Cumulative influences of a small city and former mining activities on the sediment quality of a subtropical estuarine protected area

This study aimed to evaluate the sediment quality in the estuarine protected area known as Cananéia-Iguape-Peruíbe (CIP-PA), located on the southeastern coast of Brazil. The study was designed considering possible negative effects induced by the city of Cananéia on the sediment quality of surrounding areas. This evaluation was performed using chemical and ecotoxicological analyses. Sediments were predominantly sandy, with low CaCO₃ contents. Amounts of organic matter varied, but higher contents occurred closer to the city, as well as did Fe and Total Recoverable Oils and Greases (TROGs) concentrations. Contamination by Cd and Cu was revealed in some samples, while concentrations of Zn were considered low. Chronic toxicity was detected in all tested sediments and acute toxicity occurred only in sediments collected near the city. The principal component analysis (PCA) revealed an association among Cd, Cu, Fe, TROG, fines, organic matter, CaCO₃, and chronic toxicity, whereas acute toxicity was found to be associated with Zn and mud. However, because Zn levels were low, acute toxicity was likely due to a contaminant that was not measured. Results show that there is a broad area within the CIP-PA that is under the influence of mining activities (chronic toxicity, moderate contamination by metals), whereas poorer conditions occur closer to Cananéia (acute toxicity); thus, the urban area seems to constitute a relevant source of contaminants for the estuarine complex. These results show that contamination is already capable of producing risks for the local aquatic biota, which suggests that the CIP-PA effectiveness in protecting estuarine biota may be threatened.     

Community metabolism in a deep (stratified) tropical reservoir during a period of high water-level fluctuations

As long as lakes and reservoirs are an important component of the global carbon cycle, monitoring of their metabolism is required, especially in the tropics. In particular, the response of deep reservoirs to water-level fluctuations (WLF) is an understudied field. Here, we study community metabolism through oxygen dynamics in a deep monomictic reservoir where high WLF (~10 m) have recently occurred. Simultaneous monitoring of environmental variables and zooplankton dynamics was used to assess the effects of WLF on the metabolism of the eutrophic Valle de Bravo (VB) reservoir, where cyanobacteria blooms are frequent. Mean gross primary production (P _g) was high (2.2 g C m^?2 day^?1), but temporal variation of P _g was low except for a drastic reduction during circulation attributed to zooplankton grazing. The trophogenic layer showed net autotrophy on an annual basis, but turned to net heterotrophy during mixing, and furthermore when the whole water-column oxygen balance was calculated, considering the aphotic respiration (R _aphotic). The high total respiration resulting (3.1 g C m^?2 day^?1) is considered to be partly due to mixing enhanced by WLF. Net ecosystem production was equivalent to a net export of 3.4 mg CO₂?m^?2 day^?1 to the atmosphere. Low water levels are posed to intensify boundary-mixing events driven by the wind during the stratification in VB. Long-term monitoring showed changes in the planktonic community and a strong silicon decrease that matched with low water-level periods. The effects of low water-level on metabolism and planktonic community in VB suggest that water-level manipulation could be a useful management tool to promote phytoplankton groups other than cyanobacteria.     

Soil response to a 3-year increase in temperature and nitrogen deposition measured in a mature boreal forest using ion-exchange membranes

The projected increase in atmospheric N deposition and air/soil temperature will likely affect soil nutrient dynamics in boreal ecosystems. The potential effects of these changes on soil ion fluxes were studied in a mature balsam fir stand (Abies balsamea [L.] Mill) in Quebec, Canada that was subjected to 3 years of experimentally increased soil temperature (+4 °C) and increased inorganic N concentration in artificial precipitation (three times the current N concentrations using NH₄NO₃). Soil element fluxes (NO₃, NH₄, PO₄, K, Ca, Mg, SO₄, Al, and Fe) in the organic and upper mineral horizons were monitored using buried ion-exchange membranes (PRS? probes). While N additions did not affect soil element fluxes, 3 years of soil warming increased the cumulative fluxes of K, Mg, and SO₄ in the forest floor by 43, 44, and 79 %, respectively, and Mg, SO₄, and Al in the mineral horizon by 29, 66, and 23 %, respectively. We attribute these changes to increased rates of soil organic matter decomposition. Significant interactions of the heating treatment with time were observed for most elements although no clear seasonal patterns emerged. The increase in soil K and Mg in heated plots resulted in a significant but small K increase in balsam fir foliage while no change was observed for Mg. A 6–15 % decrease in foliar Ca content with soil warming could be related to the increase in soil-available Al in heated plots, as Al can interfere with the root uptake of Ca.     

Improvement of electrical resistivity tomography for leachate injection monitoring

Leachate recirculation is a key process in the scope of operating municipal waste landfills as bioreactors, which aims to increase the moisture content to optimize the biodegradation in landfills. Given that liquid flows exhibit a complex behaviour in very heterogeneous porous media, in situ monitoring methods are required. Surface time-lapse electrical resistivity tomography (ERT) is usually proposed. Using numerical modelling with typical 2D and 3D injection plume patterns and 2D and 3D inversion codes, we show that wrong changes of resistivity can be calculated at depth if standard parameters are used for time-lapse ERT inversion. Major artefacts typically exhibit significant increases of resistivity (more than +30%) which can be misinterpreted as gas migration within the waste. In order to eliminate these artefacts, we tested an advanced time-lapse ERT procedure that includes (i) two advanced inversion tools and (ii) two alternative array geometries. The first advanced tool uses invariant regions in the model. The second advanced tool uses an inversion with a “minimum length” constraint. The alternative arrays focus on (i) a pole–dipole array (2D case), and (ii) a star array (3D case). The results show that these two advanced inversion tools and the two alternative arrays remove almost completely the artefacts within +/?5% both for 2D and 3D situations. As a field application, time-lapse ERT is applied using the star array during a 3D leachate injection in a non-hazardous municipal waste landfill. To evaluate the robustness of the two advanced tools, a synthetic model including both true decrease and increase of resistivity is built. The advanced time-lapse ERT procedure eliminates unwanted artefacts, while keeping a satisfactory image of true resistivity variations. This study demonstrates that significant and robust improvements can be obtained for time-lapse ERT monitoring of leachate recirculation in waste landfills.     

Fractions and background concentrations of potentially toxic elements in Hungarian surface soils

This work established background concentrations for the pseudo total (HNO₃ + H₂O₂-soluble), mobilisable (NH₄-acetate + EDTA-soluble) and mobile (1?M NH₄NO₃-soluble) element fractions of Hungarian surface soils that can be used as reference values for the soil quality standards. The 193 soils investigated were taken from the Hungarian Soil Information and Monitoring System. The background values for Al, As, B, Cd, Co, Cr, Cu, Mn, Ni, Pb, Sr and Zn were given as a range covering 95% of the variance of the representative samples. The differences between observed element concentrations and the calculated background values indicated anthropogenic or pedogenic impact in each fraction. The comparison of the calculated background values with the Hungarian quality standards and the contamination limit values of other countries showed that the limit values of a certain region or country are not suitable for other areas. Generally, Mn and Al had the highest, while Cd had the lowest concentration in each fraction. Cr and Al were the least and Sr was the most mobile element. The principal component analysis indicated different geochemical and physico-chemical behaviour of the elements in the fractions; the pseudo total fraction was influenced more by the geological behaviour, while mobilisable and mobile fraction explained a much higher proportion of the total variance of soil physico-chemical properties than soil geochemical properties. The Cd–Ni and Co–Mn element pairs were always in the same principal component in each fractions indicating similar geogenic origin and showing that their solubility changes are similar in function of soil properties.     

Carbon dioxide capture and recovery by means of TSA and/or VSA

Experimental work is performed with a 5A zeolite on a small laboratory column with heating from the wall. Carbon dioxide adsorption occurs at atmospheric pressure and different CO₂ concentrations in nitrogen. Comparisons of different methods of desorption by heating, purge and/or vacuum are studied. Desorption by heating only leads to almost pure CO₂ (around 99% purity) and a recovery nearly linear to the heating temperature, ranging from 45% at 130 °C to 79% at 210 °C. Recovery can be subsequently increased with a nitrogen purge to more than 98% but the recovered carbon dioxide is diluted due to the dispersive character of the desorption wave and the operation time is long. Increasing the flow rate decreases the desorption time but has no effect on the purity because the total purge volume remains about the same. Substitution of the purge step with a vacuum step leads to pure CO₂ and almost total recovery. Desorption under vacuum only without heating leads to pure CO₂ (around 99% purity) but limited recovery (85% in the present work).Desorption under vacuum seems to be more simple for large-scale applications. When using a water liquid ring pump, the temperature of the ring must be kept as low as possible to provide a high operating capacity.     

Effects of environmentally relevant concentrations of metallic compounds on the flatfish Scophthalmus maximus: biomarkers of neurotoxicity,oxidative stress and metabolism

Flatfish species, such as the turbot (Scophthalmus maximus), are common targets for toxic effects, since they are exposed through the food chain (ingestion of contaminated preys) and are in direct contact with the waterborne contaminant and sediments. Furthermore, these fish species live in close proximity to interstitial water that frequently dissolves high amounts of contaminants, including metals. Despite this significant set of characteristics, the present knowledge concerning flatfish contamination and toxicity by metals is still scarce. To attain the objective of assessing the effects of metals on a flatfish species, S. maximus specimens were chronically exposed to lead, copper and zinc, at ecologically relevant concentrations, and biochemical (oxidative stress: catalase and glutathione S-transferases activities, and lipid peroxidation; neurotoxicity: cholinesterase activity) parameters were assessed on selected tissues (gills and liver). Copper had no significant effects on all tested parameters; lead was causative of significant increases in liver GSTs activities and also in lipoperoxidation of gill tissue; exposure to zinc caused a significant increase in catalase activity of gill tissue. None of the tested metals elicited noteworthy effects in terms of neurotoxicity. The obtained results showed that only the metal lead is of some environmental importance, since it was able to cause deleterious modifications of oxidative nature at relevant concentrations.     

Effects of golpar (<Emphasis Type="Italic">Heracleum persicum</Emphasis> Desf.) and probiotics in drinking water on performance,carcass characteristics,organ weights,blood plasma constituents,and immunity of broilers

Increasing levels of Heracleum persicum (golpar) in drinking water were studied in broilers. Two hundred and forty-one-day-old male chickens were allocated to one of six treatments: control, without added phytogenics nor probiotics in drinking water, and probiotics at recommended manufacturer’s level (P) or 1.0, 1.5, 2.0, and 2.5 ml/l of golpar extract solution (G1, G1.5, G2, and G2.5 treatments, respectively) in drinking water. As a result of this study, no linear or quadratic trends in the feed intake (FI) and feed conversion rate (FCR) due to golpar supplementation were found. Body weight gain, final body weight, and relative carcass weight showed a positive linear response with increasing levels of golpar supplementation. Neither golpar nor probiotics had effects on the percentages of edible parts of the carcass. Golpar supplementation levels caused a linear negative response of the albumin content in blood plasma, whereas both abdominal fat as percentage of carcass weight and uric acid levels in blood plasma linearly increased. The effects on Ig responses were only observed at 42 days of age and were similar in probiotics and the highest level of golpar supplementation. Based on our results, both probiotics and golpar supplementation could improve broiler performance and immune function.     

The copper level dependence in vegetable crops at pesticide treatment

Abstract

Pesticides containing copper are used on wide range in vegetable production, especially in the open field. Copper has an excellent fungicidal effect against diseases of tomato, pepper, onion and in practical use it is essential as bactericide in the above mentioned crops.

The fungicides containing copper are freely available on the market, they are not expensive and widely used without any special knowledge. They are popular in simple home gardens as well as in hi‐tech vegetable production and are used even in all forms of “bio”; culture.

From the other side, copper can be toxic. The allowable level is 10 mg Cu/kg product. This concentration may be found after the first treatment and it increases after every further application.

In our experiments the copper absorbancy and accumulation has been investigated at different pesticide doses and under different experimental conditions.

The analytical measurements, the sample preparation, the instrument calibration have been made by the Inductively Coupled Plasma Spectrometer at the Department of Chemistry of the University of Horticulture and Food Industry.