Annual and weekly patterns of ozone and particulate matter in Jeddah,Saudi Arabia

Air pollution has been an increasing concern within the Kingdom of Saudi Arabia and other Middle Eastern countries. In this work the authors present an analysis of daily ozone (O₃), nitrogen oxide (NO_x), and particulate matter (<10 μm aerodynamic diameter; PM₁₀) concentrations for two years (2010 and 2011) at sites in and around the coastal city of Jeddah, as well as a remote background site for comparison. Monthly and weekly variations, along with their implications and consequences, were also examined. O₃ within Jeddah was remarkably low, and exhibited the so-called weekend effect—elevated O₃ levels on the weekends, despite reduced emissions of O₃ precursors on those days. Weekend O₃ increases averaged between 12% and 14% in the city, suggesting that NO_x/volatile organic compound (VOC) ratios within cities such as Jeddah may be exceptionally high. Sites upwind or far removed from Jeddah did not display this weekend effect. Based on these results, emission control strategies in and around Jeddah must carefully address NO_x/VOC ratios so as to reduce O₃ at downwind locations without increasing it within urban locations themselves. PM₁₀ concentrations within Jeddah were elevated compared with North American cites of similar climatology, though comparable to other large cities within the Middle East.

Implications:Daily concentrations of O₃, PM₁₀, and NO_x in and around the city of Jeddah, Saudi Arabia, are analyzed and compared with those of other reference cities. Extremely low O₃ levels, along with a significant urban weekend effect (higher weekend O₃, despite reduced NO_x concentrations), is apparent, along with high levels of PM₁₀ within the city. Urban O₃ in Jeddah was found to be lower than that of other comparable cities, but the strong weekend effect suggests that care must be taken to reduce downwind O₃ levels without increasing them within the city itself. Further research into the emissions and chemistry contributing to the reduced O₃ levels within the city is warranted.     

Comparative statistical study of hourly precipitation determined by radar-based Stage IV and ground-based methods in the North Central United States

Detailed hourly precipitation data are required for long-range modeling of dispersion and wet deposition of particulate matter and water-soluble pollutants using the CALPUFF model. In sparsely populated areas such as the north central United States, ground-based precipitation measurement stations may be too widely spaced to offer a complete and accurate spatial representation of hourly precipitation within a modeling domain. The availability of remotely sensed precipitation data by satellite and the National Weather Service array of next-generation radars (NEXRAD) deployed nationally provide an opportunity to improve on the paucity of data for these areas. Before adopting a new method of precipitation estimation in a modeling protocol, it should be compared with the ground-based precipitation measurements, which are currently relied upon for modeling purposes. This paper presents a statistical comparison between hourly precipitation measurements for the years 2006 through 2008 at 25 ground-based stations in the north central United States and radar-based precipitation measurements available from the National Center for Environmental Predictions (NCEP) as Stage IV data at the nearest grid cell to each selected precipitation station. It was found that the statistical agreement between the two methods depends strongly on whether the ground-based hourly precipitation is measured to within 0.1 in/hr or to within 0.01 in/hr. The results of the statistical comparison indicate that it would be more accurate to use gridded Stage IV precipitation data in a gridded dispersion model for a long-range simulation, than to rely on precipitation data interpolated between widely scattered rain gauges.

Implications:

The current reliance on ground-based rain gauges for precipitation events and hourly data for modeling of dispersion and wet deposition of particulate matter and water-soluble pollutants results in potentially large discontinuity in data coverage and the need to extrapolate data between monitoring stations. The use of radar-based precipitation data, which is available for the entire continental United States and nearby areas, would resolve these data gaps and provide a complete and accurate spatial representation of hourly precipitation within a large modeling domain.     

The living environment and children's fears following the Indonesian tsunami

The tsunami that struck South-east Asia on 26 December 2004 left more than 500,000 people in Aceh, Indonesia, homeless and displaced to temporary barracks and other communities. This study examines the associations between prolonged habitation in barracks and the nature of fears reported by school-age children and adolescents. In mid-2007, 30 months after the tsunami, the authors interviewed 155 child and parent dyads. Logistic regression analysis was used to compare the fears reported by children and adolescents living in barracks with those reported by their peers who were living in villages. After adjusting for demographic factors and tsunami exposure, the data reveals that children and adolescents living in barracks were three times more likely than those living in villages to report tsunami-related fears. The study demonstrates that continued residence in barracks 30 months after the tsunami is associated with higher rates of reporting tsunami-related fears, suggesting that barracks habitation has had a significant impact on the psychological experience of children and adolescents since the tsunami.     

Ethylene: An Urban Air Pollutant

Ethylene is an unusual air pollutant in that it is a plant hormone. Motor vehicle exhaust is a primary source. In the Washington, D. C, area, ethylene concentrations ranged from 700 ppb in the city center to 39 ppb in areas outside the circumferential beltway. Plants grown in these concentrations of ethylene, using controlled environment chambers, exhibited typical symptoms of ethylene toxicity: reduced growth, premature senescence, and reduced flowering and fruit production. When plants were grown in carbon-filtered ambient air, which was also filtered through KMnO₄ to remove ethylene by oxidation, growth, flowering, and fruit production increased. These observations demonstrate that ethylene air pollution is a continual source of stress for plant growth and development in an urban environment.     

Emissions into the Atmosphere Due to the Ceramic Salt Glazing Process

The techniques of Principal Component Analysis (PCA) and subsequent regression analysis were used in an attempt to describe local and upwind chemical and physical factors which affect the variability of SO₄ ^–2 concentrations observed in a rural area of the northeastern U.S. The data used in the analyses included upwind and local O₃ concentrations, temperature, relative humidity and other climatological information, SO₂, and meteorological information associated with backward trajectories. The investigation identified five principal components, three major (eigenvalues >1) and two minor (eigenvalues < one), which accounted for 52% (r = 0.72) of the variability in the SO₄ ^–2 regression model. These components can be described as representing local and upwind photochemistry, droplet growth, SO₂ emissions, and air mass characteristics. The study also indicated that in future studies it will be necessary to a priori select air pollution and meteorological variables for measurement to potentially increase the sensitivity of this type of receptor model.     

Comparison of Predicted and Measured Concentrations for 58 Alternative models of Plume Transport in Complex Terrain

The purpose of this study was to evaluate alternative prediction models for the SO₂ concentrations produced in the vicinity of the Ohio Edison Company Sammis Power Plant. The plant is situated in the northeastern portion of the Ohio River Valley in complex terrain. Comparisons of the 16 highest predicted and measured short-term SO₂ concentrations were conducted for a one year period for 58 alternative models. Several models were found to predict reasonably accurately the 16 highest measured 24-hour SO₂ concentrations. Each of these models requires an upward adjustment in the plume centerline location as the plume is transported downwind in rising terrain. These same models overpredict by substantial margins the 16 highest measured 3-hour SO₂ concentrations. Improvements in emissions inventory data and improvements in the prediction models used are believed necessary to increase prediction accuracy further.     

Rotary Kiln Incineration III. An Indepth Study—Kiln Exit/Afterburner/Stack Train and Kiln Exit Pattern Factor Measurements During Liquid CCl4 Processing

Temperature and stable species concentration data are presented from various locations within a full-scale rotary kiln incinerator firing natural gas/carbon tetrachloride/air. The data are being collected as part of a cooperative program involving university, industry and government participation. The overall goal of the program is to develop a more sophisticated understanding of and a predictive capability for rotary kiln and afterburner performance as influenced by basic design and operational parameters. Non-uniformities in stable species and temperature exist for this particular kiln, at the kiln exit, under certain operating conditions. Flow perturbations from within the kiln were found to persist into the afterburner, but not into the stack. High destruction and removal efficiencies (DRE’s) were achieved under the operating conditions of these tests through adequate secondary combustion processing.     

Rotary Kiln Incineration IV. An Indepth Study— Kiln Exit,Transition and Afterburner Sampling During Liquid CCl4 Processing

Detailed temperature and stable species concentration data are presented from the kiln exit, transition section and afterburner of a full-scale incinerator facility firing natural gas/carbon tetrachloride/air. The data are collected as part of a cooperative program involving university, industry and government participation. The overall goal of the program is to develop an understanding and predictive capability for rotary kiln and afterburner performance as influenced by basic design and operational parameters. The data demonstrate that nonuniformities in stable species and temperature exist, under certain operating conditions, at the kiln exit in the vertical direction only. Measurements from the transition section indicate that non-uniformities may exist within this region under certain operating conditions. Flow perturbations from within the kiln can persist into the afterburner, although the degree of nonuniformity is substantially reduced compared to either the kiln or transition sections. High destruction and removal efficiencies were achieved under all operating conditions of these tests through a combination of kiln and secondary combustion processing.