Coal facies characteristics and its control on methane content in South Yanchuan Block,Southeast Ordos Basin,China

The variability in depositional environments in ancient peat bog and coal facies characteristics was investigated with 29 coal samples from four coalbed methane wells in South Yanchuan Block, Southeast Ordos Basin, China. The control of methane content is described as coal facies parameters and the corresponding measurements of methane content. The results indicated that the depositional environment of ancient peat bog in South Yanchuan Block is primarily a lower delta plain, and a low tissue preservation index (TPI) and high gelification index (GI) are typical features of reservoir’s coal facies, reflecting a deep water depositional environment in ancient peat bog. Compared with the coal facies characteristics of the western area, the coal reservoir in the eastern area displays low GI and high ash content as a result of ancient peat bog’s proximity to sea and source area. Various lateral methane contents are influenced by burial depth, whereas the characteristics of coal facies have a strong control on methane content within the single well in vertical direction. The methane content increases with increase in GI and vitrinite to inertinite ratio (V:I), while there are indistinct relationships between TPI and transportation index with methane content. With high GI and longer distance to sea and source area, the methane content in the western area is higher than that of the eastern area. High desmocollinite content also has a negative influence on methane content.     

杭州市环境绩效考核指标体系的构建及应用研究

在国内外环境绩效评价研究的基础上构建了环境绩效考核指标体系的模型框架,并遵循杭州市环境管理要求,构建了杭州市环境绩效考核指标体系。最后对杭州市环境绩效考核指标体系的应用情况进行了展望。     

CCS scenarios optimization by spatial multi-criteria analysis: Application to multiple source sink matching in Hebei province

A method, based on spatial analysis of the different criteria to be taken into consideration for building scenarios of CO₂ capture and storage (CCS), has been developed and applied to real case studies in the Hebei province. Totally 88 point sources (42 from power sector, 9 from iron and steel, 18 from cement, 16 from ammonia, and 3 from oil refinery) are estimated and their total emission amounts to 231.7 MtCO₂/year with power, iron and steel, cement, ammonia and oil refinery sharing 59.13%, 25.03%, 11.44%, 3.5%, and 0.91%, respectively. Storage opportunities can be found in Hebei province, characterised by a strong tectonic subsidence during the Tertiary, with several kilometres of accumulated clastic sediments. Carbon storage potential for 25 hydrocarbon fields selected from the Huabei complex is estimated as 215 MtCO₂ with optimistic assumption that all recovered hydrocarbon could be replaced by an equivalent volume of CO₂ at reservoir conditions. Storage potential for aquifers in the Miocene Guantao formation is estimated as 747 MtCO₂ if closed aquifer assumed or 371 MtCO₂ if open aquifer and single highly permeable horizon assumed. Due to poor knowledge on deep hydrogeology and to pressure increase in aquifer, injecting very high rates requested by the major CO₂ sources (>10 MtCO₂/year) is the main challenge, therefore piezometry and discharge must be carefully controlled. A source sink matching model using ArcGIS software is designed to find the least-cost pathway and to estimate transport route and cost accounting for the additional costs of pipeline construction due to landform and land use. Source sink matching results show that only 15–25% of the emissions estimated for the 88 sources can be sequestrated into the hydrocarbon fields and the aquifers if assuming sinks should be able to accommodate at least 15 years of the emissions of a given source.     

垂直流人工湿地水力学特性研究

通过示踪剂实验从停留时间分布（RTD）曲线及其统计特征值等方面对垂直流人工湿地的水力学特性进行了定性和定量的分析。研究表明水流在垂直流人工湿地中的流动是一种非理想的不均匀流动,存在一定的死区和水流的扩散;垂直流人工湿地较大的死区率与其表面布水的不均匀性有关,这也可能是其死区率大于表流人工湿地的最主要的原因。实验还表明,进水流量对垂直流人工湿地停留时间分布影响较大,随着进水流量的增加,平均停留时间减小,但标准平均停留时间增大,死区率减小;当进水流量为15L／h（水力负荷为620mm／d）时,水流在湿地中的散度最大,水流更接近全混流,不利于污染物的降解。     

活性污泥与生物膜复合工艺处理石化废水的研究

实验研究了活性污泥与生物膜复合工艺(HP)对石化废水的处理效果,并与活性污泥工艺(ASP)进行对比研究.结果表明,HP对石化废水中COD的去除效果略好于ASP,而对NH3-N的去除效果明显优于ASP.另外,两种工艺对硫化物和油的去除效果类似.提高进水负荷时,HP表现出较强的耐冲击负荷能力.以2L/h连续运行时,石化废水...     

多环芳烃的零阶价分子连接性指数与正-辛醇/水分配系数

本文建立了准确预测多环芳烃(PAHs)及其烷基衍生物的正-辛醇/水分配系数(Kow)模型。模型表明PAHs的分配性质可用零阶价分子连接性指数(~°x~v)描述,~°x~v数值与PAHs的logKow成正比。应用本模型可以预测大范围PAHs的logKow值。     

蒽生物降解及其动力学分析

从长期被石油污染的土壤中分离了一株优势菌,经鉴定为铜绿假单胞菌,研究了该菌株对蒽的降解性能,结果发现该菌株对蒽有良好的降解效果。经过147h的降解,蒽的浓度从100mg/L降至27.5mg/L,降解了72.5mg/L,降解率达72.5%,显示了极强的降蒽能力。同时,进行了动力学分析,结果表明蒽的残留浓度Y(mg/L)与时间t(h)符合方程Y=90.4322e(-0.0098)x。     

过去百年吕梁山南端油松生长特征及其与气候变化的关系

理解树木生长对气候变化和人类活动干扰的响应有助于未来森林管理和双碳政策的落实。本文基于采自吕梁山南端的油松（Pinus tabuliformis Carr.）树轮样本建立了标准树轮宽度年表。通过Pearson相关分析发现树轮年表对研究区3—7月土壤湿度（r=0.60,P<0.01,n=37）、5—6月平均最低温度（r=-0.37,P<0.01,n=63）和5月降水量（r=0.31,P<0.05,n=64）响应敏感,说明水分条件（降水和土壤湿度）是影响研究区油松径向生长的主要限制因子,温度则是通过调控土壤湿度进而影响树木径向生长过程。近百年来（1926—2011年）,研究区油松发生了三次生长释放事件（1932年,1977—1980年,2001—2011年）和一次生长抑制事件（1991—1994年）。生长释放事件在次数、持续时间和发生强度上都高于生长抑制事件。适宜（不适宜）的水热组合能够促进生长释放（抑制）,人类活动干扰也能够诱发生长事件。空间相关分析揭示树轮年表与研究区及周边较大范围的气候环境变化密切相关。本研究对深入了解该地区油松树种生长特征及其对气候与人类活动干扰的...     

混凝-超滤短流程工艺处理北方水库原水简

采用混凝-超滤膜短流程工艺对大伙房水库原水进行处理,考察其除污染性能和膜污染情况,并对该短流程工艺参数进行优化。结果表明,当利用超滤膜直接过滤原水时,膜污染较重,并且对污染物质的去除率较低;而采用混凝-超滤短流程工艺时,膜污染得到一定程度上的缓解;当絮凝剂投加量为7 mg/L、膜清洗周期为30 min时,对浊度、COD_Mn和UV₂₅₄的去除率分别为95.61%、40.42%和37.12%,出水水质能够满足生活饮用水卫生标准。     

钠盐量影响下DD6单晶高温合金的高温热腐蚀规律研究

目的 开展镍基单晶高温合金DD6在950 ℃下的热盐腐蚀试验(95%Na2SO4+5%NaCl),探明涂盐量和涂盐方式(周期涂盐和单次涂盐)对DD6高温热腐蚀的影响规律和机理。方法 结合扫描电子显微镜、X射线能量色散谱、X射线衍射等设备,对不同涂盐量及涂盐方式下DD6的表面及横截面形貌进行观察分析,分析不同涂盐量和涂盐方式下DD6的高温热腐蚀机理。结果 DD6在950 ℃下主要发生碱性熔融热腐蚀,同时伴随氧化、硫化和氯化等过程。高温热腐蚀使得DD6合金表面生成的保护性氧化膜被熔融态的腐蚀介质破坏,导致O、S、Cl等外部元素通过氧化膜的缺陷进入DD6基体中,在合金的亚表面发生内氧化、内硫化以及内氯化反应,横截面上出现明显的腐蚀层,其主要由氧化物以及硫化物组成。随着热腐蚀的进行,DD6表面物质发生了剥蚀,沉积盐量的增加导致剥蚀现象越加严重,合金内部致密的组织结构也被破坏,横截面上出现了大量孔洞、裂纹等缺陷。在相同涂盐量下,周期涂盐法使得DD6的腐蚀程度高于单次涂盐法。结论 DD6高温热腐蚀行为与涂盐量及涂盐方式密切相关,相同涂盐方式下,涂盐量越大,DD6热腐蚀更加严重。涂盐量一定时,周期涂盐法使得DD6的热腐蚀剧烈程度大于单次涂盐法,且DD6在上述热腐蚀条件下均发生剥蚀破坏。