Biosorption of Direct Yellow 12 from aqueous solution using green alga Ulva lactuca

The potential of commonly available green alga Ulva lactuca was investigated as viable biomaterials for removal of synthetic azo dye (Direct Yellow 12, DY-12) from aqueous solution. The results obtained from the batch experiments revealed that the ability of the U. lactuca to remove DY-12 from its aqueous solution was dependent on the dye concentration, pH, and algal biomass but less dependent on the particle size of the U. lactuca. The equilibrium conditions and kinetics of adsorption were investigated, and the adsorption kinetic was consistent with the pseudo-second-order model (R²=1). The adsorption isotherm followed only the Freundlich model with a correlation coefficient R²=0.99. This study demonstrated that the U. lactuca could be used as an effective biosorbent for the removal of DY-12 from its aqueous solution.     

Efficiency and degradation products elucidation of the photodegradation of mefenpyrdiethyl in water interface using TiO2 P-25 and Hombikat UV100

The photodegradation of mefenpyrdiethyl (MFD), an herbicide safener, was investigated in aqueous suspensions by using Degussa P-25 and Hombikat UV100 titanium oxide under simulated sunlight irradiation. The effects of initial concentration of the herbicide, pH, catalysts and hydrogen peroxide doses as well as their combinations were studied and optimized. Accordingly, the kinetic parameters were determined and the effectiveness of the processes was assessed by calculating the rate constants. A pseudo first-order kinetics was observed. Under experimental conditions, the degradation rate constants were strongly influenced using P-25 and no noticeable effect was observed for Hombikat UV100. DFT calculations with B3LYP/6-311+G(2d,p)//B3LYP/6-31+G(d,p) level of theory were performed to check whether significant conformational changes occur when the charge state of the MFD substrate changes and whether these changes could play a role in the dependency of photodegradation rate constant on the studied pH. High resolution mass spectrometry (FT-ICR/MS) was implemented to identify the main degradation products.     

An assessment of heavy-metal contamination in surface sediments of the Suez Gulf using geoaccumulation indexes and statistical analysis

An assessment of marine pollution due to metals was made in the Suez Gulf based on surface costal sediment collected from 18 locations along the Gulf. The samples were dried and acid-digested, and the metal contents (Cd, Co, Cr, Cu, Fe, Mn, Ni, Pb, and Zn) were determined using a flame atomic absorption spectrophotometer (air-acetylene) with deuterium background correction. An evaluation of the heavy-metal pollution status of the Gulf was carried out using enrichment factors (EF) and geo-accumulation Indexes (I_geo). Also, heavy-metal concentrations in Suez Gulf sediments were evaluated using the Effect Range-Low (ERL) and the Effect Range-Median (ERM). The results of a Spearman correlation and factor and cluster analysis of the heavy metals analysed in the collected sediment were discussed. The main source of contamination is offshore oil field and industrial wastes, which arise due to the ineffective and inefficient operation equipments, illegal discharge and lack of supervision, and prosecution of offenders.     

Characterization of the TE-NORM waste associated with oil and natural gas production in Abu Rudeis, Egypt

The present study was conducted to characterize the Technically Enhanced Naturally Occurring Radioactive Materials (TE-NORM) waste generated from oil and gas production. The waste was characterized by means of dry screening solid fractionation, X-ray analysis (XRF and XRD) and gamma-ray spectrometry. Sediment of the TE-NORM waste was fractionated into ten fractions with particle sizes varying from less than 100 microm to more than 3 mm. The results showed that the TE-NORM waste contains mainly radionuclides of the 238U, 235U and 232Th series. The mean activity concentrations of 226Ra (of U-series), 228Ra (of Th-series) and 40K in the waste samples before fractionation (i.e. 3 mm) were found to amount to 68.9, 24 and 1.3 Bq/g (dry weight), respectively. After dry fractionation, the activity concentrations were widely distributed and enriched in certain fractions. This represented a 1.48 and 1.82-fold enrichment of 226Ra and 228Ra, respectively, in fraction F8 (2.0-2.5 mm) over those in bulk TE-NORM waste samples. The activity ratios of 238U/226Ra, 210Pb/226Ra, 223Ra/226Ra and 228Ra/224Ra were calculated and evaluated. Activity of the most hazardous radionuclide 226Ra was found to be higher than the exemption levels established by IAEA [International Atomic Energy Agency, 1994. International Basic Safety Standards for the Protection against Ionizing Radiation and for the Safety of Radiation Sources. GOV/2715/94, Vienna]. The radium equivalent activity (Ra-eq), radon (222Rn) emanation coefficient (EC) and absorbed dose rate (Dgammar) were estimated and these are further discussed.     

Mode choice model for vulnerable motorcyclists in Malaysia

OBJECTIVE: In developing countries, motorcycle use has grown in popularity in the past decades. Commensurate with this growth is the increase in death and casualties among motorcyclists in these countries. One of the strategic programs to minimize this problem is to reduce motorcyclists exposure by shifting them into safer modes of transport. This study aims to explore the differences in the characteristics of bus and motorcycle users. It identifies the factors contributing to their choice of transport mode and estimates the probability that motorcyclists might change their travel mode to a safer alternative; namely, bus travel. METHODS: In this article, a survey of 535 motorcycle and bus users was conducted in seven districts of Selangor state, Malaysia. A binary logit model was developed for the two alternative modes, bus and motorcycle. RESULTS: It was found that travel time, travel cost, gender, age, and income level are significant in influencing motorcyclists' mode choice behavior. The probability of motorcycle riders shifting to public transport was also examined based on a scenario of a reduction in bus travel time and travel cost. CONCLUSIONS: Reduction of total travel time for the bus mode emerges as the most important element in a program aimed at attracting motorcyclists towards public transport and away from the motorcycle mode.     

Comparing the usability and reliability of a generic and a domain-specific medical error taxonomy

Medical error taxonomies are used to report and analyse patient safety incidents. Medical error taxonomies can be generic or domain-specific. In comparing generic and domain-specific medical error taxonomies, the literature compares the information both type of taxonomies classify. There is little evidence the taxonomies have been compared in terms of usability and reliability. Twenty nurses and 21 pharmacists participated in a study comparing the usability and reliability of a generic medical error taxonomy and a medication error taxonomy. The medical error taxonomies utilized were the Patient Safety Event Taxonomy and the NCC MERP Taxonomy of Medication Error. The study found no significant difference in the usability ratings of both taxonomies. The taxonomies required different amount of time to classify patient safety incidents and had significantly different reliability levels. The reliability of the NCC MERP Taxonomy of Medication Error was significantly different when used by nurses and pharmacists. The taxonomy was also preferred by the majority of participants. Some recommendations are made about the design of future medical error taxonomies.