硫化氢分解制取氢和硫技术的进展

介绍了 H2 S分解制氢和硫的热力学、动力学最新研究成果 ,综述了 H2 S分解制氢和硫的各种工艺技术的新进展 ,并对这些工艺技术进行了分析和评述。 H2 S分解制氢的同时回收硫是一种很有前途的治理废气减轻污染的方法。     

一种富稀土型三效催化剂的性能考察

对一种富烯土型三效催化剂的性能进行了考察，结果表明：该催化剂具有较好的三效活性和较好的启燃温度特性，具有较宛的空速适应范围，在空速为84000h^-1时，CO,NOx的转化率仍在90％以上，HC转化率仍在70％以上，该催化剂具有较好的耐老化性能，经实验室快速老化实验，即相当于实车行驶8万km,CO劣化系数，1.09,HC劣化系1．05，NOx劣化系数1．06，该催化剂经桑塔纳轿车整车28工况测试，其交化效果与该车配置的美国Engelherd公司的催化剂相当。     

新疆百重7井区油田开发对地下水环境的影响分析

新疆百重7井区为新疆百口腺地下水的汇集径流区,是克拉玛依市生尖生产用水水源之一，在此处进行油田开发，使得保护该区地下水环境成为开发工程的重中之重，由新疆百重7井区油田开发对地下水环境的影响分析可知，正常状况下的油田开发对地下水的影响很小，一旦发生事故，则对地下水的影响很大，必须采取适当措施，保护该区丰富的地下水资源。     

论突发地质事件与形成胶莱盆地金矿关系

中生代后期 ,太平洋板块的俯冲作用使胶南地体拉分 ,断陷形成胶莱盆地。这一突发地质事件在盆地底部地势低洼部位形成局限水体 ,接受周围古老地层风化剥蚀产物的沉积而形成富含有机质、富金的莱阳群一段含矿岩系。此突发地质事件晚期的进一步改造成矿作用导致在含矿岩系不同岩性中形成不同类型的金矿床     

白云鄂博矿开发利用中放射性废渣对环境的污染及防治

包头境内的白云鄂博矿是一座资源丰富的大型矿山，已为我国大型钢铁稀土联合企业开采利用40余年，白云鄂博原矿平均伴生天然，在矿物资源的开发利用中，对环境造成放射性污染。本文从白云鄂博矿资源、资源特殊性，开发利用，放射性废渣及钍核素排放等方面进行论述，并提出防治控制管理措施。     

Spatial–temporal characteristics of haze and vertical distribution of aerosols over the Yangtze River Delta of China

Variation of haze events occurred in the Yangtze River Delta(YRD) of China, the characteristics of meteorological elements and the vertical distribution of aerosols during haze episodes were analyzed by utilizing data of ground observation, radiosonde and CALIPSO. The results illustrate that the frequency of haze events between 1981 and 2010 peaked in winter but bottomed out in summer and decreased from north to south in the YRD region, reaching at the lowest point in "low frequency center" — Shanghai. When haze happened, the most seriously affected area was 2–4 km above the ground and the concentrated range of total backscattering coefficient(TBC) that decreased with altitude was 0.8 × 10~(-3)–2.5 × 10~(-3) km~(-1)·sr~(-1). Particulate depolarization ratio(PDR) was less than 40%in a large part and 93% aerosols over the YRD area were regular particles, while the irregular ones concentrated on 2 km above the surface and the irregularity rose up but the diversity diminished when altitude increased. Color ratio(CR) was lower than 1.2 mostly at all altitudes and distributed asymmetrically above the ground. Nearly 80% aerosols under10 km were fine particles(CR 1.0) and 22.54% coarse particles(CR 1.0) clustered at 2–4 km. Large particles(CR 1.2) aggregated in lower troposphere massively yet relatively smaller ones gathered in middle and upper troposphere. In the YRD region, aerosols with more powerful capabilities were wider and less regular than the ones of Northwestern China.     

Effect of TiO2 nanoparticle aggregation on marine microalgae Isochrysis galbana

TiO_2 nanoparticles(NPs) could adversely impact aquatic ecosystems. However, the aggregation of these NPs could attenuate this effect. In this work, the biological effects of TiO_2 NPs on a marine microalgae Isochrysis galbana were investigated. The aggregation kinetics of TiO_2 NPs under different conditions was also investigated to determine and understand these effects. Results showed that, though TiO_2 NPs had no obvious impact on the size and reproducibility of algal cells under testing conditions, they caused a negative effect on algal chlorophyll, which led to a reduction in photosynthesis. Furthermore, fast aggregation of TiO_2 NPs occurred under all conditions, especially at the pH close to the p Hzpc. Increasing ionic strength and NP concentration also enhanced the aggregation rate.The aggregation and the following sedimentation of TiO_2 NPs reduced their adverse effects on I. galbana.     

A comprehensive classification method for VOC emission sources to tackle air pollution based on VOC species reactivity and emission amounts

In China, volatile organic compound(VOC) control directives have been continuously released and implemented for important sources and regions to tackle air pollution. The corresponding control requirements were based on VOC emission amounts(EA), but never considered the significant differentiation of VOC species in terms of atmospheric chemical reactivity. This will adversely influence the effect of VOC reduction on air quality improvement. Therefore,this study attempted to develop a comprehensive classification method for typical VOC sources in the Beijing–Tianjin–Hebei region(BTH), by combining the VOC emission amounts with the chemical reactivities of VOC species. Firstly, we obtained the VOC chemical profiles by measuring 5 key sources in the BTH region and referencing another 10 key sources, and estimated the ozone formation potential(OFP) per ton VOC emission for these sources by using the maximum incremental reactivity(MIR) index as the characteristic of source reactivity(SR). Then, we applied the data normalization method to respectively convert EA and SR to normalized EA(NEA) and normalized SR(NSR) for various sources in the BTH region.Finally, the control index(CI) was calculated, and these sources were further classified into four grades based on the normalized CI(NCI). The study results showed that in the BTH region,furniture coating, automobile coating, and road vehicles are characterized by high NCI and need to be given more attention; however, the petro-chemical industry, which was designated as an important control source by air quality managers, has a lower NCI.     

Are current Chinese national ambient air quality standards on 24-hour averages for particulate matter sufficient to protect public health?

With rapid economic development and urbanization in recent decades, China has experienced the worsening of ambient air quality. For better air quality management to protect human health, Chinese government revised national ambient air quality standards(NAAQS) for particulate matter(PM) in 2012(GB3095-2012). To assess the effectiveness of current NAAQS for PM on public health in Chinese population, we conducted a metaanalysis on published studies examining the mortality risk of short-term exposure to PM with aerodynamic diameters less than 10 and 2.5 μm(PM_(10) and PM_(2.5)) in China. The reported24-hour concentrations of PM_(10) and PM_(2.5) in studies ranged from 43.5 to 150.1 μg/m~3 and 37.5 to 176.7 μg/m~3. In the pooled excess, mortality risk estimates of short-term exposure to PM.In specific, per 10 μg/m~3 increase in PM_(10), we observed increases of 0.40%(95%CI: 0.33%,0.47%), 0.57%(95%CI: 0.44%, 0.70%) and 0.49%(95%CI: 0.40%, 0.58%) in total, respiratory and cardiovascular mortality, per 10 μg/m~3 increase in PM_(2.5), we observed increases of 0.51%(95%CI: 0.38%, 0.63%), 0.62%(95%CI: 0.52%, 0.73%) and 0.75%(95%CI: 0.54%, 0.95%) in total,respiratory and cardiovascular mortality. Finally, we derived 125 μg/m~3 for PM_(10) and 62.5 μg/m~3 for PM_(2.5) as 24-hour recommendation values based on the pooled estimates. Our results indicated that current Chinese NAAQS for PM could be sufficient in mitigating the excess mortality risk from short-term exposure to ambient PM. However, future research on longterm exposure cohort studies in Chinese population is also essential in revising annual averages for PM in Chinese NAAQS.     

Soot reduction by addition of dimethyl carbonate in normal and inverse ethylene diffusion flames: Nanostructural evidence

Oxygenated fuel represents an attractive alternative as an additive for reducing soot emissions.Dimethyl carbonate(DMC) is an oxygenated compound which is a good option to reduce soot,but the detailed characteristics of soot produced from combustion of hydrocarbon fuels blended with DMC are still lacking. The present research studied the nanostructure and reactivity of soot particles in ethylene/DMC normal and inverse diffusion flames. High resolution transmission electron microscopy(HRTEM), X-ray diffraction(XRD), and thermogravimetric analysis(TGA)were used to analyze the nanostructure and reactivity of soot. It was found that DMC addition was effective in decreasing the average weights of soot formed in flames. The results of HRTEM images showed that soot particles obtained with DMC addition showed liquid-like material and tight bonding, and exhibited more highly disorganized layers, which give it higher reactivity than soot obtained without DMC addition. Furthermore, HRTEM was used to analyze soot fringe characteristics consisting of fringe tortuosity, fringe length, and fringe separation. XRD was used to crosscheck the results for fringe separation, and was consistent with HRTEM results. In addition, the mass loss curve of TGA experiments showed that DMC addition could enhance the reactivity of soot particles.