海域有机污染物优先排序和风险分类模糊评判系统

本文提出了对区域性有机污染物优先排序和风险分类和定量评判系统：模糊评判系统。该评判系统以反映污染物的毒性，暴露水平和环境化学性质的７项碜数为指标，通过指标参数的标准化及模糊运算，获得有机污染优先排序和风险分类的定量结果。     

无剩余污泥A／O生物接触氧化法

Ａ／Ｏ系统在７０年代开发以来，广泛应用于城市污水处理，它具有同时去除废水中碳、氨、磷的特点。１９８５年上海石化．总厂涤纶厂首先将Ａ／Ｏ法用于石化行业废水处理中，并经过实践总结出一套完整的无剩余污泥Ａ／Ｏ生物接触氧化法处理流程。本流程操作管理方便，耐冲击，氮、磷、ＣＯＤ的去除率高、能耗低，并达到了无剩余污泥。     

2007年全球和中国十大自然灾害事件回顾与启示

本文主要总结和回顾了2007年全球和中国的十大自然灾害,介绍了中国2007年的自然灾害及救灾工作情况,并在此基础上总结了中国自然灾害的特点以及灾害给我们的启示.     

复合混凝剂用于夏季太湖水混凝脱浊研究

用特征粘度系列化的聚二甲基二烯丙基氯化铵(PDM)与聚合氯化铝(PAC)复合得到稳定的复合混凝剂,用于夏季高藻太湖水强化混凝脱浊处理.通过混凝烧杯实验.考察了无机/有机复合比例、PDM特征粘度对脱浊效果及絮团沉淀性能的影响.结果表明,对浊度为30-33 NTU,温度为28～30℃,藻含量为2.6×107个儿的太湖水,在与某市水厂混凝强度相近的搅拌强度下.当达到该水厂2NTU沉淀池出水的余浊标准时,PAC需7.00 mg/L的投加量.质量复合比例为5:1、10:1、20:1的PAC(以Al2O3计)/PDM复合混凝剂所需PAC投加量随PDM特征粘度0.52、1.53、2.46 dL/g的增加分别为3.00-2.83 ms/L、3.50-3.49ms/L、5.37-4.67 mg/L,相对于PAC减少投加量57.14%-59.57%、50%-50.14%、23.29%-33.29%;作为深度处理的技术准备.当沉淀出水浊度要求提高至1NTU的情况下,复合药剂依然可发挥好的作用,PAC需10 mg/L的投加量,PAC(以Al2O3计)与PDM质量复合配比为20:1、10:1、5:1的复合混凝剂需8.33-3.91 mg/L的投加量,能比PAC减少投加量16.7%～60.9%.可见,PDM明显提高了PAC的混凝脱浊效果与沉淀性能,且PAC/PDM质量复合配比越低,PDM特征粘度越高,脱浊效果与沉淀性能越好.     

有机钙孔隙结构与脱硫性能研究

在定碳炉上对有机钙进行煅烧试验,利用氮吸附仪测定样品的微观孔隙结构,采用智能定硫仪对有机钙进行了脱硫实验研究.结果表明.900℃下煅烧.醋酸钙镁的比表面积高达46.6 m2/g,大约为普通石灰石比表面积的4倍.醋酸钙比表面积主要分布在孔径小于5 nm的微孔和中孔,醋酸钙镁比表面积主要集中在孔径为5 nm左右的中孔.醋酸钙的烧结主要发生在微孔和中孔,醋酸钙镁的烧结发生在整个孔径分布区域,有机钙表现出良好的抗烧结特性.1 000℃下按钙硫比为1添加钙基,有机钙的脱硫效率为68.28%-75.55%.比普通石灰石高1倍以上.煅烧形成的良好孔隙结构使得有机钙具有较高的脱硫效果.     

苏州盛泽湖湿地生态恢复初探

湿地是分布于陆生生态系统和水生生态系统之间具有独特水文、土壤、植被与生物特征的生态系统。盛泽湖是位于苏州相城区东北部的天然浅水湖泊,东临阳澄湖,面积为3.86 km^2。由于当地居民对湖泊进行过度养殖和捕捞、大量的围湖造田和进行农业生产建设、工农业废水和生活污水直接排入水体及湿地附近砖瓦厂的取土等原因引起盛泽湖湿地的生态退化。用生态规划的方法来探讨如何对盛泽湖湿地进行生态恢复,并从环境效益、社会效益和经济效益来分析规划方案实施后的效果。     

腐殖酸钠对钙、镁离子吸附效果的研究

实验研究了腐殖酸钠混合液对钙、镁离子的吸附性能。高温条件下由草炭和NaOH制取的腐殖酸钠混合液,吸附水中的钙镁离子,结果发现：随着混合液用量的增加,其对钙镁离子的去除效率增加。当混合液用量为8ml时,二者的吸附效率均在88％以上,其中对镁离子的去除率可达100％,而且由于钙镁离子具有相同的核外电子层结构及类似的化学性质,因此混合液对钙镁离子的去除效果类似,表明腐殖酸钠混合液对钙镁离子具有极好的去除效果,可广泛应用于处理含钙镁离子的污水。     

油气储运设施事故的人为因素分析与预防

结合心理学知识从人为因素的角度分析和归纳了油气储运设施事故的原因,提出了应对人为因素负面影响的措施和对策。     

Arsenic and chromate removal from water by iron chips-Effects of anions

The purpose of this study is to estimate the removal efficiency of As and Cr (VI) by one kind of industrial waste — iron chips, as well as to estimate the effects of typical inorganic anions (sulfate, phosphate, and nitrate), and typical organic anions (citrate, oxalate, and humate) on As or Cr (VI) removal. The results showed that 98% of As (V) and 92% of As (III) could be removed from aqueous phase by the iron chips within 60 min. Compared with As species, Cr (VI) was removed much more rapidly and efficiently with 97% of Cr (VI) being removed within 25 min. The removal efficiency for arsenic was in the order: As (III) (sulfate), As (III) (nitrate) or As (III), As (III) (humate), As (III) (oxalate), As (III) (citrate), As (III) (phosphate), and for chromate was in the order: Cr (VI) (sulfate), Cr (VI) (phosphate) or Cr (VI) (nitrate) or Cr (VI) (oxalate), Cr (VI), Cr (VI) (citrate), Cr (VI) (humate). In all the treatments, pH level increased with time except for As (III), the removal of which was either without anions or in the presence of humate or nitrate.     

Treatment of coking wastewater by an advanced Fenton oxidation process using iron powder and hydrogen peroxide

In this study the treatment of coking wastewater was investigated by an advanced Fenton oxidation process using iron powder and hydrogen peroxide. Particular attention was paid to the effect of initial pH, dosage of H₂O₂ and to improvement in biodegradation. The results showed that higher COD and total phenol removal rates were achieved with a decrease in initial pH and an increase in H₂O₂ dosage. At an initial pH of less than 6.5 and H₂O₂ concentration of 0.3 M, COD removal reached 44-50% and approximately 95% of total phenol removal was achieved at a reaction time of 1 h. The oxygen uptake rate of the effluent measured at a reaction time of 1 h increased by approximately 65% compared to that of the raw coking wastewater. This indicated that biodegradation of the coking wastewater was significantly improved. Several organic compounds, including bifuran, quinoline, resorcinol and benzofuranol were removed completely as determined by GC-MS analysis. The advanced Fenton oxidation process is an effective pretreatment method for the removal of organic pollutants from coking wastewater. This process increases biodegradation, and may be combined with a classical biological process to achieve effluent of high quality.