An Analysis of Biomedical Waste Incineration

The California Air Resources Board (ARB) completed a series of source tests of eight operating biomedical waste incinerators (BMWI) under conditions of typical operation. The emissions of certain metals, and chlorinated dioxins and furans in the flue gases of BMWI are relatively high in comparison to emissions from other combustion sources, such as hazardous waste or municipal waste incinerators of modern design. This study reports on an analysis of the status of the existing regulatory framework and the California data base. Clarification of definitional issues at the federal level is needed to effectively treat BMWI management issues. Although few relationships among combustion parameters and emissions were uncovered, patterns of emissions were evident, suggesting commonality and relationships among the waste stream constituents and emissions. Potential implications for future research, operation of BMWI, controls and source reduction and waste segregation strategies are also discussed.     

Receptor Modeling Applied to Patterns in Space (RMAPS)Part III–Apportionment of Airborne Particulate Sulfur in Western Washington State

Abstract

Data obtained from 24 of the 31 sites of the Pacific Northwest Regional Visibility Experiment Using Natural Tracers (PREVENT) study were analyzed by the Receptor Model Applied to Patterns in Space (RMAPS) multivariate receptor model. Four spatial patterns were found and interpreted as showing the effect of the coal-fired power plant in Centralia, WA; transport from the northwest; the Se-attle-Tacoma urban area; and transport from the southeast. In Mt. Rainier National Park, up to one-third of the sulfate can be attributed to the Centralia power plant. In the North Cascades National Park, 65-82% of the sulfur is accounted for by transport from Canada. The model was applied separately to sites in the northern and southern sections of the study area. The southern sites were affected only by the Centralia, urban, and southeast transport sources; the northern sites were affected only by the northwest transport, urban, and southeast transport sources. This gave two independent estimates of the normalized source contributions of the urban and southeast transport factors, which had a correlation coefficient of more than 0.90.     

Seasonal Variations in Aerosol Composition and Acidity at Shenandoah and Great Smoky Mountains National Parks

The concentration of elements Na through Pb, select ions, and organic carbon from fine (<2.5 µm) particles has been monitored at Shenandoah and Great Smoky Mountains National Parks from 1988 through 1995. The data obtained from 1988 through 1994 show that significant changes in the concentrations of many aerosol constituents occur on a seasonal basis. Particulate sulfate and organic carbon are shown to exhibit substantially higher concentrations during the summer, while sulfur dioxide and nitrate concentrations are highest during the winter.

A method for estimating the degree of neutralization of particulate sulfate is given. This method uses routinely measured aerosol elemental compositions because ammonium ion, the primary neutralizing species for sulfate, is not measured on a routine basis. Application of this method to the selected data set shows that sulfate aerosol is most acidic during summer with an average molar H_s (moles of hydrogen associated with sulfur) to S (moles of sulfur) ratio of approximately 4. This suggests the average sulfate particle during the summer has a molar coon slightly more acidic than ammonium bisulfate (NH₄HSO₄) which has a molar hydrogen to sulfur ratio of 5. Winter H_s to S ratios, however, are approximately 8, suggesting the aerosol is on average fully neutralized ammonium sulfate [(NH₄)₂SO₄].     

Comparison of Computer Simulations of Total Lung Deposition to Human Subject Data in Healthy Test Subjects

ABSTRACT

A mathematical model was used to predict the deposition fractions (DF) of PM within human lungs. Simulations using this computer model were previously validated with human subject data and were used as a control case. Human intersubject variation was accounted for by scaling the base lung morphology dimensions based on measured functional residual capacity (FRC) values. Simulations were performed for both controlled breathing (tidal volumes [V_T] of 500 and 1000 mL, respiratory times [T] from 2 to 8 sec) and spontaneous breathing conditions. Particle sizes ranged from 1 to 5 um. The deposition predicted from the computer model compared favorably with the experimental data. For example, when V_T = 1000 mL and T = 2 sec, the error was 1.5%. The errors were slightly higher for smaller tidal volumes. Because the computer model is deterministic (i.e., derived from first principles of physics), the model can be used to predict deposition fractions for a range of situations (i.e., for different ventilatory parameters and particle sizes) for which data are not available. Now that the model has been validated, it may be applied to risk assessment efforts to estimate the inhalation hazards of airborne pollutants.     

Characterization of Fine Particulate Matter Produced by Combustion of Residual Fuel Oil

ABSTRACT

Combustion experiments were carried out on four different residual fuel oils in a 732-kW boiler. PM emission samples were separated aerodynamically by a cyclone into fractions that were nominally less than and greater than 2.5 |j.m in diameter. However, examination of several of the samples by computer-controlled scanning electron microscopy (CCSEM) revealed that part of the PM_2.5 fraction consists of carbonaceous cenospheres and vesicular particles that range up to 10 |j.m in diameter. X-ray absorption fine structure (XAFS) spectroscopy data were obtained at the S, V, Ni, Fe, Cu, Zn, and As K-edges and at the Pb L-edge. Deconvolution of the X-ray absorption near edge structure (XANES) region of the S spectra established that the dominant molecular forms of S present were sulfate (26-84% of total S) and thiophene (13-39% of total S). Sulfate was greater in the PM_2.5 samples than in the PM₂₅₊ samples. Inorganic sulfides and elemental sulfur were present in lower percentages. The Ni XANES spectra from all of the samples agreed fairly well with that of NiSO₄, while most of the V spectra closely resembled that of vanadyl sulfate (VO?SO₄?xH₂O). The other metals investigated (i.e., Fe, Cu, Zn, and Pb) also were present predominantly as sulfates. Arsenic was present as an arsen-ate (As⁺⁵). X-ray diffraction patterns of the PM_2.5 fraction exhibit sharp lines due to sulfate compounds (Zn, V, Ni, Ca, etc.) superimposed on broad peaks due to amorphous carbons. All of the samples contain a significant organic component, with the loss on ignition (LOI) ranging from 64 to 87% for the PM_2.5 fraction and from 88 to 97% for the PM_2.5+ fraction. Based on ¹³C nuclear magnetic resonance (NMR) analysis, the carbon is predominantly condensed in graphitic structures. Aliphatic structure was detected in only one of seven samples examined.     

Daily Mortality in the Philadelphia Metropolitan Area and Size-Classified Particulate Matter

ABSTRACT

Time-series of daily mortality data from May 1992 to September 1995 for various portions of the seven-county Philadelphia, PA, metropolitan area were analyzed in relation to weather and a variety of ambient air quality parameters. The air quality data included measurements of size-classified PM, SO₄ ^2-, and H+ that had been collected by the Harvard School of Public Health, as well as routine air pollution monitoring data. Because the various pollutants of interest were measured at different locations within the metropolitan area, it was necessary to test for spatial sensitivity by comparing results for different combinations of locations. Estimates are presented for single pollutants and for multiple-pollutant models, including gaseous pollutants and mutually exclusive components of PM (PM_2.5 and coarse particles, SO₄ ^2- and non-SO₄ ^2- portions of total suspended particulate [TSP] and PM₁₀), measured on the day of death and the previous day.

We concluded that associations between air quality and mortality were not limited to data collected in the same part of the metropolitan area; that is, mortality for one part may be associated with air quality data from another, not necessarily neighboring, part. Significant associations were found for a wide variety of gaseous and particulate pollutants, especially for peak O₃. Using joint regressions on peak O₃ with various other pollutants, we found that the combined responses were insensitive to the specific other pollutant selected. We saw no systematic differences according to particle size or chemistry. In general, the associations between daily mortality and air pollution depended on the pollutant or the PM metric, the type of collection filter used, and the location of sampling. Although peak O₃ seemed to exhibit the most consistent mortality responses, this finding should be confirmed by analyzing separate seasons and other time periods.     

Black Carbon Aerosol at McMurdo Station,Antarctica

ABSTRACT

Aerosol light absorption as black carbon (BC) was measured from November 19, 1995, to February 6, 1996, at a location 0.65 km downwind of the center of McMurdo Station on the Antarctic coast. The results show a bimo-dal frequency distribution of BC concentrations. Approximately 65% of the measurements were found in a mode at a low range of concentrations centered at ~20 ng/m³. These concentrations are higher than those found at other remote Antarctic locations and probably represent contamination from the station. The remaining measurements were in a high-concentration mode (BC ~300 ng/m³), indicating direct impact of local emissions from combustion activities at the station. High values of BC were associated with winds from the direction of the station, and the BC flux showed a clear directionality. Maximum BC concentrations occurred between 7:00 and 11:00 a.m. The "polluted" mode accounted for more than 80% of the BC frequency-weighted impact at this location.     

Polyfunctional Plants for Industrial Waste Disposal—Part II: Economics and Model Evaluation

ABSTRACT

This is the second part of a two-part paper dealing with the preliminary design and costing of polyfunctional waste treatment plants. In this article, we present some criteria for estimating capital investment and annual operating costs of polyfunctional plants for industrial waste treatment. The process and equipment design methods presented in Part I of this article, together with the economic approach proposed here, allow for complete technical/economic analyses. The overall mathematical model appears to be a useful tool in economic feasibility studies. The accuracy of the developed computer mathematical model has been demonstrated, referring to actual cost data from the literature.     

Cost-Effectiveness Analysis of Waste Gas Treatment Plants for the Glass Industry

ABSTRACT

Cost-effectiveness of different plant solutions for glass furnace waste gas cleaning is compared in the present paper. Plant arrangements based on electrostatic precipi-tator or fabric filter dust collectors and wet, semi-dry, or dry processes for acid gas removal have been considered. A critical survey of each solution's advantages and disadvantages has been presented, taking into account both effectiveness and costs resulting from each available system. Finally, a quantitative assessment has been provided with reference to a case study involving actual float glass production lines at SIV plants located in northern and central Italy.