Precipitation of Charged Dust Particles on Electrostatic Screen

The purpose of this paper is to present collection performance dependence upon the parameters of channeled electrodes in a twostage precipitator. The practical channeled electrostatic screens are classified into two types and the respective theoretical collection efficiency equations are obtained by employing idealized models. It is shown that In normal operating conditions the most effective particle collection mechanism in the device is electrostatic precipitation rather than the Inertlal separation. It is also pointed out that the channeled electrode, in comparison with the plate-type, should be a narrow width. An empirical efficiency equation is recommended and the agreement between experimental data and empirical equation is within 6%.     

微电解预处理靛蓝牛仔布印染废水

靛蓝牛仔布印染废水组分复杂,浓度高、水量大,属于难处理的工业废水,为了有效降低后续生物处理单元的负荷,采用铁炭微电解工艺对该废水进行预处理;通过正交实验考察pH、反应时间及铁炭比处理效果的影响规律及COD去除反应动力学,并对各因素作了单因素影响实验,确定了最佳工艺条件.结果表明,铁炭微电解法是预处理靛蓝牛仔布印染废水的一种有效方法,在Fe/C为2:1、pH为3的条件下反应90 min,铁炭微电解出水COD的去除率在49.2％,色度去除率达到80％,该印染废水经微电解处理后,BOD5/COD比值可从原来的0.248上升至0.436,可生化性明显提高.此外,微电解预处理靛蓝牛仔布印染废水中COD的去除反应符合二级反应动力学规律.     

利用CRT屏玻璃制备板状泡沫玻璃

以废旧阴极射线管(CRT屏)为主要原料,混合碳粉作为发泡剂,硼砂为助熔剂、稳泡剂,利用烧结法制备出的板状泡沫玻璃是一种高性能无机建筑保温材料。利用TG-DSC-MS研究分析了CRT屏玻璃的热性能与发泡剂协同作用的关系。配合料被预先压制成板块状,然后在发泡温度下进行烧成。研究了发泡剂碳粉的含量、发泡温度和发泡时间与其结构、性能的关系。研究分析表明,以废CRT屏玻璃为主要原料、碳粉为发泡剂,将混合料压制成块,烧制出板状泡沫玻璃。其较佳的发泡温度为850℃、碳粉的最佳用量范围为0.3%～0.5%,较好的发泡时间为30 min。烧制的板状泡沫玻璃的密度为0.292 g/cm3。在相同的制备条件下,随着发泡温度的升高,气泡孔径也呈现增大趋势,孔壁也逐渐变薄。随着发泡时间逐渐增加,气孔的直径迅速增大,并有形成连通孔。     

利用污泥熟肥作为高含水率污泥堆肥调理剂

采用静态强制通风好氧堆肥的方法,以木屑作为对比,考察了利用污泥熟肥作为调理剂对污泥堆肥过程的影响。结果表明,与以木屑作为调理剂的污泥堆体(对照组)相比,以污泥熟肥作为调理剂的污泥堆体(实验组)升温快,高温阶段(>50℃)持续时间长达10 d,满足粪便无害化卫生标准的要求,而对照组仅持续了2 d;实验组腐熟的堆肥含水率从60%降到39%,下降了21%,pH维持在7.5～8.5范围内,微生物活性较强,而对照组含水率仅下降15%,pH始终低于7.5;实验组种子发芽指数(GI)在第14天就回升到80%以上,基本上去除了植物毒性,而对照组GI在第22天才回升到50%。总体而言,污泥熟肥能显著改善堆肥中微生物的微环境,促进有机物的降解,缩短堆肥腐熟时间,是一种优质的调理剂。     

无机陶瓷膜处理油田采出水

针对陶瓷膜在油田采出水处理过程中操作参数的选择及污染机理进行了研究。通过现场实验,分析了不同的操作参数对膜通量的影响,陶瓷膜对含油量及悬浮物的去除效果,膜阻力组成及膜污染清洗方法。实验结果表明,在确定出水水质达到低渗透油田注水水质A1级标准条件下,陶瓷膜过滤最佳操作条件为:跨膜压差0.16 MPa、温度50℃、膜面流速5.0 m/s。同时发现,NaOH和HNO3联合清洗有助于恢复膜通量。     

MFC-MBR耦合系统运行效果

膜生物反应器(MBR)是一种高效的污水处理工艺,而微生物燃料电池(MFC)能有效降解污泥中的胞外生物有机质(EBOM)并回收电能.将MFC与MBR联用,建立了一套能够有效抑制膜污染同时回收电能的新系统——MFC-MBR耦合系统,MBR的剩余污泥经MFC处理后回流.以传统MBR为对照,对耦合系统中污水处理效果、膜污染情况和污泥混合液的性质进行研究.研究表明,耦合系统的污水处理效果没有明显恶化,COD去除率为94％,NH4+-N的去除率为92％.耦合系统能够有效减缓膜污染的发生,清洗周期延长了28％.污泥混合液的MLVSS/MLSS稳定在80％ ～ 88％,系统内几乎没有无机颗粒积累.松散结合态胞外聚合物(LB-EPS)降低了48％,使污泥混合液性质得到改善.较低的污泥比阻(2.69×1012m/kg)和标准化毛细吸水时间(1.67 s·L/g MLSS),证明耦合系统污泥混合液脱水性能提高了.     

钙对李氏禾富集和耐受铬的调控作用

通过水培实验,研究钙对铬胁迫下李氏禾幼苗生理生化、草酸分泌及铬吸收量的影响,考察钙对李氏禾体内草酸合成的调控,进而促进李氏禾的铬耐性富集能力的作用。结果显示,不同浓度Cr³⁺胁迫下缺钙处理,李氏禾生长受抑制及质膜过氧化作用加剧,体内总草酸含量为对照处理的113%~169%,且主要表现为水溶性草酸含量显著高于对照,水溶性草酸含量为对照处理的135%~197%;高钙处理,李氏禾细胞膜透性、丙二醛（MDA）含量低于对照,李氏禾叶部总草酸含量为对照处理的125%~155%,且主要表现为不溶性草酸含量显著高于对照,其含量为对照处理的181%~270%。低浓度（0.2、0.4 mmol/L）铬胁迫下,高钙处理总铬含量分别为对照处理的175%和215%,高浓度（0.8、1.0 mmol/L）铬胁迫下,总铬含量与对照处理无显著差异（P>0.05）。可见,添加Ca²⁺能在一定Cr³⁺浓度胁迫下,有效缓解铬对李氏禾的毒害,且能通过提高植物体内不溶性草酸含量达到促进植物富集和耐受铬的能力。     

CNTs/TiO2/CS光降解苯的动力学

综合光催化氧化苯的动力学过程、光辐射场模型和质量守恒定律,采用平板型反应器建立了碳纳米管/二氧化钛/壳聚糖(CNTs/TiO2/CS)催化薄膜光催化氧化气相苯的数学模型;该模型考虑了光强、相对湿度、初始浓度与气体流速对气相苯光降解的影响。结果表明,建立的数学模型与实验结果吻合较好。     

Effects of pH and ionic strength on sulfamethoxazole and ciprofloxacin transport in saturated porous media

Many antibiotics regarded as emerging contaminants have been frequently detected in soils and groundwater; however, their transport behaviors in soils remain largely unknown. This study examined the transport of two antibiotics, sulfamethoxazole (SMZ) and ciprofloxacin (CIP), in saturated porous media. Laboratory columns packed with quartz sand was used to test the effects of solution pH and ionic strength (IS) on their retention and transport. The results showed that these two antibiotics behaved differently in the saturated sand columns. In general, SMZ manifested a much higher mobility than CIP for all experimental conditions tested. Almost all SMZ transported through the columns within one pore volume in deionized water (i.e., pH=5.6, IS=0), but no CIP was detected in the effluents under the same condition after extended column flushing. Perturbations in solution pH (5.6 and 9.5) and IS (0 and 0.1M) showed no effect on SMZ transport in the saturated columns. When pH increased to 9.5, however, ~93% of CIP was eluted from the sand columns. Increase of IS from 0 to 0.1M also slightly changed the distribution of adsorbed CIP within the sand column at pH 5.6, but still no CIP was detected in the effluents. A mathematical model based on advection-dispersion equation coupled with equilibrium and kinetic reactions successfully simulated the transport of the antibiotics in water-saturated porous media with R(2)=0.99.     

Investigation of solution chemistry effects on sorption behavior of Cu(II) on ZSM-5 zeolite

The sorption of Cu(II) from an aqueous solution using ZSM-5 zeolite was investigated by batch technique under ambient conditions. Sorption was investigated as a function of pH, ionic strength, foreign ions, humic substances, and temperature. The results indicate that the sorption of Cu(II) on ZSM-5 zeolite is strongly dependent on pH. Sorption is dependent on ionic strength at low pH, but independent of ionic strength at high pH values. The presence of humic/fluvic acid (HA/FA) enhances the sorption of Cu(II) on ZSM-5 zeolite at low pH values, and reduces Cu(II) sorption at high pH values. Sorption isotherms were well simulated by the Langmuir model. Thermodynamic parameters (i.e., deltaH0, deltaS0 and deltaG0) for the sorption of Cu(II) were determined from temperature-dependent sorption isotherms at 293.15, 313.15, and 333.15 K, respectively. Results indicate that the sorption process of Cu(II) on ZSM-5 zeolite is spontaneous and endothermic.