Implementation of the semi-aerobic landfill system (Fukuoka method) in developing countries: a Malaysia cost analysis

Most of the existing solid waste landfill sites in developing countries are practicing either open dumping or controlled dumping. Proper sanitary landfill concepts are not fully implemented due to technological and financial constraints. Implementation of a fully engineered sanitary landfill is necessary and a more economically feasible landfill design is crucial, particularly for developing countries. This study was carried out by focusing on the economics from the development of a new landfill site within a natural clay area with no cost of synthetic liner up to 10 years after its closure by using the Fukuoka method semi-aerobic landfill system. The findings of the study show that for the development of a 15-ha landfill site in Malaysia with an estimated volume of 2,000,000 m(3), the capital investment required was about US 1,312,895 dollars, or about US 0.84 dollars/tonne of waste. Assuming that the lifespan of the landfill is 20 years, the total cost of operation was about US 11,132,536 dollars or US 7.15 dollars/tonne of waste. The closure cost of the landfill was estimated to be US 1,385,526 dollars or US 0.89 dollars/tonne of waste. Therefore, the total cost required to dispose of a tonne of waste at the semi-aerobic landfill was estimated to be US 8.89 dollars. By considering an average tipping fee of about US 7.89 dollars/tonne of waste in Malaysia in the first year, and an annual increase of 3% to about US 13.84 dollars in year-20, the overall system recorded a positive revenue of US 1,734,749 dollars. This is important information for the effort of privatisation of landfill sites in Malaysia, as well as in other developing countries, in order to secure efficient and effective landfill development and management.     

Reduction of Methane Released from Palm Oil Mill Lagoon in Malaysia and Its Countermeasures

Palm oil industry in Malaysia is one of the potential candidates for the CDM project because large amount of methane is emitted from the lagoons and open digesting tank of the wastewater treatment system. Therefore the first objective of the project is to investigate the actual GHG emission from the lagoons and open digesting tank in palm oil mills in order to establish the baseline for CDM project. Results indicated that methane contribution to biogas released from the open digesting tank and lagoon systems were 35% and 45%, respectively. These values are much lower than the reported value of 65% obtained by complete anaerobic condition of lab-scale experiments. Based on actual methane release measurement and information gathered from palm oil mill about wastewater treatment, significant amount of methane emission to the atmosphere can be reduced with the installation of new closed digesting tank system converted from the open digesting tank such as just by covering it with applying CDM. It is estimated that a total of RM2.6 million could be obtained from the selling of electricity generated from biogas generation and Certified Emission Reduction(CER). This revised version was published online in August 2006 with corrections to the Cover Date.     

Soil characteristics under cash crop farming in upland areas of Sarawak,Malaysia

This study discusses soil fertility under perennial cash crop farming (para rubber, Hevea brasiliensis; black pepper, Piper nigrum; oil palm, Elaeis guineensis) conducted by local farmers and an oil palm estate in an upland area of Sarawak, Malaysia, in comparison with the surrounding secondary forests. In the farmlands of the local farmers, rubber farming was conducted without fertilizer application, while 2–5 t ha^?1 of NPK compounds were applied annually on pepper farms. Soils under rubber farming were acidic with poor nutrient contents, resembling soils in secondary forests. In pepper farms, soils were less acidic and showed high nutrient contents, especially with respect to available P and exchangeable Ca. This trend became stronger with increasing farming duration. Fertilizers applied around pepper vines appeared to migrate and spread across the fields. Bulk density and hardness of surface soils were higher in pepper farms than in secondary forests, indicating soil compaction due to field works. In the oil palm estate, annual fertilizer application rates were moderate at 0.4–0.8 t ha^?1 of NPK compound fertilizers. However, the soil properties in the oil palm estate were similar to those of the small-scale pepper farms. Close to the bases of the palms where fertilizers usually are applied, the contents of exchangeable Ca and available P were high. Nutrient uptake by the dense root systems of the palms seemed to prevent excessive loss of nutrients through leaching. Loss of soil organic matter and deterioration of soil physical properties were brought about by terrace bench construction, but the soils seemed to recover to some extent over time. In conclusion, technologies such as intercropping and the appropriate allocation of different crops to specific locations as well as the proper selection and dosage of fertilizers should be developed and adopted to improve fertilizer efficiency and prevent water pollution due to fertilizer wash-off from farmlands.     

Distribution of Chironomidae (Insecta: Diptera) in polluted rivers of the Juru River Basin, Penang, Malaysia

The influence of physical and chemical parameters on the abundance and diversity of chironomids was studied in six rivers with moderate to highly polluted water in the Juru River Basin. The rivers: Ceruk Tok Kun (CTKR) as reference site, and polluted rivers of Pasir (PR), Juru (JR), Permatang Rawa (PRR), Ara (AR) and Kilang Ubi (KUR) were sampled over a period of five months (November 2007–March 2008). Nine chirnomid species: Chironimus kiiensis, C. javanus, Polypedilum trigonus, Microchironomus sp., Dicrotendipes sp., Tanytarsus formosanus, Clinotanypus sp., Tanypus punctipennis and Fittkauimyia sp. were identified. Assessment of their relationships with several environmental parameters was performed using the canonical correspondence analysis (CCA). Tanytarsus formosanus was the most dominant in the relatively clean CTKR and moderately polluted JR with mean densities of 19.66 and 25.32 m?2, respectively while C. kiiensis was abundant in more polluted rivers. Tanytarsus formosanus, Dicrotendipes sp. and Microchironomus sp. were grouped under moderate to high water temperature, total organic matter (TOM), total suspended solids (TSS), velocity, pH, phosphates and sulphates. However, Tanypus punctipennis, Fittkauimyia sp., and Clinotanypus sp. were associated with high contents of river sediment such as TOM, Zn and Mn and water ammonium-N and nitrate-N and they were associated with higher dissolved oxygen (DO) content in the water. Chironomus kiiensis, C. javanus and P. trigonus showed positive relationships with TOM, ammonium-N and nitrate-N as well as trace metals of Zn, Cu and Mn. These three species could be considered as tolerant species since they have the ability to survive in extreme environmental conditions with low DO and high concentrations of pollutants. Based on the water parameter scores in all rivers, the highest diversity of chironomid larvae was reported in CTKR. With higher concentrations of organic and/or inorganic pollutants as reported in PPR, KUR and AR, the chironomid larval diversity decreased, and the abundance of tolerant species, mainly Chironomus spp., increased.     

Removal of arsenic species from water by batch and column operations on bagasse fly ash

Bagasse fly ash (BFA, a sugar industrial waste) was used as low-cost adsorbent for the uptake of arsenate and arsenite species from water. The optimum conditions for the removal of both species of arsenic were as follows: pH 7.0, concentration 50.0 μg/L, contact time 50.0 min, adsorbent dose 3.0 g/L, and temperature 20.0 °C, with 95.0 and 89.5 % removal of arsenate and arsenite, respectively. The Langmuir, Freundlich, Temkin, and Dubinin–Radushkevich adsorption isotherms were used to analyze the results. The results of these models indicated single-layer uniform adsorption on heterogeneous surface. Thermodynamic parameters, i.e., ΔG°, ΔH°, and ΔS°, were also calculated. At 20.0 to 30.0 °C, the values of ΔG° lie in the range of ?4,722.75 to ?4,878.82 and ?4,308.80 to ?4,451.73 while the values of ΔH° and ΔS° were ?149.90 and ?121.07, and 15.61 and 14.29 for arsenate and arsenite, respectively, indicating that adsorption is spontaneous and exothermic. Pseudo-first-order kinetics was followed. In column experiments, the adsorption decreased as the flow rate increased with the maximum removal of 98.9 and 95.6 % for arsenate and arsenite, respectively. The bed depth service time and Yoon and Nelson models were used to analyze the experimental data. The adsorption capacity (N _o) of BFA on column was 3.65 and 2.98 mg/cm³ for arsenate and arsenite, respectively. The developed system for the removal of arsenate and arsenite species is economic, rapid, and capable of working under natural conditions. It may be used for the removal of arsenic species from any contaminated water resources.     

Extrication of biodiesel feedstock from early stage of food waste liquefaction

Biodiesel is commonly produced from vegetable oils, mostly edible and more expensive than petroleum diesel. By considering the cost of the conversion processes, cheap feedstock such as triglycerides and fatty acids (FA) extracted from early stage of food waste liquefaction has become a better choice than vegetable oils, as it could provide high yield of biodiesel without any compromise to food supply and other resources. In this study, FA from early stage of food waste liquefaction was extracted and tested for use as feedstock for biodiesel synthesis. The raw material was not pretreated but extraction was done by dry and wet methods. It was found that wet method could minimized the lost of short and medium-chained FA as well as reducing the number of steps required, thus, yielding higher amount of FA as feedstock. The effects of mixing, methanol ratio, reaction time and catalyst content were investigated for the acid-catalyzed esterification. The maximum biodiesel conversion obtained was 97.4 %.     

On-site phytoremediation applicability assessment in Alur Ilmu,Universiti Kebangsaan Malaysia based on spatial and pollution removal analyses

The present paper aims to assess the phytoremediation performance based on pollution removal efficiency of the highly polluted region of Alur Ilmu urban river for its applicability of on-site treatment. Thirteen stations along Alur Ilmu were selected to produce thematic maps through spatial distribution analysis based on six water quality parameters of Malaysia’s Water Quality Index (WQI) for dry and raining seasons. The maps generated were used to identify the highly polluted region for phytoremediation applicability assessment. Four free-floating plants were tested in treating water samples from the highly polluted region under three different conditions, namely controlled, aerated and normal treatments. The selected free-floating plants were water hyacinth (Eichhornia crassipes), water lettuce (Pistia stratiotes), rose water lettuce (Pistia sp.) and pennywort (Centella asiatica). The results showed that Alur Ilmu was more polluted during dry season compared to raining season based on the water quality analysis. During dry season, four parameters were marked as polluted along Alur Ilmu, namely dissolve oxygen (DO), 4.72 mg/L (class III); ammoniacal nitrogen (NH₃–N), 0.85 mg/L (class IV); total suspended solid (TSS), 402 mg/L (class V) and biological oxygen demand (BOD), 3.89 mg/L (class III), whereas, two parameters were classed as polluted during raining season, namely total suspended solid (TSS), 571 mg/L (class V) and biological oxygen demand (BOD), 4.01 mg/L (class III). The thematic maps generated from spatial distribution analysis using Kriging gridding method showed that the highly polluted region was recorded at station AL 5. Hence, water samples were taken from this station for pollution removal analysis. All the free-floating plants were able to reduce TSS and COD in less than 14 days. However, water hyacinth showed the least detrimental effect from the phytoremediation process compared to other free-floating plants, thus made it a suitable free-floating plants to be used for on-site treatment.     

Preparation and characterization of glass hollow fiber membrane for water purification applications

This work discusses the preparation and characterizations of glass hollow fiber membranes prepared using zeolite-5A as a starting material. Zeolite was formed into a hollow fiber configuration using the phase inversion technique. It was later sintered at high temperatures to burn off organic materials and change the zeolite into glass membrane. A preliminary study, that used thermogravimetric analysis (TGA), X-ray diffraction (XRD), and Fourier transform infrared (FTIR), confirmed that zeolite used in this study changed to glass at temperatures above 1000 °C. The glass hollow fiber membranes prepared using the phase inversion technique has three different microstructures, namely (i) sandwich-like structure that originates from inner layer, (ii) sandwich-like that originates from outer layer, and (iii) symmetric sponge like. These variations were influenced by zeolite weight loading and the flow rate of water used to form the lumen. The separation performances of the glass hollow fiber membrane were studied using the pure water permeability and the rejection test of bovine serum albumin (BSA). The glass hollow fiber membrane prepared from using 48 wt% zeolite loading and bore fluid with 9 mL min^?1 flow rate has the highest BSA rejection of 85% with the water permeability of 0.7 L m^?2 h^?1 bar^?1. The results showed that the separation performance of glass hollow fiber membranes was in the ultrafiltration range, enabled the retention of solutes with molecular sizes larger than 67 kDa such as milk proteins, endotoxin pyrogen, virus, and colloidal silica.     

Economic analysis of biogas and compost projects in a palm oil mill with clean development mechanism in Malaysia

This article is a case study to compare the economic viabilities of biogas generation and compost projects in a palm oil mill in Malaysia with and without clean development mechanism (CDM). Biogas is captured from anaerobic ponds or digester tanks treating palm oil mill effluent (POME) and converted to green renewable electricity for grid connection, while compost is produced from the shredded empty fruit bunch and raw untreated POME. The both technologies were compared by considering the changes of the materials flow and energy balances. A palm oil mill with a capacity of 54?t fresh fruit bunch per hour has the potential to produce either 6.9?GWh of electricity from biogas or fertilizer equivalent to 488?t of nitrogen, 76?t of phosphorus and 1,065?t of potassium per year. The economic analysis for 10?years project term analysis indicated that CDM gave a significant impact and ensured economic viability for both projects with 25?% of internal rate of return (IRR), RM 12.39 million of net present value (NPV) and 3.5?years of payback period (PBP) for biogas project, whereas 31?% of IRR, RM 10.87 million of NPV and 2.9?years of PBP for compost project, respectively. In addition, sensitivity analysis indicated that the profitability of both projects will vary depending on the economic situation, such as electricity price which is based on the government policy, whereas compost price that depend on fertilizer market price with 43?% NPV change in 20?% range of fertilizer value.