超声波-膜生物法联合处理垃圾焚烧厂渗滤液

采用超声波-膜生物法(MBR)联合处理垃圾渗滤液,探讨了超声波辐射时间和MBR的水力负荷对COD、NH3-N和TP去除的影响。结果表明,(1)超声波单独处理时,超声波辐射时间在30～90 s时,COD、NH3-N最大增加率分别34.31%、3.36%,而对TP的去除没有影响;(2)超声波-膜生物(MBR)联合处理时,超声波辐射时间为300 s,MBR的水力负荷为6.4 L/(m2.d)时,COD、NH3-N和TP的最佳去除率分别为92.20%、80.10%和91.12%;MBR的水力负荷为12.8 L/(m2.d),超声波辐射时间在5～20 min时,COD、NH3-N的最佳去除率分别为92.34%、79.93%,TP的浓度低于0.2 mg/L;MBR反应时间为7 h,超声波辐射时间为5～20 min,与未进行超声波辐射处理(超声波辐射时间为0 min)相比,COD、NH3-N的去除率增加了11.37%、15.26%;超声波预处理有助于提高后续MBR对COD、NH3-N的去除作用。     

铅锌矿尾矿制备陶粒处理选矿废水

以铅锌矿浮选尾矿为原料,水玻璃和木质素作为添加剂,通过高温焙烧,制备水处理陶粒,并用其对选矿废水进行了吸附处理实验研究。实验结果表明,在不添加任何添加剂的条件下,800℃左右烧制的陶粒对选矿废水的COD吸附效果较好,COD去除率达到87.1%;当木质素+水玻璃作为粘结剂烧制陶粒时,不仅陶粒散落减少,COD的去除率和吸附容量都有所增加,COD去除率达到了88.21%,从而达到了"以废治废"的目的。     

温度对亚硝化及氧化亚氮释放的影响

采用批次实验的方法探讨了3种不同温度(15℃,25℃,35℃)对亚硝化及其过程中温室气体氧化亚氮释放情况。结果表明,温度对亚硝化过程及氧化亚氮的释放有显著影响。在15～35℃范围内,随着温度的升高,氨氧化率和亚硝化积累率逐渐升高,N2O释放量也逐渐增大,35℃可以作为适宜的亚硝化温度,平均氨氧化率为50.9%,亚硝化积累率为55.6%,NO2--N与NH4+-N出水浓度比为1.1,氨氧化率,亚硝化积累率和出水中亚硝氮与氨氮浓度比较合适,从而可以为厌氧氨氧化工艺提供合适的进水,但在此温度下平均N2O释放量相对较高,为1.494μg/g MLSS。     

厌氧后猪场废水资源化制备微生物絮凝剂

通过检测碳源、氮源、磷酸盐和pH等对微生物絮凝剂絮凝率的影响,考察了红平红球菌利用厌氧处理后的猪场废水生产微生物絮凝剂的性能。通过正交实验研究各因素对絮凝率的交互影响以及影响程度的相对大小,从而确定了最佳培养基。结果表明,1.0 L厌氧处理后的猪场废水中加入蔗糖10.0 g、KH2PO42.0 g、K2HPO45.0 g、NaCl 1.0 g、Mg-SO40.2 g,在温度30℃、摇床速度120 r/min、pH=8的条件下发酵72 h后,发酵液的絮凝率可达到92.57%。表明厌氧处理后的猪场废水中加入适量的蔗糖和磷酸盐,完全可以作为一种有效的生产微生物絮凝剂的培养基。     

PCF型湿式脱硫除尘器入口结构优化

以PCF型湿式脱硫除尘器为物理模型,利用Fluent软件包,采用RNGк-ε湍流模型和SIMPLEC算法,对装置内三维流场进行数值模拟.模拟结果发现,原倾斜入口(A)的装置内烟气分布不均匀.提出了水平入口(B)、左入口(C)、右入口(D)3种优化结构,并分别对A、B、C、D入口装置内气流速度、湍流强度与压降进行了模拟分析.结果表明,C、D入口使装置内气流速度分布更加均匀,且增强了装置内湍流强度,但C入口会导致压降增加,因此最佳入口为D.最后,针对入口D装置中的低速区,模拟分析了30°、45°与54°3种不同切入角度,得出45 °效果最佳.     

纳污水体中好氧脱氮菌的筛选与氨氮去除特性

采用异养硝化培养基从城市纳污水体中富集好氧脱氮菌,将得到的富集菌种分离纯化,得到1株好氧脱氮菌NC1,对氨氮的去除率为72.6%;好氧菌株NC1繁殖较快,生长3~4 h即进入对数生长期,有一定实用意义。考察了在不同条件下菌NC1对氨氮的去除效果,发现当pH为6~9之间、转速超过100 r/min、温度为30℃、碳氮比为6~12时对氨氮的去除效果较好。NC1在去除氨氮过程中pH值升高,且能在异养条件下利用亚硝酸盐和硝酸盐生长。     

添加剂对烟气脱硫的强化作用

采用鼓泡式烟气脱硫反应装置,研究了己二酸、硫酸镁、无机盐A和无机盐B等4种添加剂的脱硫强化作用。实验结果表明:4种添加剂均能较明显地提高脱硫浆液的脱硫率,且添加无机盐A和无机盐B的脱硫效果更好;随着添加剂加入量的增加,脱硫率逐渐提高,综合考虑,本实验适宜的添加剂加入量为1.0 g/L。现场实际应用中加入质量比为1∶1的无机盐A和无机盐B作为复合添加剂,在使用2台循环泵、烟气流量约1 020 km3/h、初始SO2质量浓度由2 981 mg/Nm3增加至约3 843 mg/Nm3的条件下,脱硫率仍由81.79%提高到89.92%。     

Influence of the composition and removal characteristics of organic matter on heavy metal distribution in compost leachates

Compost leachates were collected to investigate the influence of the composition and removal of volatile fatty acids (VFAs), humic-like substances (HSs), and dissolved organic nitrogen (DON) on heavy metal distribution during the leachate treatment process. The results showed that acetic and propionic acids accounted for 81.3 to 93.84 % of VFAs, and that these acids were removed by the anaerobic-aerobic process. Humic- and fulvic-like substances were detected by excitation–emission matrix spectroscopy coupled with parallel factor analysis, and their content significantly decreased after the anaerobic and membrane treatments. DON in compost leachates ranged from 26.53 mg L^-1 to 919.46 mg L^-1, comprised of dissolved free amino acids and the protein-like matter bound to humic- and fulvic-like substances, and was removed by the aerobic process. Correlation analysis showed that Mn, Ni, and Pb were bound to VFAs and protein-, fulvic-, and humic-like substances in the leachates. Co was primarily bound to fulvic- and humic-like matter and inorganic sulfurs, whereas Cu, Zn, and Cd interacted with inorganic sulfur.     

乙醇溶析结晶法从白炭黑废母液中回收硫酸钠

以乙醇为溶析剂,通过过滤—中和—蒸馏浓缩—溶析结晶等工序,从白炭黑废母液中回收硫酸钠。考察了硫酸钠回收效果的影响因素,并进行了热能消耗和处理成本的分析。实验结果表明：乙醇的加入量对硫酸钠溶解度和蒸馏浓缩过程有着显著影响;在蒸馏醇水比（乙醇与中性废母液的体积比）为0.27,浓缩废母液中硫酸钠质量浓度为69.27 g/L,溶析醇水比（乙醇与浓缩废母液的体积比）为1的最佳工艺条件下,白炭黑废母液中硫酸钠的一次回收率可达69.94%,硫酸钠产品的纯度达到97.3%。     

Decomposition of NO in automobile exhaust by plasma–photocatalysis synergy

The combination of plasma discharge and TiO₂ photocatalysis exhibits high performances in the removal of nitrogen monoxide (NO). This article is aimed at elucidating the relationships between NO decomposition efficiency and various experimental parameters, including voltages, humidity and temperature. The experimental results indicate that the efficiency of NO removal by synergic plasma-catalyst coupling is significantly higher than plasma only or photocatalyst only systems. Moreover, the NO removal efficiency improves with the increase of applied voltage. Meanwhile, a higher humidity results in a reduced number of electron–hole pairs at the surface of TiO₂ photocatalyst, leading to lower synergic purification efficiencies. Finally, the efficiency of NO removal is raised with the increase of temperature due to the fact that the adsorption of NO and water by nano-TiO₂ is affected by environmental temperature.