Reductive dechlorination of polychlorinated biphenyls as affected by sediment characteristics

The effect of sediment sources on the selection of polychlorinated biphenyl (PCB) dechlorinating competence was investigated using sediments from two different locations, the Grasse River and Owasco Lake. These two sediments had a similar organic carbon content but different particle size distribution. The two PCB-free sediments were spiked with Aroclor 1248 and inoculated with microorganisms from the Reynolds and General Motors sites in the St. Lawrence River, which exhibited different dechlorination patterns. When each inoculum was serially transferred into fresh sediments four times (every 8-10 weeks), they still maintained the initial dechlorination patterns regardless, the source of sediments and the number of transfers, and dechlorination patterns of the two inocula in the same sediments did not converge. In a parallel approach, when the acclimated microorganisms from the Reynolds site were inoculated into fresh sediments from both sources as well as sediments enriched with organic carbon (2%, w/v), the dechlorination pattern remained unchanged after a 40-week incubation. These results suggest that the sediment characteristics or organic carbon content did not play a role in the selection of dechlorinating populations.     

PCDD and PCDF exposures in workers and controls living near an industrial waste incinerator

This study measured the levels of 17 congeners of PCDDs/PCDFs in serum to compare the levels between potentially exposed workers at an industrial waste incinerator and any residents with no known exposures. The 1,2,3,6,7,8- and 1,2,3,7,8,9-HxCDD were detected in serum of workers but in controls. Likewise, 1,2,3,7,8-PeCDF, 1,2,3,6,7,8- and 1,2,3,7,8,9-HxCDF were detected only in serum of workers. The international toxic equivalent (TEQ) levels of PCDDs/PCDFs in sera of workers are much higher than in controls. Among PCDDs, the proportion of total concentration and TEQ level is dominated predominantly by 1,2,3,6,7,8- and 1,2,3,7,8,9-HxCDD. We need extensive studies to estimate human exposure and are continuing this investigation.     

Time-series analysis of above-road particulate matter at the Caldecott Tunnel exit

On November 18, 1997, above-road particulate matter (PM) lidar (light detection and ranging) signals and heavy-duty (HD) and light-duty (LD) vehicle counts were simultaneously collected for 894 10-sec sampling periods at the Caldecott Tunnel in Orinda, CA, for the purpose of measuring the relative contributions of LD and HD vehicles to the PM lidar signal under real-world driving conditions. The relationship between the PM lidar signal and traffic activity (i.e., LD and HD traffic volumes) was examined using a time-series analysis technique, multilagged regression. The time-series model results indicate that the PM lidar signal in the current sampling period (PMt) depended on the level recorded in the previous three sampling periods (i.e., PMt-1, PMt-2, and PMt-3), the number of LD vehicles in the seventh past sampling period (LDt-7), and the number of HD vehicles measured 80 sec previous to the current sampling period (HDt-8). On a 10-sec period basis, the model results indicate that HD vehicles contributed, on average, 3 times more to above-road PM lidar signals than did LD vehicles. The observed lag in the relationship between vehicle types and the lidar signal 20 m above the road suggests that resuspended road dust, rather than tailpipe exhaust emissions, was the main source of the detected PM. Detection of road dust at such heights above the road suggests the need for investigating the processes governing the vertical transport and recycling of PM over the road as a function of vehicle dynamics under a range of meteorological conditions.     

Persistence of residues in water and sediment of a fresh-water lake after surface application of technical chlordane

A fresh-water lake, free from detectable pesticide residues before this study, was treated with a commercial formulation of technical chlordane. Water and sediment samples were analysed for chlordane residues 7, 24, 52, 279. and 421 days after treatment. Residues moved rapidly from the water to the lake bottom, supporting earlier results of a laboratory study with other organochlorines. In water, alpha- and gamma-chlordane concentrations remained proportional to total chlordane concentrations, as determined by total-peak area measurements of gas-liquid chromatogrammes. But in bottom sediments, alpha- and gamma-chlordane were more persistent than other constituents of technical chlordane, supporting recent evidence that quantification of technical chlordane residues on the basis of gamma-chlordane quantification only (or that of alpha- and gamma-chlordane only), can lead to incorrect results and that this method, although simple and fast, should no longer be recommended.     

Experimental and numerical study of the dispersion of motor vehicle pollutants under idle condition

The aim of the work presented here is to study experimentally and numerically the dispersion characteristics of vehicular exhaust plume at an idle condition in an idealized and simplified environment. The gaseous and particulate concentrations in the exhaust plume of three idling motor vehicles were measured in an isolated environment under calm weather conditions. Despite the difference in the initial concentrations, the pollutants decayed exponentially in all directions.The CFD code PHOENICS 3.3, with the k–ε eddy dissipation sub-model, was used for the numerical simulation. The simulated results match very well with the experimental results close to the source of emission but decay to the ambient concentrations much slower. The effects of the initial emission concentration, exit velocity, exit direction and crosswind intensity have been investigated parametrically. The initial pollutant concentration will increase the local concentrations but the pattern of dispersion remains the same. The exit velocity will increase the momentum of the jet, resulting in a deeper penetration downstream. The exit angle has a stronger influence on pollutant dispersion than both initial pollutant concentration and exit velocity. When the exit angle is 15°, the pollutants tend to spread on the ground region. Crosswind shows a significant effect on the dispersion of the exhaust plume also. It will divert the plume to disperse in the same direction of the wind with limited penetration in the downstream direction.     

Use of autotrophic sulfur-oxidizers to remove nitrate from bank filtrate in a permeable reactive barrier system

This study was conducted to evaluate the potential applicability of an in situ biological reactive barrier system to treat nitrate-contaminated bank filtrate. The reactive barrier consisted of sulfur granules as an electron donor and autotrophic sulfur-oxidizing bacteria as a biological component. Limestone was also used to provide alkalinity. The results showed that the autotrophic sulfur oxidizers were successfully colonized on the surfaces of the sulfur particles and removed nitrate from synthetic bank filtrate. The sulfur-oxidizing activity continuously increased with time and then was maintained or slightly decreased after five days of column operation. Maximum nitrate removal efficiency and sulfur oxidation rate were observed at near neutral pH. Over 90% of the initial nitrate dissolved in synthetic bank filtrate was removed in all columns tested with some nitrite accumulation. However, nitrite accumulation was observed mainly during the initial operation period, and the concentration markedly diminished with time. The nitrite concentration in effluent was less than 2 mg-N/l after 12 days of column operation. When influent nitrate concentrations were 30, 40, and 60 mg-N/l and sulfur content in column was 75%, half-order autotrophic denitrification reaction rate constants were 31.73 x 10(-3), 33.3 x 10(-3), and 36.4 x 10(-3) mg(1/2)/l(1/2)min, respectively. Our data on the nitrate distribution profile along the column suggest that an appropriate wall thickness of a reactive barrier for autotrophic denitrification may be 30 cm when influent nitrate concentration is less than 60 mg-N/l.     

Decomposition of 2-mercaptothiazoline in aqueous solution by ozonation

This study investigates the ozonation of 2-mercaptothiazoline (2-MT). The 2-MT is one of the important organic additives for the electroplating solution of the printed wiring board industry and has been widely used as a corrosion inhibitor in many industrial processes. It is of concern for the aquatic pollution control especially in the wastewaters. Semibatch ozonation experiments in the completely stirred tank reactor are performed under various concentrations of input ozone. The concentrations of 2-MT, sulfate, and ammonium are analyzed at specified time intervals to elucidate the decomposition of 2-MT during the ozonation. In addition, the time variation of the dissolved ozone concentration (C(ALb)) is continuously monitored in the course of experiments. Total organic carbon (TOC) is chosen and measured as a mineralization index of the ozonation of 2-MT. The results indicate that the decomposition of 2-MT is efficient, while the mineralization of TOC is limited via the ozonation only. Simultaneously, the yield of sulfate with the maximum value of about 47% is characterized by the increases of TOC removal and ozone consumption. These results can provide some useful information for assessing the feasibility of the treatment of 2-MT in the aqueous solution by the ozonation.     

Manganese uptake and accumulation by the hyperaccumulator plant Phytolacca acinosa Roxb. (Phytolaccaceae)

The perennial herb Phytolacca acinosa Roxb. (Phytolaccaceae), which occurs in Southern China, has been found to be a new manganese hyperaccumulator by means of field surveys on Mn-rich soils and by glasshouse experiments. This species not only has remarkable tolerance to Mn but also has extraordinary uptake and accumulation capacity for this element. The maximum Mn concentration in the leaf dry matter was 19,300 microg/g on Xiangtan Mn tailings wastelands, with a mean of 14,480 microg/g. Under nutrient solution culture conditions, P. acinosa could grow normally with Mn supplied at a concentration of 8000 micromol/l, although with less biomass than in control samples supplied with Mn at 5 micromol/l. Manganese concentration in the shoots increased with increasing external Mn levels, but the total mass of Mn accumulated in the shoots first increased and then decreased. At an Mn concentration of 5000 micromol/l in the culture solution, the Mn accumulation in the shoot dry matter was highest (258 mg/plant). However, the Mn concentration in the leaves reached its highest value (36,380 microg/g) at an Mn supply level of 12,000 micromol/l. These results confirm that P. acinosa is an Mn hyperaccumulator which grows rapidly, has substantial biomass, wide distribution and a broad ecological amplitude. This species provides a new plant resource for exploring the mechanism of Mn hyperaccumulation, and has potential for use in the phytoremediation of Mn-contaminated soils.     

Chemical composition of post-harvest biomass burning aerosols in Gwangju, Korea

The main objective of this study was to investigate the chemical characteristics of post-harvest biomass burning aerosols from field burning of barley straw in late spring and rice straw in late fall in rural areas of Korea. A 12-hr integrated intensive sampling of particulate matter (PM) with an aerodynamic diameter less than or equal to 10 microm (PM10) and PM with an aerodynamic diameter less than or equal to 2.5 microm (PM2.5) biomass burning aerosols had been conducted continuously in Gwangju, Korea, during two biomass burning periods: June 4--15, 2001, and October 8--November 14, 2002. The fine and coarse particles of biomass burning aerosols were analyzed for mass and ionic, elemental, and carbonaceous species. The average fine and coarse mass concentrations of biomass burning aerosols were, respectively, 129.6 and 24.2 microg/m3 in June 2001 and 47.1 and 33.2 microg/m3 in October--November 2002. An exceptionally high PM2.5 concentration of 157.8 microg/m3 was observed during biomass burning events under stagnant atmospheric conditions. In the fine mode, chlorine and potassium were unusually rich because of the high content of semi-arid vegetation. Both organic carbon (OC) and elemental carbon increased during the biomass burning periods, with the former exhibiting a higher abundance. PM from the open field burning of agricultural waste has an adverse impact on local air quality and regional climate.