Experimental investigation of hydrogen–air deflagrations and detonations in semi-confined flat layers

This paper presents results of an experimental investigation on the deflagration and deflagration-to-detonation transition (DDT) in an obstructed (blockage ratio BR = 50%), semi-confined flat layer filled with uniform hydrogen–air mixtures. The effect of mixture reactivity depending on flat layer thickness and its width is studied to evaluate the critical conditions for sonic flame propagation and the possibility for detonation onset. The experiments were performed in a transparent, rectangular channel with a length of 2.5 m. The flat layer thickness was varied from 0.06 to 0.24 m and the experiments were performed for different channel widths of 0.3, 0.6 and 0.9 m. The experimental results show flame velocity vs. hydrogen concentration for different thicknesses and widths of the semi-confined flat layer. Three different flame propagation regimes were observed: slow subsonic flame (M << 1), sonic deflagration (M ～ 1) and detonation (M >> 1). It is shown that flame acceleration (FA) to sonic speed is independent of the width of the flat layer. The critical expansion ratio for effective flame acceleration to sonic speed was found to be linearly dependent on the reciprocal layer thickness.     

Two-phase jet releases,droplet dispersion and rainout,II. Rainout experiments

This paper describes the results of the first experimental stage of Phase IV of a Joint Industry Project (JIP) on liquid jets and two-phase droplet dispersion. The objective of this stage of the JIP was to generate experimental rainout data for non-flashing water and xylene experiments. See the overview companion paper I for a wider overview of the problem, model implementation and associated model validation.A range of orifice sizes (2.5 and 5 mm) and stagnation pressures (4–16 barg) were applied. Measurements included flow rate, initial droplet size, plume concentrations/temperatures for a range of downstream locations, and distributed rainout.Instead of the Phase Doppler Anemometry method used for droplet size measurements earlier in the JIP, a photographic technique was applied in an attempt to include measurement of the larger (non-spherical) droplets. This enabled a more accurate evaluation of the initial droplet size distribution and a much clearer understanding of the droplet morphology. The results showed that the droplet behaviour in the jet is more complex than had been anticipated with the mass distribution dominated by a very small number of large non-spherical droplets. Consequently a large number of spray images were required to evaluate an accurate size distribution.Distributed rainout was measured by weighing the amount of rainout in trays positioned along the jet direction. The rainout results showed a good degree of repeatability and internal consistency. They indicated that an increasing proportion of the released material did not rainout for increasing pressure. Rainout distance also increased with increasing pressure. Evaporation of the liquid was confirmed by temperature measurements, which showed the effect of evaporative cooling.Xylene concentration measurements (up to 1%) were carried out using a direct reading photoionization detector calibrated for xylene (measuring vapour only). For a limited dataset, the accuracy of these measurements was estimated by means of comparison against an alternative more time-consuming concentration method (xylene absorption onto a charcoal filter; measuring both vapour and liquid). The concentration measurements displayed several consistent qualitative features. For example, at a given downstream distance, the peak concentration increases with increasing pressure and nozzle diameter and the vertical height at which the peak is achieved increases. The cross-stream profiles displayed a consistent tendency to increased concentration at the edge of the jet, and the reason for this has not been established.Finally recommendations are provided for potential future work.     

Analysis of underlying causes of investigated loss of containment incidents in Dutch Seveso plants using the Storybuilder method

In the Netherlands there are around 400 “Seveso” sites that fall under the Dutch Major Hazards Decree (BRZO) 1999. Between 2006 and 2010 the Dutch Labour Inspectorate's Directorate for Major Hazard Control completed investigations of 118 loss of containment incidents involving hazardous substances from this group. On the basis of investigation reports the incidents were entered in a tailor-made tool called Storybuilder developed for the Dutch Ministry of Social Affairs and Employment for identifying the dominant patterns of technical safety barrier failures, barrier task failures and underlying management causes associated with the resulting loss of control events. The model is a bow-tie structure with six lines of defence, three on either side of the central loss of containment event. In the first line of defence, failures in the safety barriers leading to loss of control events were primarily equipment condition failures, pre start-up and safeguarding failures and process deviations such as pressure and flow failures. These deviations, which should have been recovered while still within the safe envelope of operation, were missed primarily because of inadequate indication signals that the deviations have occurred. Through failures of subsequent lines of defence they are developing into serious incidents. Overall, task failures are principally failures to provide adequate technical safety barriers and failures to operate provided barriers appropriately. Underlying management delivery failures were mainly found in equipment specifications and provisions, procedures and competence. The competence delivery system is especially important for identifying equipment condition, equipment isolation for maintenance, pre-start-up status and process deviations. Human errors associated with operating barriers were identified in fifty per cent of cases, were mostly mistakes and feature primarily in failure to prevent deviations and subsequently recover them. Loss of control associated with loss of containment was primarily due to the containment being bypassed (72% of incidents) and less to material strength failures (28%). Transfer pipework, connections in process plant and relief valves are the most frequent release points and the dominant release material is extremely flammable. It is concluded that the analysis of a large number of incidents in Storybuilder can support the quantification of underlying causes and provide evidence of where the weak points exist in major hazard control in the prevention of major accidents.     

Small-scale physical explosions in shock tubes in comparison with condensed high explosive detonations

A series of small-scale experiments involving physical explosions in a 1.6 l pressure vessel was carried out. Explosions were initiated by spontaneous rupture of an aluminium membrane on one side of the vessel at a pressure in the range 1–1.2 MPa. The pressure waves released were measured at different distances along two separate shock tubes, one 10 m long and 200 mm in diameter (closed at one end by the high pressure vessel) and the other 15 m long and 100 mm in diameter.TNT equivalency was used for predicting the blast wave characteristics after vessel rupture. TNT equivalency was used because equations for prediction of peak pressure and impulse of the blast wave in 1-D geometry after detonations of condensed explosives are known. Some experiments with an equivalent amount of real explosive were carried out for comparison with the theoretical and experimental data obtained. The applicability of the TNT equivalency method presented for calculations of maximum pressure and shock wave impulse generated after rupture of the pressure vessel in 1-D geometry is discussed.     

Survey of polycyclic aromatic hydrocarbons (PAHs) in arterial street air of Hangzhou

ＩｎｔｒｏｄｕｃｔｉｏｎＰｏｌｙｃｙｃｌｉｃａｒｏｍａｔｉｃｈｙｄｒｏｃａｒｂｏｎｓ (ＰＡＨｓ)ａｒｅｗｉｄｅｓｐｒｅａｄｅｎｖｉｒｏｎｍｅｎｔａｌｐｏｌｌｕｔａｎｔｓｉｎｔｈｅａｔｍｏｓｐｈｅｒｅ.Ｔｈｅｙａｒｅｇｅｎｅｒａｔｅｄｉｎｔｈｅｃｏｍｂｕｓｔｉｏｎ .Ｔｈｅｍａｊｏｒｓｏｕｒｃｅｓｉｄｅｎｔｉｆｉｅｄｉｎｃｌｕｄｅｆｏｓｓｉｌｆｕｅｌｓ,ｖｅｈｉｃｕｌａｒｔｒａｆｆｉｃ,ｉｎｄｕｓｔｒｉａｌｐｒｏｃｅｓｓｅｓ,ｓｍｏｋｉｎｇａｎｄｄｏｍｅｓｔｉｃｈｅａｔｉｎｇ (Ｐｅｌｔｏｎｅｎ ,1995) .Ｔ…     

A matter of approach: the retort's potential to reduce mercury consumption within small-scale gold mining settlements in Tanzania

The mercury-based gold extraction processes prevalent within small-scale mining are both efficient and harmful. While ensuring relatively high levels of gold recovery, they cause environmental and health problems for people living within mining settlements. This mercury consumption can be minimized by using a simple mercury recycling device known as a retort. While mining legislation in Tanzania dictates the use of retorts for gold recovery, virtually no miners use them, indicating the inadequacy of previous introduction attempts. During action research, retorts were introduced in two mining settlements through a thorough and participatory approach. Twenty miners were given retorts and their attitudes and receptiveness to them were studied. Of the recipients, 18 used the retorts over a period of five months, recycling 10 kilos of mercury. Less mercury was spilled into the environment and miners saved money normally spent on purchasing mercury. The findings have implications for the strategies of development interventions targeting mercury-instigated problems within small-scale gold mining.     

Development of vermicast from sludge and powdered oyster shell

Soil acidification is one of the rising land degradation issues facing world agriculture. The risk of acidification is currently being assessed as part of agriculture productivity and sustainable theme. This study was conducted to produce a new vermicomposting cast as a recycling resource derived from municipal sewage sludge and waste oyster shell. The earthworm, Eisenia Andrei, was fed under different conditions. The most suitable mixture was 77:23 w/w% of sewage sludge and waste oyster shell. Powdered oyster shell (POS) sludge blend provided a stable pH, due to its buffering capacity during vermiculture because of the Ca²⁺ and OH^? release effect. The vermicast products fulfilled the cast standards of Korea Ministry of Environment for all the parameters such as moisture content, pH, salinity, organic carbon, TKN, Phosphate, and heavy metals. Slowly released organic matter when added to soil improves the capacity of the soil to hold nutrients for plants, improve soil aeration for roots, and improves soil drainage. This product will be an addition to already-commercialized sludge vermicast as a higher value product.     

Yield response of potato to spatially patterned nitrogen application

Although crop response to nitrogen fertilization has long been studied, classical experimental designs have led to inadequate accounting of spatial variability in field properties and yield response. Analytical methods to explicitly account for spatial variability now exist but the complementary modification of experimental design is still developing. There is a need to combine these analytical methods with non-traditional experimental design. A 2-year study was implemented to assess the response of potato (Solanum tuberosum cv. Kennebec) yield to nitrogen fertilizer rate. We used a transect-type plot design where four nitrogen treatments (0, 56, 112, and 280 kg N ha^?1) were applied systematically in a continuous sinusoidal pattern along longitudinal transects. Measured field properties included topography, soil texture, pre-application soil nitrate levels, and plant available soil water content. A random field linear model was used to simultaneously account for treatment effects and soil properties. The results showed that treatment effects were significantly different from each other; however, if spatially correlated errors were accounted for, these differences were smaller and significance levels lower. Nitrogen response functions varied widely throughout the field. Of the covariates, only clay content proved important in explaining spatial differences in response to N. The sinusoidal response pattern of N was similar over the 2 years but the amplitudes varied due to differences in weather. Interactions between uncharacteristically high rainfall and a sandy field soil may have minimized discernable effects of the other covariates. The results demonstrated how the statistical analysis of potato response to a patterned application of nitrogen fertilizer can take advantage of spatial correlations to understand the response of potato to nitrogen application over larger areas.