Measurement of real time black carbon for investigating spot loading effects of Aethalometer data

Measurements of real-time continuous PM_2.5 black carbon (BC) concentrations were made using a single-wavelength Aethalometer (@880 nm) in three different environments, i.e., an indoor office, a residential indoor living room and an urban site, to evaluate the difference in temporal behaviors of BC particles and investigate the optical shadowing effect in the Aethalometer BC data. An empirical method was used for correcting the optical saturation effect on the original BC data obtained from the measurements at the three sites. Also, the elemental carbon (EC) concentrations from 24-h filter-based measurements of PM_2.5 particles were determined using a thermal optical transmittance (TOT) method at the same urban site for comparison with the Aethalometer BC results. Transient events of BC were often observed for period of a few hours at all sites, reaching a maximum level of 27.3 μg m^?3 at the urban site. The diurnal cycles of the BC concentrations observed at the two indoor environments were found to be considerably affected by the air exchange rate, occupants' behavior patterns and nearby traffic emissions. The time-series plots of the Aethalometer data showed obvious discontinuities at the filter spot change, and a rise in the apparent BC concentrations after filter tape advances. Also, the relationship between the attenuation and BC concentration was found to be non-linear at all sites. The empirical approach presented here demonstrated a definite improvement in the continuity of the BC data across the time gaps of each tape advance. The compensated BC concentration was 1.10–1.23 times greater than the raw BC data, depending on the observation sites, with the highest difference observed between the raw and compensated BC data at an indoor office near a small traffic road. The 24-h integrated EC concentration was approximately 12% higher than the original 24-h average BC concentration and 6% lower than the loading compensated BC concentration, showing that the loading compensation process accounted for the saturation effect of the filter tape.     

Methane production during storage of anaerobically digested municipal organic waste

Anaerobic digestion of source-separated municipal organic waste is considered feasible in Denmark. The limited hydraulic retention in the biogas reactor (typically 15 d) does not allow full degradation of the organic waste. Storage of anaerobically digested municipal organic waste can therefore be a source of methane (CH4) emission that may contribute significantly to the potential global warming impact from the waste treatment system. This study provides a model for quantifying the CH4 production from stored co-digested municipal organic waste and estimates the production under typical Danish climatic conditions, thus quantifying the potential global warming impact from storage of the digested municipal organic waste before its use on agricultural land. Laboratory batch tests on CH4 production as well as temperature measurements in eight full-scale storage tanks provided data for developing a model estimating the CH4 production in storage tanks containing digested municipal organic waste. The temperatures measured in separate storage tanks on farms receiving digested slurry were linearly correlated with air temperature. In storage tanks receiving slurry directly from biogas reactors, significantly higher temperatures were measured due to the high temperatures of the effluent from the reactor. Storage tanks on Danish farms are typically emptied in April and have a constant inflow of digested material. During the warmest months the content of digested material is therefore low, which limits the yearly CH4 production from storage.     

教育性建筑物中的能源效率设计和可再生能源的利用:MEDUCA项目

MEDUCA(教育性建筑模式)项目包括7个国家的8个示范项目.这些项目分布在挪威的格龙(65°);瑞典的哥德堡(58°N);瑞典的Falkenberg(57°N);丹麦的巴勒鲁普(56°N);德国的新明斯特(54°N);西班牙的阿尔梅里亚(36°50'N);意大利的Bagheria(38°N);和希腊的Legraina(38°N).     

Toxaphene chemistry: separation and characterisation of selected enantiomers of the Polychloropinene mixtures

The primary goal for the study presented here was the preparation and characterisation of enantiomeric pure chlorobornane standards (Toxaphene). In this context, we partially modeled the procedure for Polychloropinene production in the former USSR. The initial reaction was ionic addition of hydrogen chloride to (1S)-alpha-pinene resulting predominantly in (1S)-2-endo-chlorobornane. Further photochlorination gave mixtures of chlorinated terpenes with different average content of Cl per molecule. The resulting mixtures were separated on a silica-gel column and a number of known hepta to decachlorobornanes were identified in fractions with the help of NMR and GC (using electron capture and mass spectrometric detection)--but in very unusual ratios as compared to the technical Toxaphene mixture formerly produced by Hercules (USA). Also several previously unknown congeners were isolated or detected. Three of the isolated congeners were obtained in crystalline state and X-ray crystallography showed their enantiomeric purity.     

Effects of pre-treatment technologies on quantity and quality of source-sorted municipal organic waste for biogas recovery

Source-sorted municipal organic waste collected from different dwelling types in five Danish cities and pre-treated at three different plants was sampled and characterized several times during one year to investigate the origin of any differences in composition of the pre-treated waste introduced by city, pre-treatment technology, dwelling type or annual season. The investigated pre-treatment technologies were screw press, disc screen and shredder+magnet. The average quantity of pre-treated organic waste (biomass) produced from the incoming waste varied between the investigated pre-treatment technologies: 59%, 66% and 98% wet weight, respectively (41%, 34% and 2% reject, respectively). The pre-treatment technologies showed differences with respect to distribution of the chemical components in the waste between the biomass and the rejected material (reject), especially for dry matter, ash, collection bag material (plastic or paper) and easily degradable organic matter. Furthermore, the particle size of the biomass was related to the pre-treatment technology. The content of plastic in the biomass depended both on the actual collection bag material used in the system and the pre-treatment technology. The sampled reject consisted mostly of organic matter. For cities using plastic bags for the source-separated organic waste, the expected content of plastic in the reject was up to 10% wet weight (in some cases up to 20%). Batch tests for methane potential of the biomass samples showed only minor variations caused by the factors city, pre-treatment technology, dwelling type and season when based on the VS content of the waste (overall average 459STPm(3)/tVS). The amount of methane generated from 1t of collected waste was therefore mainly determined by the efficiency of the chosen pre-treatment technology described by the mass distribution of the incoming waste between biomass and reject.     

Songbird response to increased willow (Salix spp.) growth in Yellowstone's northern range

After nearly a century of height suppression, willows (Salix spp.) in the northern range of Yellowstone National Park, U.S.A., are increasing in height growth as a possible consequence of wolf (Canis lupus) restoration, climate change, or other factors. Regardless of the drivers, the recent release of this rare but important habitat type could have significant implications for associated songbirds that are exhibiting declines in the region. Our objective was to evaluate bird response to releasing willows by comparing willow structure and bird community composition across three willow growth conditions: height suppressed, recently released, and previously tall (i.e., tall prior to the height increase of released willows). Released and previously tall willows exhibited high and similar vertical structure, but released willows were significantly lower in horizontal structure. Suppressed willows were significantly shorter and lower in horizontal cover than released or previously tall willows. Bird richness increased along a gradient from lowest in suppressed to highest in previously tall willows, but abundance and diversity were similar between released and previously tall willows, despite lower horizontal cover in the released condition. Common Yellowthroat (Geothlypis trichas) and Lincoln's Sparrow (Melospiza lincolnii) were found in all three growth conditions; however, Yellow Warbler (Dendroica petechia), Warbling Vireo (Vireo gilvus), Willow Flycatcher (Empidonax traillii), and Song Sparrow (Melospiza melodii) were present in released and previously tall willows only. Wilson's Warbler (Wilsonia pusilla) was found in previously tall willows only, appearing to specialize on tall, dense willows. The results of our a priori habitat models indicated that foliage height diversity was the primary driver of bird richness, abundance, and diversity. These results indicate that vertical structure was a more important driver of bird community variables than horizontal structure and that riparian and willow-dependent bird species have responded positively to increased willow growth in the region.     

Metals and organotins in multiple bivalve species in a one-off global survey

The Galathea 3 expedition circumnavigated the globe in 2006-2007 and collected marine samples from six continents. Bivalves were collected from harbours, other impacted locations and reference sites, and samples from 57 sites were analyzed for metals and 47 for organotins, to assess current contamination levels on a global scale. Metal concentrations in nine bivalve species were normalised to the Mytilidae family using conversion factors based on cosampled species and literature bioconcentration factors. The lowest metal and tributyltin concentrations were below background assessment concentrations (BACs) agreed in the Oslo-Paris convention (OSPAR) for the North Sea, and at most harbours the concentrations were orders of magnitude above BACs. The lowest concentrations of Cd and Pb measured here suggest that the BACs should be lower in a worldwide context. The sources of metals were classified according to human impact using principal component analysis. High relative concentrations of Hg, Pb and P were source indicators for industrial activity and land use; Zn, organotins, Cd and Cu for shipping activities, and V for oil spills. Generally the concentration levels at reference sites were low, but not always lower than expected impacted areas. The most contaminated areas were harbours, where especially Copenhagen, St Croix and Sydney, can be considered hotspots of tributyltin as well as a number of metals.     

Universities in capacity building in sustainable development: focus on solid waste management and technology.

This paper analyses some of the higher education and research capacity building experiences gained from 1998-2006 by Danish and Malaysian universities. The focus is on waste management, directly relating to both the environmental and socio-economic dimensions of sustainable development. Primary benefits, available as an educational legacy to universities, were obtained in terms of new and enhanced study curricula established on Problem-oriented Project-based Learning (POPBL) pedagogy, which strengthened academic environmental programmes at Malaysian and Danish universities. It involved more direct and mutually beneficial cooperation between academia and businesses in both countries. This kind of university reach-out is considered vital to development in all countries actively striving for global and sustainable development. Supplementary benefits were accrued for those involved directly in activities such as the 4 months of field studies, workshops, field courses and joint research projects. For students and academics, the gains have been new international dimensions in university curricula, enhanced career development and research collaboration based on realworld cases. It is suggested that the area of solid waste management offers opportunities for much needed capacity building in higher education and research, contributing to sustainable waste management on a global scale. Universities should be more actively involved in such educational, research and innovation programmes to make the necessary progress. ISWA can support capacity building activities by utilizing its resources--providing a lively platform for debate, securing dissemination of new knowledge, and furthering international networking beyond that which universities already do by themselves. A special challenge to ISWA may be to improve national and international professional networks between academia and business, thereby making education, research and innovation the key driving mechanisms in sustainable development in solid waste management.     

Evaluation of the readsorption of plutonium and americium in dynamic fractionations of environmental solid samples

A dynamic extraction system exploiting sequential injection (SI) for sequential extractions incorporating a specially designed extraction column is developed to fractionate radionuclides in environmental solid samples such as soils and sediments. The extraction column can contain up to 5 g of a soil sample, and under optimal operational conditions it does not give rise to creation of back pressure. Attention has been placed on studies of the readsorption problems during sequential extraction using a modified Standards, Measurements and Testing (SM&T) scheme with four-step sequential extractions. The degree of readsorption in dynamic and conventional batch extraction systems is compared and evaluated by using a double-spiking technique. A high degree of readsorption of plutonium and americium (>75%) was observed in both systems, and they also exhibited similar distribution patterns of the two radionuclides. However, the dynamic system is fully automated, eliminates manual separations, significantly reduces the operational time required, and offers detailed kinetic information.