Effect of Refractory on the Thermal Stability of SF6

The thermal decomposition of SF₆ is known to be oxygen-independent. Nevertheless, because of its high stability, the use of SF6 as a "conservative" surrogate in incinerator performance evaluation has been advocated and researched. This paper shows that refractory decreases markedly the stability of SF₆. The resulting increase in SF₆ decomposition was from 0 percent to 95 percent at 900°C, and the temperatures at which 90-99 percent decomposition occurred were lowered by 300-150°C. Refractory also decreased the stability of CCl₄ and C₂Cl₄, but to a lesser extent. The difference between the decompositions of C₂Cl₄ and SF₆ was reduced from several orders of magnitude to a factor of 2-4. Such a drastic and adverse change in relative stability could render SF₆ unsuitable as a "conservative" surrogate. The requirements for a "conservative" surrogate and the need for caution in its use are discussed, and further research areas are indicated.     

Use of inorganic and organic wastes for in situ immobilisation of Pb and Zn in a contaminated alkaline soil

Purpose  

This study aims to examine whether addition of immobilising agents to a sandy, alkaline (pH = 8.1) soil, which had been contaminated with Pb and Zn by airborne particles from a Pb/Zn smelter, would substantially reduce metal bioavailability.     

Properties of alkali-activated systems with stone powder sludge

This article investigates the effects of stone powder sludge on the microstructure and strength development of alkali-activated fly ash and blast furnace slag mixes. Stone powder sludge produced from a crushed aggregate factory was used to replace fly ash and granulated blast furnace slag at replacement ratios of 0%, 10%, 20%, and 30% by mass. The unit weight and compressive strength of the samples were measured, and scanning electron microscopy/energy dispersive spectroscopy and X-ray diffraction (XRD) analyses were performed. The test results indicated that the compressive strength of alkali-activated blast furnace slag mixes using stone powder sludge was higher than that of the alkali-activated blast furnace slag control mix, but the compressive strength of alkali-activated fly ash mixes decreased with increasing replacement ratio of stone powder sludge. Microscopy results indicated that for alkaliactivated blast furnace slag samples, broken surfaces were more evident than for the alkali-activated fly ash samples. For all XRD diagrams, broad and diffuse peaks were observed around 2θ = 35° (d = 2.96–3.03 Å), implying amorphous or short-ordering structure phases.     

Why ozonolysis may not increase the hydrophilicity of particles

It is commonly assumed that atmospheric oxidation of hydrocarbon particles or hydrocarbon coatings on particles leads to polar products and increased water uptake, altering atmospheric visibility and increasing the likelihood they will act as cloud condensation nuclei (CCN). We show here through laboratory experiments that increased water uptake depends on the 3-dimensional structure of the particles. Laboratory studies of particles formed during ozonolysis of surface-bound alkenes, present as terminally unsaturated self-assembled monolayers (C8= SAM) on a silica substrate, were carried out at room temperature and 1 atm pressure. SAMs were exposed to ～10¹³ O₃ molecules cm^?3 for 40 min and resultant particles were analyzed using single particle Fourier transform infrared micro-spectroscopy (micro-FTIR) and secondary ion mass spectroscopy (SIMS). Spectroscopy results show that –COOH and other polar groups are formed but are buried inside a hydrophobic shell, consistent with earlier observations (McIntire et al., 2005, Moussa et al., 2009) that water uptake does not increase after reaction of the terminal alkene with O₃. These insights into the 3-D structure of particles formed on oxidation have important implications for the ability of secondary organic aerosols to act as CCN. In addition, the nature of the surface of the particles is expected to determine their uptake into biological systems such as the surface of the lungs.     

Effects of agricultural pesticides on the health of Rana pipiens frogs sampled from the field

There is evidence that over the last 30 years, there have been mass declines in diverse geographic locations among amphibian populations due to disease outbreaks. Multiple causes have been suggested to explain this increase in disease incidence. Among these, climate changes, environmental pollution and reduced water quality are gaining attention. Indeed, some chemicals of environmental concerns are known to alter the immune system. It is possible that exposure to these pollutants could alter the immune system of anurans and render them more susceptible to different pathogens. In this study, we sampled Rana pipiens in five different sites near St. Lawrence River (Quebec, Canada) during the months of July and September in 2001. Two of these sites were protected areas, in which low levels of pesticides were detected, while the remaining three sites were located in areas with intensive corn and soybeans cultivations. Our results demonstrated that frogs living in agricultural regions are smaller in size and weight than frogs living in areas with lower levels of pesticides at both sampling times. Moreover, we have observed a significant decrease in the number of splenocytes (cellularity) and the phagocytic activity in frogs sampled in impacted sites. Taken together, these results suggest that frogs living in agricultural regions might be more vulnerable to infections and diseases through their smaller size and alteration of their immune system. Our results also contribute to the overall discussion on factors involved in amphibian declines.     

PAH air pollution at a Portuguese urban area: carcinogenic risks and sources identification

This study aimed to characterize air pollution and the associated carcinogenic risks of polycyclic aromatic hydrocarbon (PAHs) at an urban site, to identify possible emission sources of PAHs using several statistical methodologies, and to analyze the influence of other air pollutants and meteorological variables on PAH concentrations.The air quality and meteorological data were collected in Oporto, the second largest city of Portugal. Eighteen PAHs (the 16 PAHs considered by United States Environment Protection Agency (USEPA) as priority pollutants, dibenzo[a,l]pyrene, and benzo[j]fluoranthene) were collected daily for 24 h in air (gas phase and in particles) during 40 consecutive days in November and December 2008 by constant low-flow samplers and using polytetrafluoroethylene (PTFE) membrane filters for particulate (PM₁₀ and PM_2.5 bound) PAHs and pre-cleaned polyurethane foam plugs for gaseous compounds. The other monitored air pollutants were SO₂, PM₁₀, NO₂, CO, and O₃; the meteorological variables were temperature, relative humidity, wind speed, total precipitation, and solar radiation. Benzo[a]pyrene reached a mean concentration of 2.02 ng?m^?3, surpassing the EU annual limit value. The target carcinogenic risks were equal than the health-based guideline level set by USEPA (10^?6) at the studied site, with the cancer risks of eight PAHs reaching senior levels of 9.98?×?10^?7 in PM₁₀ and 1.06?×?10^?6 in air. The applied statistical methods, correlation matrix, cluster analysis, and principal component analysis, were in agreement in the grouping of the PAHs. The groups were formed according to their chemical structure (number of rings), phase distribution, and emission sources. PAH diagnostic ratios were also calculated to evaluate the main emission sources. Diesel vehicular emissions were the major source of PAHs at the studied site. Besides that source, emissions from residential heating and oil refinery were identified to contribute to PAH levels at the respective area. Additionally, principal component regression indicated that SO₂, NO₂, PM₁₀, CO, and solar radiation had positive correlation with PAHs concentrations, while O₃, temperature, relative humidity, and wind speed were negatively correlated.     

Cadmium (Cd2+) removal by nano zerovalent iron: surface analysis, effects of solution chemistry and surface complexation modeling

Nano zerovalent iron (nZVI) is an effective remediant for removing various organic and inorganic pollutants from contaminated water sources. Batch experiments were conducted to characterize the nZVI surface and to investigate the effects of various solution properties such as pH, initial cadmium concentration, sorbent dosage, ionic strength, and competitive ions on cadmium removal by nZVI. Energy-dispersive X-ray and X-ray photoelectron spectroscopy results confirmed removal of Cd²⁺ ions by nZVI through adsorption. Cd²⁺ adsorption decreased in the presence of competitive cations in the order: Zn²⁺?>?Co²⁺?>?Mg²⁺?>?Mn²⁺?=?Cu²⁺?>?Ca²⁺?>?Na²⁺?=?K⁺. Higher concentrations of Cl^? significantly decreased the adsorption. Cadmium removal increased with solution pH and reached a maximum at pH 8.0. The effects of various solution properties indicated Cd²⁺ adsorption on nZVI to be a chemisorption (inner-sphere complexation) process. The three surface complexation models (diffuse layer model, constant capacitance model, and triple layer model) fitted well to the adsorption edge experimental data indicating the formation of nZVI–Cd bidentate inner-sphere surface complexes. Our results suggest that nZVI can be effectively used for the removal of cadmium from contaminated water sources with varying chemical conditions.