Soil carbon pools and fluxes in urban ecosystems

The transformation of landscapes from non-urban to urban land use has the potential to greatly modify soil carbon (C) pools and fluxes. For urban ecosystems, very little data exists to assess whether urbanization leads to an increase or decrease in soil C pools. We analyzed three data sets to assess the potential for urbanization to affect soil organic C. These included surface (0-10 cm) soil C data from unmanaged forests along an urban-rural gradient, data from "made" soils (1 m depth) from five different cities, and surface (0-15 cm) soil data of several land-use types in the city of Baltimore. Along the urban-rural land-use gradient, we found that soil organic matter concentration in the surface 10 cm varied significantly (P=0.001). In an analysis of variance, the urban forest stands had significantly (P=0.02) higher organic C densities (kg m(-2) to 1 m depth) than the suburban and rural stands. Our analysis of pedon data from five cities showed that the highest soil organic C densities occurred in loamy fill (28.5 kg m(-2)) with the lowest occurring in clean fill and old dredge materials (1.4 and 6.9 kg m(-2), respectively). Soil organic C densities for residential areas (15.5 +/- 1.2 kg m(-2)) were consistent across cities. A comparison of land-use types showed that low density residential and institutional land-uses had 44 and 38% higher organic C densities than the commercial land-use type, respectively. Our analysis shows that as adjacent land-use becomes more urbanized, forest soil C pools can be affected even in stands not directly disturbed by urban land development. Data from several "made" soils suggests that physical disturbances and inputs of various materials by humans can greatly alter the amount C stored in these soils.     

Analysis of pesticide runoff from mid-Texas estuaries and risk assessment implications for marine phytoplankton

During 1993, estuarine surface water samples were collected from the mid-Texas coast (Corpus Christi to Port Lavaca, TX). Agricultural watershed areas as well as tidal creeks immediately downstream were chosen as sampling sites along with adjoining bay sampling stations. Collections were made throughout the growing season (February to October 1993) before and after periods of significant (> 1.25 cm) rainfall. All samples were initially screened for the presence of pesticides using enzyme-linked immunosorbent assay (ELISA) test kits (EnviroGard) for triazine herbicides and carbamate insecticides. All samples were extracted and then analyzed using gas chromatography (GC) for quantification of atrazine. Only samples testing positive for carbamate insecticides via ELISA were further extracted for GC analysis to quantify aldicarb and carbofuran. Additionally, laboratory toxicity tests using phytoplankton were examined from published, peer-reviewed literature and compared with the atrazine field levels found in Texas. Results of ELISA screening indicated the presence of triazine herbicides in nearly all samples (>93%). GC analysis further confirmed the presence of atrazine concentrations ranging from <0.01-62.5 microg/L. Screening tests also found detectable levels of carbamate insecticides (aldicarb and carbofuran) that were also confirmed and quantified by GC. Comparison of measured concentrations of atrazine compared with published toxicity tests results indicated that there was a potential environmental risk for marine/estuarine phytoplankton in surface waters of Texas estuaries, particularly when the chronic nature of atrazine exposure is considered.     

Microcosm studies of microbial degradation in a coal tar distillate plume

Investigation of a groundwater plume containing up to 24 g l(-1) phenolic compounds suggested that over a period of nearly 50 years, little degradation had occurred despite the presence of a microbial community and electron acceptors within the core of the plume. In order to study the effect of contaminant concentration on degradation behaviour, laboratory microcosm experiments were performed under aerobic and anaerobic conditions at four different concentrations obtained by diluting contaminated with uncontaminated groundwater. The microcosms contained groundwater with total phenols at ca. 200, 250, 660 and 5000 mg l(-1), and aquifer sediment that had been acclimatised within the plume for several months. The microcosms were operated for a period of 390-400 days along with sterile controls to ascertain whether degradation was microbially mediated or abiotic. Under aerobic conditions, degradation only occurred at concentrations up to 660 mg l(-1) total phenols. At phenol concentrations below 250 mg l(-1) a benzoquinone intermediate, thought to originate from the degradation of 2,5-dimethylphenol, was isolated and identified. This suggested an unusual degradative pathway for this compound; its aerobic degradation more commonly proceeding via catecholic intermediates. Under anaerobic conditions, degradation only occurred in the most dilute microcosm (total phenols 195 mg l(-1)) with a loss of p-cresol accompanied by a nonstoichiometric decrease in nitrate and sulphate. By inference, iron(III) from the sediment may also have been used as a terminal electron acceptor, in which case the amount of biologically available iron released was calculated as 1.07 mg Fe(III)/g of sediment. The study shows that natural attenuation is likely to be stimulated by dilution of the plume.     

Sediment evidence of early eutrophication and heavy metal pollution of Lake Mälaren, central Sweden

Lake M?laren is the water supply and recreation area for more than 1 million people in central Sweden and subject to considerable environmental concern. To establish background data for assessments of contemporary levels of trophy and heavy metal pollution, sediment cores from the lake were analyzed. Diatom-inferred lake-water phosphorus concentrations suggest that pre-20th century nutrient levels in S?dra Bj?rkfj?rden, a basin in the eastern part of M?laren, were higher (c. 10-20 micrograms TP L-1) than previously assumed (c. 6 micrograms TP L-1). Stable lead isotope and lead concentration analyses from 3 basins (S. Bj?rkfj?rden, Gisselfj?rden and Ask?fj?rden) show that the lake was polluted in the 19th century and earlier from extensive metal production and processing in the catchment, particularly in the Bergslagen region. The lake has experienced a substantial improvement of the lead pollution situation in the 20th century following closure of the mining and metal industry. The lead pollution from the old mining industry was large compared to late-20th century pollution from car emissions, burning of fossil fuels and modern industries.     

Modeling relationships between indoor and outdoor air quality

Information about the ratio between indoor and outdoor concentrations (IO ratios) of air pollutants is a crucial component in human exposure assessment. The present study examines the relationship between indoor and outdoor concentrations as influenced by the combined effect of time patterns in outdoor concentrations, ventilation rate, and indoor emissions. Two different mathematical approaches are used to evaluate IO ratios. The first approach involves a dynamic mass balance model that calculates distributions of transient IO ratios. The second approach assumes a linear relationship between indoor and outdoor concentrations. We use ozone and benzene as examples in various modeling exercises. The modeled IO ratio distributions are compared with the results obtained from linear fits through plots of indoor versus outdoor concentrations.     

Effect of methyl tertiary butyl ether concentrations on exhaust emissions from gasoline used in the metropolitan area of Mexico City

In this work, the primary objective was to assess the impact of oxygenated fuel on the exhaust emissions from an important fraction of vehicles in the Metropolitan Area of Mexico City (MAMC). The results aim to provide information on the actual effect of MTBE on a fleet that represents more than 60% of the in-use vehicles in the MAMC. Ten vehicles were tested with a low-octane base gasoline, and 10 more with a regular-grade unleaded base gasoline. Three MTBE concentrations, 5, 10, and 15 vol %, were tested following the U.S. Federal Test Procedure (FTP). CO, total HC, and NOx from the exhaust gases were quantitatively evaluated and also characterized for FTP speciated organic emissions. From this data, the O3-forming potential of the fuels was calculated. Results show that for the fleet using low-octane gasoline, the addition of 10% MTBE substantially reduced CO emissions, but total HC concentration in the exhaust showed a modest decrease. For the regular gasoline, the 10% MTBE blend seemed to be the best choice, but there was not a significant decrease in emissions. The specific reactivity of each fuel, expressed in grams of O3 per gram of nonmethane organic gases, increased with MTBE concentration in both cases. This result is important to consider, especially for a region like Mexico City, which has high atmospheric O3 concentrations.     

Neural network model for predicting peak photochemical pollutant levels

In this paper, an attempt is made for the 24-hr prediction of photochemical pollutant levels using a neural network model. For this purpose, a model is developed that relates peak pollutant concentrations to meteorological and emission variables and indexes. The analysis is based on measurements of O3 and NO2 from the city of Athens. The meteorological variables are selected to cover atmospheric processes that determine the fate of the airborne pollutants while special care is taken to ensure the availability of the required input data from routine observations or forecasts. The comparison between model predictions and actual observations shows a good agreement. In addition, a series of sensitivity tests is performed in order to evaluate the sensitivity of the model to the uncertainty in meteorological variables. Model forecasts are generally rather insensitive to small perturbations in most of the input meteorological data, while they are relatively more sensitive in changes in wind speed and direction.     

Use of Project MOHAVE perfluorocarbon tracer data to evaluate source and receptor models

Project MOHAVE was a major monitoring, modeling, and data analysis study whose objectives included the estimation of the contributions of the Mohave Power Project (MPP) and other sources to visibility impairment in the southwestern United States, in particular at Grand Canyon National Park. A major element of Project MOHAVE was the release of perfluorocarbon tracers at MPP and other locations during 50-day summer and 30-day winter intensive study periods. Tracer data (from about 30 locations) were sequestered until several source and receptor models were used to predict tracer concentrations. None of the models was successful in predicting the tracer concentrations; squared correlation coefficients between predicted and measured tracer were all less than 0.2, and most were less than 0.1.     

The use of mosses and pine needles to detect persistent organic pollutants at local and regional scales

Polycyclic aromatic hydrocarbons (PAHs) were analysed in mosses (Hypnum cupressiforme) and pine needles (Pinus sylvestris) collected in the Czech Republic between 1988-94 at a regional background site in Kosetice, south Bohemia (1988-94) and two industrial sources. One industrial site (sampled 1989-91) in middle Moravia, was near a factory producing PAHs, carbon black and phthalates, the other (sampled 1991-93) near a coal and gas fuel production plant in western Bohemia. Selected chlorinated pesticides and polychlorinated biphenyl congeners were also analysed in samples at the regional background site. This study clearly shows that vegetation sampling can be used to show spatial differences in the atmospheric burden of a range of persistent organic pollutants with differences in the mixtures of compounds reflecting differences in their regional or local use/atmospheric emission.     

Effects of point-source PCB contamination on breeding performance and post-fledging survival in the dipper Cinclus cinclus

Despite widespread information on the incidence and biochemical effects of polychlorinated biphenyls (PCBs) in birds, field studies of effects on population processes are still scarce. This is particularly so in passerines. We therefore assessed breeding performance and post-fledging survival in dippers, Cinclus cinclus, breeding along the Afon Mule, a Welsh river where previous work indicated locally elevated PCB concentrations. We hypothesised that marked toxicological effects, including endocrine disruption, would be detectable as altered clutch-size, hatching success, nest success, brood-size, post-fledging survival or recruitment to the breeding population. Congener-specific analysis of PCBs in failed and deserted dipper eggs during 1990-93 revealed that geometric mean concentrations were four to 20 times higher along the Mule than elsewhere in Wales, UK. PCB signatures also varied highly significantly from other locations, with congeners 138, 153 and 180 dominant at the contaminated site, but 118 or 170 more frequent in eggs elsewhere. Subsequent analysis of surface runoff confirmed a small breaker's yard as a point source. Neither laying dates, clutch-sizes, brood-sizes, nest failure nor hatching failure along the contaminated Mule (n=46 breeding attempts and 218 eggs) differed significantly from dippers along adjacent reference rivers (n=82 breeding attempts and 315 eggs) or Welsh rivers as a whole (n=332 breeding attempts and 1534 eggs). Subsequent recaptures of breeding dippers ringed initially as nestlings were nearly identical between the Mule (7.7% of 182 nestlings), the reference set (7.5% of 323 nestlings) and all other Welsh rivers (7.3% of 2821 nestlings). These data illustrate the value of congener-specific analysis of bird's eggs in indicating local PCB sources. The data show also that PCBs can occur in dipper eggs at total concentrations of 0.49 (geometric mean)-1.29 (upper quartile) microg g(-1) wet mass without effects on breeding performance and survival. These values are below those at which biochemical or reproductive effects on other passerines have been detected, but above current concentrations in any other population of European dippers for which PCB data are available. Population effects by PCBs on European dippers are therefore unlikely. Survivors from locally contaminated sites like that in our study might allow field assessments of second-generation effects on breeding performance in wild birds that have developed under PCB exposure.