Examples of the role of analytical chemistry in environmental risk management research

Analytical chemistry is an important tier of environmental protection and has been traditionally linked to compliance and/or exposure monitoring activities for environmental contaminants. The adoption of the risk management paradigm has led to special challenges for analytical chemistry applied to environmental risk analysis. Namely, methods developed for regulated contaminants may not be appropriate and/or applicable to risk management scenarios. This paper contains examples of analytical chemistry applied to risk management challenges broken down by the analytical approach and analyte for some selected work in our laboratory. Specific techniques discussed include stable association complex electrospray mass spectrometry (cESI-MS), gas chromatography-mass spectrometry (GC-MS), split-flow thin cell (SPLITT) fractionation and matrix-assisted laser desorption time of flight mass spectrometry (MALDI-ToF-MS). Specific analytes include haloacetic acids (HAA9), perchlorate, bromate, triazine degradation products, metal-contaminated colloids and Cryptosporidium parvum oocysts.     

Preliminary air pollution monitoring in San Miguel, Buenos Aires

Passive diffusion samplers were employed in San Miguel(Buenos Aires Metropolitan Area) for a preliminary airpollution monitoring. The highest loads were observedin downtown, compared with an urban background site.Total suspended particulate matter (TSPM) varied from0.257 to 0.033 mg cm^-2 month^-1; dust was examinedfor particle nature and size distribution. A similartrend was observed for nitrogen dioxide (NO₂) andTSPM spatial distribution, suggesting that traffic isthe major pollution source. Sulphur dioxide (SO₂)values were low and rather homogeneous. Levels for theinvestigated pollutants are below EPA's guide linevalues. Geographic (flat area, near to Rio de LaPlata) and climatologic factors (rainfalls andvariable wind directions) contribute to disperse pollutants.     

Development of monitoring technology for airborne particulate matter

Particulate matter suspended in the air has adverse effects onhuman health. Its level of concentration is an important parameter in evaluating the degree of hazard it poses to the atmosphere. Conventional methods used in measuring particulatematter are often filter-based, which indicates some disadvantagesbecause such a base requires labor and time. In this study, to achieve real-time measurements, a new electrical method was developed for measuring PM10 and PM2.5 concentrations. The basicprinciple is to electrically charge particles passing through thePM inlet using a corona charger and measure the currents createdby charged particles to obtain the number concentration of particulate matter. A new type inlet based on the particle cupimpactor configuration was designed and its performance was evaluated. A unipolar diffusion charger was developed and thecharger's efficiency was determined experimentally in terms ofPn, which represents the penetration through the charger,P, times the average charge number acquired by a particle,n, for different particle sizes. The correlation was constructed between the PM10 (or the PM2.5) mass concentrationsand the electrical currents due to particles, which were chargedby the diffusion charger.     

Response of the Ascorbate-Peroxidase of Selenastrum capricornutum to Copper and Lead in Stormwaters

The green alga Selenastrum capricornutum expresses a uniqueascorbate peroxidase, that responds to copper and lead. Attemptswere made to test if this peroxidase could be used to monitor thelevels of copper and lead in natural waters. When S.capricornutum was exposed to a stormwater sample, the specificactivity of the peroxidase in the cell extract was commensuratewith the combined copper and lead contents in the sample. Theperoxidase responses were also correlated with the 96 hr biomasstoxicity assay of S. capricornutum. However, unlike thebiomass toxicity assay, the peroxidase activity was not affectedby the anions in the samples. The use of this peroxidase can beused as a marker for testing heavy metal toxicity in the water.     

Luminescence spectroscopy as a screening tool for the potential carcinogenicity of asphalt fumes

A subset of polycyclic aromatic compounds (PACs), which contain 4-6 annulated rings, has been documented as the source of carcinogenicity in animal skin painting studies of petroleum products and asphalt fumes (M. L. Machado, P. W. Beatty, J. C. Fetzer, A. H. Glickman and E. L. McGinnis, Fundam. Appl. Toxicol., 1993, 21, 492; T. A. Roy, S. W. Johnson, G. R. Blackburn and C. R. Mackerer, Fundam. Appl. Toxicol., 1988, 10, 466). Because of the chemical complexity of these materials, it has been difficult to identify the specific compounds within this broad range of PACs responsible for their carcinogenicity. An alternative approach using luminescence spectroscopy was taken in this study to quantify, without identification, a subset of these compounds that appears to cause cancer. The fluorescence response at a specific wavelength pair was obtained for 39 laboratory asphalt fume condensates from animal skin painting studies, yielding a linear correlation coefficient of R2 = 0.96 between the fluorescence response in these materials and the carcinogenicity found in animal studies. In the absence of other asphalt fume condensates from animal studies, 17 petroleum oils were also evaluated using this method and compared with the available animal skin painting data. The details of the method include a clean-up step that removes the highly polar compounds and spectral subtraction of two- and three-ring PAC interference, both of which add to the fluorescence response, yet were not found to contribute to a carcinogenic response from skin painting studies. Full scan fluorescence plots also produce a fingerprint which can be used to assess contamination, such as coal tar products or mixtures of materials, that are not defined as asphalt, yet may be present in the working environment.     

Influence of environmental parameters on the accuracy of nitrogen dioxide passive diffusion tubes for ambient measurement

Two studies at three sites in the UK provided confirmation that systematic positive bias in NO2 diffusion tube measurement occurred because of changes to "within-tube" chemistry, rather than eddy diffusion at the mouth of the tube. In the first study in Cambridge, UK, sampler overestimation for 1 and 2 week exposures was compared to corresponding time-averaged monitor measurements (NO-NO2-NOx, O3) and weather variables. Noninearity between sampler and monitor NO2 measurements was interpreted in terms of spatial and temporal variations in relative and absolute availability of NO, NO2 and O3 at the site. A maximum overestimation occurred for an exposure mean NO2/NOx approximately 0.5. The separate contributions of reduced NO2 photolysis and eddy diffusion were compared in Study II using samplers of two materials, acrylic and quartz, and of different lengths (40, 55, 71 and 120 mm) at three sites: Norwich background, Cambridge intermediate, London kerbside. For compared sites, NO2 measured by acrylic samplers was significantly higher than for equivalent quartz samplers. For quartz samplers [NO2]mean was only just above the monitor at Norwich and London; sampler/monitor NO2 = 1.04 (P = 0.59) and 1.01(P = 0.76), respectively. For acrylic samplers the order of [NO2]mean was 40 mm > 120 mm > 71 mm > or = 55 mm. Excepting 40 mm samplers, this accords with a chemical bias where co-diffusing NO and 03 molecules in longer tubes have more time to react to form excess NO2. Bias in 40 mm samplers is discussed. Eddy diffusion is negligible for standard samplers because [NO2]mean was equivalent for 55 mm and 71 mm acrylic samplers and close to monitor NO2 for 71 mm quartz tubes. Both studies showed that sampler accuracy was dependent on location. Significantly, overestimation was greatest (approximately 3-4 ppb) where the NO2 annual mean was approximately 20 ppb, close to the UK and EU air quality standard of 21 ppb.     

Characterisation of mineralogical forms of barium and trace heavy metal impurities in commercial barytes by EPMA, XRD and ICP-MS

This study was carried out to characterise the mineralogical forms of barium and the trace heavy metal impurities in commercial barytes of different origins using electron probe microanalysis (EPMA), X-ray diffraction (XRD) and inductively coupled plasma mass spectrometry (ICP-MS). Qualitative EPMA results show the presence of typically eight different minerals in commercial barytes including barite (BaSO4), barium feldspar, galena (PbS), pyrite (FeS2), sphalerite (ZnS), quartz (SiO2), and silicates, etc. Quantitative EPMA confirms that the barite crystals in the barytes contain some strontium and a little calcium, whereas trace heavy metals occur in the associated minerals. Analysis of aqua regia extracts of barytes samples by ICP-MS has shown the presence of a large number of elements in the associated minerals. Arsenic, copper and zinc concentrations correlate closely in all 10 samples. The findings suggest that barytes is not, as traditionally thought, an inert mineral, but is a potentially toxic substance due to its associated heavy metal impurities, which can be determined by an aqua regia digest without the need for complete dissolution of the barite itself. X-ray powder diffraction was not informative as the complex barite pattern masks the very weak lines from the small amounts of associated minerals.     

Fate and movement of atrazine, cyanazine, metolachlor and selected degradation products in water resources of the deep Loess Hills of Southwestern Iowa, USA

The environmental fate and movement of herbicides widely used for weed control in corn are assessed for a deep loess soil in southwestern Iowa. Beginning in the early 1980s, the herbicide-based weed control program emphasized the application of atrazine (ATR) or cyanazine (CYN) and metolachlor (MET) for both broadleaf and grass control. Between 1992 and 1995, concentrations of ATR, desethylatrazine (DEA), desisopropylatrazine (DIA), CYN and MET were measured in rainwater, both shallow and deep vadose zone water, and well water. Results show that the frequency of herbicide detections and the range and distribution of occurrences are dependent upon both landscape position and temporal inputs of recharge water from rainfall. Generally, DIA was observed more frequently and in higher mean concentration in well water than DEA, while DEA was observed more frequently than DIA in vadose zone groundwater. A chromatographic analogy is suggested to explain the occurrence patterns observed for both parent herbicide and degradation products within the unsaturated zone water. Analysis of rainwater samples collected during this time also revealed low concentrations of ATR, CYN and MET, with the timing of the detections indicative of non-local transport. Results show that the deep loess soil conducts both water and agricultural chemicals relatively rapidly and as such represents a production system which is vulnerable to contamination of shallow groundwater by herbicide-derived chemicals. Results also illustrate the importance of including major herbicide degradation products in water resource impact assessment studies.     

Organic contaminants and trace metals in flounder liver and sediment from the Amsterdam and Rotterdam harbours and off the Dutch coast

Organic contaminants [polychlorinated biphenyls (PCBs), organochlorine pesticides (OCPs), polybrominated diphenylethers (PBDEs), nonylphenols], organotin compounds and trace metals (cadmium, chromium, mercury and zinc) were determined in flounder (Platichthys flesus) liver and sediment from the Amsterdam harbour (North Sea Canal) and Rotterdam harbour (Euromonding) and off the Dutch coast between the Amsterdam and Rotterdam harbour mouths in order to assess the level of contamination in these harbours and to study contamination gradients.     

Perceived changes in well-being and happiness with gardening in urban organic allotments in Portugal

Urban allotment gardens (AG) in Portugal have increased in recent years, as in many other European countries and worldwide. The contribution of these gardens to the happiness and well-being of urban populations has been recognized, but evaluations of their benefits are still very scarce. The objective of this study was to evaluate this contribution, based on the urban organic AG of the Devesa Park in Vila Nova de Famalicão, Portugal. The sample included 65 gardeners who completed the self-administered questionnaires of Bem-Estar Pessoal (personal well-being scale), Felicidade Subjetiva (subjective happiness scale) and sociodemographic characteristics. Respondents were mainly adults under 65 years, married and academically well qualified and about half of them had a professional activity, with nearly one third being retired. They considered themselves happy with their life (Personal Well-being Index = 74.5%) and revealed an optimistic and positive attitude towards life, regardless of economic or social difficulties. The increased frequency of visits for gardening was positively related to a greater perception of subjective happiness. The gardeners who visited the AG more frequently considered themselves happier from a self-perspective and in comparison with peers. It can be suggested that urban organic AG represent a means for enhancing citizen well-being, contributing positively to their feelings of happiness and life satisfaction, changing behaviours and developing personal capacities. Beyond economic measures, urban AG can be recommended to capture the well-being of societies.