Colloid-enhanced ultrafiltration in removal of traces amounts of borates from water

The use of colloid-enhanced ultrafiltration for boron removal from water is investigated. Biodegradable surfactant, 1,4-sorbitol oleate, was applied to obtain micelles and high molecular weight chitosan to reinforce their stability. Two kind of membranes were compared: neat porous polysulfone membrane and charged porous sulfonated polysylfone membrane; both with similar average pore diameter of 5 nm. The studies revealed that two key factors affect the boron rejection: presence of surfactant in the colloidal mixture and a repulsion effect of sulfone groups on the membrane surface. Both have a positive effect on boron removal.     

Ozonation catalyzed by homogeneous and heterogeneous catalysts for degradation of DEHP in aqueous phase

Di-(2-ethyl hexyl) phthalate (DEHP), a recalcitrant and an endocrine disrupting chemical, was studied for its removal from wastewater by advanced oxidation process. The effects of pH, transition metal ions, and granular activated carbon (GAC) were investigated. Removal of DEHP increased with increase in pH and among metal ions Cr(III) was found to be the most active catalyst to remove DEHP. In the case of GAC, original carbon (G0) and GAC pre-ozonated in gas phase for 10 min (G10) were tested as catalysts in catalytic ozonation and found G0 to be more active than G10. This is because, during pre-ozonation, basic groups like chromene, pyrones and also graphene layers were oxidized to acidic surface oxygen groups. These basic surface groups are reported to be active catalytic centres for ozone decomposition into .OH which is a strong oxidant. According to kinetic manipulations, DEHP degradation rate constant due to .OH was affected by the catalyst while that due to direct ozonation is same in all cases with or without catalyst. G0 was doped with chromia gels (G0/CrA) to combine the benefits of homogeneous and heterogeneous catalysis. G0/CrA showed lower catalytic efficiency than that of only G0. This might be because of changes in surface structure of GAC caused by doping of chromia gel and changes in chemical nature of Cr(III) during formation of gel. A good correlation was found between the rate constants of ozone decay and DEHP degradation (R2=0.96). This correlation confirms that ozone decomposition into .OH is a critical factor for the activity of a catalyst during ozonation.     

Fluoride and health hazards: community perception in a fluorotic area of central Rajasthan (India): an arid environment

India is among the 23 nations around the globe where health problems occur due to excess ingestion of fluoride (>1.5 mg/l) by drinking water. In Rajasthan, 18 out of 32 districts are fluorotic and 11 million of the populations are at risk. An exploratory qualitative survey was conducted to describe perception of the community regarding fluoride and related health problems in Central Rajasthan. A study on distribution and health hazards by fluoride contaminate in groundwater was performed in 1,030 villages of Bhilwara district of Central Rajasthan. One thousand thirty water samples were collected and analyzed for fluoride concentration. Fluoride concentration in these villages varies from 0.2 to 13.0 mg/l. Seven hundred fifty-six (73.4%) villages have fluoride concentration above 1.0 mg/l. Sixty (5.83%) villages have fluoride concentration above 5.0 mg/l with maximum numbers (24, 19.5%) from Shahpura tehsil. A detailed fluorosis study was carried out in 41 villages out of 60 villages having fluoride above 5.0 mg/l in the study age, sex, and occupation data were also collected. Four thousand, two hundred fifty-two individuals above 5 years age were examined for the evidence of dental fluorosis, while 1998 individuals above 21 years were examined for the evidence of skeletal fluorosis. The overall prevalence of dental and skeletal fluorosis was found to be 3,270/4,252 (76.9%) and 949/1,998 (47.5%), respectively. Maximum of 23.9% (1,016) individuals have mild grade of Dean’s classification. Three hundred seventy-four (8.8%) individuals have severe type of dental fluorosis. The Dean’s Community Fluorosis Index for the studied area in total is 1.62. Maximum CFI 3.0 was recorded from Surajpura of Banera Tehsil. Five hundred sixty-six (28.3%) individuals have Grade I type of skeletal fluorosis while only 0.6% (12) individuals have Grade III skeletal fluorosis. In conclusion, the prevalence and severity of fluorosis increased with increasing fluoride concentration. It was interesting to note that in some villages, the prevalence and severity of fluorosis were highest in subjects belonging to the economically poor community. Similarly, male laborers showed highest prevalence of fluorosis. Prevalence and severity of fluorosis were observed higher in subjects using tobacco, bettle nuts, and alcoholic drinks. In contrast, subjects using citrus fruits and having good nutritional status showed low prevalence.     

Improvement of the BCR three step sequential extraction procedure prior to the certification of new sediment and soil reference materials

The Standards, Measurements and Testing Programme (formerly BCR) of the European Commission proposed a three-step sequential extraction procedure for sediment analysis, following extensive expert consultations and two interlaboratory studies. This scheme was recently used to certify the extractable trace element contents of a sediment reference material (CRM 601). Although this procedure offers a means to ensure the comparability of data in this field, some difficulties concerning the interlaboratory reproducibility still remain, and a new project is currently being conducted to determine the causes of poor reproducibility in the extraction scheme. The final objective of the project is the certification of new sediment and soil reference materials for their extractable contents of Cd, Cr, Cu, Ni, Pb and Zn. This paper presents the results of a small-scale interlaboratory study, which aimed to test a revised version of the extraction schemes by comparing the original and the modified protocols using the CRM 601 sample. This work offers an improvement to the BCR sequential extraction procedure through intercomparison exercises. This improved procedure will allow the obtaining of CRMs to validate analytical data in the analysis of soils and sediments, and it will also facilitate comparability of data in the European Union.     

The Influence of pH on Mobility of Heavy Metals from Municipal Solid Waste Incinerator Fly Ash

Incineration has become one of the principal methods for municipal solid waste disposal particularly in all large cities throughout the world. Currently, the municipal solid waste incinerator fly ashes (MSWIF) are disposed of by landfill. The metal speciation of cadmium (Cd), chromium (Cr), copper (Cu), lead (Pb), and zinc (Zn) in MSWIF after been extracted with water at different pH values were examined using a sequential extraction procedure. The extraction sequence was as follows: (1) Exchangeable (NaOAc, pH 8.2), (2) Bound to Carbonates (NaOAc, pH 5.0), (3) Bound to metal oxides (HONH3Cl), (4) Bound to organic matters (HNO3, H2O2), and (5) Residual (HNO3, HCl, H2O2, HF, 1:3:1:3). The heavy metal contents in the extraction solutions were determined by inductively coupled plasma atomic emission spectrometry. The heavy metal concentrations in the different fractions obtained by sequential extraction show distinct distribution trends. The extractable fraction ranges from 25.5 to 88% of the total element content. With the pH of the extractant fall below the neutral and acidic ranges, the concentrations of heavy metals rise substantially due to the released of metals bound to carbonate fraction.     

An Automated Technique for Delineating and Characterizing Valley-Bottom Settings

Accurate delineation and characterization of valley-bottom settings is crucial to the assessment of the biological and geomorphological components of riverine systems; yet, to date, most valley-bottom mapping endeavors have been done manually. To improve this situation, we developed automated techniques in a Geographic Information System (GIS) for delineating and characterizing valley-bottom settings in river basins ranging in size from approximately 1,000–10,000 km². All procedures were developed with ARC/INFO GIS software and fully automated in Arc Macro Language (AML). The GRID module is required for valley-bottom delineation and slope calculations; whereas characterization (i.e., measuring the width of the valley-bottom zone) requires Coordinate Geometry (COGO) in the ARCEDIT module. The process requires three inputs: a polygon coverage of the analysis area; an arc coverage of its hydrography, and a grid representing its digital elevation. The AML is designed to operate within a wide range of computer memory/disk space options, and it allows users to customize several procedures to match the scale and complexity of a given analysis area with available computer hardware.     

Impacts of atmospheric pollution on the plant communities of British acid grasslands

Air pollutants are recognised as important agents of ecosystem change but few studies consider the effects of multiple pollutants and their interactions. Here we use ordination, constrained cluster analysis and indicator value analyses to identify potential environmental controls on species composition, ecological groupings and indicator species in a gradient study of UK acid grasslands. The community composition of these grasslands is related to climate, grazing, ozone exposure and nitrogen deposition, with evidence for an interaction between the ecological impacts of base cation and nitrogen deposition. Ozone is a key agent in species compositional change but is not associated with a reduction in species richness or diversity indices, showing the subtly different drivers on these two aspects of ecosystem degradation. Our results demonstrate the effects of multiple interacting pollutants, which may collectively have a greater impact than any individual agent.     

Remediation of contaminated agricultural soils near a former Pb/Zn smelter in Austria: batch, pot and field experiments

Metal contaminated crops from contaminated soils are possible hazards for the food chain. The aim of this study was to find practical and cost-effective measures to reduce metal uptake in crops grown on metal contaminated soils near a former metal smelter in Austria. Metal-inefficient cultivars of crop plants commonly grown in the area were investigated in combination with in-situ soil amendments. A laboratory batch experiment using 15 potential amendments was used to select 5 amendments to treat contaminated soil in a pot study using two Barley (Hordeum vulgare L.) cultivars that differed in their ability to accumulate cadmium. Results from this experiment identified 3 of these amendments for use in a field trial. In the pot experiment a reduction in ammonium nitrate extractable Cd (<41%) and Pb (<49%) compared to the controls was measured, with a concurrent reduction of uptake into barley grain (Cd<62%, Pb<68%). In the field extractable fractions of Cd, Pb, and Zn were reduced by up to 96%, 99%, and 99%, respectively in amended soils.     

The solid-phase controls on the mobility of heavy metals at the Copper Cliff tailings area, Sudbury, Ontario, Canada

The Copper Cliff Tailings Disposal Area, located near Sudbury, Ontario, covers an area of approximately 2200 ha and constitutes more than 10% of the total area of all mine tailings in Canada. The area has been utilized since 1936, receiving sulphide-containing tailings from the Inco Sudbury operations. Field measurements of pore-gas oxygen and carbon dioxide in the vadose zone indicate that sulphide oxidation has progressed to depths of 1.6 m to 1.7 m within the tailings. The oxidation of sulphide minerals within the vadose zone, and the accompanying dissolution of carbonate and aluminosilicate minerals within these tailings releases SO₄, Fe(II) and other metals to the pore water. In the vadose and saturated zones, concentrations of Fe and Ni exceed 10100 mg/l and 2210 mg/l, respectively. These high concentrations of dissolved metals are attenuated by a series of precipitation, coprecipitation and adsorption reactions. The precipitation of secondary sulphate and hydroxide phases also create hardpan layers at or near the oxidation front. Geochemical modelling of the pore-water chemistry suggests that pH-buffering reactions are occurring within the shallow oxidized zones, and that secondary-phase precipitation is occurring at or near the underlying hardpan and transition zones. Mineralogical study of the tailings confirmed the presence of jarosite, gypsum and goethite within the shallow tailings, suggesting that these phases are controlling the dissolved concentrations of Fe, SO₄ and Ca. Extraction experiments conducted on the tailings solids indicate that the constituents contained in the water-soluble fraction of the shallow, weathered tailings are derived from the original pore water and the dissolution of highly soluble phases such as gypsum. The acid-leachable fraction of the weathered tailings accounts for up to 25% of the heavy metals, and the reducible fraction may contain up to 100% of the heavy metals within the shallow, weathered tailings. Based on the pore water profiles and the geochemistry of the tailings solids, a relative mobility scale of Fe=Mn=Ni=Co>Cd Zn>Cr=Pb>Cu can be determined.     

Simultaneous conversion of CHClF(2) and CH(3)Br to CH(2)CF(2)

Gas phase reaction of CHClF(2) with CH(3)Br in an alumina tube reactor at 773-1123 K as a function of various input ratios of CH(3)Br to CHClF(2) is presented. The major products detected include C(2)F(4), CH(2)CF(2), and CH(4). Minor products include CH(3)Cl, CHF(3), C(2)H(4), C(2)H(2), CH(2)CF-CF(3), and C(2)H(3)F. The reaction produces a high yield of CH(2)CF(2) (53% based on CHClF(2) feed) at 1123 K and an input molar ratio of CH(3)Br to CHClF(2) of 1.8, suggesting that the reaction potentially can be developed as a process to convert two ozone depleting substances (CHClF(2) and CH(3)Br) to a highly valuable chemical, CH(2)CF(2). The reaction of CHClF(2) with CH(3)Cl and CH(3)I was also investigated under similar reaction conditions, to assist in understanding the reaction chemistry involved in the reaction of CHClF(2) with CH(3)Br.