Transfer of pesticides to the brew during mate drinking process and their relationship with physicochemical properties

In order to evaluate the extraction of pesticide residues that are transferred to the brew during mate drinking process of P.U.1 yerba mate leaves (Ilex paraguariensis), a special device to simulate the way in which mate is drunk in Uruguay was developed. The transfer to the brew of 12 organophosphates, 5 synthethic pyrethroids and one organochlorine pesticide from spiked samples was studied. The relationship between the transfer data thus obtained and physicochemical properties like water solubility (Ws), octanol-water coefficient (Kow) and Henry's constant (H) was evaluated. The extractability of the pesticide residues from yerba mate can be correlated with log Ws and log Kow. These transfer values allowed the calculation of ARLs (acceptable residue level) for the pesticides following Food and Agriculture Organization (FAO), World Health Organizaion (WHO) guidelines. These results can help the future establishment of maximum residue levels (MRLs).     

Consequences of nitrate leaching following stem-only harvesting of Swedish forests are dependent on spatial scale

Short-term increases in soil solution nitrate (NO₃⁻) concentration are often observed after forest harvest, even in N-limited systems. We model NO₃⁻ leaching below the rooting zone as a function of site productivity. Using national forest inventories and published estimates of N attenuation in rivers and the riparian zone, we estimate effects of stem-only harvesting on NO₃⁻ leaching to groundwater, surface waters and the marine environment. Stem-only harvesting is a minor contributor to NO₃⁻ pollution of Swedish waters. Effects in surface waters are rapidly diluted downstream, but can be locally important for shallow well-waters as well as for the total amount of N reaching the sea. Harvesting adds approximately 8 Gg NO₃-N to soil waters in Sweden, with local concentrations up to 7 mg NO₃-N l⁻¹. Of that, ∼3.3 Gg reaches the marine environment. This is ∼3% of the overall Swedish N load to the Baltic.     

Potential physiological effects of pharmaceutical compounds in Atlantic salmon (<Emphasis Type="Italic">Salmo salar</Emphasis>) implied by transcriptomic analysis

Background, aim, and scope  

Pharmaceuticals are emerging pollutants widely used in everyday urban activities which can be detected in surface, ground, and drinking waters. Their presence is derived from consumption of medicines, disposal of expired medications, release of treated and untreated urban effluents, and from the pharmaceutical industry. Their growing use has become an alarming environmental problem which potentially will become dangerous in the future. However, there is still a lack of knowledge about long-term effects in non-target organisms as well as for human health. Toxicity testing has indicated a relatively low acute toxicity to fish species, but no information is available on possible sublethal effects. This study provides data on the physiological pathways involved in the exposure of Atlantic salmon as representative test species to three pharmaceutical compounds found in ground, surface, and drinking waters based on the evaluation of the xenobiotic-induced impairment resulting in the activation and silencing of specific genes.     

Ecotoxicity assessment of lipid regulators in water and biologically treated wastewater using three aquatic organisms

Background, aim, and scope  

The high consumption of blood lipid regulators is leading to frequent reports of the occurrence of fibrates in natural streams and wastewater effluents. This paper describes a study undertaken to evaluate the acute toxicity of bezafibrate, clofibric acid, gemfibrozil, and fenofibric acid, a metabolite of fenofibrate whose ecotoxicity has not been previously reported.     

Integrated emergy,energy and economic evaluation of rice and vegetable production systems in alluvial paddy fields: Implications for agricultural policy in China

China is the largest rice producing and consuming country in the world, but rice production has given way to the production of vegetables during the past twenty years. The government has been trying to stop this land-use conversion and increase the area in rice-vegetable rotation. Important questions that must be answered to determine what strategy is best for society are, “What is the reason behind this conversion?”; “Which system is more productive and which is more sustainable?”; and “How can economic policy be used to adjust the pattern of farmland use to attain sustainable development?” To answer these questions, a combined evaluation of these agricultural production systems was done using emergy, energy and economic methods. An economic analysis clearly showed that the reason for this conversion was simply that the economic output/input ratio and the benefit density of the vegetable production system were greater than that of rice. However, both energy and emergy evaluations showed that long-term rice was the best choice for sustainable development, followed by rotation systems. The current price of rice is lower than the em-value of rice produced from the long-term rice system, but higher than that of rice produced from the rotation system. Scenario analysis showed that if the government increases the price of rice to the em-value of rice produced from the long-term rice system, US$0.4/kg, and takes the value of soil organic matter into account, the economic output/input ratios of both the rice and rotation systems will be higher than that of the vegetable system. The three methods, energy, emergy and economics, are different but complementary, each revealing a different aspect of the same system. Their combined use shows not only the reasons behind a system’s current state or condition, but also the way to adjust these systems to move toward more sustainable states.     

Biological Assessment to Support Ecological Recovery of a Degraded Headwater System

An assessment of the benthic macroinvertebrate community was conducted to characterize the ecological recovery of a channelized main stem and two small tributaries at the Watershed Research and Education Center (WREC, Arkansas, USA). Three other headwater streams in the same basin were also sampled as controls and for biological reference information. A principal components analysis produced stream groupings along an overall gradient of physical habitat integrity, with degraded reaches showing lower RBP habitat scores, reduced flow velocities, smaller substrate sizes, greater conductivity, and higher percentages of sand and silt substrate. The benthic macroinvertebrate assemblage at WREC was dominated by fast-reproducing dipteran larvae (midge and mosquito larvae) and physid snails, which comprised 71.3% of the total macroinvertebrate abundance over three sampling periods. Several macroinvertebrate assemblage metrics should provide effective targets for monitoring overall improvements in the invertebrate assemblage including recovery towards a more complex food web (e.g., total number of taxa, number of EPT taxa, percent 2 dominant taxa). However, current habitat conditions and the extent of existing degradation, system isolation and surrounding urban or agricultural land-uses might affect the level of positive change to the system. We therefore suggest a preliminary restoration strategy involving the addition of pool habitats in the system. At one pool we collected a total of 29 taxa (dominated by water beetle predators), which was 59% of total number of taxa collected at WREC. Maintaining water-retentive pools to collect flows and maintain water permanence focuses on enhancing known biology and habitat, thus reducing the effects of abiotic filters on macroinvertebrate assemblage recovery. Furthermore, biological assessment prior to restoration supports a strategy primarily focused on improving the existing macroinvertebrate community in the current context of the system, thereby reducing costs associated with active channel restoration. Monitoring future biological recovery and determining the contribution of changing assemblages to specific ecological processes would provide a critical underpinning for adaptive management and ecologically-effective restoration.     

Evaluation of the National Land Cover Database for Hydrologic Applications in Urban and Suburban Baltimore,Maryland1

Smith, Monica Lipscomb, Weiqi Zhou, Mary Cadenasso, Morgan Grove, and Lawrence E. Band, 2010. Evaluation of the National Land Cover Database for Hydrologic Applications in Urban and Suburban Baltimore, Maryland. Journal of the American Water Resources Association (JAWRA) 46(2):429-442. DOI: 10.1111/j.1752-1688.2009.00412.x Abstract: We compared the National Land Cover Database (NLCD) 2001 land cover, impervious, and canopy data products to land cover data derived from 0.6-m resolution three-band digital imagery and ancillary data. We conducted this comparison at the 1 km², 9 km², and gauged watershed scales within the Baltimore Ecosystem Study to determine the usefulness and limitations of the NLCD in heterogeneous urban to exurban environments for the determination of land-cover information for hydrological applications. Although the NLCD canopy and impervious data are significantly correlated with the high-resolution land-cover dataset, both layers exhibit bias at <10 and >70% cover. The ratio of total impervious area and connected impervious area differs along the range of percent imperviousness – at low percent imperviousness, the NLCD is a better predictor of pavement alone, whereas at higher percent imperviousness, buildings and pavement together more resemble NLCD impervious estimates. The land-cover composition and range for each NLCD urban land category (developed open space, low-intensity, medium-intensity, and high-intensity developed) is more variable in areas of low-intensity development. Fine-vegetation land-cover/lawn area is incorporated in a large number of land use categories with no ability to extract this land cover from the NLCD. These findings reveal that the NLCD may yield important biases in urban, suburban, and exurban hydrologic analyses where land cover is characterized by fine-scale spatial heterogeneity.     

Evaluation of airborne particulate matter and metals data in personal,indoor and outdoor environments using ED-XRF and ICP-MS and co-located duplicate samples

Factors and sources affecting measurement uncertainty associated with monitoring metals in airborne particulate matter (PM) were investigated as part of the Windsor, Ontario Exposure Assessment Study (WOEAS). The assessment was made using co-located duplicate samples and a comparison of two analytical approaches: ED-XRF and ICP-MS. Sampling variability was estimated using relative percent difference (RPD) of co-located duplicate samples. The comparison of ICP-MS and ED-XRF results yields very good correlations (R² ≥ 0.7) for elements present at concentrations that pass both ICP-MS and ED-XRF detection limits (e.g. Fe, Mn, Zn, Pb and Cu). PM concentration ranges (median, sample number) of 24-h indoor PM₁₀ and personal PM₁₀ filters, and outdoor PM_2.5 filters were determined to be 2.2–40.7 (11.0, n = 48) μg m^?3, 8.0–48.3 (11.9, n = 48) μg m^?3, and 17.1–42.3 (21.6, n = 18) μg m^?3, respectively. The gravimetric analytical results reveal that the variations in PM mass measurements for same-day sampling are insignificant compared to temporal or spatial variations: 92%, 100% and 96% of indoor, outdoor and personal duplicate samples, respectively, pass the quality criteria (RPD ≤ 20%). Uncertainties associated with ED-XRF elemental measurements of S, Ca, Mn, Fe and Zn for 24-h filter samples are low: 78%–100% of the duplicate samples passed the quality criteria. In the case of 24-h filter samples using ICP-MS, more elements passed the quality criteria due to the lower detection limits. These were: Li, Na, K, Ca, Si, Al, V, Fe, Mn, Co, Cu, Mo, Ag, Zn, Pb, As, Mg, Sb, Sn, Sr, Th, Ti, Tl, and U. Low air concentrations of metals (near or below instrumental detection limits) and/or inadvertent introduction of metal contamination are the main causes for excluding elements based on the pass/fail criteria. Uncertainty associated with elemental measurements must be assessed on an element-by-element basis.