表面活性剂加强动电技术去除污泥中铜和镉

以实际城市污泥为研究对象,通过采用表面活性剂作为阴极液,并考虑阴极液pH值、表面活性剂类型和电压3种因素对动电技术去除污泥中重金属(铜和镉)的影响,选用正交试验确定最佳试验条件.结果表明,采用表明活性剂作为阴极液加强动电技术去除污泥中重金属足可行的,铜和镉的去除率分别达到11.1%～52.6%和9.1%～46.7%.通过对正交试验结果进行极差和方差分析,试验的最佳条件为:电压为20 V,阴极液加入十六烷基三甲基氯化铵并控制pH值为4～6.表面活性剂的类型对动电技术去除镉具有显著影响.其中,表面活性剂类型对动电过程的影响最大,阴极液pH值次之,电压影响最小.     

珠江三角洲4种淡水养殖鱼类重金属的残留及食用风险评价

为全面了解珠江三角洲淡水水产品中重金属污染现状,评估其生态风险与食用安全,于2014年8月至2015年8月采集罗非鱼、草鱼、乌鳢及鳜鱼主要养殖鱼类样品共计57份,采用原子荧光光谱仪(AFS),电感耦合等离子体质谱(ICP-MS)仪进行分析测定,并采用单因子污染指数(Pi)、重金属污染指数(MPI)、每周可耐受摄入量(PTWI)以及食入健康风险指标(Ri总)分别评估其污染程度、食用安全性与健康风险。结果表明,样品中Cr、Ni、Cu、Zn、As、Cd、Hg、Pb的含量范围分别为0.020~3.240,0.020~0.800,0.110~1.100,0.190~19.970,0.030~1.480,nd~0.606,0.003~0.118,0.040~0.803 mg·kg-1(湿重),Cr、As、Cd、Pb在水产品中超标率大小依次为As(7.0%),Pb(7.0%),Cd(5.3%),Cr(1.8%)。Pi结果表明,目前珠江三角洲养殖水域水产品中Cu与Zn残留处于正常范围内,Cr和Hg有少量样品为轻度污染,Pb、Cd与As存在重度污染样品,所占比例为2.86%、6.02%和5.74%。MPI结果显示不同水产品污染程度为乌鳢>鳜鱼>罗非鱼>草鱼,总体上各种水产品MPI依然处于较低的水平;食用安全性结果显示,目前成人每周摄入水产品是安全的,但乌鳢Cr,罗非鱼As含量较高分别达到PTWI的37.76%和19.51%,表明水产品中Cr、As残留可能存在一定的食用安全隐患。健康风险模型结果显示,所有样品均未超过国际辐射防护委员会(ICRP)的推荐的最大可接受水平(5×10-6a-1)。综合分析珠江三角洲淡水养殖主要水产品可知,其尚未出现明显的污染安全问题,但As与Cr等元素的潜在风险值得进一步关注。     

利用污泥熟肥作为高含水率污泥堆肥调理剂

采用静态强制通风好氧堆肥的方法,以木屑作为对比,考察了利用污泥熟肥作为调理剂对污泥堆肥过程的影响。结果表明,与以木屑作为调理剂的污泥堆体(对照组)相比,以污泥熟肥作为调理剂的污泥堆体(实验组)升温快,高温阶段(>50℃)持续时间长达10 d,满足粪便无害化卫生标准的要求,而对照组仅持续了2 d;实验组腐熟的堆肥含水率从60%降到39%,下降了21%,pH维持在7.5～8.5范围内,微生物活性较强,而对照组含水率仅下降15%,pH始终低于7.5;实验组种子发芽指数(GI)在第14天就回升到80%以上,基本上去除了植物毒性,而对照组GI在第22天才回升到50%。总体而言,污泥熟肥能显著改善堆肥中微生物的微环境,促进有机物的降解,缩短堆肥腐熟时间,是一种优质的调理剂。     

Ozonation as an advanced oxidant in treatment of bamboo industry wastewater

The present study employed ozonation process to treat the bamboo industry wastewater (BIWW). The impact of ozone dosage and initial organic concentration on color, COD and TOC removal rates were studied along with characterization of the major organics in raw and treated wastewater. The results suggested the ozone dosage of 3.15 g h⁻¹ (concentration 52.5 mg L⁻¹) was suitable for the treatment. After 25 min ozonation of 1 L raw wastewater, the color, COD and TOC removal efficiencies were 95%, 56% and 40%, respectively, with an influent COD concentration of 835 mg L⁻¹. The ratio of kg O₃ kg⁻¹ COD at 3.15 g h⁻¹ was 2.8 (<3), revealing that ozonation was a cost effective process for tertiary treatment of BIWW. Longer oxidization time was required to achieve similar results for raw wastewater with higher COD concentration. The chromatogram from gel permeation chromatography revealed that ozonation resulted in the breakdown of high molecular weight compounds into lower molecular weight components but could not completely mineralize the organic matter. The majority of these compounds were identified in both raw and ozonated samples via GC-MS analysis. In addition to ester derivatives as the main intermediates of ozonation, 1-chloroctadecane, methyl stearate, benzophenone and α-cyperone were identified as the by-products of ozonation.     

Harvesting of Chlorella sp. using hollow fiber ultrafiltration

Introduction

The suitability of the application of ultrafiltration (UF) to harvest Chlorella sp. from the culture medium was examined. We investigated the effects of two improved UF system, forward air?Cwater flushing and backwash with permeate, on the concentration process.

Materials and methods

Backwash with permeate was selected as an optimization of the improved UF system, which was more effective for permeate flux recovery. Moreover, the hollow fiber UF system by adding periodical backwash with permeate was examined for Chlorella sp. harvesting.

Results and discussion

It was found that Chlorella sp. could be concentrated with high recovery in a lab-scale experiment. An overall algal biomass recovery of above 90% was achieved when the volume concentration factor was 10. For an original biomass of 1.3?±?0.05?g/L, 1?min backwash followed by 20?min forward concentrating was more effective, which resulted in a recovery of 94% and a high average flux of 30.3?L/m²/h. In addition, the algal recovery was highly correlated to the volume concentration factor and the initial biomass. A high concentration factor or a high initial biomass resulted in a low biomass recovery.     

改性CMC聚合物吸附酸法地浸废水中的铀

在温度为70～80℃、单体质量浓度为30%～35%、羧甲基纤维素∶丙烯酸(质量比)为10∶2.5、反应时间为3.5～4 h条件下对CMC进行改性,接枝率可达68%以上。以改性前后的CMC为吸附剂,对模拟酸法地浸含铀废水进行了对比吸附实验研究。结果表明:改性CMC对铀吸附效果最佳的实验条件为:改性CMC质量浓度为0.10 g/L,温度为25℃,pH为5.0,吸附时间100 min,此时铀去除率达到了97.1%,比CMC改性后对铀的吸附率平均提高了近21%。影响吸附效果程度由强到弱的顺序为:改性CMC投加量、pH、吸附时间、温度。     

微生物絮凝剂与聚合氯化铝复配处理涂料废水的响应面优化

采用响应面分析法对聚合氯化铝(PAC)与污泥生产的微生物絮凝剂复配处理涂料废水的过程进行了优化,设定的响应值为COD和色度去除率。实验分别拟合了关于COD去除率和色度去除率的二次模型,根据响应值的分布情况,确定涂料废水的最佳絮凝条件为微生物絮凝剂浓度47 mg/L,PAC浓度39 mg/L,pH为8.2,CaCl2浓度0.38 g/L,搅拌速度210 r/min。最佳絮凝条件下,微生物絮凝剂对涂料废水中COD和色度的去除率分别达到77.6%和68.9%。     

好氧-缺氧-闲置运行模式处理生活污水

在3个序批式反应器中,利用好氧-缺氧-闲置的运行模式处理实际生活污水,比较了不同曝气时间（2、3和4h）条件下的处理效果,结果表明,在R2（2 h）反应器中成功实现了单级好氧除磷和内聚物驱动的短程硝化反硝化。采用此反应器运行模式,对实际生活污水进行长期处理,反应器的COD、TN和TP的平均去除率分别为85.29%、74.09%和87.97%。本研究表明,在好氧-缺氧-闲置的运行模式下处理生活污水,能成功地实现单级好氧除磷与内聚物驱动的短程硝化反硝化的结合,并且在长期运行的过程中,能稳定地取得较好的脱氮、除磷效率。     

黑藻对铅离子的生物吸附

研究了黑藻对Pb^2＋的生物吸附作用,考察了溶液pH、Pb^2＋初始质量浓度、黑藻加入量和吸附时间对吸附效果的影响。实验结果表明,溶液pH在2．5～5．0时吸附效果最好,吸附20min基本达到平衡。在溶液pH为4．0、黑藻加入量为2g／L、吸附时间为60min、Pb^2＋初始质量浓度为100mg／L的条件下,黑藻对Pb^2＋的吸附量为47．5mg／g。通过元素分析和等温吸附模型对黑藻吸附Pb^2＋的机理进行了研究,发现黑藻吸附Pb“是阳离子交换过程,吸附符合Langmuir、Freundlich和D—R等温吸附模型。考察了Cd^2＋、Cu^2＋和Ni^2＋对黑藻吸附Pb^2＋的影响,结果表明,Cd^2＋、Cu^2＋和Ni^2＋的存在不干扰黑藻对Pb^2＋的吸附。