The effect of pH on zinc adsorption equilibria and exchangeable zinc pools in soils

Zinc adsorption equilibria were measured in soils differing in pH but with similar textures and total zinc concentrations, using adsorption isotherm and isotopic exchange techniques. The results suggested that the equilibrium between solution and exchangeable zinc was strongly pH dependent and the active zinc species in adsorption was single charged (e.g. Zn(OH)(+)). The size of the exchangeable zinc pool was not strongly pH dependent. Similar results were obtained when zinc was added to the soils, either as Zn(NO(3))(2) or in sewage sludge.     

Nitrogen oxides from waste incineration: control by selective non-catalytic reduction

An experimental study of the selective non-catalytic reduction (SNCR) process was carried out to determine the efficiency of NOx removal and NH3 mass balance, the NOx reducing reagent used. Experimental tests were conducted on a full-scale SNCR system installed in a hospital waste incineration plant. Anhydrous NH3 was injected at the boiler entrance for NOx removal. Ammonia was analyzed after each flue-gas treatment unit in order to establish its mass balance and NH3 slip in the stack gas was monitored as well. The effective fraction of NH3 for the thermal NOx reduction was calculated from measured values of injected and residual NH3. Results show that a NOx reduction efficiency in the range of 46.7-76.7% is possible at a NH3/NO molar ratio of 0.9-1.5. The fraction of NH3 used in NOx removal was found to decrease with rising NH3/NO molar ratio. The NH3 slip in the stack gas was very low, below permitted limits, even at the higher NH3 dosages used. No direct correlation was found between the NH3/NO molar ratio and the NH3 slip in the stack gas since the major part of the residual NH3 was converted into ammonium salts in the dry scrubbing reactor and subsequently collected in the fabric filter. Moreover, another fraction of NH3 was dissolved in the scrubbing liquor.     

Boreal bog plants: nitrogen sources and uptake of recently deposited nitrogen

The main goals of this study were to determine the delta15N signature of quantitatively important boreal bog plants as basis for discussing their N sources, and to assess the effects of five different 3 year N treatments (i.e. 0, 5, 10, 20 and 40 kg N ha(-1) year(-1)) on the bog plants and surface peat at different depths (i.e. 0, 5, 10, 20 and 40 cm) by using 15N as tracer. Plants and peat were analyzed for N concentration, 15N natural abundance and 15N at.%. From the results we draw three main conclusions: First, the relative importance of different N sources is species-specific among bog plants. Second, an annual addition of 5 kg N ha(-1) year(-1) was sufficient to significantly increase the N concentration in Sphagnum mosses, liverworts and shallow rooted vascular plants, and an annual addition of 40 kg N ha(-1) year(-1) during 3 years was not sufficient to increase the N concentration in deep rooted plants, although the 15N content increased continuously, indicating a possible longer term effect. Third, an annual addition of 40 kg N ha(-1) year(-1) during 3 years increased the N content in surface peat at depths of 5 and 10 cm, but not at depths of 20 and 40 cm, indicating the capacity of the living Sphagnum mosses and the surface peat to take up deposited N, and thereby function as a filter.     

Liquid chromatography study of pyrene degradation by two micromycetes in a freshwater sediment.

Pyrene biodegradation in a freshwater sediment without fungi supply, or inoculated with two sediment micromycetes, Mucor racemosus var. sphaerosporus and Phialophora alba was studied after 0, 5, 13, 28, 60 and 90 days. The influence of glucose addition was estimated, and a liquid chromatographic method for simultaneous quantitative determination of residual anthracene, fluoranthene and pyrene in the sediment was developed. Samples with PAHs were extracted in Soxhlet with ethyl acetate, and LC analysis was performed on a 5 microm Supelcosil column (150 x 4.6 mm I.D.) with gradient elution (2 ml min(-1)) of acetonitrile-water and UV detection at 254 nm. Recoveries of anthracene, fluoranthene and pyrene were 90.3%+/-1.1%, 93.2%+/-0.9% and 90.42%+/-1.9%, respectively, without interference. The native sediment microorganisms (with or without glucose added) have shown 35% pyrene degradation and sediment with glucose inoculated by the strains revealed 40%.     

Dissolved organic matter fractions formed during composting of winery and distillery residues: evaluation of the process by fluorescence excitation-emission matrix

The aim of the present paper is to assess the maturity degree reached by different samples of several mixtures from winery and distillery residues composted using the Rutgers composting system, by means of excitation-emission matrix (EEM) fluorescence spectroscopy. The composts were sampled once a week for about 200d. EEM spectra indicate the presence of different fluorophores. The fluorescence intensities of these peaks show trends related to the maturity of the composting samples selected. The "contour density" of EEM maps is strongly modified through time. We have used the quantitative method of fluorescence regional integration (FRI). The EEMs were delineated into five excitation-emission regions. The degree of compost maturity could be correlated with the percentage of the volumetric integration under the EEM within each region. Further refinement of these techniques should provide a relatively rapid method for assessing the suitability of the compost to soil application.     

Bioremediation of tributyltin contaminated sediment: degradation enhancement and improvement of bioavailability to promote treatment processes

Bioremediation of tributyltin (TBT) contaminated sediment was studied and degradation enhancement and improvement of bioavailability were also investigated. In TBT spiked sediment, the half-life of TBT in the control sample, representing natural attenuation, was 578 d indicating its persistence. In the stimulated sample (pH 7.5, aeration and incubated at 28 °C), the half-life was significantly reduced to 11 d. Further stimulation by nutrient addition (succinate, glycerol and l-arginine) or inoculation with Enterobacter cloacae (∼10⁷ viable cells g⁻¹ of sediment) resulted in half-life reduction to 9 and 10 d, respectively. In non-spiked sediment, the indigenous microorganisms were able to degrade aged TBT, but the extended period of contamination decreased the degradation efficiency. To improve bioavailability, addition of surfactant, adjustment of salinity and sonication were studied. The highest percentage solubilisation of TBT in water was obtained by adjusting salinity to 20 psu, which increased the solubility of TBT from 13% to 33%. Half-lives after bioavailability was improved were 5, 4 and 4 d for stimulation, stimulation w/nutrient addition and stimulation w/inoculation, respectively. However, natural attenuation in the control sample was not enhanced. The results show that providing suitable conditions is important in enhancing TBT biodegradation, and bioavailability improvement additionally increased the rate and degraded amount of TBT. Unfortunately, nutrient addition and inoculation of the degrader did not enhance the degradation appreciably.     

PAH and soot emissions from burning components of medical waste: examination/surgical gloves and cotton pads

This is a laboratory investigation on the emissions from batch combustion of representative infectious ("red bag") medical waste components, such as medical examination latex gloves and sterile cotton pads. Plastics and cloth account for the majority of the red bag wastes by mass and, certainly, by volume. An electrically heated, horizontal muffle furnace was used for batch combustion of small quantities of shredded fuels (0.5-1.5 g) at a gas temperature of approximately 1000 degrees C. The residence time of the post-combustion gases in the furnace was approximately 1 s. At the exit of the furnace, the following emissions were measured: CO, CO2, NOx, particulates and polynuclear aromatic compounds (PACs). The first three gaseous emissions were measured with continuous gas analyzers. Soot and PAC emissions were simultaneously measured by passing the furnace effluent through a filter (to collect condensed-phase PACs) and a bed of XAD-4 adsorbent (to capture gaseous-phase PACs). Analysis involved soxhlet extraction, followed by gas chromatography-mass spectrometry (GC-MS). Results were contrasted with previously measured emissions from batch combustion of pulverized coal and tire-derived fuel (TDF) under similar conditions. Results showed that the particulate soot) and cumulative PAC emissions from batch combustion of latex gloves were more than an order of magnitude higher than those from cotton pads. The following values are indicative of the relative trends (but not necessarily absolute values) in emission yields: 26% of the mass of the latex was converted to soot, 11% of which was condensed PAC. Only 2% of the mass of cotton pads was converted to soot, and only 3% of the weight of that soot was condensed PAC. The PAC yields from latex were comparable to those from TDF. The PAC yields from cotton were higher than those from coal. A notable exception to this trend was that the three-ring gas-phase PAC yields from cotton were more significant than those from latex. Emission yields of CO and CO2 from batch combustion of cotton were, respectively, comparable and higher than those from latex, despite the fact that the carbon content of cotton was half that of latex. This is indicative of the more effective combustion of cotton. Nearly all of the mass of carbon of cotton gasified to CO and CO2 while only small fractions of the carbon in latex were converted to CO2 and CO (20% and 10%, respectively). Yields of NOx from batch combustions of latex and cotton accounted for 15% and 12%, respectively, of the mass of fuel nitrogen indicating that more fuel nitrogen was converted to NOx in the former case, possibly due to higher flame temperatures. No SO2 emissions were detected, indicating that during the fuel-rich combustion of latex, its sulfur content was converted to other compounds (such as H2S) or remained in the soot.     

Tracing sources of atmospheric sulphur using epiphytic lichens

The overall objective of this work was to measure the spatial variation of sulphur isotopic composition of lichens across the island of Newfoundland in order to assess the degree to which the atmosphere is being affected by long-range transport of anthropogenic sulphur from eastern North America, and/or local pollution sources. A contour map (based on over 80 composite samples of the lichen Alectoria sarmentosa) illustrates the spatial distribution of sulphur isotopic composition of the Newfoundland atmosphere. It shows a gradient of delta(34)S of sulphur in lichen, decreasing from the coast to the interior of the island. It also shows local anomalies corresponding to the city of St. John's, the Come-By-Chance Oil Refinery, mining areas and fossil-fuel powered pulp and paper mills in central and western Newfoundland. The study strongly suggests that the isotopic composition of sulphur in the Newfoundland atmosphere is influenced more by the ocean (sea salt sulphate) and local anthropogenic activities in the province, than by long-range transport of continental North American sulphate.     

Quantifying road dust resuspension in urban environment by Multilinear Engine: A comparison with PMF2

Atmospheric PM pollution from traffic comprises not only direct emissions but also non-exhaust emissions because resuspension of road dust that can produce high human exposure to heavy metals, metalloids, and mineral matter. A key task for establishing mitigation or preventive measures is estimating the contribution of road dust resuspension to the atmospheric PM mixture. Several source apportionment studies, applying receptor modeling at urban background sites, have shown the difficulty in identifying a road dust source separately from other mineral sources or vehicular exhausts. The Multilinear Engine (ME-2) is a computer program that can solve the Positive Matrix Factorization (PMF) problem. ME-2 uses a programming language permitting the solution to be guided toward some possible targets that can be derived from a priori knowledge of sources (chemical profile, ratios, etc.). This feature makes it especially suitable for source apportionment studies where partial knowledge of the sources is available.In the present study ME-2 was applied to data from an urban background site of Barcelona (Spain) to quantify the contribution of road dust resuspension to PM₁₀ and PM_2.5 concentrations. Given that recently the emission profile of local resuspended road dust was obtained (Amato, F., Pandolfi, M., Viana, M., Querol, X., Alastuey, A., Moreno, T., 2009. Spatial and chemical patterns of PM₁₀ in road dust deposited in urban environment. Atmospheric Environment 43 (9), 1650–1659), such a priori information was introduced in the model as auxiliary terms of the object function to be minimized by the implementation of the so-called “pulling equations”.ME-2 permitted to enhance the basic PMF solution (obtained by PMF2) identifying, beside the seven sources of PMF2, the road dust source which accounted for 6.9 μg m^?3 (17%) in PM₁₀, 2.2 μg m^?3 (8%) of PM_2.5 and 0.3 μg m^?3 (2%) of PM₁. This reveals that resuspension was responsible of the 37%, 15% and 3% of total traffic emissions respectively in PM₁₀, PM_2.5 and PM₁. Therefore the overall traffic contribution resulted in 18 μg m^?3 (46%) in PM₁₀, 14 μg m^?3 (51%) in PM_2.5 and 8 μg m^?3 (48%) in PM₁. In PMF2 this mass explained by road dust resuspension was redistributed among the rest of sources, increasing mostly the mineral, secondary nitrate and aged sea salt contributions.