Ozone Injury to Pinus Strobus

In a study of the ozone-induced needle blight of eastern white pine in central New York, acute injuries naturally induced on field trees during a year of relatively low ozone concentrations (1 966) were compared with injuries induced during a year of higher concentrations (1967). Injuries were more frequent and severe and were associated with higher mean ozone concentrations in 1967 than in 1966. Characteristic symptoms were induced on foliage of pine branches exposed to controlled doses of ozone as low as 7 ± 1 pphm for four hours or 3 ± 1 pphm for 48 hours. Such doses were equalled or exceeded two and four times, respectively, in the field during the 1 967 season. Ozone sensitivity of pine needle tissue was increased by fumigation in atmospheres containing water mist. High concentrations of ozone (40-60 pphm) caused general injury of foliage of both ozone-susceptible and resistant trees; the symptoms were unlike those found in the field or caused by fumigation with low concentrations of ozone.     

Honorary Memberships

Honorary Memberships are conferred by the Air Pollution Control Association on persons of widely recognized eminence in some part of the field of air pollution control or who have rendered especially meritorious service to the Association. Honorary Memberships were awarded this year to Dr. Leonard Greenburg and Mr. Milton Reizenstein, both past presidents of APCA.     

Mathematical Modeling of Photochemical Smog Using the PICK Method

A new method for solving the turbulent atmospheric diffusion equation has been developed based on Lagrangian mass points, or particles moving through an Eulerian grid. The method is one of a family of Particle-/n-Cell techniques but is a unique extension to incorporate the effects of turbulent diffusion based on K-theory; thus the acronym PICK.

In the three-dimensional computer-aided model, NEXUS (Numerical EXamination of Urban Smog), this method has been applied to simulation of carbon monoxide (CO) in Los Angeles. For CO the NEXUS simulation was within 20% of observed day-averaged concentrations at 12 stations and the hour-averages were also in good agreement. This model was extended to include the effects of photochemical smog in Los Angeles. The results of the photochemical simulation were also qualitatively correct due to rapid NO to NO₂ conversion in the simulation.     

Rotating Concentric “Homogeneous Turbulence” Gas Scrubber

A device which utilizes the Couette (secondary) flow patterns, which are developed in a fluid between rotating concentric cylinders, is proposed for use in particle collection. The gas being cleaned is dispersed in the scrubbing liquid within the annular space between cylinders. The device was untested at the time of presentation of the paper.     

Stack Dust Sampling: in-Stack Filter or E.P.A. Train

The Environmental Protection Agency has recommended or specified methods for the measurement of participate concentrations in flue gases. The EPA Train for this measurement originally comprised two segments: the front half and the impinger train downstream from the filter proper. This review examines the controversial areas implicit in the use of this EPA Train or the revised EPA train which eliminates the impinger train.     

Evaluation of the Effectiveness of The Lead Peroxide Method for Atmospheric Monitoring of Sulfur Dioxide

This paper presents a simplified analysis to determine the variables that affect the empirical correlation factor used in the lead peroxide method. The rate of sulfation has been determined from two different models. In the first model, the mass transfer rate is calculated from the gas phase resistance alone whereas in the second model, the diffusion resistance in the gel phase is assumed to be the rate limiting step. Although the gas phase and the gel phase resistances may be both important in the actual case, it has been found that the correlation factor based on the first model is adequate to describe general experimental observations. Reasonable agreement has been obtained between the measured and the calculated va|ue of the correlation factor.     

Prevention Of Significant Deterioration A Critical Review

Prevention of significant deterioration has been a subject of study and discussion for about ten years. An extensive survey of the legislative and legal aspects of this concept is presented in this review. The growth of the concept and its implementation are subjected to critical scrutiny.     

Needed: A National R&D Effort To Develop Individual Air Pollution Monitor Instrumentation

The results from the regional air quality analysis for the Four Corners Study are discussed in this paper. This study was one of five regional studies conducted for the National Commission on Air Quality. Potential regional air quality impacts were evaluated through the year 1995 for alternative energy scenarios under current and alternative regulatory policies. The alternative regulatory policies include emission fees, technology standards, emission ceilings, and prevention of significant deterioration class elimination. The alternatives were compared in terms of their impacts on regional visibility and on the ambient concentrations of SO₂, SO₄, and primary fine particulates. The fate of the pollutants was estimated. The alternative regulatory policies were quite different with respect to their control of SO_X emissions and their impacts on regional visibility. Sources located outside of the study region were estimated to have a major impact on regional air quality within the study region.     

Transmissometer Measurement of Participate Emissions from a Jet Engine Test Facility

The body of information presented in this paper is directed toward those individuals involved with handling hazardous materials, whether in actual use of such chemicals, or in monitoring atmospheric emissions. Although specifically relating experience in the design and testing of phosgene emission control equipment, it attempts to establish general guidelines for effectively dealing with emissions of hazardous materials. An approach for handling chemical pollutants having no established air quality emission standards is developed. The paper presents a technique for establishing process emissions at acceptably low levels to insure the health and safety of the general population as well as that of the process workers themselves. Methods, suitable for measuring phosgene at these low levels, have been investigated, and problems associated with such an investigation are discussed. While complete theoretical scrubber design criteria are beyond the scope of this paper, many of the "real world" problems which affected scrubber performance are presented. Finally, the practical aspects of process emissions control are illustrated by actual results from the system test.