低碳农业评价指标体系的构建及对广东的评价

本文对低碳农业评价指标体系的构建进行深入探讨,主要从农业生产要素产出效率、能源利用低碳化水平、农业生产方式低碳化水平、农业碳汇效应4个维度构建指标体系,并运用德尔菲法、加乘混合合成法确立综合指标评价值及设定低碳农业发展水平的等级评价标准,以此为科学量化评价农业低碳发展水平提供一个简便工具,实现对低碳农业评价由定性描述向定量分析的转变。在此基础上,将该评价指标体系应用于对广东省低碳农业发展综合评价的实证研究,以期为农业决策者制定和实施科学的低碳发展政策提供依据。研究结果显示,2006-2010年广东省低碳农业发展水平与低碳农业发展要求尚有较大差距,处于从较高碳发展水平向中碳发展水平迈进的阶段;“农业生产方式低碳化水平”成为广东农业低碳发展的最大制约性因素;与全国其他9省区比较,广东省低碳农业发展综合指数属于中等偏下的位次。由此可见,当前广东省高碳化的现代农业发展模式,成为阻碍低碳农业发展的最大因素;而坚持现有耕地的有效保护与合理拓展有效耕地面积,并因地制宜地提高农地的复种指数,对增强广东种植业的碳汇效应,保护和改善生态环境具有关键性的作用。     

Particulate matter emissions from on-road vehicles in a freeway tunnel study

Particulate matter, including coarse particles (PM_2.5–10, aerodynamic diameter of particle between 2.5 and 10 μm) and fine particles (PM_2.5, aerodynamic diameter of particle lower than 2.5 μm) and their compositions, including elemental carbon, organic carbon, and 11 water-soluble ionic species, and elements, were measured in a tunnel study. A comparison of the six-hour average of light-duty vehicle (LDV) flow of the two sampling periods showed that the peak hours over the weekend were higher than those on weekdays. However, the flow of heavy-duty vehicles (HDVs) on the weekdays was significant higher than that during the weekend in this study. EC and OC content were 49% for PM_2.5–10 and 47% for PM_2.5 in the tunnel center. EC content was higher than OC content in PM_2.5–10, but EC was about 2.3 times OC for PM_2.5. Sulfate, nitrate, ammonium were the main species for PM_2.5–10 and PM_2.5. The element contents of Na, Al, Ca, Fe and K were over 0.8 μg m^?3 in PM_2.5–10 and PM_2.5. In addition, the concentrations of S, Ba, Pb, and Zn were higher than 0.1 μg m^?3 for PM_2.5–10 and PM_2.5. The emission factors of PM_2.5–10 and PM_2.5 were 18 ± 6.5 and 39 ± 11 mg km^?1-vehicle, respectively. The emission factors of EC/OC were 3.6/2.7 mg km^?1-vehicle for PM_2.5–10 and 15/4.7 mg km^?1-vehicle for PM_2.5 Furthermore, the emission factors of water-soluble ions were 0.028(Mg²⁺)–0.81(SO₄^2?) and 0.027(NO₂^?)–0.97(SO₄^2?) mg km^?1-vehicle for PM_2.5–10 and PM_2.5, respectively. Elemental emission factors were 0.003(V)–1.6(Fe) and 0.001(Cd)–1.05(Na) mg km^?1-vehicle for PM_2.5–10 and PM_2.5, respectively.     

\"老龄期\"填埋场渗滤液COD蒸发规律研究

\"老龄期\"填埋场渗滤液由于可生化性差而难于处理.采用常规蒸发、减压蒸发和载气蒸发处理不同pH值的\"老龄期\"渗滤液.实验结果表明,3种蒸发方式下,冷凝液COD下降过程中均存在明显的浓度转折点,转折点之后COD维持较低水平,为\"老龄期\"渗滤液的\"三分处理法\"提供理论依据.与常规蒸发相比,减压蒸发和载气蒸发的前期冷凝液COD较高,且浓度转折点偏后.     

耐低温贫营养好氧反硝化菌群脱氮特性及安全性

针对微污染水体强化原位生物脱氮技术同时面临低温、贫营养及好氧问题,对实验室已分离筛选的贫营养好氧反硝化菌和耐低温好氧反硝化菌进行菌源重组,构建出高效耐低温贫营养好氧脱氮功能菌群T1(Y3+F3+H8)和T2(Y3+F4)。研究不同投菌量条件下菌群的脱氮特性,结果表明,投菌量对T1脱氮效果有一定影响,0.1、0.2和1.0 mg/L投量对NO3--N去除率为71%、91%和100%,总氮去除率为56%、34%和52%;T2菌群,当投量为0.2 mg/L时,对NO3--N、总氮去除率最大可达66%和59.48%。对菌群T1、T2进行生物安全性分析,采用次氯酸钠进行消毒,其生物灭活率均达到99.9%以上。     

潜流人工湿地水力学特性及工程设计

以净化低污染水体的潜流人工湿地水力学特性工程设计为重点,系统开展了室内外实验研究,并利用Peelet数分析了水平潜流人工湿地碎石床渗流返混程度。结果表明,潜流人工湿地集水花管孔口出流计算、基质填料内渗流计算、碎石床平均水力停留时间计算可分别借鉴薄壁孔口恒定淹没出流、线性或非线性渗流、活塞流理论;但受工程实际条件及运行淤堵等影响,工程实测结果均小于理论计算值。基于室内外实验成果,提出一套包括集配水系统水力计算、填料内渗流计算、平均水力停留时间计算在内的潜流人工湿地水力学特性计算方法和参数选择,可为人工湿地技术的工程设计提供借鉴。     

以不同底物和苯胺为燃料的微生物燃料电池的产电特性

通过构建空气阴极型双室微生物燃料电池,研究了以500 mg/L苯胺作为唯一燃料以及苯胺和不同底物共基质时MFC对苯胺的降解特性及MFC的产电性能。结果表明,在外电阻1000Ω,以500 mg/L苯胺为唯一燃料以及500 mg/L苯胺分别和500 mg/L乙酸钠,葡萄糖和可溶性淀粉作为共同基时的MFC运行周期分别为3、3.4、4.6和5 d;最大输出电压分别为273、450、428和380 mV;输出功率分别为142、225、201和160 mW/m2。苯胺去除率分别为68%、85.8%、71%和65%。内阻分别为931、524、564和751Ω,COD去除率分别为68%、85%、72%和65%。库伦效率分别为1.8%、7.9%、6.6%和4.5%。MFC可以使用苯胺作为唯一燃料,且当添加的基质不同时,MFC产电性能以及苯胺降解状况有所不同。利用MFC可以使苯胺高效快速降解的同时实现稳定的电压输出。     

Distribution and temporal trend of polybrominated diphenyl ethers in one Shanghai municipal landfill, China

The scarcity of information on polybrominated diphenyl ethers’ (PBDEs) flow in landfill restricts the life cycle analysis of PBDEs. In this study, eight PBDE congeners (BDEs 28, 47, 99, 100, 153, 154, 183, and 209) in topsoil, vegetation leaves, leachate, and municipal aged refuse collected from Shanghai Laogang Municipal Landfill (SLML) were investigated. The present study revealed elevated PBDE concentrations in topsoil and proved PBDE leakage from SLML and vegetation uptake. BDE-209 was the predominant congener, and this could be due to massive usage of deca-BDE mixture in Shanghai. ΣPBDE concentrations in leachates treated by reed wetland and A²/O process fell in the low end of the worldwide range. ΣPBDE concentrations in aged refuse samples rose from under 50 ng/g dw in 1989 to the range of 5,150–5,718 ng/g dw in 2002. PBDE concentrations increase in aged refuse samples throughout the 1990s into the 2000s paralleled municipal solid waste output from 1991 to 2002 in Shanghai. Exponential increase in BDE-209 concentration in aged refuse suggested the increasing market demands for deca-BDE mixture after 1990 in China. Notably, the inventory of PBDEs in SLML was 28.7 MT, and the doubling time of BDE-209 in aged refuse was calculated to be 1.6 year. SLML can be considered as a source of PBDE and one main recipient of PBDE as well, receiving inputs predominantly from the PBDE-containing waste. Priority should be given to formulate regulation on PBDEs and sorting work before landfill disposal.     

垃圾焚烧炉炉膛温度的影响因素

垃圾焚烧过程的不稳定会导致大量有害物质的生成,为确保垃圾的清洁燃烧需要将炉膛温度控制在850℃以上,为此测试了焚烧炉运行的主要可控参数对炉膛温度的影响。结果表明,垃圾堆放位置在垃圾池深3～8 m处,并经过6 d以上发酵脱水后适合焚烧;炉膛温度随给料量、一次风率和一次风温增加而增大,随过量空气系数增加而降低,其中给料量宜控制在95%～110%之间;当过量空气系数为1.6、一次风率为90%、一次风温为260℃、给料量为100%时炉膛温度达901℃。     

Physiological responses involved in cadmium tolerance in a high-cadmium-accumulating rice (Oryza sativa L.) line

Environmental Science and Pollution Research - The disparity of tolerance in plants in response to Cd stress is associated with multiple physiological processes. A pot experiment was conducted to...