Air quality in cabin environment of different passenger cars: effect of car usage,fuel type and ventilation/infiltration conditions

Environmental Science and Pollution Research - Despite that commuters spend only 5.5% of their time in cabin vehicles, their exposure to harmful air pollutants, originated from the vehicle itself,...     

Solid waste management planning for sub-district scale: a case study in Buleleng sub-district,Buleleng district,Bali province,Indonesia

Journal of Material Cycles and Waste Management - This study aims to identify the amount of solid waste generation, composition, and characteristics of the Buleleng sub-district waste. The results...     

Air Pollution in Singapore: Its Multielemental Aspect as Measured by Nuclear Analytical Techniques

Aerosol samples were collected in 1994 in Singapore on two occasions: once in June during the normal meteorological conditions and later in October during a long haze period caused by the heavy forest fire in Indonesia. Filtration and impaction collection methods were used simultaneously so that detailed elemental analysis of bulk as well as of different size fractions could be performed. Accelerator based nuclear analytical techniques such as Particle Induced X-Ray Emission (PIXE), Rutherford Backscattering (RBS) and Nuclear Microscopy (NM) were used for analysis. These techniques are fast, truly multielemental and perfectly suited for routine analysis of a large number of aerosol samples. Typically all samples were analysed for the following 24 elements: Na, Mg, Al, Si, P, S, Cl, K, Ca, Ti, V, Mn, Cr, Fe, Co, Ni, Cu, Zn, Ga, As, Br, Rb, Sr and Pb. Detection limits for bulk analysis were generally below ng/m3 and for single particle analysis absolute detectable mass was approximately 10-17 g. Additionally, trace elements such as Cd, Sn, Sb and Ba whose characteristic X-ray lines were normally "obscured" by the lines of other more abundant elements, were detected when analysing by nuclear microscope in single particle mode.Judging by the average concentrations of lead and sulphur which are good indicators of industrial component of air pollution the situation in Singapore is satisfactory. Pb was typically found in concentrations of 5 to 50 ng/m3 and sulphur in concentrations of 1 to 2 µg/m3. These concentrations are well below limits set by the World Health Organisation (1500 ng/m3 and 40 µg/m3, respectively). On the other hand during the haze period the average concentrations of elements like S, K, Ti, V, Mn, Ni, As and Pb were found to be 3 to 6 times higher than usual. Results are presented and discussed.     

Uranium series isotopes in the Avon Valley, Nova Scotia

An U-series isotopic study was carried out in the waters of the Avon Valley, Nova Scotia. The fresh and acidic recharge waters flow rapidly through the watershed composed of a granitic highland and a sedimentary, largely carbonate, lowland plain, before draining to the sea. There is no significant anthropogenic pollution; but, naturally elevated U levels can be encountered within the bedrock. Nonetheless, the U concentrations of the surface and groundwater are low (generally within the range of several hundredths to several tenths of a microg l(-1)), except in the proximity to weathering of U mineralization. The dissolved U in the surface waters appears to be stabilized by organic rather than inorganic complexes. Both the groundwaters and surface waters have similar (234)U/(238)U activity ratios that rarely deviate from secular equilibrium by more than 20% throughout the watershed. The magnitude of the (234)U/(238)U activity ratio is not determined by lithology but rather by the weathering mechanism, the high rate of flushing, and the leaching of local U mineralization. Dissolved Ra is consistently absent. The dissolved Rn concentrations, though variable, are measurable even in surface waters. This may be due to a continual degassing from the U-enriched bedrock or release from local sites of U mineralization underlying the surface water sources.     

Flow structure and turbulence characteristics downstream of a spanwise suspended linear array

Laboratory experiments are conducted to quantify the mean flow structure and turbulence properties downstream of a spanwise suspended linear array in a uniform ambient water flow using Particle Tracking Velocimetry. Eighteen experimental scenarios, with four depth ratios (array depth to water column depth) of 0.35, 0.52, 0.78, and 0.95 and bulk Reynolds number (length scale is the array depth) from 11,600 to 68,170, are investigated. Three sub-layers form downstream of the array: (1) an internal wake zone, where the time-averaged velocity decreases with increasing distance downstream, (2) a shear layer which increases in vertical extent with increasing distance downstream of the array, and the rate of the increase is independent of the bulk Reynolds number or the depth ratio, and (3) an external wake layer with enhanced velocity under the array. The location of the shear layer is dependent on the depth ratio. The spatially averaged and normalized TKE of the wake has a short production region, followed by a decay region which is comparable to grid turbulence decay and is dependent on the depth ratio. The results suggest that the shear layer increases the transfer of horizontal momentum into the internal wake zone from the fluid outside of the array and that the turbulence in the internal wake zone can be modeled similarly to that of grid turbulence.     

Assessment of oxidative and UV-C treatments for inactivating bacterial biofilms from groundwater wells

Microorganisms are ubiquitous in natural environments and in water supply infrastructure including groundwater wells. Sessile-state microorganisms may build up on well surfaces as biofilms and, if excessive, cause biofouling that reduces well productivity and water quality. Conditions can be improved using biocides and other traditional well rehabilitation measures; however, biofilm regrowth is inevitable given the continuous introduction of microorganisms from the surrounding environment. Alternative and less invasive well maintenance approaches are desirable for reducing biofilm densities while also minimizing harmful disinfection-by-products. The primary objective of this research was to evaluate effectiveness of alternative treatments for inactivating microorganisms comprising biofilms. A novel approach was designed for in situ growth of biofilms on steel coupons suspended from ‘chandeliers’. After more than 100 days of in situ growth, biofilms were harvested, sampled, and baseline biofilm densities quantified through cultivation. Ultraviolet-C (UV-C) and oxidative treatments including hydrogen peroxide (H₂O₂), ozone (O₃) and mixed oxidants were then applied to the biofilms in laboratory-scale treatments. Microbial inactivation was assessed by comparing treated versus baseline biofilm densities. H₂O₂ was the most effective treatment, and decreased density below baseline by as much as 3.1 orders of magnitude. Mixed oxidants were effective for the well having a lower density biofilm, decreasing density below baseline by as much as 1.4 orders of magnitude. Disparity in the response to treatment was apparent in the wells despite their spatial proximity and common aquifer source, which suggests that microbiological communities are more heterogeneous than the natural media from which they originate.