Starch- polyvinyl alcohol crosslinked film— performance and biodegradation

Starch-PVOH cast films were prepared with and without crosslinking agent (hexamethoxymethylmelamine) in the absence of plasticizer. Moisture absorption in films without crosslinking agent at a low relative humidity was similar to that of PVOH and increased as the relative humidity increased. Films with crosslinking agent showed moisture absorption linearly proportional to the relative humidity. Significant improvement in resistance to water disintegration for crosslinked starch-PVOH films was observed. While the tensile strength decreased with increased relative humidity, crosslinking significantly improved the tensile strength. Increased PVOH content improved elongation of films even when the relative humidity was 80% or higher. Biodegradation studies revealed that the degradation rate was negatively correlated with the PVOH content in films and crosslinking generated more converged degradation curves. Names are necessary to report factually on available data; however, the USDA neither guarantees nor warrants the standard of the product, and the use of the name by USDA implies no approval of the product to the exclusion of others that may also be suitable.     

Design parameters for fixed bed reactors of activated carbon developed from fertilizer waste for the removal of some heavy metal ions

Activated carbon, developed from fertilizer waste, has been used for the removal of Hg²⁺, Cr⁶⁺, Pb²⁺, and Cu²⁺. Mass transfer kinetic approach has been successfully applied for the determination of various parameters necessary for designing a fixed-bed absorber. Parameters selected are the length of the (PAZ) primary adsorption zone (δ), total time involved for the establishment of primary adsorption zone (t_x), mass rate of flow to the absorber (F_m), time for primary adsorption zone to move down its length (t_δ), amount of adsorbate adsorbed in PAZ from breakpoint to exhaustion (M_s), fractional capacity (f), time of initial formation of PAZ (t_f) and per cent saturation of column at break point. Chemical regeneration has been achieved with 1 M HNO₃.     

Lightweight Concrete Containing an Alkaline Resistant Starch-Based Aquagel

Starch aquagel-based lightweight concrete has properties similar to those of other lightweight concrete products. However, starch aquagels are unstable in the strongly alkaline conditions typical of Portland Cement-based concrete and may interfere with the setting process. The effect of alkali treatments on the physical, mechanical, and functional properties of starch aquagels and aquagels from starch/polymer blends was investigated. Starch was blended at 100–115°C in a twin-screw extruder with five different polymers to determine whether the blends improved alkaline resistance. Polymer blends containing 5%, 15%, and 30% of the polymer hydrated and formed aquagels when equilibrated in water for 24 h. However, equilibrium moisture content was lower for the blends compared to the starch control. Aquagels equilibrated in 0.15 N NaOH swelled, lost compressive strength and had greater than 90% moisture. The blend of starch and 30% PVOH absorbed less moisture and was more resistant to alkaline dissolution in 1 N NaOH than the other blends tested making it a more suitable material for aquagel-based concrete. The moisture content of starch-based aquagels and mixing time were critical factors in determining setting times. The size of aquagel blends had a minor effect on density and compressive strength.     

Assessing the Performance Level of a Water System

Water, Air, &; Soil Pollution: Focus - What should System Managers prefer? Systems that never fail or systems that remain safe during a failure? The present paper tries to give an answer to this...     

Review of in situ remediation technologies for lead,zinc, and cadmium in soil

This article presents a review of in situ technologies for the remediation of soils contaminated with lead, zinc, and/or cadmium. The objective of this review is to assess the developmental status of the available in situ technologies and provide a general summary of typical applications and limitations of these technologies. The literature review identified seven in situ remediation technologies—solidification/stabilization, vitrification, electrokinetic remediation, soil flushing, phytoextraction, phytostabilization, and chemical stabilization. These technologies were considered for their ability to meet a specific set of remediation objectives under a range of conditions. Each of these technologies has both strengths and weaknesses for addressing particular remedial situations discussed in the article for each of the technologies. A general summary of which technologies are most applicable to common remedial scenarios is also provided. © 2004 Wiley Periodicals, Inc.     

Electroremediation: A study of the influence of buffering behavior in contaminated soils

This article presents the results of an experimental study conducted to evaluate the behavior of two types of andisol soils found in Tenerife, Canary Islands, Spain. The soils were evaluated in relation to their buffering capacity when confronted with acid and alkaline fronts generated during electroremediation treatment. The study was conducted using a cell, which established a continuous flow of distilled water through electrode chambers to remove H⁺ and OH^? generated during electrolysis. The results indicate that the soils had sufficient buffer capacity to support variations in pH independent of the maintenance of flow of solution in the electrode chambers. Although the mechanism of migration was not affected, the flow of water favored the movement of ions by diffusion monitoring of the electrolytic current allowed for a real‐time parameter to act as an indicator of the quantity of ions available in regions near the electrodes. © 2004 Wiley Periodicals, Inc.     

NITRATE CONCENTRATIONS IN ILLINOIS RIVERS 1967 TO 1974: COMPARISON AMONG REPORTING AGENCIES1

ABSTRACT: Long term data on surface water quality can sometimes be assembled by combining data collected by different agencies at different times and assuming that between agency differences in data quality are insignificant. The objective of this paper was to assess the quality of riverine nitrate (NO₃) concentrations in Illinois measured and reported by four agencies from 1967 to 1974 by comparing median values for similar sampling locations and periods. A total of 17 river reaches were identified for which two agencies reported NO₃ concentrations during similar periods. Nonparametric comparison of median values and analysis of covariance with discharge as a covariant produced similar results. Nitrate concentrations reported by the U.S. Geological Survey (USGS) from 1967 to 1971 were not statistically (P > 0.05) different from values reported by the Illinois State Water Survey (ISWS) for two of three river reaches. Additionally, NO₃ concentrations reported by USGS from 1972 to 1974 were not statistically different than concentrations reported by the Illinois Environmental Protection Agency (IEPA) for four of five river reaches. From 1969 to 1971, NO₃ concentrations reported by the Illinois Department of Public Heath and the Illinois Environmental Protection Agency (IDPH/IEPA) were less than one‐fourth the magnitude of values reported by ISWS. The median NO₃ concentrations measured by the Central Illinois Public Service (CIPS) were significantly greater than those measured by USGS and IDPH/IEPA in the three comparable sampling locations. The use of NO₃ concentrations measured by CIPS and IDPH/IEPA prior to 1972 is not recommended.     

Steady-state analyses for reactive distillation control: An MTBE case study

An approach, based purely on steady-state analyses, for synthesizing effective control structures for reactive distillation (RD) columns is presented. The main idea is to analyze the steady-state relationships between the manipulated (input) variables and the potential controlled (output) variables to identify input–output (IO) pairings that are sensitive and avoid steady-state multiplicities providing a large range of nearly linear operating region around the base case design. Traditional SISO control loops are then implemented using these IO pairings to obtain control structures that maintain the column near the design product purity and conversion for the anticipated primary disturbances. The Niederlinski Index is used to eliminate dynamically unstable pairings in control structures with multiple loops. The approach is demonstrated on an example MTBE RD column. The impact of steady-state multiplicities on control structure design is highlighted.     

Nitrogen removal in laboratory model leachfields with organic-rich layers

Septic system leachfields can release dissolved nitrogen in the form of nitrate into ground water, presenting a significant source of pollution. Low cost, passive modifications, which increase N removal in traditional leachfields, could substantially reduce the overall impact on ground water resources. Bench-scale laboratory models were constructed to evaluate the effect of placing an organic layer below the leachfield on total N removal. The organic layer provides a carbon source for denitrification. Column units representing septic leachfields were constructed with sawdust-native soil organic layers placed 0.45 m below the influent line and with thicknesses of 0.0, 0.3, 0.6, and 0.9 m. Using a synthetic septic tank effluent, NO(3)-N concentrations at 3.8 m below the influent line were consistently below 1 mg L(-1) during 10 months of operation compared with a NO(3)-N concentration of nearly 12 mg L(-1) in the control column. The average total N removal increased from 31% without the organic layer to 67% with the organic layer. Total N removal appeared limited by the extent of organic N oxidation and nitrification in the 0.45-m aerobic zone. Design modifications targeted at improving nitrification above the organic layer may further increase total N removal. Increased organic layer thicknesses from 0.3 m to 0.9 m did not significantly improve average total N removal, but caused a shift in residual nitrogen from organic N to ammonia N. Results indicate that addition of a layer of carbon source material at least 0.3 m thick below a standard leachfield substantially improves total N removal.     

BIOECONOMIC ANALYSIS OF SELECTED CONSERVATION PRACTICES ON SOIL EROSION AND FRESHWATER FISHERIES1

ABSTRACT: Farmers can generate environmental benefits (improved water quality and fisheries and wildlife habitat), but they may not be able to quantify them. Furthermore, farmers may reduce their incomes from managing lands to produce these positive externalities but receive little monetary compensation in return. This study simulated the relationship between agricultural practices, water quality, fish responses to suspended sediment and farm income within two small watersheds, one of a cool water stream and one of a warm water stream. Using the Agricultural Drainage and Pesticide Transport (ADAPT) model, this study related best management practices (BMPs) to calculated instream suspended sediment concentrations by estimating sediment delivery, runoff, base flow, and streambank erosion to quantify the effects of suspended sediment exposure on fish communities. By implementing selected BMPs in each watershed, annual net farm income declined $18,000 to $28,000 (1 to 3 percent) from previous levels. “Lethal” fish events from suspended sediments in the cool water watershed decreased by 60 percent as conservation tillage and riparian buffers increased. Despite reducing suspended sediments by 25 percent, BMPs in the warm water watershed did not reduce the negative response of the fisheries. Differences in responses (physical and biological) between watersheds highlight potential gains in economic efficiency by targeting BMPs or by offering performance based “green payments.”