate the PCB at an activation temperature of 900 degrees C and 1 atm using steam as an activating reagent. X-ray photoelectron spectroscopy (XPS) was adopted to measure the surface composition and chemical structure of carbon surface. Various elemental spectra (C, O, and S) of each carbon sample were further deconvoluted by peak synthesis. Results showed that the surfaces of PCB and PCB-PAC consisted mainly of C-C and C-O. The PCB-PAC surface had a higher percentage of oxygenated functional groups (C=O and O-C=O) than PCB. The O1s spectra show that the oxygen detected on the PCB surface was mainly bonded to carbon (C-O), whereas the oxygen on the PCB-PAC surface could be bonded to hydrogen (O-H) and carbon (C-O). Sulfur on the surface of PCB consisted of 58.9 wt% zinc sulfide (ZnS) and 41.1 wt% S=C=S, whereas that on the surfaces of PCB-PAC consisted mainly of S=C=S. Furthermore, the increase of oxygen content from 9.6% (PCB) to 11.9% (PCB-PAC) resulted in the increase of the pH values of PCB-PAC after steam activation.     

Heavy metal leaching from coal fly ash amended container substrates during Syngonium production

Coal fly ash has been proposed to be an alternative to lime amendment and a nutrient source of container substrates for ornamental plant production. A great concern over this proposed beneficial use, however, is the potential contamination of surface and ground water by heavy metals. In this study, three fly ashes collected from Florida, Michigan, and North Carolina and a commercial dolomite were amended in a basal substrate. The formulated substrates were used to produce Syngonium podophyllum Schott 'Berry Allusion' in 15-cm diameter containers in a shaded greenhouse. Leachates from the containers were collected during the entire six months of plant production and analyzed for heavy metal concentrations. There were no detectable As, Cr, Hg, Pb, and Se in the leachates; Cd and Mo were only detected in few leachate samples. The metals constantly detected were Cu, Mn, Ni, and Zn. The total amounts of Cu, Mn, Ni, and Zn leached during the six-month production period were 95, 210, 44, and 337 microg per container, indicating that such amounts in leachates may contribute little to contamination of surface and ground water. In addition, plant growth indices and fresh and dry weights of S. podophyllum 'Berry Allusion' produced from fly ash and dolomite-amended substrates were comparable except for the plants produced from the substrate amended with fly ash collected from Michigan which had reduced growth indices and fresh and dry weights. Thus, selected fly ashes can be alternatives to commercial dolomites as amendments to container substrates for ornamental plant production. The use of fly ashes as container substrate amendments should represent a new market for the beneficial use of this coal combustion byproduct.     

Different reaction mechanisms of diphenylether and 4-bromodiphenylether with nitrous acid in the 355 nm laser flash photolysis of mixed aqueous solution

The microscopic reaction mechanisms of diphenylether (DPE) and 4-bromodiphenylether (4-BrDPE) with nitrous acid (HNO(2)) in the absence of O(2) have been explored by the 355nm laser flash photolysis. It was proposed that OH radical, from the photolysis of HNO(2), added to DPE forms the C(12)H(10)O-OH adduct while added to 4-BrDPE forms the 4-BrDPE-OH and 4-BrOH-DPE adducts. The first-order decay rate constants of the C(12)H(10)O-OH adduct, 4-BrDPE-OH adduct and 4-BrOH-DPE adduct were measured to be (1.86+/-0.14)x10(5)s(-1), (2.19+/-0.04)x10(5)s(-1) and (1.56+/-0.03)x10(5)s(-1), respectively. The final photolysis products of DPE and HNO(2) identified by GC/MS analysis were phenol, o-hydroxydiphenylether, p-hydroxydiphenylether and p-nitrodiphenylether, while the final photolysis product of 4-BrDPE and HNO(2) identified by LC/MS analysis was mainly the dimer.