Inactivation of hepatitis A virus and murine norovirus on surfaces of plastic,steel and raspberries using steam-ultrasound treatment

Food and Environmental Virology - The leading causes of foodborne viral disease outbreaks are human norovirus and hepatitis A virus (HAV). Their environmental persistence enables contamination of...     

Release and fate of fluorocarbons in a shredder residue landfill cell: 2. Field investigations

The shredder residues from automobiles, home appliances and other metal containing products are often disposed in landfills, as recycling technologies for these materials are not common in many countries. Shredder waste contains rigid and soft foams from cushions and insulation panels blown with fluorocarbons. The objective of this study was to determine the gas composition, attenuation, and emission of fluorocarbons in a monofill shredder residue landfill cell by field investigation. Landfill gas generated within the shredder waste primarily consisted of CH₄ (27%) and N₂ (71%), without CO₂, indicating that the gas composition was governed by chemical reactions in combination with anaerobic microbial reactions. The gas generated also contained different fluorocarbons (up to 27 μg L^?1). The presence of HCFC-21 and HCFC-31 indicated that anaerobic degradation of CFC-11 occurred in the landfill cell, as neither of these compounds has been produced for industrial applications. This study demonstrates that a landfill cell containing shredder waste has a potential for attenuating CFC-11 released from polyurethane (PUR) insulation foam in the cell via aerobic and anaerobic biodegradation processes. In deeper, anaerobic zones of the cell, reductive dechlorination of CFCs to HCFCs was evident, while in the shallow, oxic zones, there was a high potential for biooxidation of both methane and lesser chlorinated fluorocarbons. These findings correlated well with both laboratory results (presented in a companion paper) and surface emission measurements that, with the exception from a few hot spots, indicated that surface emissions were negative or below detection.     

Environmental and climatic signals from stable isotopes in Anatolian tree rings, Turkey

Dendrochronological and oxygen–carbon isotopic analysis was conducted on tree rings collected at two different elevations from three different regions in western Anatolia, Turkey. Tree rings were sampled from Anatolian black pines (Pinus nigra Arn. subsp. pallasiana (Lamb.) Holmboe) of at least 200?years old through an N–S transect covering Bolu-Mengen (north), Kütahya–Simav, and Antalya–Alanya (south) forests. Cellulose was extracted from 5-year blocks of tree rings from lower to upper altitudes in each region. Dendrochronological site chronologies were built for each of the 6 sites, and response to climate was evaluated. The long-term δ¹³C chronologies comprising the period 1800–2008 strongly decline by an average of 2.5‰ from the mid-twentieth century, which corresponds with the commencement of industrialization in Turkey. Oxygen isotope (δ¹⁸O) time series show dominantly low undulations, although some high-frequency variations of up to 6‰ are also observed. As a result of latitude and continent effects, oxygen isotope values of tree rings show an average of 3‰ increase from south (Antalya) to the north (Bolu). Correlations between carbon isotope ratios yield high positive values indicating that industrial pollution exerts a major control on the δ¹³C systematics of the studied trees. Corrected δ¹³C ratios are mostly represented by strong positive responses to variations in temperature and precipitation, whereas δ¹⁸O and summer temperature/precipitation are negatively correlated. Tree-ring widths and δ¹⁸O display similar responses to the temperature and sensitivity to the climatic impact of historic volcanic eruptions, and changes in the solar irradiance record are also detected in other high-resolution paleoclimate archives for the region.     

A Technique for Plume Visualization in Power Plant Siting

Because of the increasing demand for energy, construction of a number of large power plants is planned, particularly in the southwestern U.S. Before construction of a plant can begin, however, it must be shown that its emissions will not degrade air quality beyond certain acceptable limits. A new plant must undergo not only a New Source Review¹ to demonstrate compliance with New Source Performance Standards,² but also an analysis to show that it will not produce significant deterioration of air quality in designated pristine areas (often these areas are state or federal parks.) Further, as a result of the 1977 amendments³ to the Clean Air Act, visibility must not be impaired where impairment is defined as a reduction in visual range or as atmospheric discoloration. Plume visual impact must thus be considered before permission for construction will be granted. Because of these requirements, it is important to be able to visualize the plume from a power plant as it travels through surrounding terrain.     

Pilot-scale aerated submerged biofilm reactor for organics removal and nitrification at cold temperatures.

This research describes pilot-scale experiments for efficient removal of dissolved organic and nitrogen compounds in domestic wastewater using aerated submerged biofilm (ASBF) reactors. These reactors could enhance the performance of shallow wastewater treatment lagoons through the addition of specially designed structures. The structures are designed to encourage the growth of a nitrifying bacterial biofilm on a submerged surface. They also force the direct contact of rising air bubbles against the submerged biofilm. This direct gas-phase contact is postulated to increase the oxygen transfer rate into the biofilm and increase the microclimate mixing of water, nutrients, and waste products into and out of the biofilm. This research investigated the efficiency of dissolved organic matter and ammonia-nitrogen removals. Specifically, the effects of cold temperatures on the dissolved organic matter and ammonia-nitrogen performance of the ASBF pilot plant (see Figure 1) was investigated for the batch system. Over a period of 3.5 months, a total of 11 batch runs were performed. By the fourth run, the biofilm had matured to the point that it consumed all the ammonia in 40 hours. On the ninth run, the air supply was left off as a control run. This time, the ammonia was barely consumed, with the level dropping from 24 to 18 mg/L in 40 hours. By the middle of December, the average water temperature during the runs had dropped to approximately 6 degrees C and, at one point, was as low as 3.3 degrees C. The biofilm continued to perform even at these low temperatures, reducing ammonia levels from approximately 25 mg/L to basically zero within 40 to 48 hours.     

The Identification of Xenobiotics in the New UK Context of Drinking Water Safety Planning and Related Environmental Legislation

Recent European environmental legislation (the Water Framework Directive, the Environmental Liability Directive, and the REACH Regulation) should provide better protection of terrestrial water bodies but their focus is on the more conspicuous pollutants, as opposed to the large number of xenobiotic micro-pollutants that are increasingly being detected in the urban water cycle. The development of Drinking Water Safety Plans (DWSPs), as promoted by the World Health Organization, utilises a proactive risk assessment—risk management approach that necessarily should include micro-pollutants, although currently in the UK micro-pollutants have largely been ignored. The generic assessment of the risks posed by micro-pollutants is proposed and will require a consensus on analytical screening methods, sampling points and frequencies, and a method for prioritising concern, and would enable DWSPs to take fuller account of the risks posed.     

Release and fate of fluorocarbons in a shredder residue landfill cell: 1. Laboratory experiments

The shredder residues from automobiles, home appliances and other metal-containing products are often disposed in landfills, as recycling technologies for these materials are not common in many countries. Shredder waste contains rigid and soft foams from cushions and insulation panels blown with fluorocarbons. The objective of this study was to use laboratory experiments to estimate fluorocarbon release and attenuation processes in a monofill shredder residue (SR) landfill cell. Waste from the open SR landfill cell at the AV Miljø landfill in Denmark was sampled at three locations. The waste contained 1–3% metal and a relatively low fraction of rigid polyurethane (PUR) foam particles. The PUR waste contained less blowing agent (CFC-11) than predicted from a release model. However, CFC-11 was steadily released in an aerobic bench scale experiment. Anaerobic waste incubation bench tests showed that SRSR produced significant methane (CH₄), but at rates that were in the low end of the range observed for municipal solid waste. Aerobic and anaerobic batch experiments showed that processes in SRSR potentially can attenuate the fluorocarbons released from the SRSR itself: CFC-11 is degraded under anaerobic conditions with the formation of degradation products, which are being degraded under CH₄ oxidation conditions prevailing in the upper layers of the SR.     

Improving road transport-related air quality in England through joint working between Environmental Health Officers and Transport Planners

In this paper the necessity for effective joint working arrangements between Environmental Health Officers and Transport Planners is demonstrated as a fundamental prerequisite for successful management of traffic-related air quality in English local government areas. Current approach to joint working and collaboration between the officers was examined based on the evidence from a three-year study which involved questionnaire surveys and case study interviews. The findings show that despite good administrative devolution and policy integration, the chance of improving specific local air quality situations through the Local Transport Planning process is dependent on other overriding factors which influence the capabilities of the authorities to integrate policies across departments and tiers of governments. Implicit in these findings is the need for a shared paradigm of continuous engagement by all the policy actors and stakeholders if proper integration and the possibility of tangible results in future policy development are to be achieved. The paper proposes a new framework through which such collaborations can be developed and within which solutions to the issues identified can be evaluated.