Concentrations and gas/particle partitioning of PCBs in Chicago

Thirty seven air samples were collected in Chicago, IL from June to October 1995 and analyzed for gas and particle concentrations of polychlorinated biphenyls (PCBs). Lower molecular weight (MW) PCBs dominated the samples and on average 95% of the Sigma50PCB concentration (gas+particulate) was in the vapor phase. Sigma50PCB concentrations were classified based on prevailing winds (lake and land). The Sigma50PCB concentration varied between 0.42 and 5.21 ng/m3 (1.80+/-1.70 ng/m3) for lake and 0.53 and 8.31 ng/m3 (2.41+/-2.15 ng/m3) for land wind directions. Back trajectory analyses suggested that SW of Chicago can be an important local or regional source sector for PCBs. Partitioning between gas and particulate phases was modeled using the Junge-Pankow model. The measured particle phase concentrations for low MW PCBs were lower than those predicted by the model while the opposite was observed for high MW PCBs. Plots of gas/particle partition coefficient (log Kp) vs. subcooled liquid vapor pressure (log pL(0)) had reasonable correlations for individual samples but the slope varied among the samples. Samples that originated from over the lake had higher slopes than samples that originated from over the land.     

Reduced mercury deposition in New Hampshire from 1996 to 2002 due to changes in local sources

Changes in deposition of gaseous divalent mercury (Hg(II)) and particulate mercury (Hg(p)) in New Hampshire due to changes in local sources from 1996 to 2002 were assessed using the Industrial Source Complex Short Term (ISCST3) model (regional and global sources and Hg atmospheric reactions were not considered). Mercury (Hg) emissions in New Hampshire and adjacent areas decreased significantly (from 1540 to 880 kg yr⁻¹) during this period, and the average annual modeled deposition of total Hg also declined from 17 to 7.0 μg m⁻² yr⁻¹ for the same period. In 2002, the maximum amount of Hg deposition was modeled to be in southern New Hampshire, while for 1996 the maximum deposition occurred farther north and east. The ISCST3 was also used to evaluate two future scenarios. The average percent difference in deposition across all cells was 5% for the 50% reduction scenario and 9% for the 90% reduction scenario.     

Polychlorinated biphenyls (PCB) and dichlorodiphenyltrichloroethane (DDE) air concentrations in the Lake Ontario region: Trends and potential sources

Airborne particle and gas samples were collected approx every 12 days from April 2002 to June 2006 at the Sterling Nature Center located near the southeast corner of Lake Ontario. These samples were analyzed for polychlorinated biphenyls (PCBs) and dichlorodiphenyltrichloroethane (DDE). Clausius-Clapeyron (C–C) regression analyses of PCBs and DDE yielded moderate correlations (r² = 0.54, p < 0.001; r² = 0.74, p < 0.001, respectively) indicating that much of the variations in concentrations can be explained by temperature. Back trajectory analysis indicated that the most important factors driving unusually high PCB partial pressures relative to those predicted by the C–C regression were slow wind speeds and winds generally from the southwest. This combination, which occurred frequently in 2004, increased contact of the air with contaminated upwind surfaces with minimum dilution. Hybrid receptor modeling (Potential Source Contribution Function (PSCF)) results for the total PCBs identified the midwestern US region that contains the urban areas of southern Indiana (IN), southwestern Ohio (OH), and northern Kentucky (KY) having the highest PSCF values. In general urban areas like Chicago (IL), Detroit (MI), Cleveland (OH), St. Louis (MO), and Nashville (TN) also had significant possibilities. In contrast, the PSCF modeling for DDE identified northern Alabama as the area with the highest probability where DDT was applied to cotton fields.     

Mercury (Hg) emissions from domestic biomass combustion for space heating

Three mercury (Hg) species (gaseous elemental mercury (GEM), gaseous oxidized mercury (GOM), and fine particulate-bound mercury (PBM_2.5)) were measured in the stack of a small scale wood combustion chamber at 400 °C, in the stack of an advanced wood boiler, and in two areas influenced by wood combustion. The low temperature process (lab-scale) emitted mostly GEM (∼99% when burning wood pellets and ∼95% when burning unprocessed wood). The high temperature wood boiler emitted a greater proportion of oxidized Hg (approximately 65%) than the low temperature system. In field measurements, mean PBM_2.5 concentrations at the rural and urban sites in winter were statistically significantly higher than in warmer seasons and were well correlated with Delta-C concentrations, a wood combustion indictor measured by an aethalometer (UV-absorbable carbon minus black carbon). Overall the results suggest that wood combustion may be an important source of oxidized mercury (mostly in the particulate phase) in northern climates in winter.     

Mercury wet deposition in rural Korea: concentrations and fluxes

The characteristics of Hg wet deposition were investigated in a rural area of Korea from August 2006 to July 2008. The volume weighted mean (VWM) Hg(T) concentration and cumulative Hg(T) flux were 8.8 ng L(-1) and 9.4 μg m(-2) per year, respectively. The VWM Hg(T) concentration varied seasonally, similar to the seasonal pattern in atmospheric Hg(p) concentration. The enhancement of both VWM Hg(T) and atmospheric Hg(p) concentrations in spring and winter was likely caused by the long-range transport of Hg from China. Monthly VWM Hg(T) and atmospheric Hg(p) concentrations were well correlated (R(2) = 0.36); however, there was no correlation between VWM Hg(T) and RGM (reactive gaseous mercury) concentrations, suggesting that Hg(p) was responsible for the majority of the Hg in wet deposition at this site. The VWM Hg(T) concentration in snow was statistically higher than in rain. In addition, the atmospheric Hg(p) concentration appeared to be elevated for snow events as well. This suggests that both elevated Hg(p) concentrations and the enhanced scavenging efficiency of snow for Hg(p) were responsible for the elevated VWM Hg(T) concentrations measured during snow events.     

Measured summertime concentrations of particulate components,Hg0, and speciated polycyclic aromatic hydrocarbons at rural sites in New York State

Daily PM2.5 samples, Hg0 and speciated polycyclic aromatic hydrocarbon (PAH) were simultaneously collected at Potsdam and Stockton site in NY during the summers of 2000 and 2001. Samples for determination of the mass concentration and chemical composition of the PM2.5 were obtained with a speciation network PM2.5 sampler. Chemical composition including trace elemental composition, water-soluble ions, and elemental carbon were analyzed. Elemental mercury and PAHs were sampled separately. Daily PM2.5 concentrations ranged from 0.47 to 53.7 microg m(-3) at the Potsdam site, and from 0.82 to 47.23 microg m(-3) at the Stockton site with large daily differences between the two sites. Potsdam consistently had lower mass values than Stockton. The greatest contributors to the PM2.5 mass (generally >0.1 microg/m(3)) were sulfate, nitrate, ammonium, and BC at both sites. Seventeen PAHs were identified at each site in 2000 and the average total concentrations were 3.2 ng/m(3) and 2.9 ng/m(3) at the Potsdam and Stockton sites, respectively. The mean vapor phase mercury concentration at the Potsdam site (2.4 +/-1.2 ng m(-3), n=93) was higher than that at the Stockton site (1.2 +/- 1.0 ng m(-3), n=60) in 2000, whereas in 2001, the average concentrations were 1.1 ng m(-3) and 1.6 ng m(-3) at the Potsdam and Stockton sites, respectively. In general, vapor phase mercury concentrations increased with increasing ambient temperature at the Stockton site in 2000. These differences in values between 2000 and 2001 can be largely explained by distinct differences in the meteorological regimes that dominated in the different years.     

Temperature dependence of gas-phase polycyclic aromatic hydrocarbon and organochlorine pesticide concentrations in Chicago air

The temperature dependence of gas-phase atmospheric concentrations of polycyclic aromatic hydrocarbons (PAHs) and organochlorine pesticides measured in Chicago, IL between June and October 1995 were investigated using plots of the natural logarithm of partial pressures (ln P) vs. reciprocal mean temperatures (1/T). For the eight lowest molecular weight PAHs, temperature dependence was statistically significant (at the 95% confidence level) and temperature accounted for 23–49% of the variability in gas-phase concentrations. The relatively higher slopes for most of the PAHs suggested that volatilization from local sources and short-range transport influenced their concentrations. For pesticides, temperature dependence was statistically significant for DDD and for trans-nonachlor (at the 95% and 90% confidence levels), and was not statistically significant for the other five compounds (2–18% of the variability in their gas-phase concentrations). The relatively lower slopes for individual pesticides suggested that they have mostly non-urban and distant sources.Results of back trajectory analyses suggested that the region, southwest of Chicago, might be an important local or regional source sector for PAHs and organochlorine pesticides. No statistically significant relationship was observed between wind speed and PAH or pesticide concentrations. None of the variables (temperature, wind speed, wind direction, local and regional sources) could fully explain the variation in their concentrations measured in Chicago, therefore, this variation can be attributed to the combined effect of those factors.     

Factors influencing concentrations of dissolved gaseous mercury (DGM) and total mercury (TM) in an artificial reservoir

The effects of various factors including turbidity, pH, DOC, temperature, and solar radiation on the concentrations of total mercury (TM) and dissolved gaseous mercury (DGM) were investigated in an artificial reservoir in Korea. Episodic total mercury accumulation events occurred during the rainy season as turbidity increased, indicating that the TM concentration was not controlled by direct atmospheric deposition. The DGM concentration in surface water ranged from 3.6 to 160 pg/L, having a maximum in summer and minimum in winter. While in most previous studies DGM was controlled primarily by a photo-reduction process, DGM concentrations tracked the amount of solar radiation only in winter when the water temperature was fairly low in this study. During the other seasons microbial transformation seemed to play an important role in reducing Hg(II) to Hg(0). DGM increased as dissolved organic carbon (DOC) concentration increased (p-value < 0.01) while it increased with a decrease of pH (p-value < 0.01).     

Gaseous mercury fluxes from the forest floor of the Adirondacks

The flux of gaseous elemental mercury (Hg⁰) from the forest floor of the Adirondack Mountains in New York (USA) was measured numerous times throughout 2005 and 2006 using a polycarbonate dynamic flux chamber (DFC). The Hg flux ranged between −2.5 and 27.2 ng m⁻² h⁻¹ and was positively correlated with temperature and solar radiation. The measured Hg emission flux was highest in spring, and summer, and lowest in winter. During leaf-off periods, the Hg emission flux was highly dependent on solar radiation and less dependent on temperature. During leaf-on periods, the Hg emission flux was fairly constant because the forest canopy was shading the forest floor. Two empirical models were developed to estimate yearly Hg⁰ emissions, one for the leaf-off period and one for the leaf-on period. Using the U.S. EPA's CASTNET meteorological data, the cumulative estimated emission flux was approx. 7.0 μg Hg⁰ m⁻² year⁻¹.     

Total gaseous concentrations in mercury in Seoul, Korea: Local sources compared to long-range transport from China and Japan

Total gaseous mercury (TGM) and carbon monoxide (CO) were measured every 5 min and hourly, respectively, in Seoul, Korea, from February 2005 through December 2006. The mean concentrations of TGM and CO were 3.44 ± 2.13 ng m⁻³ and 613 ± 323 ppbv, respectively. TGM and CO concentrations were highest during the winter and lowest during the summer. In total, 154 high TGM concentration events were identified: 86 were classified as long-range transport events and 68 were classified as local events. The TGM and CO concentrations were well correlated during all long-range transport events and were weakly correlated during local events. Five-day backward trajectory analysis for long-range transport events showed four potential source regions: China (79%), Japan (13%), the Yellow Sea (6%), and Russia (2%). Our results suggest that measured ΔTGM/ΔCO can be used to identify long-range transported mercury and to estimate mercury emissions from long-range transport.