基于汶川8.0级强震记录的近场地震动特征分析

在汶川8.0级大地震中,国家数字强震动台网布设在龙门山断裂带及其周围地区的50多个台站获得了大于100 Gal的加速度记录。选取其中断层附近11个台站的加速度记录,分别进行了地震反应谱分析和基于正交化HHT法的能量分布特征分析,通过对竖向与水平向加速度峰值比、竖向与水平向加速度反应谱比值,以及能量分布和峰值系数的分析与比较,探讨了汶川地震的近场地震动特征。     

自然灾害社会脆弱性评估研究——以上海市为例

基于投影寻踪聚类模型(PPC),结合基于实数编码的加速遗传算法(RAGA),对上海市进行了自然灾害社会脆弱性评估的尝试。结果表明:①灾害社会脆弱性最高的为崇明县,其次为宝山区和金山区;②灾害社会脆弱性最低的是黄埔区,其次是徐汇区和静安区;③总体而言,灾害脆弱性较低的地区集中于上海城市中心区,而城市边缘区的社会脆弱性一般较高。     

台风灾害债券设计——基于广东省数据的实证研究

台风作为全球发生频率最高,影响最严重的一种自然灾害,对我国的影响也非常严重。在巨灾风险证券化、巨灾债券已成为巨灾保险业大趋势的背景下,发展我国台风灾害债券具有重要的现实意义。以我国受台风灾害影响最严重的省份——广东省为研究对象,收集了其近30年相关台风损失数据,利用非寿险精算技术分析其台风的损失分布和次数分布,在此基础上利用CAMP模型和现金流分析对广东省的台风灾害债券做了初步设计。     

火灾下约束钢柱临界温度的简化计算方法

在火灾条件下,约束钢柱轴力由于升温而增加,会导致在较低的温度下发生屈曲;但屈曲后,钢柱的轴向温度膨胀得到释放,轴力下降,因此屈曲后钢柱仍能继续承栽。本文通过计算长度系数将转动约束钢柱转换为铰支钢柱,给出了一种轴向约束钢柱在火灾升温条件下的临界温度的简化计算方法——轴力放大系数设计方法。此法通过轴力放大系数将轴向约束钢柱转化为无约束钢柱,再按无约束钢柱计算得到钢柱的临界温度。用验证过的有限元模型对简化计算方法进行了验证,计算结果表明简化方法吻合较好。     

断裂构造对斜坡应力场影响的数值模拟及成灾机理研究

断裂构造及活动强度对斜坡体的应力场分布具有重要的影响。采用基于强度折减法的有限元法,分别以正断层和逆断层与斜坡体的组合关系为例,剖析了断裂构造对斜坡体应力场的影响及成灾机理,揭示了含有断层的斜坡体塑性区的贯通过程。研究表明,包含断层的斜坡体在应力分布特征及斜坡变形破坏机理方面与无断层的斜坡体有较大差别:含断层的斜坡体在坡面和断层面附近的最大主应力迹线与坡面或断层面相平行,在天然状态下,塑性区同时出现在坡脚和断层面后方,随着折减系数的增大,塑性区分别从坡脚和断层面后方向坡体深部和上部发展,直至断层面前后两个塑性区相贯通,坡体发生破坏,并且对坡体变形破坏的影响程度以逆断层最强,其次为正断层,断层不活动时较弱。     

750kV罐式断路器内部接地故障保护动作行为分析

针对一起750kV罐式断路器内部接地故障,通过对保护动作数据和波形图进行综合分析,快速、准确地找出故障点并排除了故障。分析结果表明:故障原因为拉杆绝缘材料存在质量问题,在稳态电压下内部放电,致使其绝缘击穿。     

NOx Removal with Combined Selective Catalytic Reduction and Selective Noncatalytic Reduction: Pilot-Scale Test Results

Pilot-scale tests were conducted to develop a combined nitrogen oxide (NO_x) reduction technology using both selective catalytic reduction (SCR) and selective noncatalytic reduction (SNCR). A commercially available vanadium- and titanium-based composite honeycomb catalyst and enhanced urea (NH₂CONH₂) were used with a natural-gas-fired furnace at a NO_x concentration of 110 ppm. Changes in SNCR chemical injection temperature and stoichiometry led to varying levels of post-furnace ammonia (NH₃), which acts as the reductant feed to the downstream SCR catalyst. The urea-based chemical could routinely achieve SNCR plus SCR total NO_x reductions of 85 percent with less than 3 ppm NH₃ slip at reductant/NO_x stoichiometries ranging from about 1.5 to 2.5 and SCR space velocities of 18,000 to 32,000 h^?1. This pilot-scale research has shown that SNCR and SCR can be integrated to achieve high NO_x removal. SNCR provides high temperature reduction of NO_x followed by further removal of NO_x and minimization of NH₃ slip by a significantly downsized (high-space velocity) SCR.     

The Relationship between the Quantity of Heavy Metal and PAHs in Fly Ash

ABSTRACT

Heavy metal and polycyclic aromatic hydrocarbons (PAHs) in flue gas have received considerable attention in recent years due to their mutagenic or carcinogenic properties. The present study is carried out to investigate the influence of the quantity of heavy metals on PAHs formation in fly ash.

A fluidized bed incinerator was used in this experiment to obtain fly ash of chemical similarity by incinerating various compositions of waste. The obtained fly ash, both with and without heavy metal, were used to adsorb the PAHs in the flue gas and to investigate the formation of PAHs in fly ash. The results indicate that carbon and heavy metals most greatly influence the formation of PAHs in the fly ash. Carbon is absorptive; heavy metals encourage not only absorption of PAHs but also catalyze PAHs formation.     

Analysis of a Summertime PM2.5 and Haze Episode in the Mid-Atlantic Region

Abstract

Observations of the mass and chemical composition of particles less than 2.5 μm in aerodynamic diameter (PM_2.5), light extinction, and meteorology in the urban Baltimore-Washington corridor during July 1999 and July 2000 are presented and analyzed to study summertime haze formation in the mid-Atlantic region. The mass fraction of ammoniated sulfate (SO₄ ^2-) and carbonaceous material in PM_2.5 were each ～50% for cleaner air (PM_2.5 < 10 μg/m³) but changed to ～60% and ～20%, respectively, for more polluted air (PM_2.5 > 30 μg/m³). This signifies the role of SO₄ ^2- in haze formation. Comparisons of data from this study with the Interagency Monitoring of Protected Visual Environments network suggest that SO₄ ^2? is more regional than carbonaceous material and originates in part from upwind source regions. The light extinction coefficient is well correlated to PM_2.5 mass plus water associated with inorganic salt, leading to a mass extinction efficiency of 7.6 ± 1.7 m²/g for hydrated aerosol. The most serious haze episode occurring between July 15 and 19, 1999, was characterized by westerly transport and recirculation slowing removal of pollutants. At the peak of this episode, 1-hr PM_2.5 concentration reached ～45 μg/m³, visual range dropped to ～5 km, and aerosol water likely contributed to ～40% of the light extinction coefficient.     

The Reuse of Biosludge as an Adsorbent from a Petrochemical Wastewater Treatment Plant

Abstract

Biosludge was obtained from a petrochemical industry’s biological wastewater treatment plant. Zinc chloride (ZnCl₂) was used as a sludge activation agent during the pyrolytic process. Scanning electron microscope (SEM) image photographs, element composition, surface functional group, and pore structure were analyzed for the sludge adsorbent characteristics. Results indicated the proper ZnCl₂-immersed concentration, pyrolytic temperature, and time could produce adsorbent from the bio-sludge. The optimal conditions for a larger surface area adsorbent were 3 M ZnCl₂-immersed sludge pyrolyzed at 600 °C for 30 min and washed with 3 N hydrochloric acid (HCl) solution and distilled water. The predominant pore size of the sludge adsorbent was the mesopore.