Preparation of Sulfurized Powdered Activated Carbon from Waste Tires Using an Innovative Compositive Impregnation Process

Abstract

The objective of this study is to develop an innovative compositive impregnation process for preparing sulfurized powdered activated carbon (PAC) from waste tires. An experimental apparatus, including a pyrolysis and activation system and a sulfur (S) impregnation system, was designed and applied to produce sulfurized PAC with a high specific surface area. Experimental tests involved the pyrolysis, activation, and sulfurization of waste tires. Waste-tire-derived PAC (WPAC) was initially produced in the pyrolysis and activation system. Experimental results indicated that the Brunauer-Emmett-Teller (BET) surface area of WPAC increased, and the average pore radius of WPAC decreased, as water feed rate and activation time increased. In this study, a conventional direct impregnation process was used to prepare the sulfurized PAC by impregnating WPAC with sodium sulfide (Na₂S) solution. Furthermore, an innovative compositive impregnation process was developed and then compared with the conventional direct impregnation process. Experimental results showed that the compositive impregnation process produced the sulfurized WPAC with high BET surface area and a high S content. A maximum BET surface area of 886 m²/g and the S content of 2.61% by mass were obtained at 900°C and at the S feed ratio of 2160 mg Na₂S/g C. However, the direct impregnation process led to a BET surface area of sulfurized WPAC that decreased significantly as the S content increased.     

A Modal Approach to Vehicular Emissions and Fuel Consumption Model Development

Abstract

This study reports on the analysis of emissions and fuel consumption from motor vehicles using a modal approach. The four standard driving modes are idling, accelerating, cruising, and decelerating. On‐road data were collected using instrumented test vehicles traveling many times through the urban areas of Hong Kong. A model was developed for estimating vehicular fuel consumption and emissions as a function of instantaneous speed and driving mode. Piecewise interpolation functions were proposed for each nonidling driving mode. Idling emission and fuel consumption rates were estimated as negative exponential functions of idling time. Preliminary modeling results showed good agreements for the test vehicles and indicated that the on‐road measurements are feasible for the development of modal emission and fuel consumption models.     

Annual input fluxes of heavy metals in agricultural soil of Hainan Island,China

The accumulation of heavy metals in farmland has become an important issue related to food security and environmental risk. The annual inputs of heavy metals (As, Cd, Hg, Pb, Cr, Cu, and Zn) to agricultural soil for a full year in Hainan Island have been studied. Three fluxes through the cultivated horizon were considered: (1) atmospheric depositions, (2) fertilization, and (3) irrigation water. The corresponding samples were collected and analyzed on a large regional scale. The total input fluxes show obvious spatial variability among different regions. The inventory of heavy metal inputs to agricultural land demonstrates that agricultural soil is potentially at risk of heavy metal accumulation from irrigation water. The potential at risk of heavy metal accumulation from atmospheric deposition and fertilizer is relatively low compared to irrigation. The results indicate that Hg is the element of prior concern for agricultural soil, followed by Cd and As, and other heavy metal elements represent little threat to the environment in the study area. This work provides baseline information to develop policies to control and reduce toxic elements accumulated in agricultural soil.     

Radiosynthesis of perfluorooctanesulfonate (PFOS) and perfluorobutanesulfonate (PFBS), including solubility, partition and adhesion studies

Here, we describe for the first time the synthesis of [³⁵S] PFOS and [³⁵S] PFBS with sulfur-35 enriched sulfur dioxide as the radiolabelled reagent, resulting in 2.5 and 2.3 mCi of product, respectively. Basic information concerning the physicochemical properties of perfluorooctanesulfonate (PFOS), perfluorobutanesulfonate (PFBS) and perfluorooctanoic acid (PFOA) are still limited. Hence, we utilized these radiolabelled perfluoroalkanesulfonates (PFSAs), as well as carbon-14 labelled perfluorooctanoic acid ([¹⁴C] PFOA) to determine some basic characteristics of physiological and experimental significance.The solubility of PFOS in buffered aqueous solutions at pH 7.4 was found to be severely reduced in the presence of potassium and sodium ions, which, however, did not reduce the solubility of PFOA or PFBS. PFOS was found to adhere to a small extent to polypropylene and polystyrene, whereas no such adhesion of PFOA or PFBS was detected. The extents of adhesion of PFOS and PFOA to glass were found to be 20% and 10%, respectively. For the first time, the partition coefficients for PFOS, PFBS and PFOA between n-octanol and water were determined experimentally, to be −0.7, −0.3, and 1.4, respectively, reflecting the difference in the amphiphilic natures of these molecules.     

On the use of a freeze-dried versus an air-dried soil humic acid as a surrogate of soil organic matter for contaminant sorption

The sorption of phenanthrene (PHN) to relatively pure soil humic acids (HAs) was investigated to assess the suitability of the soil HA as a surrogate sorbent for the soil organic matter (SOM). The HAs were prepared in both freeze-dried and air-dried forms. The two forms of HAs from the same source are similar in composition but the freeze-dried HAs exhibit a significantly higher initial surface area (SA) (3.86-4.59 m(2)/g); the SAs of air-dried HAs are below 0.1 m(2)/g. However, the SAs of freeze-dried HAs are not stable upon contact with water; the samples lose practically all the SA after 4 days of immersion in water. The PHN sorption to both forms of HAs is practically linear, whether a co-solute is present or not. The sorption linearity observed with the present freeze-dried HAs is in sharp contrast with the allegedly nonlinear PHN sorption on similar freeze-dried HAs as presented by others.     

Polychlorinated dibenzo-p-dioxins (PCDDs), polychlorinated dibenzofurans (PCDFs), dioxin-like polychlorinated biphenyls (PCBs) and polybrominated diphenyl ethers (PBDEs) in waterbird eggs of Hong Kong, China

Concentrations of PCDD/Fs, PCBs and PBDEs were measured in 56 egg samples collected from waterbirds of different species (Great Egret, Little Egret, Night Heron and Chinese Pond Heron) from different regions of Hong Kong (Ho Sheung Heung, Mai Po Village and Mai Po Lung Village) during 2000 and 2006. Dominance of 2,3,4,7,8-PeCDF indicates a signature associated with commercial usage of PCBs. Although no significant variations were observed within- and between-site in the levels of PCDD/Fs, coplanar PCBs and PBDEs, the concentrations of coplanar PCBs were much higher than PCDD/Fs. Similarity in composition profiles of PCDD/F and coplanar PCBs from different egretries is possibly associated with non-point sources of these contaminants to Hong Kong. Predominant accumulation of BDE-47, BDE-99 and BDE-100 suggested the penta-BDE technical mixtures usage in Hong Kong and its vicinity. Toxic equivalency and Monte Carlo simulation technique showed potential risks on waterbirds due to their exposure to PCDD/Fs.     

Photocatalytic degradation of methyl orange by a multi-layer rotating disk reactor

Introduction

Solar wastewater treatment based on photocatalytic reactions is a green process that utilizes renewable energy resources and minimizes secondary pollution. Reactor design plays an important role in promoting treatment efficiency and throughput density (based on unit volume of the reactor).

Experimental

A rotating disk reactor that significantly increases the process efficiency has been designed and evaluated for application to photocatalytic decomposition of dye pollutants in aqueous solutions. In this process, a novel multi-layer rotating disk reactor (MLRDR) was presented. Photocatalyst (TiO₂) particles are immobilized on the surfaces of disks. Within each layer of the reactor, methyl orange aqueous solution is allowed to flow from the center of the disk in a radial direction along the surface of the disk, which is rotating at high speed and is irradiated with UV lamps. The effluent is then directed to the center of another layer that lies underneath. Up to four stacked layers have been tested in this study, and the effects due to the number of the layers and volumetric flow rate on reaction conversion are investigated.

Results and discussion

The efficiency of this photocatalytic reactor exhibits complex dependence on these parameters. With selected operating conditions, conversions greater than 95% can be achieved within seconds of residence time. Design equations of the reactor have been derived based on fluid dynamics and kinetic models, and the simulation results show promising scale-up potential of the reactor.     

污染场地不同深度土壤有机-矿质复合体中有机氯农药的分布

采用物理方法将某农药厂土壤分成4种粒径的有机-矿质复合体组分,粘粒、粉粒、细砂和粗砂,研究有机氯农药在土壤不同有机-矿质复合体组分中的分布特征及有机质含量对污染物质赋存分布的影响。结果表明,粉粒组分中污染物质六六六含量较高,粘粒组分中滴滴涕含量较高。粘粒和粉粒组分中污染物质的含量与相应的有机质含量间呈现显著相关关系,而在细砂和粗砂中这种相关性不显著。lgKoc值与污染物质含量的相关性分析结果与有机质的相关性分析结果相似。有机质可能是影响场地土壤有机氯农药分布的重要因素之一。本研究的结果可为污染场地的风险控制和环境修复提供基础依据。     

市政污泥与不同烟煤混合燃烧特性

使用非等温热重法,研究了淮北烟煤和神华烟煤在6种不同市政污泥掺混比条件下对混合燃烧特性的影响,并对混合燃烧过程的动力学特性进行了分析。实验结果表明:污泥与煤的混合燃烧特性从总体上表现为污泥与煤共同作用的结果,最优的污泥掺混比受到煤种的影响。在不同煤中污泥掺烧比少于20%对煤的活性影响较小。活化性能较差的淮北烟煤在污泥掺混比为30%时,在不同的温度区间分别表现出污泥与煤的反应特征。活化性能较好的神华烟煤在污泥掺混比为40%时表现这一趋势。     

Persistent organic pollutants in food items collected in Hong Kong

This study aims to investigate levels of POPs in meat, edible oils, nuts, milk and wine collected from Hong Kong. Naphthalene, pp-DDE, beta-, gamma-HCH and PBDE 47 were detected in most of the food items. Goose liver accumulated the highest PAHs (47.9 ng g⁻¹ wet wt), DDTs (25.6), HCHs (13.0), PCBs (4.17), PBDEs (468 pg g⁻¹ wet wt) among all the selected food. Meat and nut groups had significant (p < 0.01 or 0.05) correlations between lipid contents and concentrations of PAHs (meat: r = 0.878), HCHs (meat: r = 0.753), DDTs (meat: r = 0.937; nuts: r = 0.968) and PCBs (meat: r = 0.832; nut: r = 0.946). The concentrations of DDTs, HCHs and PCBs in vegetable oil were lower, but HCHs in fish oil were higher, when compared with other countries. The concentrations of PAHs, DDTs, PCBs and PBDEs in food tested in the present study were all below various safety guidelines.