Nutrient losses by surface run-off following the application of organic manures to arable land. 2. Phosphorus

Phosphorus (P) surface run-off losses were studied following organic manure applications to land, utilising a purpose-built facility on a sloping site in Herefordshire under arable tillage. Different rates and timing of cattle slurry, farm yard manure (FYM) and inorganic nitrogen (N) and P fertiliser were compared, over a 4-year period (1993-97). N losses from the same studies are reported in a separate paper. The application of cattle FYM and, especially slurry, to the silty clay loam soil increased both particulate and soluble P loss in surface water flow. Losses via subsurface flow (30 cm interflow) were consistently much lower than via surface water movement and were generally unaffected by treatment. Increased application of slurry solids increased all forms of P loss via surface run-off; the results suggested that a threshold for greatly increased risk of P losses via this route, as for N, occurred at ca. 2.5-3.0 t/ha solids loading. This approximates to the 50 m3/ha application rate limit suggested for slurry within UK 'good agricultural practice'. The studies also provided circumstantial evidence of the sealing of the soil surface by slurry solids as the major mechanism by which polluting surface run-off may occur following slurry application on susceptible soils. Losses of total and soluble P, recorded for each of the 4 years of experiments, reached a maximum of only up to 2 kg/ha total P (TP), even after slurry applications initiating run-off. Whilst these losses are insignificant in agronomic terms, peak concentrations of P (up to 30,000 micrograms/l TP) in surface water during a run-off event, could be of considerable concern in sensitive catchments. Losses of slurry P via surface run-off could make a significant contribution to accelerated eutrophication on entry to enclosed waters, particularly when combined with high concentrations of NO3(-)-N. Restricting slurry application rates to those consistent with good agronomic practice, and within the limits specified in existing guidelines on good agricultural practice, offers the simplest and most effective control measure against this potentially important source of diffuse pollution.     

PAH and soot emissions from burning components of medical waste: examination/surgical gloves and cotton pads

This is a laboratory investigation on the emissions from batch combustion of representative infectious ("red bag") medical waste components, such as medical examination latex gloves and sterile cotton pads. Plastics and cloth account for the majority of the red bag wastes by mass and, certainly, by volume. An electrically heated, horizontal muffle furnace was used for batch combustion of small quantities of shredded fuels (0.5-1.5 g) at a gas temperature of approximately 1000 degrees C. The residence time of the post-combustion gases in the furnace was approximately 1 s. At the exit of the furnace, the following emissions were measured: CO, CO2, NOx, particulates and polynuclear aromatic compounds (PACs). The first three gaseous emissions were measured with continuous gas analyzers. Soot and PAC emissions were simultaneously measured by passing the furnace effluent through a filter (to collect condensed-phase PACs) and a bed of XAD-4 adsorbent (to capture gaseous-phase PACs). Analysis involved soxhlet extraction, followed by gas chromatography-mass spectrometry (GC-MS). Results were contrasted with previously measured emissions from batch combustion of pulverized coal and tire-derived fuel (TDF) under similar conditions. Results showed that the particulate soot) and cumulative PAC emissions from batch combustion of latex gloves were more than an order of magnitude higher than those from cotton pads. The following values are indicative of the relative trends (but not necessarily absolute values) in emission yields: 26% of the mass of the latex was converted to soot, 11% of which was condensed PAC. Only 2% of the mass of cotton pads was converted to soot, and only 3% of the weight of that soot was condensed PAC. The PAC yields from latex were comparable to those from TDF. The PAC yields from cotton were higher than those from coal. A notable exception to this trend was that the three-ring gas-phase PAC yields from cotton were more significant than those from latex. Emission yields of CO and CO2 from batch combustion of cotton were, respectively, comparable and higher than those from latex, despite the fact that the carbon content of cotton was half that of latex. This is indicative of the more effective combustion of cotton. Nearly all of the mass of carbon of cotton gasified to CO and CO2 while only small fractions of the carbon in latex were converted to CO2 and CO (20% and 10%, respectively). Yields of NOx from batch combustions of latex and cotton accounted for 15% and 12%, respectively, of the mass of fuel nitrogen indicating that more fuel nitrogen was converted to NOx in the former case, possibly due to higher flame temperatures. No SO2 emissions were detected, indicating that during the fuel-rich combustion of latex, its sulfur content was converted to other compounds (such as H2S) or remained in the soot.     

Evidence for the contribution of methane in the formation of aromatics and soot in fuel-rich pre-mixed combustion

Experimental results from an isothermal laminar flow reactor at atmospheric pressure are presented on the chemical composition in the post-oxidative region of two sooting fuel-rich pre-mixed mixtures diluted in nitrogen. A base case composed of n-heptane and O2 in N2 at 1425 K with a C/O of 2.85 was perturbed by substituting 10% of the carbon in n-heptane with carbon as CH4. While these changes would intuitively reduce aromatics and soot formation by increasing H2 and decreasing C2H2 concentrations, we observe the opposite. The concentrations of individual aromatic species are observed to actually increase by up to 50% and the soot yield increases by 80%.     

Remediation of s-triazines contaminated water in a laboratory scale apparatus using zero-valent iron powder

Atrazine, propazine and simazine were tested separately and in mixture by batch procedure in a laboratory-constructed apparatus. 3.75 l of a buffered s-triazines pesticide solution was treated at room temperature by 325-mesh zero-valent iron powder (ZVIP) (20 g/l). High performance liquid chromatography was used to separate by-products and study the decline in the pesticide’s concentrations. Results obtained show that the order of degradation was simazine, atrazine and then propazine. The half-lives (t_1/2) of the s-triazines pesticides are, respectively, 7.4, 9.0 and 10.6 min when they are treated separately, and 9.8, 11.2 and 13.7 min when they are treated together under the same conditions. The final by-product obtained after 50 min of contact of simazine with ZVIP shows a shift to longer wavelength in its UV spectrum. A similar phenomenon is shown for atrazine and propazine. Identical primary by-products are produced and subsequently degraded to 4,6-(diamino)-s-triazine, which seems to be the major by-product of the reductive treatment process. Pathways for the degradation of the studied s-triazines by ZVIP are proposed.     

Biodegradation of 2,4,6-trichlorophenol in the presence of primary substrate by immobilized pure culture bacteria

In this study, pure strains that are capable of utilizing 2,4,6-trichlorophenol have been isolated from the mixed culture grown on substrates containing chlorophenolic compounds. Studies have been carried out on the capability of these isolated pure strains in suspended and immobilized forms to decompose 2,4,6-trichlorophenol. Additionally, the influence of primary substrates (e.g., phenol, 2-chlorophenol, 3-chlorophenol, 4-chlorophenol, 2,4-dichlorophenol) on the decomposition of 2,4,6-trichlorophenol by the isolated pure strains grown in immobilized form is also investigated. The results are: Through bacterial isolation and identification, three pure strains have been obtained: Pseudomonas spp. strain 01, Pseudomonas spp. strain 02 and Agrobacterium spp. Whether in suspended or immobilized forms, all strains have poor removal efficiencies of 2,4,6-trichlorophenol. However, addition of 200 mg/l phenol will enable the immobilized Pseudomonas spp. strain 01, and Pseudomonas spp. strain 02 to achieve 65% and 48% removal of 2,4,6-trichlorophenol, respectively. Addition of phenol will assist the immobilized Pseudomonas spp. strain 02 in achieving removal of 2,4,6-trichlorophenol but the removal efficiency is not good if the phenol concentration is too low. The optimum phenol concentration should be between 200 and 400 mg/l.     

Solar photocatalytic mineralization of commercial pesticides: acrinathrin

A comparative study of the degradation of commercial acrinathrin spiked in water using TiO2 photocatalysis and photolysis under sunlight was performed. Samples were analysed by liquid chromatography-diode array detector (HPLC-DAD) and gas chromatography-ion trap-mass spectrometric detector (GC-ITMS). Additional total organic carbon (TOC) analyses were carried out to evaluate the mineralisation rates. One photoproduct, 2-phenoxy benzaldehyde, was unequivocally identified and evaluated by GC-ITMS during the processes. Although acrinathrin is almost destroyed when exposed to irradiation for more than 400 h, photocatalysis with TiO2 noticeably reduced degradation to a few hours. In this case, with the additional presence of peroxydisulphate, in less than 2 h acrinathrin is completely destroyed. Mineralisation of acrinathrin, without catalyst, was only around 50% after 400 h of irradiation.     

Accumulation pattern and biotransformation enzyme induction in rainbow trout embryos exposed to sublethal aqueous concentrations of 3,3',4,4'-tetrachlorobiphenyl

Accumulation pattern of 3,3',4,4'-tetrachlorobiphenyl (PCB 77) and the exposure time needed to activate the monooxygenase (EROD) and conjugation (GST) enzyme systems of fish at the advanced embryonic stage were studied. Eyed stage embryos of rainbow trout (Oncorhynchus mykiss) were exposed to sublethal doses (0, 1, 10, and 100 micrograms/l) of PCB 77. Results indicated direct accumulation of the chemical into the eggs, but the exposure time was not long enough for PCB 77 to reach constant steady state. However, at the two lowest test concentrations (1 microgram/l and 10 micrograms/l) a temporary plateau at chemical accumulation was reached at the third exposure day (185 and 1221 ng PCB/g egg w.w). At the highest concentration (100 micrograms/l) the decrease in the accumulation rate was already evident after the first day (2182 ng PCB/g egg w.w). The chemical uptake increased again at day 7 in all the exposure groups. That event could have been caused by the increased metabolic rate of the embryos in preparation for the upcoming hatching event. The microsomal CYP1A monooxygenase system (EROD) was shown to be a sensitive indicator of embryonic exposure, being induced at the low (1 microgram/l, 182 ng/g egg) PCB concentration and after a short (3 day) exposure time. The conjugation enzyme system (GST) was shown to be functioning already at the advanced embryonic stage, although no response to the studied chemical stress was detected.     

Atrazine induction of cytochrome P450 in Chironomus tentans larvae

Cytochrome P450-dependent aldrin epoxidation was characterized in third instar larvae of the aquatic midge, Chironomus tentans. Optimal in vitro assay conditions for the epoxidase were pH 7.6 and 31 degrees C. Activity was linear up to 40 min of incubation time and 0.5 mg microsomal protein per incubation. The activity was concentrated in the microsomal fraction of whole body homogenates and was NADPH-dependent. The effect of atrazine exposure on aldrin epoxidase was measured to determine if this herbicide induces cytochrome P450-dependent activity. Comparisons of control and atrazine-exposed midges indicated increased epoxidase activity as a result of atrazine exposure, and a 45 kDa protein of increased intensity was observed after SDS-PAGE of microsomal protein. The molecular weight of this protein was similar in size to cytochrome P450 enzymes reported for other insects. Heme staining of SDS-PAGE gels and immunochemical studies using a Drosophila melanogaster anti-P450 polyclonal antiserum, further support the cytochrome P450 nature of this inducible 45 kDa protein.     

Forecasts using neural network versus Box-Jenkins methodology for ambient air quality monitoring data

This study explores ambient air quality forecasts using the conventional time-series approach and a neural network. Sulfur dioxide and ozone monitoring data collected from two background stations and an industrial station are used. Various learning methods and varied numbers of hidden layer processing units of the neural network model are tested. Results obtained from the time-series and neural network models are discussed and compared on the basis of their performance for 1-step-ahead and 24-step-ahead forecasts. Although both models perform well for 1-step-ahead prediction, some neural network results reveal a slightly better forecast without manually adjusting model parameters, according to the results. For a 24-step-ahead forecast, most neural network results are as good as or superior to those of the time-series model. With the advantages of self-learning, self-adaptation, and parallel processing, the neural network approach is a promising technique for developing an automated short-term ambient air quality forecast system.     

An intelligent emissions controller for fuel lean gas reburn in coal-fired power plants

The application of artificial intelligence techniques for performance optimization of the fuel lean gas reburn (FLGR) system is investigated. A multilayer, feedforward artificial neural network is applied to model static nonlinear relationships between the distribution of injected natural gas into the upper region of the furnace of a coal-fired boiler and the corresponding oxides of nitrogen (NOx) emissions exiting the furnace. Based on this model, optimal distributions of injected gas are determined such that the largest NOx reduction is achieved for each value of total injected gas. This optimization is accomplished through the development of a new optimization method based on neural networks. This new optimal control algorithm, which can be used as an alternative generic tool for solving multidimensional nonlinear constrained optimization problems, is described and its results are successfully validated against an off-the-shelf tool for solving mathematical programming problems. Encouraging results obtained using plant data from one of Commonwealth Edison's coal-fired electric power plants demonstrate the feasibility of the overall approach. Preliminary results show that the use of this intelligent controller will also enable the determination of the most cost-effective operating conditions of the FLGR system by considering, along with the optimal distribution of the injected gas, the cost differential between natural gas and coal and the open-market price of NOx emission credits. Further study, however, is necessary, including the construction of a more comprehensive database, needed to develop high-fidelity process models and to add carbon monoxide (CO) emissions to the model of the gas reburn system.