Influence of sea-land breezes on the tempospatial distribution of atmospheric aerosols over coastal region

The influence of sea-land breezes (SLBs) on the spatial distribution and temporal variation of particulate matter (PM) in the atmosphere was investigated over coastal Taiwan. PM was simultaneously sampled at inland and offshore locations during three intensive sampling periods. The intensive PM sampling protocol was continuously conducted over a 48-hr period. During this time, PM2.5 and PM(2.5-10) (PM with aerodynamic diameters < 2.5 microm and between 2.5 and 10 microm, respectively) were simultaneously measured with dichotomous samplers at four sites (two inland and two offshore sites) and PM10 (PM with aerodynamic diameters < or =10 microm) was measured with beta-ray monitors at these same 4 sites and at 10 sites of the Taiwan Air Quality Monitoring Network. PM sampling on a mobile air quality monitoring boat was further conducted along the coastline to collect offshore PM using a beta-ray monitor and a dichotomous sampler. Data obtained from the inland sites (n=12) and offshore sites (n=2) were applied to plot the PM10 concentration contour using Surfer software. This study also used a three-dimensional meteorological model (Pennsylvania State University/National Center for Atmospheric Research Meteorological Model 5) and the Comprehensive Air Quality Model with Extensions to simulate surface wind fields and spatial distribution of PM10 over the coastal region during the intensive sampling periods. Spatial distribution of PM10 concentration was further used in investigating the influence of SLBs on the transport of PM10 over the coastal region. Field measurement and model simulation results showed that PM10 was transported back and forth across the coastline. In particular, a high PM10 concentration was observed at the inland sites during the day because of sea breezes, whereas a high PM10 concentration was detected offshore at night because of land breezes. This study revealed that the accumulation of PM in the near-ocean region because of SLBs influenced the tempospatial distribution of PM10 over the coastal region.     

Levels and regional trends of persistent organochlorines and polybrominated diphenyl ethers in Asian breast milk demonstrate POPs signatures unique to individual countries

Human breast milk samples collected in 2007–2008 from four countries, Vietnam (Hanoi), China (Beijing), Korea (Seoul) and Japan (Sendai, Kyoto and Takayama), were analyzed for persistent organic pollutants (POPs) such as dichlorodiphenyltrichloroethane and its metabolites (DDTs), chlordane-related compounds (CHLs), hexachlorocyclohexanes (HCHs), hexachlorobenzene (HCB), polychlorinated biphenyls (PCBs) and polybrominated diphenyl ethers (PBDEs). Comparing with previous surveys, the present study indicates that the DDTs in breast milk from China and Vietnam had gradually decreased during the last decade, but were still 5–10 times higher than those in other nations. The ratios of p,p′-DDE/p,p′-DDT and o,p′-DDT/p,p′-DDT were higher in Beijing than in the other countries, suggesting that there is less fresh intake of commercial DDT products and a possible exposure to dicofol in China. CHL and PCB levels were relatively higher in mothers from Japan, whereas β-HCH and HCB were more common in Chinese women. In Japan, it is suspected that mothers in the urban/coastal area (Sendai) were more continuously exposed to organochlorine pesticides (OCPs) than mothers in the rural/inland area (Takayama). In addition, OCP levels in primiparae were significantly higher than those in multiparae from Japan and Korea. These indicate that both parity and regional factors are major determinants of the levels of OCPs and PCBs in human milk. On the other hand, higher concentrations of PBDEs were observed in mothers' milk from Korea. The congener was dominated by BDE-47 (43–54%), followed by BDE-153 (23–33%) in all regions except for Beijing where BDE-28 (23%) was relatively abundant. In Japanese breast milk, regional and parity-dependent distributions were not observed for PBDEs. Among PBDE congeners, age-dependency was observed for BDE-153, which was negatively correlated (p < 0.05) to the age of mothers in Kyoto (17 participants were housewives), while it increased with age in Sendai (10 participants were clerks). No such correlation was seen for BDE-47, indicating that BDE-47 was ingested and assimilated via different kinetics or routes from BDE-153 in Japan.     

The organic contamination level based on the total soil mass is not a proper index of the soil contamination intensity

Concentrations of organic contaminants in common productive soils based on the total soil mass give a misleading account of actual contamination effects. This is attributed to the fact that productive soils are essentially water-saturated, with the result that the soil uptake of organic compounds occurs principally by partition into the soil organic matter (SOM). This report illustrates that the soil contamination intensity of a compound is governed by the concentration in the SOM (C_om) rather than by the concentration in whole soil (C_s). Supporting data consist of the measured levels and toxicities of many pesticides in soils of widely differing SOM contents and the related levels in in-situ crops that defy explanation by the C_s values. This SOM-based index is timely needed for evaluating the contamination effects of food crops grown in different soils and for establishing a dependable priority ranking for intended remediation of numerous contamination sites.     

Validation of a flow-through sampler for pesticides and polybrominated diphenyl ethers in air

At locations without access to the electrical grid, a flow-through sampler (FTS) collects large volumes of air for the analysis of semi-volatile organic compounds (SVOCs). To test its performance under field conditions, an FTS and a traditional pumped high volume air sampler, both using polyurethane foam (PUF) as sampling medium, were co-deployed at the campus of the University of Toronto Scarborough from August 2006 to June 2007. Polybrominated diphenyl ethers (PBDEs) and various pesticides were quantified in the samples taken by both samplers to test the FTS's applicability to relatively non-volatile and slightly polar SVOCs. Air concentrations in samples taken with the FTS over five 2-week periods compare favourably with the average of the concentrations in several 24-h active high volume samples taken during the same period. In particular, time trends, temperature dependence relationships, and isomer ratios show a reasonable agreement between the two sampling techniques. An empirical linear solvation energy relationship for predicting the apparent theoretical plate number of the PUF assembly used in the FTS illustrates the effect of chemical properties, as well as temperature and wind speed, on sampling efficiency. In the absence of electrical power, the FTS can collect SVOCs from large air volumes as reliably and quantitatively as traditional HiVol samplers, although without separating gas and particle phase.     

Catalytic oxidation of gaseous PCDD/Fs with ozone over iron oxide catalysts

Catalytic oxidation of PCDD/Fs (polychlorinated dibenzo-p-dioxins and polychlorinated dibenzofurans) with ozone (catalytic ozonation) over nano-sized iron oxides (denoted as FexOy) was carried out at temperature of 120-180 degrees C. The effects of operating temperature, ozone concentration, space velocity (SV) and water vapor contents on PCDD/F removal and destruction efficiencies via catalytic ozonation were investigated. High activity of the iron oxide catalyst towards PCDD/F decomposition was observed even at low temperatures with the aid of ozone. The PCDD/F removal and destruction efficiencies achieved with FexOy/O3 at 180 degrees C reach 94% and 91%, respectively. In the absence of ozone, the destruction efficiencies of all PCDD/F congeners are below 20% and decrease with increasing chlorination level of PCDD/F congener at lower temperature (120 degrees C). However, in the presence of ozone, the destruction efficiencies of all PCDD/F congeners are over 80% on FexOy/O3 at 180 degrees C. Higher temperature and ozone addition increase the activity of iron oxide for the decomposition of PCDD/Fs. Additionally, in the presence of 5% water vapor, the destruction efficiency of the PCDD/Fs is above 90% even at lower operating temperature (150 degrees C). It indicates that the presence of appropriate amount of water vapor enhances the catalytic activity for the decomposition of gas-phase PCDD/Fs.     

Relationships between pesticides and organic carbon fractions in sediments of the Danshui River estuary and adjacent coastal areas of Taiwan

In order to understand the fate of pesticides in marine environments, concentrations of pesticides and different carbonaceous fractions were determined for surface sediments in the Danshui River and nearby coastal areas of Taiwan. The major compounds detected were tetrachlorobenzene, HCHs, chlordane, aldrin, DDDs, DDEs and DDTs. Total concentrations of pesticides in the sediments ranged from not detectable to 23 ng g(-1), with the maximum value detected near the discharge point of the marine outfall from the Pali sewage treatment plant. These results confirm that pesticides persist in estuarine and nearby coastal environments of the Danshui River well after their ban. Concentrations of total pesticides significantly correlate with concentrations of total organic carbon and black carbon in these sediments, suggesting that total organic carbon and black carbon regulate the distribution of trace organic pollutants in fluvial and coastal marine sediments.     

The application of seismic risk-benefit analysis to land use planning in Taipei City

In the developing countries of Asia local authorities rarely use risk analysis instruments as a decision-making support mechanism during planning and development procedures. The main purpose of this paper is to provide a methodology to enable planners to undertake such analyses. We illustrate a case study of seismic risk-benefit analysis for the city of Taipei, Taiwan, using available land use maps and surveys as well as a new tool developed by the National Science Council in Taiwan--the HAZ-Taiwan earthquake loss estimation system. We use three hypothetical earthquakes to estimate casualties and total and annualised direct economic losses, and to show their spatial distribution. We also characterise the distribution of vulnerability over the study area using cluster analysis. A risk-benefit ratio is calculated to express the levels of seismic risk attached to alternative land use plans. This paper suggests ways to perform earthquake risk evaluations and the authors intend to assist city planners to evaluate the appropriateness of their planning decisions.     

Arbuscular mycorrhizal fungi induced differential Cd and P phytoavailability via intercropping of upland kangkong (Ipomoea aquatica Forsk.) with Alfred stonecrop (Sedum alfredii Hance): post-harvest study

A post-harvest experiment was conducted further to our previous greenhouse pot study on upland kangkong (Ipomoea aquatica Forsk.) and Alfred stonecrop (Sedum alfredii Hance) intercropping system in Cd-contaminated soil inoculated with arbuscular mycorrhizal (AM) fungi. Previously, four treatments were established in the intercropping experiment, including monoculture of kangkong (control), intercropping with stonecrop (IS), and IS plus inoculation with Glomus caledonium (IS?+?Gc) or Glomus versiforme (IS?+?Gv). Both kangkong and stonecrop plants were harvested after growing for 8 weeks. Then, the tested soils were reclaimed for growing post-harvest kangkong for 6 weeks. In the post-harvest experiment, there were no significant differences between the IS and control treatments, except for a significantly decreased (p?<?0.05) soil available P concentration with IS treatment. Compared with IS, both IS?+?Gc and IS?+?Gv significantly decreased (p?<?0.05) soil DTPA-extractable (phytoavailable) Cd concentrations, but not total Cd, by elevating soil pH, causing significantly lower (p?<?0.05) Cd concentrations in both the root and shoot of kangkong. In addition, both Gc and Gv significantly increased (p?<?0.05) soil acid phosphatase activities and available P concentrations and hence resulted in significantly higher (p?<?0.05) plant P acquisitions. However, only Gv significantly increased (p?<?0.05) kangkong yield, while Gc only significantly elevated (p?<?0.05) the shoot P concentration. It suggested that AM fungi have played key roles in Cd stabilization and P mobilization in the intercropping system, and such positive responses seemed to be sustainable and valuable in post-harvest soils.     

Source Location and Characterization of Volatile Organic Compound Emissions at a Petrochemical Plant in Kaohsiung,Taiwan

Abstract

This paper elucidated a novel approach to locating volatile organic compound (VOC) emission sources and characterizing their VOCs by database and contour plotting. The target of this survey was a petrochemical plant in Linyan, Kaohsiung County, Taiwan. Samples were taken with canisters from 25 sites inside this plant, twice per season, and analyzed by gas chromatography–mass spectrometry. The survey covered 1 whole year. By consolidated into a database, the data could be readily retrieved, statistically analyzed, and clearly presented in both table and graph forms. It followed from the cross‐analysis of the database that the abundant types of VOCs were alkanes, alkenes/dienes, and aromatics, all of which accounted for 99% of total VOCs. By contour plotting, the emission sources for alkanes, aromatics, and alkenes/dienes were successfully located. Through statistical analysis, the database could provide the range and 90% confidence interval of each species from each emission source. Both alkanes and alkene/dienes came from tank farm and naphtha cracking units and were mainly composed of C₃–C₅ members. Regarding aromatics, benzene, toluene, and xylenes were the primary species; they were emitted from tank farm, aromatic units, and xylene units.     

在香港提供消防与安全工程研究生教育的必要性分析

论述了在香港提供消防与安全工程研究生教育的必要性,为了培养高质量人才,消防与安全工程高等教育的科目应当包括消防工程学和安全工程学(如火灾动力学),用于建筑设计的计算机火灾模拟,消防工程系统,火灾安全管理立法因素,用于火灾安全管理的设计事项,建造的安全因素,职业安全和人类工程学,事故防范、危害评估和控制,安全管理系统和安全审核。而这些重要课程的质量提高都强烈依赖于相关研究的进展。