An investigation on pollutant emissions from co-firing of RDF and coal

Pollutant emissions from co-firing of refuse derived fuel (RDF) and coal were investigated in a vortexing fluidized bed combustor (VFBC). RDF-5 was made of common municipal solid waste (MSW). CaCO₃ was injected in the combustor to absorb HCl at 850 °C. The results show that NO_x and HCl emissions increase with RDF-5 co-firing ratio. The NO_x concentration in flue gas at the bottom of the combustor is higher than that at the top. However, the trend of HCl released is reverse compared with NO_x emissions. It was found that the HCl concentration decreases with increasing the molar ratio of Ca/Cl. However, the effect of CaCO₃ addition on HCl retention is not significant when the molar ratio of Ca/Cl is higher than 5. The chlorine content in fly ash increases obviously with the molar ratio of Ca/Cl. PCDD/Fs emissions decrease slightly with an addition of CaCO₃. In this study incomplete combustion is regarded as the main cause for polychlorinated dibenzo-p-dioxins and dibenzofurans (PCDD/Fs) formation.     

Mineralogy and pore water chemistry of a boiler ash from a MSW fluidized-bed incinerator

This paper presents an investigation of the mineralogy and pore water chemistry of a boiler ash sampled from a municipal solid waste fluidized-bed incinerator, subject to 18 months of dynamic leaching in a large percolation column experiment. A particular focus is on the redox behaviour of Cr(VI) in relation to metal aluminium Al⁰, as chromium may represent an environmental or health hazard. The leaching behaviour and interaction between Cr(VI) and Al⁰ are interpreted on the basis of mineralogical evolutions observed over the 18-month period and of saturation indices calculated with the geochemical code PhreeqC and reviewed thermodynamic data. Results of mineralogical analyses show in particular the alteration of mineral phases during leaching (e.g. quartz and metal aluminium grains), while geochemical calculations suggest equilibria of percolating fluids with respect to specific mineral phases (e.g. monohydrocalcite and aluminium hydroxide). The combination of leaching data on a large scale and mineralogical analyses document the coupled leaching behaviour of aluminium and chromium, with chromium appearing in the pore fluids in its hexavalent and mobile state once metal aluminium is no longer available for chromium reduction.     

Environmentally Friendly Polyurethane Composites: Preparation, Characterization and Mechanical Properties

The waterborne polyurethane (PU) prepolymer was prepared based on isophorone diisocyanate (IPDI), polyester polyol (N220), dimethylol propionic acid (DMPA) and hydroxyethyl methyl acrylate (HEMA). The modified waterborne polyurethane–acrylate (PUA) emulsions were obtained with different proportions of acrylate (butyl acrylate and methyl methacrylate) and initiating agent by in situ dispersion technique. The structures and thermal properties of prepared PU and PUA were analyzed and characterized with FT-IR, UV–Vis spectroscopy and DSC. The PUA hybrid samples had lower glass transition temperature of hard segment and higher decomposition temperatures than PU sample. Performances of the emulsion and film were studied by means of apparent viscidity, particle size and polydispersity, surface tension and mechanical properties. The results indicated that the particle sizes of the PUA dispersions were larger than those of the pure PU and the solvent resistance, mechanical properties of PUA films was improved compare with the unmodified polyurethane film. The film had the biggest hardness and the least water absorption when the BA/MMA mass ratio 5:5 modified PU. The obtained PUA have great potential application such as coatings, leather finishing, adhesives, sealants, plastic coatings and wood finishes.     

Design and risk assessment tool for vegetative treatment areas receiving agricultural wastewater: Preliminary results

Vegetative treatment areas (VTAs) are commonly being used as an alternative method of agricultural process wastewater treatment. However, it is also apparent that to completely prevent discharge of pollutants to the surrounding environment, settling of particulates and bound constituents from overland flow through VTAs is not sufficient. For effective remediation of dissolved agricultural pollutants, VTAs must infiltrate incoming wastewater. A simple water balance model for predicting VTA soil saturation and surface discharge in landscapes characterized by sloping terrain and a shallow restrictive layer is presented and discussed. The model accounts for the cumulative effect of successive rainfall events and wastewater input on soil moisture status and depth to water table. Nash–Sutcliffe efficiencies ranged from 0.65 to 0.81 for modeled and observed water table elevations after calibration of saturated hydraulic conductivity. Precipitation data from relatively low, average, and high annual rainfall years were used with soil, site, and contributing area data from an example VTA for simulations and comparisons. Model sensitivity to VTA width and contributing area (i.e. barnyard, feedlot, silage bunker, etc.) curve number was also investigated. Results of this analysis indicate that VTAs should be located on steeper slopes with deeper, more-permeable soils, which effectively lowers the shallow water table. In sloping landscapes (>2%), this model provides practitioners an easy-to-use VTA design and/or risk assessment tool that is more hydrological process-based than current methods.     

Quantifying the effects of trampling and habitat edges on forest understory vegetation – A field experiment

We investigated the effects of human trampling on boreal forest understory vegetation on, and off paths from suburban forest edges towards the interiors and on the likelihood of trampling-aided dispersal into the forests for three years by carrying out a trampling experiment. We showed that the vegetation was highly sensitive to trampling. Even low levels of trampling considerably decreased covers of the most abundant species on the paths. Cover decreased between 10 and 30% on paths which had been trampled 35 times, and at least by 50% on those trampled 70–270 times. On-path vegetation cover decreased similarly at forest edges and in the interiors. However, some open habitat plant species that occurred outside the forest patches and at forest edges dispersed into the forests, possibly through the action of trampling. A higher cover percentage of an open habitat species at the forest edge line increased its probability to disperse into the forest interior. The vegetation community on, next to, and away from lightly trampled paths remained the same throughout the trampling experiment. For heavily trampled paths, the community changed drastically on the paths, but stayed relatively similar next to and away from the paths. As boreal vegetation is highly sensitive to the effects of trampling, overall ease of access throughout the forest floor should be restricted to avoid the excessive creation of spontaneous paths. To minimize the effects of trampling, recreational use could be guided to the maintained path network in heavily used areas.     

Resource Use Among Rural Agricultural Households Near Protected Areas in Vietnam: The Social Costs of Conservation and Implications for Enforcement

This article examines the use of forests in a protected area by nearby agriculturalists in central Vietnam. Research indicates that the majority of rural farmers interviewed who lived near a state designated protected area were receiving both subsistence and cash incomes from forest-based activities, primarily from the collection of forest products. However, much of the collection of forest produce was officially illegal, as it occurred in state protected forests, and interdiction efforts were on the increase. Yet, little attention has been paid in Vietnam to the need for income substitution for households who lose access to forest produce as a result of conservation enforcement, particularly in the case of farmers who live near, but not in, protected areas; their resources use has been ‘invisible’ due to a lack of attention and research on the topic. This misunderstanding of the importance of forests to rural farmers has the potential to result in households facing adverse welfare and livelihood outcomes as protected areas boundaries are tightened, and local communities face increased opportunity costs due to stricter conservation enforcement. The article concludes that substitution for loss of income due to conservation activities would best be achieved through carefully targeted interventions to specific high-impact and high-dependency households. Additionally, investments in new sources of wage labor and other low capital-input activities, rather than in agriculture, would likely be of most benefit.     

The potential of algae blooms to produce renewable gaseous fuel

Ulva lactuca (commonly known as sea letuce) is a green sea weed which dominates Green Tides or algae blooms. Green Tides are caused by excess nitrogen from agriculture and sewage outfalls resulting in eutrophication in shallow estuaries. Samples of U. lactuca were taken from the Argideen estuary in West Cork on two consecutive years. In year 1 a combination of three different processes/pretreatments were carried out on the Ulva. These include washing, wilting and drying. Biomethane potential (BMP) assays were carried out on the samples. Fresh Ulva has a biomethane yield of 183 L CH₄/kg VS. For dried, washed and macerated Ulva a BMP of 250 L CH₄/kg VS was achieved. The resource from the estuary in West Cork was shown to be sufficient to provide fuel to 264 cars on a year round basis. Mono-digestion of Ulva may be problematic; the C:N ratio is low and the sulphur content is high. In year 2 co-digestion trials with dairy slurry were carried out. These indicate a potential increase in biomethane output by 17% as compared to mono-digestion of Ulva and slurry.     

A comparative assessment of waste incinerators in the UK

The uptake in Europe of Energy from Waste (EfW) incinerator plants has increased rapidly in recent years. In the UK, 25 municipal waste incinerators with energy recovery are now in operation; however, their waste supply chains and business practices vary significantly. With over a hundred more plant developments being considered it is important to establish best business practices for ensuring efficient environmental and operational performance. By reviewing the 25 plants we identify four suitable case study plants to compare technologies (moving grate, fluidised bed and rotary kiln), plant economics and operations. Using data collected from annual reports and through interviews and site visits we provide recommendations for improving the supply chain for waste incinerators and highlight the current issues and challenges faced by the industry. We find that plants using moving grate have a high availability of 87–92%. However, compared to the fluidised bed and rotary kiln, quantities of bottom ash and emissions of hydrogen chloride and carbon monoxide are high. The uptake of integrated recycling practices, combined heat and power, and post incineration non-ferrous metal collections needs to be increased among EfW incinerators in the UK. We conclude that one of the major difficulties encountered by waste facilities is the appropriate selection of technology, capacity, site, waste suppliers and heat consumers. This study will be of particular value to EfW plant developers, government authorities and researchers working within the sector of waste management.